remove seats YAMAHA RHINO 700 2008 Owners Manual

4-37 1. Driver seat 2. Passenger seat
3. Seat lock lever (× 2)
1. Siège du conducteur 2. Siège du passager
3. Manette de verrouillage de siège (× 2)
1. Asiento del conductor 2. Asiento del pasajero
3. Palanca de bloqueo del asiento (× 2)
EVU00330
Seats
To remove a seat, pull its seat lock lever upward,
lift the front of the seat, and then slide the seat for-
ward and up.
To install a seat, insert the projections on the rear
of the seat into the seat holders and push down on
the seat at the front. Make sure the seats are se-
curely latched. WARNING! A loose seat could
cause the operator to lose control, or cause
the operator or passenger to fall.
EE.book Page 37 Monday, October 8, 2007 4:48 PM

8-21 1. Console
1. Console
1. Consola
1
5B410011
Console
To remove
1. Remove the seats. (See page 4-37 for seat
removal and installation procedures.)
2. Remove the parking brake lever boot.
3. Pull the console forward and upward (the
drive select lever boot will come loose). To
ease removal of the console, shift the drive
select lever into the low gear “L” position.
EE.book Page 21 Monday, October 8, 2007 4:48 PM

8-97 a. Parking brake lever free play
a. Garde du levier de frein de stationnement
a. Holgura de la palanca del freno de estacionamiento
a
EVU00870
Parking brake lever free play adjustment
Periodically check the parking brake lever free
play and adjust it if necessary.
1. Shift the drive select lever into low gear “L”.
2. Remove the seats. (See page 4-37 for seat
removal and installation procedures.)
3. Remove the console. (See pages 8-21–8-23
for console removal and installation proce-
dures.)
4. Check the parking brake lever free play. The
maximum free play is equal to one click of the
parking brake lever. If necessary, adjust the
free play as follows.
5. The parking brake lever must be released
when checking and adjusting the parking
brake lever free play.
6. Loosen the locknut.
EE.book Page 97 Monday, October 8, 2007 4:48 PM