parking brake YAMAHA RHINO 700 2012 Manuale de Empleo (in Spanish)

6-17
4. Release the parking brake.
5. Check behind the vehicle for people or obsta-
cles, and then release the brake pedal.
6. Press the accelerator pedal gradually and
continue to watch to the rear while backing.
1RB60-EE.book Page 17 Thursday, April 7, 2011 10:43 AM

6-23
EVU01210
Parking
When parking, stop the engine and shift the drive
select lever into the neutral position. Apply the
parking brake to help prevent the vehicle from roll-
ing. See pages 7-47–7-49 for more information on
parking and parking on a slope.
1RB60-EE.book Page 23 Thursday, April 7, 2011 10:43 AM

7-43
Accelerating
With the engine idling in neutral and your foot on
the brake, shift the drive select lever into low or
high. NOTICE: Do not shift from low to high or
vice versa without coming to a complete stop
and waiting for the engine to return to normal
idle speed – damage to the engine or drive
train may occur. Then release the parking
brake. Press the accelerator pedal slowly and
smoothly. The centrifugal clutch will engage and
the vehicle will begin to accelerate.
Avoid higher speeds and sudden or hard acceler-
ation until you are thoroughly familiar with the op-
eration of your vehicle. Avoid sudden or hard
acceleration in any turn.
1RB60-EE.book Page 43 Thursday, April 7, 2011 10:43 AM

7-47
Leaving the vehicle
Do not get out of the vehicle while the engine is
running and the drive select lever is in any gear.
There is a risk of injury because:

Children or others may accidentally press the
accelerator pedal.


Objects tossed into the vehicle may strike the
accelerator pedal.


The parking brake may not keep the vehicle
from accelerating.
Unwanted vehicle movement can cause serious
injury or death, and it may be dangerous to try to
stop the vehicle.
Parking on a flat area
When parking on a flat area, stop the engine and
shift the drive select lever into the neutral position.
Apply the parking brake to help prevent the vehicle
from rolling.
1RB60-EE.book Page 47 Thursday, April 7, 2011 10:43 AM

7-49
Parking on a slope
The parking brake acts only on the rear wheels
when in “2WD”. For the parking brake to take ef-
fect on all four wheels, shift to “LOCK” before stop-
ping the engine.
If you park on a hill that is too steep the vehicle
may roll out of control. Never park on hills that are
so steep you cannot walk up them easily. If you
must park on an incline follow these instructions:
1. Bring the vehicle to a stop by applying the
brake pedal.
2. Put the vehicle in “LOCK”.
3. Turn the key to “OFF”.
4. With the brake pedal applied, set the parking
brake.
5. Block the front and rear wheels with rocks or
other objects.
1RB60-EE.book Page 49 Thursday, April 7, 2011 10:43 AM

7-75
Encountering obstacles
If you cannot go around an obstacle, such as a fall-
en tree or a ditch, stop the vehicle where it is safe
to do so. Set the parking brake and get out to in-
spect the area thoroughly. Look from both your ap-
proach side and exit side. If you believe you can
continue safely, choose the path that will allow you
to get over the obstacle and at as close to a right
angle as possible to minimize vehicle tipping. Go
only fast enough to maintain your momentum but
still give yourself plenty of time to react to changes
in conditions.
If there is any question about your ability to ma-
neuver safely over the obstacle, you should turn
around if the ground is flat and you have the room
or back up until you find a less difficult path.
1RB60-EE.book Page 75 Thursday, April 7, 2011 10:43 AM

8-8
EVU01650
General maintenance and lubrication chart
ITEM ROUTINEWhichever
comes firstINITIAL EVERY
month136612
km
(mi)320
(200)1200
(750)2400
(1500)2400
(1500)4800
(3000)
hours 20 75 150 150 300
Cooling system*Check coolant leakage.
Repair if necessary.
Replace coolant every 24 months.
Air filter elementClean.
Replace if necessary.Every 20–40 hours
(More often in wet or dusty areas.)
Engine oilReplace (warm engine before draining).Engine oil filter cartridgeReplace.Final gear oil
Check oil level/oil leakage.
Replace.Differential gear oil
Front brake*Check operation/brake pad wear/fluid leakage/see page 8-9.
Correct if necessary. Replace pads if worn to the limit.Rear brake*Check operation/brake pad wear/fluid leakage/see page 8-9.
Correct if necessary. Replace pads if worn to the limit.Parking brake*Check operation and free play/brake pad wear.
Correct if necessary. Replace pads if worn to the limit.Accelerator pedal*Check operation and free play.V-belt*Check operation.
Check for wear, cracks, or damage.Wheels*Check balance/damage/runout.
Repair if necessary.Wheel bearings*Check bearing assemblies for looseness/damage.
Replace if damaged.Front and rear
suspension*Check operation and for leakage.
Correct if necessary.Steering system*Check operation and for looseness/Replace if damaged.
Check toe-in/Adjust if necessary.Rear upper and lower
knuckle pivots*Lubricate with lithium-soap-based grease.
1RB60-EE.book Page 8 Thursday, April 7, 2011 10:43 AM

8-21 1. Console
1. Console
1. Consola
1
5B410011
Console
To remove
1. Remove the seats. (See page 4-37 for seat
removal and installation procedures.)
2. Remove the parking brake lever boot.
3. Pull the console forward and upward (the
drive select lever boot will come loose). To
ease removal of the console, shift the drive
select lever into the low gear “L” position.
1RB60-EE.book Page 21 Thursday, April 7, 2011 10:43 AM

8-23
To install
1. Place the console in its original position.
2. Install the parking brake lever boot.
3. Install the seats.NOTICE

Be sure to position the seat belt buckles to
the outside of the console.


When installing the console, be sure not to
pinch the cables or wires.


Make sure that the groove at the bottom of
the parking brake lever boot and the drive
select lever boot fits securely around the
edge of the hole in the console.
1RB60-EE.book Page 23 Thursday, April 7, 2011 10:43 AM

8-91 1. Brake pad wear indicator groove
1. Rainure d’indication d’usure de plaquette de frein
1. Ranura indicadora de desgaste de la pastilla de freno
1
5B410020
Checking the parking brake pads
Each brake pad is provided with two wear indicator
grooves, which allow you to check the brake pad
wear without having to disassemble the brake. To
check the brake pad wear, check the wear indica-
tor grooves. If a brake pad has worn to a wear in-
dicator groove, have a Yamaha dealer replace the
brake pads as a set.
1RB60-EE.book Page 91 Thursday, April 7, 2011 10:43 AM