wheel YAMAHA RHINO 700 2012 Owner's Guide

8-139
1. Fuel injection system spare fuse 2. Fuel injection system fuse
3. Main fuse 4. Headlight fuse “HEAD”
5. Signaling system fuse “SIGNAL”
6. Auxiliary DC jack fuse “TERMINAL”
7. Four-wheel-drive motor fuse “DIFF”
8. Ignition fuse “IGNITION”
9. Backup fuse “BACK UP” (for clock)
10. Spare fuse (× 3) 11. Radiator fan fuse “FAN”
1. Fusible de rechange du système d’injection de carburant
2. Fusible du système d’injection de carburant
3. Fusible principal 4. Fusible de phare “HEAD”
5. Fusible du circuit de signalisation “SIGNAL”
6. Fusible de la prise pour accessoire “TERMINAL”
7. Fusible du moteur du système quatre roues motrices “DIFF”
8. Fusible d’allumage “IGNITION”
9. Fusible de sauvegarde “BACK UP” (pour la montre)
10. Fusible de rechange (× 3)
11. Fusible du ventilateur de radiateur “FAN”
1. Fusible de repuesto del sistema de inyección
2. Fusible del sistema de inyección
3. Fusible principal 4. Fusible de los faros “HEAD”
5. Fusible del sistema de intermitencia “SIGNAL”
6. Fusible de la toma auxiliar de corriente continua “TERMINAL”
7. Fusible de la tracción a las cuatro ruedas “DIFF”
8. Fusible del encendido “IGNITION”
9. Fusible de repuesto “BACK UP” (reloj)
10. Fusible de reserva (× 3)
11. Fusible del ventilador del radiador “FAN”
3 2 17
9 5 468
A
@
0
5. Remove the blown fuse, and then install a
new fuse of the specified amperage.
WARNING! Always use a fuse of the spec-
ified amperage. Never use any material in
place of the proper fuse. Using an improp-
er fuse can cause damage to the electrical
system and may lead to a fire.
Specified fuses:
Main fuse: 40.0 A
Fuel injection system fuse: 10.0 A
Headlight fuse: 15.0 A
Ignition fuse: 10.0 A
Auxiliary DC jack fuse: 10.0 A
Signaling system fuse: 10.0 A
Four-wheel-drive motor
fuse: 10.0 A
Radiator fan fuse: 25.0 A
Backup fuse: 10.0 A
1RB60-EE.book Page 139 Thursday, April 7, 2011 10:43 AM

9-1
EVU01030
1-CLEANING AND STORAGE
A. Cleaning
Frequent, thorough cleaning of your vehicle will
not only enhance its appearance but will improve
its general performance and extend the useful life
of many components.
1. Before cleaning the vehicle:
a. Block off the end of the exhaust pipe to
prevent water entry. A plastic bag and
strong rubber band may be used.
b. Make sure the spark plug and all filler
caps are properly installed.
2. If the engine case is excessively greasy, ap-
ply degreaser with a paint brush. Do not ap-
ply degreaser to the wheel axles.
1RB60-EE.book Page 1 Thursday, April 7, 2011 10:43 AM

9-3
3. Rinse the dirt and degreaser off with a garden
hose. Use only enough pressure to do the
job. WARNING! Test the brakes after
washing. Apply the brakes several times
at slow speeds to let friction dry out the
linings. Wet brakes may have reduced
stopping ability, increasing the chance of
an accident. NOTICE: Excessive water
pressure may cause water seepage and
deterioration of wheel bearings, brakes,
transmission seals and electrical devices.
Many expensive repair bills have resulted
from improper high-pressure detergent
applications, such as those available in
coin-operated car washers.
1RB60-EE.book Page 3 Thursday, April 7, 2011 10:43 AM

9-9
3. Lubricate all control cables.
4. Block up the frame to raise all wheels off the
ground.
5. Tie a plastic bag over the exhaust pipe outlet
to prevent moisture from entering.
6. If storing in a humid or salt-air atmosphere,
coat all exposed metal surfaces with a light
film of oil. Do not apply oil to any rubber parts
or the seat covers.
7. Remove the battery and charge it. Store it in
a dry place and recharge it once a month. Do
not store the battery in an excessively warm
or cold place [less than 0°C (30°F) or more
than 30°C (90°F)].
Use of fuel stabilizer and conditioner eliminates
the need to drain the fuel system. Consult a
Yamaha dealer if the fuel system needs to be
drained.
1RB60-EE.book Page 9 Thursday, April 7, 2011 10:43 AM

10-1
1 -SPECIFICATIONS
Dimensions:Overall length:
2885 mm (113.6 in)
Overall width:
1385 mm (54.5 in)
Overall height:
YXR700FAB 1853 mm (73.0 in)
YXR7FSPB 1901 mm (74.8 in)
YXR7FB 1853 mm (73.0 in)
Seat height:
818 mm (32.2 in)
Wheelbase:
1910 mm (75.2 in)
Ground clearance:
280 mm (11.0 in)
Minimum turning radius:
3900 mm (154 in)Weight:With oil and fuel:
YXR700FAB 540.0 kg (1190 lb)
YXR7FSPB 548.0 kg (1208 lb)
YXR7FB 540.0 kg (1190 lb)
Noise and vibration level:
Noise level (77/311/EEC):
YXR7FSPB 80.2 dB(A)
YXR7FB 80.2 dB(A)
Vibration on seat (EN1032, ISO5008):
YXR7FSPB Will not exceed 0.5 m/s²
YXR7FB Will not exceed 0.5 m/s²Vibration on steering wheel (EN1032, ISO5008):
YXR7FSPB Will not exceed 2.5 m/s²
YXR7FB Will not exceed 2.5 m/s²
Engine:Engine type:
Liquid cooled 4-stroke, SOHC
Cylinder arrangement:
Forward-inclined single cylinder
Displacement:
686 cm³
Bore × stroke:
102.0 × 84.0 mm (4.02 × 3.31 in)
Compression ratio:
9.20 : 1
Starting system:
Electric starter
Lubrication system:
Wet sumpEngine oil:Recommended brand:
YAMALUBE
1RB60-EE.book Page 1 Thursday, April 7, 2011 10:43 AM

10-3
Transmission:Primary reduction system:
V-belt
Secondary reduction system:
Shaft drive
Secondary reduction ratio:
41/21 × 17/12 × 33/9 (10.142)
Transmission type:
V-belt automatic
Operation:
Right hand operation
Reverse gear:
23/14 × 28/23 (2.000)
Low range:
31/16 (1.938)
High range:
31/21 (1.476)Chassis:Frame type:
Steel tube frame
Caster angle:
5.0 °
Trail:
26.0 mm (1.02 in)Front tire:Type:
Tubeless
Size:
25 × 8-12NHS
Manufacturer/model:
MAXXIS/M951Y
Rear tire:Type:
Tubeless
Size:
25 × 10-12NHS
Manufacturer/model:
MAXXIS/M952YLoading:Maximum loading limit:
YXR700FAB 367.0 kg (809 lb)
YXR7FSPB 359.0 kg (791 lb)
YXR7FB 367.0 kg (809 lb)
(Total weight of rider, passenger, cargo, accessories, and
tongue)Tire air pressure (measured on cold tires):Recommended:
Front:
70.0 kPa (0.700 kgf/cm², 10 psi)
Rear:
98.0 kPa (0.980 kgf/cm², 14 psi)
Minimum:
Front:
63.0 kPa (0.630 kgf/cm², 9 psi)
Rear:
91.0 kPa (0.910 kgf/cm², 13 psi)Front wheel:Wheel type:
YXR700FAB Panel wheel
YXR7FSPB Cast wheel
YXR7FB Panel wheel
Rim size:
12 × 6.0AT
1RB60-EE.book Page 3 Thursday, April 7, 2011 10:43 AM

10-4
Rear wheel:Wheel type:
YXR700FAB Panel wheel
YXR7FSPB Cast wheel
YXR7FB Panel wheel
Rim size:
12 × 7.5ATFront brake:Type:
Disc brake
Operation:
Unified brake
Specified brake fluid:
DOT 4Rear brake:Type:
Disc brake
Operation:
Unified brake
Specified brake fluid:
DOT 4Front suspension:Type:
Double wishbone
Spring/shock absorber type:
YXR700FAB Coil spring/oil damper
YXR7FSPB Coil spring/gas-oil damper
YXR7FB Coil spring/oil damper
Wheel travel:
185 mm (7.3 in)
Rear suspension:Type:
Double wishbone
Spring/shock absorber type:
YXR700FAB Coil spring/oil damper
YXR7FSPB Coil spring/gas-oil damper
YXR7FB Coil spring/oil damper
Wheel travel:
185 mm (7.3 in)Electrical system:Ignition system:
TCI
Charging system:
AC magnetoBattery:Model:
U1L-11
Voltage, capacity:
12 V, 28.0 AhHeadlight:Bulb type:
Krypton bulbBulb voltage, wattage × quantity:Headlight:
12 V, 30.0/30.0 W × 2
Tail/brake light:
12 V, 5.0/21.0 W × 2
Neutral indicator light:
LED
Reverse indicator light:
LED
1RB60-EE.book Page 4 Thursday, April 7, 2011 10:43 AM

10-5 Coolant temperature warning light:
LED
Engine trouble warning light:
LED
Parking brake indicator light:
LED
On-Command four-wheel-drive/differential gear lock indica-
tor:
LCD
High-range indicator light:
LED
Low-range indicator light:
LED
Differential gear lock indicator light:
LED
Helmet/seat belt indicator light:
12 V, 0.7 W × 2
Fuses:Main fuse:
40.0 A
Fuel injection system fuse:
10.0 A
Headlight fuse:
15.0 A
Signaling system fuse:
10.0 A
Ignition fuse:
10.0 A
Auxiliary DC jack fuse:
10.0 A
Backup fuse:
10.0 AFour-wheel-drive motor fuse:
10.0 A
Radiator fan fuse:
25.0 A
For EUR only
The figures quoted are emission levels and are not
necessarily safe working levels. Whilst there is a
correlation between the emission and exposure
levels, this cannot be used reliably to determine
whether or not further precautions are required.
Factors that influence the actual level of exposure
of work-force include the characteristics of the
work room, the other sources of noise, etc. i.e. the
number of machines and other adjacent process-
es, and the length of time for which an operator is
exposed to the noise. Also the permissible expo-
sure level can vary from country. This information,
however, will enable the user of the machine to
make a better evaluation of the hazard and risk.
1RB60-EE.book Page 5 Thursday, April 7, 2011 10:43 AM