lock YAMAHA T105 2002 User Guide

EAU03780*Drive chain slack adjustment
1. Loosen the rear brake adjusting nut
and axle nut.
2. Loosen the locknut at each end of the
swingarm.
3. To tighten the drive chain, turn the ad-
justing nut clockwise.
To loosen the drive chain, turn the ad-
justing nut counterclockwise and then
push the rear wheel forward.NOTE:
There are the alignment marks on each
side of the swingarm, use these marks to
align the rear wheel.
59
q
w
1. Rear brake adjusting nut 2. Axle nut
qw
e
r
1. Rear wheel axle 2. Alignment marks
3. Adjusting nut 4. Locknut
5SD O/M-3 9/4/01 2:50 PM Page 59 (1,1)

EC000096cCImproper drive chain slack will overload
the engine and other vital parts and can
lead to chain slippage or breakage. Keep
the drive chain slack within the specified
limits.4. Tighten both locknuts, and then tight-
en the axle nut to the specified torque.
5. Adjust the brake pedal free play. (See
page 53 for adjustment procedure.)
EW000103wAfter adjusting the brake pedal free play,
check the operation of the brake light.
60
Tightening torque:
Axle nut:
60 Nm (6.0 m•kg)
5SD O/M-3 9/4/01 2:50 PM Page 60 (1,1)

3. Remove the drive chain. Thoroughly
clean the chain with solvent and lubri-
cate it. Reinstall the chain or store it in
a plastic bag (tied to frame for safe-
keeping).
4. Lubricate all control cables.
5. Block up the frame to raise both
wheels off the ground.
6. Tie a plastic bag over the exhaust pipe
outlet to prevent moisture from enter-
ing.
7. If storing in a humid or salt-air atmos-
phere, coat all exposed metal surfaces
with a light film of oil. Do not apply oil
to any rubber parts or the seat cover.
8. Remove the battery and charge it.
Store it in a dry place and recharge it
once a month. Do not store the bat-
tery in an excessively warm or cold
place (less than 0°C (32°F) or more
than 30°C (86°F)).
EUU05800NOTE:
Make any necessary repairs before storing
the motorcycle.
70
5SD O/M-3 9/4/01 2:50 PM Page 70 (1,1)