recommended oil YAMAHA TDR 125 2001 Owners Manual

EAU00009
TABLE OF CONTENTS
GIVE SAFETY THE RIGHT OF WAY.................1-1
DESCRIPTION....................................................2-1
Left view...........................................................2-1
Right view.........................................................2-2
Controls and instruments..................................2-3
INSTRUMENT AND CONTROL FUNCTIONS....3-1
Main switch/steering lock..................................3-1
Indicator and warning lights..............................3-2
Speedometer unit.............................................3-3
Tachometer......................................................3-3
Coolant temperature gauge..............................3-4
Handlebar switches..........................................3-4
Clutch lever.......................................................3-6
Shift pedal.........................................................3-6
Brake lever.......................................................3-7
Brake pedal......................................................3-7
Fuel tank cap....................................................3-7
Fuel (except for Switzerland and Austria).........3-8
Fuel (for Switzerland and Austria)....................3-8
Catalytic converter
(for Switzerland and Austria)..........................3-9
2-stroke engine oil..........................................3-10
Fuel cock........................................................3-11
Starter (choke) lever ......................................3-12
Seat................................................................3-12Helmet holder.................................................3-13
Adjusting the shock absorber assembly.........3-13
YEIS handling precautions.............................3-14
YPVS..............................................................3-14
Sidestand........................................................3-15
Ignition circuit cut-off system..........................3-16
PRE-OPERATION CHECKS...............................4-1
Pre-operation check list....................................4-1
OPERATION AND IMPORTANT RIDING
POINTS...............................................................5-1
Starting a cold engine.......................................5-1
Starting a warm engine.....................................5-2
Shifting..............................................................5-3
Recommended shift points
(for Switzerland only)......................................5-3
Tips for reducing fuel consumption...................5-4
Engine break-in................................................5-4
Parking.............................................................5-5
PERIODIC MAINTENANCE AND MINOR
REPAIR...............................................................6-1
OwnerÕs tool kit.................................................6-1
Periodic maintenance and lubrication chart......6-2
Removing and installing cowlings and panel....6-5
Checking the spark plug...................................6-7
123
456
5AE-9-E4 (ENG) 8/30/00 5:04 PM Page 5

3-10
INSTRUMENT AND CONTROL FUNCTIONS
1
23
4
5
6
7
8
9
EC000114
cCThe following precautions must be
observed to prevent a fire hazard
or other damages.
8Use only unleaded gasoline.
The use of leaded gasoline will
cause unrepairable damage to
the catalytic converter.
8Never park the motorcycle
near possible fire hazards
such as grass or other materi-
als that easily burn.
8Do not allow the engine to idle
too long.
EAU03750
2-stroke engine oilMake sure that there is sufficient oil in
the 2-stroke engine oil tank. Add the
recommended 2-stroke engine oil if
necessary.NOTE:
Make sure that the 2-stroke engine
oil tank cap is properly installed.
1
1.2-stroke engine oil tank cap
Recommended oil:
Yamalube 2 or equivalent
2-stroke engine oil (JASO
grade ÒFCÓ, or ISO grades
ÒEG-CÓ or ÒEG-DÓ)
Oil quantity:
1.2 L
5AE-9-E4 (ENG) 8/30/00 5:04 PM Page 20

4-1
EAU01114
PRE-OPERATION CHECKS
1
2
34
5
6
7
8
9The condition of a vehicle is the ownerÕs responsibility. Vital components can start to deteriorate quickly and unexpect-
edly, even if the vehicle remains unused (for example, as a result of exposure to the elements). Any damage, fluid leak-
age or loss of tire air pressure could have serious consequences. Therefore, it is very important, in addition to a thor-
ough visual inspection, to check the following points before each ride.
EAU03439
Pre-operation check list
ITEMCHECKSPAGE
Fuel¥Check fuel level in fuel tank.
¥Refuel if necessary.
¥Check fuel line for leakage.3-7Ð3-9
Two-stroke engine oil¥Check oil level in oil tank.
¥If necessary, add recommended oil to specified level.
¥Check vehicle for oil leakage.3-10
Transmission oil¥Check oil level in transmission case.
¥If necessary, add recommended oil to specified level.6-8Ð6-10
Coolant¥Check coolant level in reservoir.
¥If necessary, add recommended coolant to specified level.
¥Check cooling system for leakage.6-10Ð6-13
Front brake¥Check operation.
¥If soft or spongy, have Yamaha dealer bleed hydraulic system.
¥Check lever free play.
¥Adjust if necessary.
¥Check fluid level in reservoir.
¥If necessary, add recommended brake fluid to specified level.
¥Check hydraulic system for leakage.3-7, 6-21, 6-23Ð6-24
5AE-9-E4 (ENG) 8/30/00 5:04 PM Page 28

1
4.Install the transmission oil drain
bolt, and then tighten it to the
specified torque.
5.Add the specified amount of the
recommended transmission oil,
and then install and tighten the
oil filler cap.1.Transmission oil drain bolt
6-9
1
1.Oil filler capTo change the transmission oil
1.Start the engine, warm it up for
several minutes, and then turn it
off.
2.Place an oil pan under the trans-
mission to collect the used oil.
3.Remove the oil filler cap and
drain bolt to drain the oil from the
transmission.
PERIODIC MAINTENANCE AND MINOR REPAIR
1
2
3
4
56
7
8
9Tightening torque:
Transmission oil drain bolt:
15 Nm (1.5 m0kg)
1
2
1.Check window
2.Minimum level mark3.Wait a few minutes until the oil
settles, and then check the oil
level through the check window
located at the right side of the
crankcase.NOTE:
The transmission oil should be above
the minimum level mark.4.If the oil is below the minimum
level mark, remove the oil filler
cap, add sufficient oil of the rec-
ommended type to raise it to the
correct level, and then install and
tighten the cap.
5AE-9-E4 (ENG) 8/30/00 5:04 PM Page 44

6-10
EC000077
cC8In order to prevent clutch slip-
page (since the transmission
oil also lubricates the clutch),
do not mix any chemical addi-
tives with the oil.
8Make sure that no foreign
material enters the transmis-
sion.6.Start the engine, and then let it
idle for several minutes while
checking the transmission for oil
leakage. If oil is leaking, immedi-
ately turn off the engine and
check for the cause.
PERIODIC MAINTENANCE AND MINOR REPAIR
1
2
3
4
56
7
8
9 Recommended transmission oil:
See page 8-1
Oil quantity:
Periodic oil change:
0.75 L
Total amount (dry transmission):
0.8 L
1
2
1.Maximum level mark
2.Minimum level mark2.Check the coolant level in the
coolant reservoir.NOTE:
The coolant should be between the
minimum and maximum level marks.3.If the coolant is at or below the
minimum level mark, open the
reservoir cap, add coolant to the
maximum level mark, and then
close the reservoir cap.
EAU03761
CoolantTo check the coolant level
1.Place the motorcycle on a level
surface and hold it in an upright
position.NOTE:
8The coolant level must be
checked on a cold engine since
the level varies with engine tem-
perature.
8Make sure that the motorcycle is
positioned straight up when
checking the coolant level. A
slight tilt to the side can result in
a false reading.
5AE-9-E4 (ENG) 8/30/00 5:04 PM Page 45

6-14
PERIODIC MAINTENANCE AND MINOR REPAIR
1
2
3
4
56
7
8
9 4.Lift the front of the fuel tank to
position the fuel tank away from
the air filter case. (Do not discon-
nect the fuel hoses!)
EW000071
w8Make sure that the fuel tank is
well supported.
8Do not tilt or pull the fuel tank
too much, otherwise the fuel
hoses may come loose, which
could cause fuel leakage.
1
3
3
2
1.Relay (´2)
2.Air filter case cover
3.Screw (´7)5.Remove the relays by pulling
them off their holders, and the air
filter case cover by removing the
screws.
1
1.Sponge material6.Pull the sponge material out,
clean it with solvent, and then
squeeze the remaining solvent
out.
7.Apply oil of the recommended
type to the entire surface of the
sponge material, and then
squeeze the excess oil out.NOTE:
The sponge material should be wet
but not dripping.
Recommended oil:
2-stroke engine oil
5AE-9-E4 (ENG) 8/30/00 5:04 PM Page 49

6-24
PERIODIC MAINTENANCE AND MINOR REPAIR
1
2
3
4
56
7
8
9
EAU03774
Checking the brake fluid
levelInsufficient brake fluid may allow air
to enter the brake system, possibly
causing it to become ineffective.
Before riding, check that the brake
fluid is above the minimum level mark
and replenish if necessary. A low
brake fluid level may indicate worn
brake pads and/or brake system
leakage. If the brake level is low, be
sure to check the brake pads for
wear and the brake system for leak-
age.
1
LOWER
1.Minimum level mark FRONT
8Refill with the same type of brake
fluid. Mixing fluids may result in a
harmful chemical reaction and
lead to poor braking perfor-
mance.
8Be careful that water does not
enter the brake fluid reservoir
when refilling. Water will signifi-
cantly lower the boiling point of
the fluid and may result in vapor
lock.
8Brake fluid may deteriorate paint-
ed surfaces or plastic parts.
Always clean up spilled fluid
immediately.
8As the brake pads wear, it is nor-
mal for the brake fluid level to
gradually go down. However, if
the brake fluid level goes down
suddenly, have a Yamaha dealer
check the cause.
1
LOWER UPPER
1.Minimum level markObserve these precautions:
8When checking the fluid level,
make sure that the top of the
brake fluid reservoir is level.
8Use only the recommended qual-
ity brake fluid, otherwise the rub-
ber seals may deteriorate, caus-
ing leakage and poor braking
performance.REARRecommended brake fluid:
DOT 4
5AE-9-E4 (ENG) 8/30/00 5:04 PM Page 59

6-27
PERIODIC MAINTENANCE AND MINOR REPAIR
1
2
3
4
56
7
8
9
EAU02962
Checking and lubricating the
cablesThe operation of all control cables
and the condition of the cables
should be checked before each ride,
and the cables and cable ends
should be lubricated if necessary. If a
cable is damaged or does not move
smoothly, have a Yamaha dealer
check or replace it.
Recommended lubricant:
Engine oil
EW000112
wDamage to the outer sheath may
interfere with proper cable opera-
tion and will cause the inner cable
to rust. Replace a damaged cable
as soon as possible to prevent
unsafe conditions.
2.Wipe the drive chain dry.
3.Thoroughly lubricate the drive
chain with a special O-ring chain
lubricant.
ECA00052
cCDo not use engine oil or any other
lubricants for the drive chain, as
they may contain substances that
could damage the O-rings.
5AE-9-E4 (ENG) 8/30/00 5:04 PM Page 62

6-28
PERIODIC MAINTENANCE AND MINOR REPAIR
1
2
3
4
56
7
8
9
EAU03209
Checking and lubricating the
throttle grip and cableThe operation of the throttle grip and
the condition of the throttle cable
should be checked before each ride,
and the cable should be lubricated or
replaced if necessary.NOTE:
Since the throttle grip must be
removed to access the throttle cable
end, the throttle grip and the cable
should always be lubricated at the
same time.1.Remove the throttle grip by
removing the screws.
2.Disconnect the throttle cable,
hold it up, and then apply several
drops of oil to the cable end,
allowing it to trickle into the
sheath.
3.Connect the throttle cable, and
then grease the inside of the
throttle grip housing.4.Grease the metal-to-metal con-
tact surface of the throttle grip,
and then install the grip by
installing the screws.
Recommended lubricant:
Throttle cable:
Engine oil
Throttle grip housing and grip:
Lithium-soap-based grease
(all-purpose grease)
EAU00774
Adjusting the Autolube
pumpThe Autolube pump is a vital and
sophisticated component of the
engine, which must be adjusted by a
Yamaha dealer at the intervals speci-
fied in the periodic maintenance and
lubrication chart.
5AE-9-E4 (ENG) 8/30/00 5:04 PM Page 63

6-30
PERIODIC MAINTENANCE AND MINOR REPAIR
1
2
3
4
56
7
8
9 Recommended lubricant:
Lithium-soap-based grease
(all-purpose grease)
EAU00790
Lubricating the rear
suspensionThe pivoting points of the rear sus-
pension must be lubricated at the
intervals specified in the periodic
maintenance and lubrication chart.
EAU02939
Checking the front forkThe condition and operation of the
front fork must be checked as follows
at the intervals specified in the peri-
odic maintenance and lubrication
chart.
To check the condition
EW000115
wSecurely support the motorcycle
so that there is no danger of it
falling over.Check the inner tubes for scratches,
damage and excessive oil leakage. Recommended lubricant:
Molybdenum disulfide grease
5AE-9-E4 (ENG) 8/30/00 5:04 PM Page 65