maintenance YAMAHA TT600RE 2004 Owner's Manual

WHEEL INSPECTION/
SPOKE INSPECTION AND TIGHTENING
3-44
INSP
ADJ
WHEEL INSPECTION
1. Inspect:
•Wheels
Damage/Deformation ➔Replace.
NOTE:
Always balance the wheel after the replacement
or reassembly of a tyre or rim.
WARNING
Never try to repair a rim in any way.
Bearing inspection
Check the front and rear wheel bearings periodi-
cally to make sure that they do not have free play
in the hub and that the wheel turns smoothly with-
out sticking. Wheel bearings must always be
checked in accordance with the maintenance
table.
SPOKE INSPECTION AND TIGHTENING
1. Inspect:
•Spokes (1)
Curvature/Damaged ➔Replace.
Loose spoke ➔Tighten.
2. Tighten:
•Spoke (s)
NOTE:
Tighten the spokes before and after the break-in
period.
Spoke:
3 Nm (0.3 mkg)
ProCarManuals.com

ENGINE DISASSEMBLY
5-8
ENG
Avoid using the hammer to pull the pin out.
CAUTION: Piston pin puller set:
P/N. 90890-01304
3. Remove:
•Neutral gear switch cable (1)
2. Remove:
•Intermediate starter gear (1)
•Bearing (2)
•Distributor shaft (3)
INTERMEDIATE STARTER GEAR, CRANKCASE
COVER (L) AND GENERATOR STATOR
NOTE:
With the engine installed, maintenance of the inter-
mediate starter gear and the crankcase cover (L)
may be performed by removing the following parts.
•Exhaust pipe
•Starter
•Sprocket cover
1. Remove:
•Cover (1) intermediate starter gear
•Centring pins
•Gasket
ProCarManuals.com