belt YAMAHA VERSITY 300 2004 Owners Manual
[x] Cancel search | Manufacturer: YAMAHA, Model Year: 2004, Model line: VERSITY 300, Model: YAMAHA VERSITY 300 2004Pages: 104, PDF Size: 2.82 MB
Page 10 of 104
GIVE SAFETY THE RIGHT OF WAY
1Scooters are fascinating vehicles, which can give you an unsurpassed feeling of power and freedom. However,
they also impose certain limits, which you must accept; even the best scooter does not ignore the laws of
physics.
Regular care and maintenance are essential for preserving value and operating condition of your scooter.
Moreover, what is true for the scooter is also true for the rider: good performance depends on being in good
shape. Riding under the influence of medication, drugs and alcohol is, of course, out of the question. Scooter
riders — more than car drivers — must always be at their mental and physical best. Under the influence of
even small amounts of alcohol, there is a tendency to take dangerous risks.
Protective clothing is as essential for the scooter rider as seat belts are for car drivers and passengers.
Always wear a complete scooter suit (whether made of leather or tear-resistant synthetic materials with
protectors), sturdy boots, scooter gloves and a properly fitting helmet. Optimum protective wear, however,
should not encourage carelessness. Although full-coverage helmets and suits, in particular, create an illu-
sion of total safety and protection, motorcyclists will always be vulnerable. Riders who lack critical self-
control run the risk of going too fast and are apt to take chances. This is even more dangerous in wet
weather. The good motorcyclist rides safely, predictably and defensively — avoiding all dangers, including
those caused by others.
Enjoy your ride!
1-1
Page 14 of 104
2
DESCRIPTION
Left view
1
2 3 4 5 6
1. Rear storage compartment (Page 3-13)
2. Shock absorber spring preload
adjusting ring (Page 3-14)
3. Air filter element (Page 6-18)4. V-belt case air filter element (page 6-18)
5. Sidestand (page 3-16, 6-27)
6. Coolant level check window (page 6-17)
2-1
Page 47 of 104
EAU00462
PERIODIC MAINTENANCE AND MINOR REPAIR
Owner’s tool kit ........................................................ 6-1
Periodic maintenance and lubrication chart ............ 6-2
Removing and installing cowlings and panels ........ 6-5
Checking the spark plug ....................................... 6-11
Engine oil .............................................................. 6-13
Final transmission oil ............................................ 6-16
Coolant .................................................................. 6-17
Air filter and the V-belt case air filter elements ...... 6-18
Adjusting the carburetor ........................................ 6-20
Adjusting the throttle cable free play ..................... 6-20
Adjusting the valve clearance ............................... 6-21
Tires ...................................................................... 6-21
Cast wheels .......................................................... 6-23
Adjusting the front and rear brake lever
free play ................................................................ 6-23
Checking the front and rear brake pads ................ 6-24
Checking the brake fluid level ............................... 6-24
Changing the brake fluid ....................................... 6-25Checking and lubricating the cables ..................... 6-26
Checking and lubricating the throttle grip
and cables ............................................................. 6-26
Lubricating the front and rear brake levers ........... 6-26
Checking and lubricating the centerstand
and sidestand ........................................................ 6-27
Checking the front fork .......................................... 6-27
Checking the steering ........................................... 6-28
Checking the wheel bearings ................................ 6-29
Battery ................................................................... 6-29
Replacing the fuses .............................................. 6-30
Replacing a headlight bulb .................................... 6-32
Replacing a front turn signal light bulb .................. 6-34
Replacing tail/brake light bulb
or rear turn signal light bulb .................................. 6-34
Replacing the license plate light bulb .................... 6-35
Troubleshooting ..................................................... 6-35
Troubleshooting charts .......................................... 6-36
6
Page 49 of 104
PERIODIC MAINTENANCE AND MINOR REPAIR
6
EAU03685
Periodic maintenance and lubrication chart
NOTE :
•The annual checks must be performed every year, except if a kilometer-based maintenance is performed instead.
•From 50,000 km, repeat the maintenance intervals starting from 10,000 km.
•Items marked with an asterisk should be performed by a Yamaha dealer as they require special tools, data and technical
skills.
1 * Fuel line•Check fuel hoses and vacuum hose for cracks or damage.√√√√ √
•Check condition.
√√
2 Spark plug•Clean and regap.
•Replace.√√
3 * Valves•Check valve clearance.
√√
•Adjust.
4 Air filter element•Clean.√√•Replace.√√
5 V-belt case air filter element•Clean.√√√√
•Check operation, fluid level and vehicle for fluid leakage.
√√√√√ √
6 * Front brake(See NOTE on page 6-4.)
•Replace brake pads. Whenever worn to the limit
ODOMETER READING (x 1,000 km)
NO. ITEMCHECK OR MAINTENANCE JOB
1
ANNUAL
CHECK
10 20 30 40
6-2
Page 51 of 104
PERIODIC MAINTENANCE AND MINOR REPAIR
6
•Change. (See page 3-7 for more information about the√When the oil change indicator comes on19 Engine oil oil change indicator)( Every 3000 km)
•Check oil level and vehicule for oil leakage. Every 3,000 km√
20 * Engine oil strainer•Clean.√
21 * Cooling system•Check coolant level and vehicule for coolant leakage.√√√√ √•Change. Every 3 years
22Final transmission oil•Check vehicle for oil leakage.√√ √•Change.√√√
23 * V-belt•Replace. Every 20,000 km
24 *Front and rear brake
•Check operation.√√√√√ √
switches
25 Moving parts and cables•Lubricate.√√√√ √
Throttle grip housing•Check operation and free play.
26 *
and cable•Adjust the throttle cable free play if necessary.√√√√ √
•Lubricate the throttle grip housing and cable.
27 *Lights, signals•Check operation.
√√√√√ √
and switches•Adjust headlight beam.
ODOMETER READING (x 1,000 km)
NO. ITEMCHECK OR MAINTENANCE JOB
1
ANNUAL
CHECK
10 20 30 40
EAU03884*
NOTE :
•The air filter needs more frequent service if you are riding in unusually wet or dusty areas.
•Hydraulic brake service
•Regularly check and, if necessary, correct the brake fluid level.
•Every two years change the brake fluid.
•Replace the brake hoses every four years and if cracked or damaged.
6-4
Page 65 of 104
PERIODIC MAINTENANCE AND MINOR REPAIR
6
EC000080
•If coolant is not available, use
distilled water or soft tap water
instead. Do not use hard water or
salt water since it is harmful to
the engine.
•If water has been used instead of
coolant, replace it with coolant as
soon as possible, otherwise the
engine may not be sufficiently
cooled and the cooling system
will not be protected against frost
and corrosion.
•If water has been added to the
coolant, have a Yamaha dealer
check the antifreeze content of
the coolant as soon as possible,
otherwise the effectiveness of the
coolant will be reduced.
NOTE :
The radiator fan is automatically
switched on or off according to the
coolant temperature in the radiator. If
the engine overheats, see page 6-37
for further instructions.
CAUTION:EAU03627*
Air filter and V-belt case air
filter elements
The air filter and V-belt case air filter
elements should be cleaned at the
intervals specified in the periodic main-
tenance and lubrication chart. Clean
both filter elements more frequently if
you are riding in unusually wet or dusty
areas.
EC000092*
•Make sure that each filter
element is properly seated in its
case.
•The engine should never be
operated without the filter
elements installed, otherwise
the piston and/or cylinder may
become excessively worn.Cleaning the air filter element
1. Place the scooter on the
centerstand.
2. Remove the air filter case cover
by removing the screws.
CAUTION:
1. Air filter case cover
2. Screw (x5)
3. Sponge material
4. Mesh sheet
6-18
1
2 2
34ZAUM0446
Page 66 of 104
PERIODIC MAINTENANCE AND MINOR REPAIR
63. Pull the sponge material out along
with the mesh sheet, clean it with
solvent, and then squeeze the
remaining solvent out.
4. Check the sponge material for
damage and replace it if
necessary.
5. Allow the sponge material to dry.
6. Apply oil of the recommended
type to the entire surface of the
sponge material, and then
squeeze the excess oil out.
NOTE :
The sponge material should be wet but
not dripping.
Recommended oil:
Engine oil
7. Insert the sponge material into the
air filter case.
8. Install the air filter case cover by
installing the screws.
Cleaning the V-belt case air filter
element
1. Remove the V-belt case air filter
cover by removing the screws.
1. V-belt case air filter cover
2. Screw (x3)
6-19
ZAUM0447
21
ZAUM0448
Page 67 of 104
PERIODIC MAINTENANCE AND MINOR REPAIR
6 2. Blow the dirt out of the air filter
element with compressed air as
shown.
3. Check the V-belt case air filter
element for damage and replace
it if necessary.
4. Install the V-belt case air filter
element cover by installing the
screws.
1. V-belt case air filter cover
2. V-belt case air filter element
EAU00631
Adjusting the carburetor
The carburetor is an important part of
the engine and requires very
sophisticated adjustment. Therefore, all
carburetor adjustments should be left
to a Yamaha dealer, who has the
necessary professional knowledge and
experience.
EAU00635
Adjusting the throttle cable
free play
The throttle cable free play should
measure 1.5 – 3 mm at the throttle grip.
Periodically check the throttle cable free
play and, if necessary, have a Yamaha
dealer adjust it.
a. Throttle cable free play
6-20
21
ZAUM0449
a
ZAUM0051
Page 93 of 104
SPECIFICATIONS
8
Transmission oil:
Type Engine oil SAE 10W30
(API SE)
Total amount 0.25L
Coolant system capacity:
(including all routes)1.6L
Air filter:Wet type element.
Fuel:
Recommended fuel REGULAR UNLEADED
GASOLINE ONLY
Fuel tank capacity 10.9L
Carburetor:
Type / quantity TK5SE x 1
Manufacturer TK
Spark plug:
Type / Manufacturer DR8EA / NGK
Spark plug gap 0.6—0.7 mm
Clutch type:Dry, centrifugal automatic
Transmission:
Primary reduction system Helical gear
Primary reduction ratio 40/15 (2.666)
Secondary reduction system Helical gear
Secondary reduction ratio 37/12 (3.083)
Transmission type V-belt automatic
Operation Centrifugal automatic typeChassis:
Frame type Steel tube underbone
Caster angle ((degree)) 26°
Trail 90 mm
Tires:
Front:
Type Tubeless
Size 120/80-14 58P
Manufacturer / Model MICHELIN / PILOT CITY TL
Rear:
Type Tubeless
Size 150/70-14 66P
Manufacturer / Model MICHELIN / PILOT CITY TL
Maximum load * 202 Kg
Air pressure (cold tire):
Up to 90 kg load*
Front 180 kpa (1.8 kgf/cm
2, 1.8 Bar)
Rear 190 kpa (1.9 kgf/cm2, 1.9 Bar)
90 kg load — 160 kg load *
Front 180 kpa (1.8 kgf/cm
2, 1.8 Bar)
Rear 200 kpa (2.0 kgf/cm2, 2.0 Bar)
160 kg load — maximum
load *
Front 190 kpa (1.9 kgf/cm
2, 1.9 Bar)
Rear 220 kpa (2.2 kgf/cm2, 2.2 Bar)
* Total weight of rider, passenger, cargo and accessories.
8-2
Page 100 of 104
INDEX
A
Acceleration and deceleration ............. 5-3
Air filter and V-belt case air filter
elements, cleaning ....................... 6-18
Anti-theft alarm (optional) ................... 3-7
Auxiliary DC jack ............................... 3-18
Anti-theft device housing ................... 3-14
B
Battery .............................................. 6-29
Battery voltage / coolant
temperature gauge ......................... 3-3
Brake fuid level, checking ................. 6-24
Brake fluid, changing ........................ 6-25
Bake lever, front .................................. 3-9
Brake lever, rear .................................. 3-9
Brake levers, lubricating .................... 6-26
Brake pads, checking ........................ 6-24Braking ................................................ 5-3
C
Cables, checking and lubricating ...... 6-26
Carburator, adjusting ......................... 6-20
Care .................................................... 7-1
Catalytic converter ............................ 3-11
Centerstand and sidestand, checking
and lubricating .............................. 6-27
Conversion table ................................. 8-4
Coolant .............................................. 6-17
Cowlings and panels, removing
and installing .................................. 6-5
E
Engine break-in ................................... 5-4
Engine oil .......................................... 6-13
F
Final transmission oil ........................ 6-16
Front and rear brake lever free play,
adjusting ....................................... 6-23
Front fork, checking ........................... 6-27
Fuel ................................................... 3-10
Fuel consumption, tips for reducing .... 5-4
Fuel gauge .......................................... 3-3
Fuel tank cap .................................... 3-10Fuses, replacing ................................ 6-30
H
Handlebar switches ............................. 3-8
Dimmer switch ............................... 3-8
Engine stop switch ......................... 3-8
Horn switch .................................... 3-8
Hazard switch ................................ 3-9
Pass switch .................................... 3-8
Start switch .................................... 3-8
Turn signal switch ........................... 3-8
Headlight bulb, replacing ................... 6-32
I
Identification number ........................... 9-1
Ignition circuit cut-off system ............. 3-16
Indicator lights ..................................... 3-2
High beam indicator light ............... 3-2
Low beam indicator light ................ 3-2
Turn signal indicator lights .............. 3-2
K
Key identification number .................... 9-1
L
License plate liht bulb, replacing ....... 6-35