lock YAMAHA VMAX 2001 User Guide

PERIODIC MAINTENANCE AND MINOR REPAIR
6-39
6
EAU00855
Replacing a turn signal light
bulb or the tail/brake light
bulb 1. Remove the lens by removing the
screws.
2. Remove the defective bulb by
pushing it in and turning it counter-
clockwise.3. Insert a new bulb into the socket,
push it in, and then turn it clock-
wise until it stops.4. Install the lens by installing the
screws.
EC000108
CAUTION:@ Do not overtighten the screws, oth-
erwise the lens may break. @
1. Screw (´2)
1. Tail/brake light bulb (´2)
1. Turn signal light bulb
E_3lr.book Page 39 Wednesday, November 22, 2000 4:10 PM

PERIODIC MAINTENANCE AND MINOR REPAIR
6-46
6 Engine overheating
EW000070
WARNING
@ l
Do not remove the radiator cap when the engine and radiator are hot. Scalding hot fluid and steam may be
blown out under pressure, which could cause serious injury. Be sure to wait until the engine has cooled.
l
After removing the radiator cap retaining bolt, place a thick rag, like a towel, over the radiator cap, and then
slowly rotate the cap counterclockwise to the detent to allow any residual pressure to escape. When the hiss-
ing sound has stopped, press down on the cap while turning it counterclockwise, and then remove the cap.
@NOTE:@ If coolant is not available, tap water can be temporarily used instead, provided that it is changed to the recommended coolant
as soon as possible. @
Wait until the
engine has cooled.
Check the coolant level in the
reservoir and radiator.
The coolant level
is OK.The coolant level is low.
Check the cooling system
for leakage.
Have a Yamaha dealer checkand repair the cooling system.Add coolant. (See NOTE.)
Start the engine. If the engine overheats again,
have a
Yamaha dealer check
and repair the cooling system.
There is
leakage.
There is
no leakage.
E_3lr.book Page 46 Wednesday, November 22, 2000 4:10 PM

INDEX
Speedometer unit .................................... 3-2
Starter (choke) lever ................................ 3-8
Starting a cold engine .............................. 5-1
Starting a warm engine ............................ 5-3
Start switch .............................................. 3-5
Steering, checking ................................. 6-32
Steering lock............................................ 3-9
Storage.................................................... 7-4
Suspension (rear), lubricating ................ 6-31
Suspension settings, matching
front and rear....................................... 3-15TTachometer ............................................. 3-3
Throttle cable free play, adjusting .......... 6-21
Throttle grip and cable, checking and
lubricating............................................ 6-29
Tires ...................................................... 6-21
Tool kit..................................................... 6-1
Troubleshooting..................................... 6-44
Troubleshooting charts .......................... 6-45
Turn signal indicator light ......................... 3-1
Turn signal light or tail/brake light bulb,
replacing ............................................. 6-39
Turn signal switch .................................... 3-4VValve clearance, adjusting ..................... 6-21
Vehicle identification number ................... 9-1
W Wheel bearings, checking ..................... 6-33
Wheel (front) ......................................... 6-40
Installing .......................................... 6-40
Removing ........................................ 6-40
Wheel (rear) .......................................... 6-41
Installing .......................................... 6-43
Removing ........................................ 6-41
Wheels .................................................. 6-24
E_3lr.book Page 2 Wednesday, November 22, 2000 4:10 PM