clock YAMAHA VX110 2005 User Guide

5-65
EPOWRVALVES AND VALVE SPRINGS
2. Install the new valve guide 2
by striking
the special service tool from the camshaft
side until the valve guide clip 3
contacts
the cylinder head.
NOTE:
Apply engine oil to the surface of the new
valve guide.
Valve guide remover:
Intake (ø4.0 mm):
YM-04111/90890-04111
Exhaust (ø4.5 mm):
YM-04116/90890-04116
Valve guide installer:
Intake (ø4.0 mm):
YM-04112/90890-04112
Exhaust (ø4.5 mm):
YM-04117/90890-04117
3
E
2
3. Insert the special service tool into the
valve guide 2
, and then ream the valve
guide.
NOTE:
Turn the valve guide reamer clockwise to
ream the valve guide.
Do not turn the reamer counterclockwise
when removing the reamer.
4. Measure:
Valve guide inside diameter
Valve guide reamer:
Intake (ø4.0 mm):
YM-04113/90890-04113
Exhaust (ø4.5 mm):
YM-04118/90890-04118
Valve guide inside diameter:
Intake:
4.000–4.012 mm
(0.1575–0.1580 in)
Exhaust:
4.500–4.512 mm
(0.1772–0.1776 in)
2
ProCarManuals.com

5-67
EPOWRVALVES AND VALVE SPRINGS
Valve seat reface
1. Reface the valve seat with the valve seat
cutter.
2. Cut the surface of the valve seat with a 45°
cutter by turning the cutter clockwise until
the valve seat face has become smooth.
aSlag or rough surface
CAUTION:
Do not over cut the valve seat. Be sure to
turn the cutter evenly downward at a pres-
sure of 40–50 N (4–5 kgf, 8.8–11 lbf) to pre-
vent chatter marks.
Valve seat cutter holder:
Intake (ø4.0 mm):
90890-06811
Exhaust (ø4.5 mm):
90890-06812
Valve seat cutter:
30° (intake):
90890-06815
45° (intake):
90890-06814
60° (intake):
90890-06813
30° (exhaust):
90890-06328
45° (exhaust):
90890-06312
60° (exhaust):
90890-06315
Neway valve seat cutter kit:
YM-91044
3. Use a 30° cutter to adjust the contact width
of the top edge of the valve seat.
bPrevious contact width
30˚
b
ProCarManuals.com