engine oil YAMAHA VX110 2005 Workshop Manual

5-95
EPOWRCRANKSHAFT
CAUTION:
Do not interchange the crankshaft journal
bearings. To obtain the correct crankshaft
journal oil clearance and prevent engine
damage, the crankshaft journal bearings
must be installed in their original positions.
Measurement steps:
Clean the crankshaft journal bearings,
crankshaft journals, and bearing portions
of the crankcase.
Place the upper crankcase upside down
on a bench.
Install the crankshaft journal upper bear-
ings 1
and the crankshaft into the upper
crankcase.
NOTE:
Align the projections a
of the crankshaft
journal upper bearings with the notches b
in the upper crankcase.
Put a piece of Plastigauge 2
on each
crankshaft journal.
NOTE:
Do not put the Plastigauge over the oil hole
in the crankshaft journal.
Install the crankshaft journal lower bear-
ings into the lower crankcase and assem-
ble the crankcase halves.
NOTE:
Align the projections a
of the crankshaft
journal lower bearings with the notches b
in the lower crankcase.
Do not move the crankshaft until the
clearance measurement has been com-
pleted.
1
a
b
2
ProCarManuals.com

5-97
EPOWRCRANKSHAFT
Crankshaft installation
1. Install:
Crankshaft journal upper bearings
(into the upper crankcase)
Crankshaft journal lower bearings
(into the lower crankcase)
NOTE:
Align the projections a
on the crankshaft
journal upper bearings with the notches b
in
the upper crankcase.
Be sure to install each crankshaft journal
bearing in its original place.
a
b
2. Lubricate:
Crankshaft journals
Crankshaft journal bearings
(with the recommended lubricant)
Recommended lubricant:
Engine oil
ProCarManuals.com

E
–+ELEC
1
2
3
4
5
6
7
8
9
CHAPTER 7
ELECTRICAL SYSTEM
ELECTRICAL COMPONENTS........................................................................ 7-1
FUSE BOX ....................................................................................................... 7-2
EXPLODED DIAGRAM ............................................................................. 7-2
REMOVAL AND INSTALLATION CHART ................................................ 7-2
ECM AND RECTIFIER/REGULATOR............................................................. 7-7
EXPLODED DIAGRAM ............................................................................. 7-7
REMOVAL AND INSTALLATION CHART ................................................ 7-7
ELECTRICAL ANALYSIS ............................................................................... 7-9
INSPECTION............................................................................................. 7-9
Digital tester ........................................................................................ 7-9
Low resistance measurement ........................................................... 7-10
Peak voltage measurement .............................................................. 7-10
Peak voltage adapter ........................................................................ 7-11
Test harness .................................................................................... 7-11
IGNITION SYSTEM ....................................................................................... 7-12
WIRING DIAGRAM ................................................................................. 7-12
IGNITION SPARK ................................................................................... 7-14
IGNITION SYSTEM PEAK VOLTAGE .................................................... 7-15
BATTERY ................................................................................................ 7-17
FUSE ....................................................................................................... 7-17
SPARK PLUGS ....................................................................................... 7-17
IGNITION COIL ....................................................................................... 7-18
ENGINE STOP SWITCH ......................................................................... 7-18
ENGINE TEMPERATURE SENSOR ...................................................... 7-19
SENSOR ASSEMBLY ............................................................................. 7-19
THERMOSWITCH (ENGINE).................................................................. 7-20
THERMOSWITCH (EXHAUST) .............................................................. 7-21
MAIN AND FUEL PUMP RELAY............................................................. 7-22
ELECTRONIC CONTROL THROTTLE VALVE RELAY ......................... 7-23
THROTTLE POSITION SENSOR ........................................................... 7-24
ACCELERATOR POSITION SENSOR ................................................... 7-26
CAM POSITION SENSOR ...................................................................... 7-29
SLANT DETECTION SWITCH ................................................................ 7-30
ProCarManuals.com

E
–+ELEC
FUEL CONTROL SYSTEM ........................................................................... 7-31
WIRING DIAGRAM ................................................................................. 7-31
ELECTRIC FUEL PUMP ......................................................................... 7-33
FUEL SENDER ....................................................................................... 7-33
FUEL INJECTOR .................................................................................... 7-34
MAIN AND FUEL PUMP RELAY............................................................. 7-34
OIL PRESSURE SWITCH ....................................................................... 7-34
THERMOSWITCH (ENGINE).................................................................. 7-34
THERMOSWITCH (EXHAUST) .............................................................. 7-34
SLANT DETECTION SWITCH ................................................................ 7-34
REMOTE CONTROL UNIT (DELUXE MODEL ONLY) ........................... 7-34
THROTTLE POSITION SENSOR ........................................................... 7-34
ACCELERATOR POSITION SENSOR ................................................... 7-34
STARTING SYSTEM ..................................................................................... 7-35
WIRING DIAGRAM ................................................................................. 7-35
BATTERY ................................................................................................ 7-37
WIRING CONNECTIONS........................................................................ 7-37
FUSES..................................................................................................... 7-37
START SWITCH...................................................................................... 7-37
STARTER RELAY ................................................................................... 7-38
REMOTE CONTROL UNIT (DELUXE MODEL ONLY) ........................... 7-38
THROTTLE POSITION SENSOR ........................................................... 7-38
ACCELERATOR POSITION SENSOR ................................................... 7-38
STARTER MOTOR ........................................................................................ 7-39
EXPLODED DIAGRAM ........................................................................... 7-39
REMOVAL AND INSTALLATION CHART ............................................. 7-39
SERVICE POINTS .................................................................................. 7-41
Armature inspection .......................................................................... 7-41
Brush holder inspection..................................................................... 7-42
Starter motor front cover inspection .................................................. 7-42
CHARGING SYSTEM .................................................................................... 7-43
WIRING DIAGRAM ................................................................................. 7-43
FUSE ....................................................................................................... 7-44
BATTERY ................................................................................................ 7-44
LIGHTING COIL ...................................................................................... 7-44
RECTIFIER/REGULATOR ...................................................................... 7-44
OFF THROTTLE STEERING SYSTEM......................................................... 7-45
WIRING DIAGRAM ................................................................................. 7-45
STEERING SENSOR .............................................................................. 7-47
ECM......................................................................................................... 7-47
PICKUP COIL .......................................................................................... 7-47
THROTTLE POSITION SENSOR ........................................................... 7-47
ACCELERATOR POSITION SENSOR ................................................... 7-47
ProCarManuals.com

E
–+ELEC
INDICATION SYSTEM .................................................................................. 7-48
WIRING DIAGRAM ................................................................................. 7-48
FUSE ....................................................................................................... 7-50
BATTERY ................................................................................................ 7-50
MAIN AND FUEL PUMP RELAY............................................................. 7-50
ECM......................................................................................................... 7-50
ENGINE TEMPERATURE SENSOR ...................................................... 7-50
THERMOSWITCH (ENGINE).................................................................. 7-50
THERMOSWITCH (EXHAUST) .............................................................. 7-50
REMOTE CONTROL UNIT (DELUXE MODEL ONLY) ........................... 7-50
BUZZER .................................................................................................. 7-50
OIL PRESSURE SWITCH ....................................................................... 7-51
MULTIFUNCTION METER...................................................................... 7-51
Multifunction meter ............................................................................ 7-51
MULTIFUNCTION METER REMOVAL ................................................... 7-51
Display function (Sport model only) .................................................. 7-52
Display function (Deluxe model only) ................................................ 7-53
Speedometer display ........................................................................ 7-54
Tachometer display ........................................................................... 7-55
Hour meter display ............................................................................ 7-55
Voltage meter display........................................................................ 7-55
Low oil pressure warning indicator .................................................... 7-55
Fuel level meter display and fuel warning indicator .......................... 7-55
Overheat warning indicator ............................................................... 7-56
Check engine warning indicator ........................................................ 7-56
Diagnostic display ............................................................................. 7-57
REMOTE CONTROL SYSTEM (DELUXE MODEL ONLY) .......................... 7-58
WIRING DIAGRAM ................................................................................. 7-58
REMOTE CONTROL SYSTEM ............................................................... 7-59
Yamaha Security System indicator ................................................... 7-59
Low-rpm mode indicator.................................................................... 7-59
Checking the remote control transmitter ........................................... 7-60
Transmitter registration ..................................................................... 7-62
Replacing of the transmitter battery .................................................. 7-63
ProCarManuals.com

7-1
E
–+ELECELECTRICAL COMPONENTS
ELECTRICAL COMPONENTS
O
N
M
L
K
J
I
H
G
F
E
D
C
B
A
0
91
2
3
4
5
6
7
8
1Thermoswitch (engine)
2Fuse box
3Slant detection switch
4Starter motor
5Engine temperature sensor
6Spark plugs and ignition coils
7Cam position sensor
8Battery
9Speed sensor
0Sensor assembly (intake air
pressure and intake air tem-
perature)AOil pressure switch
BFuel injectors
CThermoswitch (exhaust)
DRectifier/regulator
EECM
FThrottle body assembly
GLighting coil and pickup coil
HEngine stop switch, engine
shut-off switch, and start
switch
ISteering sensor
JBuzzerKAccelerator position sensor
LElectric fuel pump
MFuel sender
NMultifunction meter
ORemote control unit (Deluxe
model only)
ProCarManuals.com

7-11
E
–+ELECELECTRICAL ANALYSIS
Peak voltage adapter
NOTE:
Throughout this chapter the part numbers of
the specified peak voltage adapters have
been omitted. Refer to the following part
numbers.
The peak voltage adapter should be used
with a digital tester.
When measuring the peak voltage, connect
the peak voltage adapter to the digital circuit
tester and switch the selector to the DC volt-
age mode.
NOTE:
Make sure that the adapter leads are prop-
erly installed in the digital circuit tester.
Make sure that the positive pin (the “+” mark
facing up as shown) on the adapter is
installed into the positive terminal of the
tester.
The test harness is needed for the following
tests.
È Voltage measurement
É Peak voltage measurement
Test harness
NOTE:
If the lighting coil and pickup coil(s) are mea-
sured unloaded, disconnect the test harness
on the output side coupler.
Peak voltage adapter:
YU-39991
Peak voltage adapter B:
90890-03172
Checking steps:
Disconnect the coupler connections.
Connect the test harness between the
couplers.
Connect the tester terminals to the termi-
nals which are being checked.
Run the engine and observe the mea-
surement.È
É
ProCarManuals.com

7-12
E
–+ELECIGNITION SYSTEM
IGNITION SYSTEM
WIRING DIAGRAM
10A
10A
3A
30A20A
WBrBRFREE
PUSHBWFREE
PUSH
Br BrFREE
PUSH
BW
W
BrBrBrBrR
W
B/W
B/O
B/O
B/O
B/R
P/R
P/R
W/B
P/W
P/W
B/O
L/B
B/WB/R
B/OP/W
P/R
W
W
WLR
Y
G
O
O
W
GG
BW
GG
O
OLG
W
Y
W
G/O
W/BR/Y
Y/G
BL
PBWP/W
B/GB/Y
Y/WL/RB/RB/W
B
B
BBP
P
P
BBP
RR
BBR
R/Y
B/OL/BB/OL/B
B/G
G/OB/OG/O
P/W
B/OB/YB/YR/Y
R/Y
R/Y
R/YB/YR/Y
R/Y
B/O
B/RR/Y
R/Y
R/YY/W
Y/GL/R
Y
P
P
O
O R
R
R
BB
BrRB/O
BBr
B/W
Y BrL R B
R
GB
R/YBBr
4
0 98
B
B B
B
H
I JK LM NOQ
PR
3
5
67 2 1
A
A A
A
C
D
E
F
G
1Battery
2Fuse (30 A)
3Fuse (20 A)
4Fuse (3 A)
5Fuse (10 A)
6Fuse (10 A)
7Starter relay
8Main and fuel pump
relay9Electronic control
throttle valve relay
0Slant detection switch
AIgnition coil
BSpark plug
CCam position sensor
DEngine temperature
sensor
EThermoswitch
(engine)FThermoswitch
(exhaust)
GOil pressure switch
HRemote control unit
(Deluxe model only)
IAntenna
(Deluxe model only)
JECM
KRectifier/regulatorLThrottle body assem-
bly
MAccelerator position
sensor
NPickup coil
OLighting coil
PStart switch
QEngine stop switch
REngine shut-off switch
ProCarManuals.com

7-14
E
–+ELECIGNITION SYSTEM
IGNITION SPARK
WARNING
When checking the spark gap, do not
touch any of the connections of the spark
checker/ignition tester lead wires.
When performing the spark gap test, take
special care not to let sparks leak out of
the removed spark plug cap.
When performing the spark gap check,
keep flammable gas or liquids away,
since this test can produce sparks.
1. Check:
Ignition spark
Weak →
Check the ECM output peak
voltage.
Check the ignition coil for resistance.
Checking steps:
Connect the spark plug cap to the special
service tool.
Spark checker:
YM-34487
Ignition tester:
90890-06754
Crank the engine and observe the igni-
tion system spark through the discharge
window.
OK
ProCarManuals.com

7-15
E
–+ELECIGNITION SYSTEM
IGNITION SYSTEM PEAK VOLTAGE
WARNING
When checking the electrical components,
do not touch any of the connections of the
digital tester lead wires.
NOTE:
If there is no spark, or the spark is weak,
continue with the ignition system test.
If a good spark is obtained, the problem is
not with the ignition system, but possibly with
the spark plug(s) or another component.
1. Measure:
ECM output peak voltage
Below specification →
Measure the
pickup coil output peak voltage.
NOTE:
When measuring the ECM output peak volt-
age while cranking the engine, disconnect
the ignition coil couplers for all cylinders
except for the cylinder being measured.
To crank the engine, connect the engine
shut-off cord (lanyard) to the engine shut-off
switch, and then press the start switch.
Test harness (2 pins):
New: YB-06867
Current: YB-06767
Test harness FWY-2 (2 pins):
New: 90890-06867
Current: 90890-06767
ECM output peak voltage:
Black/red (B/R) –
Red/yellow (R/Y)
Black/white (B/W) –
Red/yellow (R/Y)
Black/yellow (B/Y) –
Red/yellow (R/Y)
Black/green (B/G) –
Red/yellow (R/Y)
r/minLoaded
Cranking 2,000 3,500
V 90 130 140
ProCarManuals.com