lock YAMAHA XV535 2001 User Guide

PERIODIC MAINTENANCE AND MINOR REPAIR
6-33
6
EAU00855
Replacing a turn signal light
bulb or the tail/brake light
bulb1. Remove the lens by removing the
screws.2. Remove the defective bulb by
pushing it in and turning it counter-
clockwise.
3. Insert a new bulb into the socket,
push it in, and then turn it clock-
wise until it stops.
4. Install the lens by installing the
screws.
EC000108
CAUTION:@ Do not overtighten the screws, oth-
erwise the lens may break. @
EAU01579
Supporting the motorcycle Since this model is not equipped with a
centerstand, follow these precautions
when removing the front and rear
wheel or performing other mainte-
nance requiring the motorcycle to
stand upright. Check that the motor-
cycle is in a stable and level position
before starting any maintenance. A
strong wooden box can be placed un-
der the engine for added stability.
To service the front wheel
1. Stabilize the rear of the motorcycle
by using a motorcycle stand or, if
an additional motorcycle stand is
not available, by placing a jack un-
der the frame in front of the rear
wheel.
2. Raise the front wheel off the
ground by using a motorcycle
stand.
1. Screw (´ 2)
1. Tail/brake light bulb (´ 2)
E_3bt.book Page 33 Thursday, September 7, 2000 10:01 AM

INDEX
Spark plugs, checking ............................. 6-5
Specifications .......................................... 8-1
Speedometer unit .................................... 3-2
Starter (choke) lever ................................ 3-6
Starting a cold engine .............................. 5-1
Starting a warm engine ............................ 5-2
Start switch .............................................. 3-3
Steering, checking ................................. 6-27
Steering lock............................................ 3-7
Storage.................................................... 7-4
Supporting the motorcycle ..................... 6-33
Suspension (rear), lubricating ................ 6-26TThrottle cable free play, adjusting .......... 6-14
Throttle grip and cable, checking and
lubricating............................................ 6-24
Tires ...................................................... 6-15
Tool kit..................................................... 6-1
Troubleshooting..................................... 6-37
Troubleshooting chart ............................ 6-38
Turn signal indicator light ......................... 3-1
Turn signal or tail/brake light bulb,
replacing ............................................. 6-33
Turn signal switch .................................... 3-2VValve clearance, adjusting ..................... 6-14
Vehicle identification number ................... 9-1
WWheel bearings, checking ..................... 6-28
Wheel (front) ......................................... 6-34
Installing .......................................... 6-35
Removing ........................................ 6-34
Wheel (rear) .......................................... 6-35
Installing .......................................... 6-37
Removing ........................................ 6-35
Wheels .................................................. 6-17
E_3bt.book Page 2 Thursday, September 7, 2000 10:01 AM