2-1
2
EAU00026
2-DESCRIPTIONLeft view1. Shift pedal (page 3-6)
2. Fuel cock (page 3-8)
3. Rear shock absorber spring preload adjusting ring (page 3-14)
4. Helmet holder (page 3-11)
5. Storage compartment (page 3-11)
6. Tool kit (page 6-1)
7. Fuses (page 6-25)
E_5el_Description.fm Page 1 Monday, May 1, 2000 9:37 AM
PERIODIC MAINTENANCE AND MINOR REPAIR
6-25
6
EAU01711
Fuse replacementSub fuse box
The sub fuse box is located behind the
storage compartment cover. (See page
3-11 for removal and installation proce-
dures.)Main fuse
The main fuse is located under the rid-
er seat.
1. Remove the rider seat. (See page
3-10 for removal and installation
procedures.)2. Remove each quick fastener by
pushing the center in with a screw-
driver, then pulling the fastener
out.1. Odometer fuse
2. Ignition fuse
3. Headlight fuse
4. Carburetor heater fuse
5. Spare fuse (´ 2)
6. Signaling system fuse
Specified fuses:
Odometer fuse: 5 A
Ignition fuse: 10 A
Headlight fuse: 15 A
Carburetor heater fuse: 15 A
Signaling system fuse: 10 A
1. Quick fastener (´ 3)
E_5el_Periodic.fm Page 25 Monday, May 1, 2000 9:44 AM
PERIODIC MAINTENANCE AND MINOR REPAIR
6-26
6 3. Pull the ignitor unit panel outward
to the right.
If any fuse is blown, turn off the main
switch and the switch of the circuit in
question. Install a new fuse of specified
amperage. Turn on the switches and
see if the electrical device operates. If
the fuse immediately blows again, con-
sult a Yamaha dealer.
EC000103
CAUTION:@ Do not use fuses of higher amper-
age rating than those recommend-
ed. Substitution of a fuse of
improper rating can cause extensive
electrical system damage and pos-
sibly a fire. @4. Place the ignitor unit panel in the
original position and install the
quick fasteners.
NOTE:@ When installing a quick fastener, push
its pin back so that it will protrude from
the fastener head, then insert the fas-
tener and push the protruding pin in un-
til it is flush with the fastener head. @5. Install the rider seat.
1. Ignitor unit panel
2. Spare fuse
3. Main fuse
Specified main fuse: 30 A
After removal Before installation
E_5el_Periodic.fm Page 26 Monday, May 1, 2000 9:44 AM
SPECIFICATIONS
8-4
8
Headlight typeQuar tz bulb (halogen)
Bulb voltage, wattage ´ quantity
Headlight 12 V, 60/55 W ´ 1
Auxiliary light 12 V, 4 W ´ 1
Tail/brake light 12 V, 5/21 W ´ 1
Turn signal light 12 V, 21 W ´ 4
Meter light 14 V, 1.4 W ´ 2
Oil level indicator light 12 V, 1.7 W ´ 1
Neutral indicator light 12 V, 1.7 W ´ 1
Turn indicator light 12 V, 1.7 W ´ 1
Engine trouble indicator light 12 V, 1.7 W ´ 1
High beam indicator light 12 V, 1.7 W ´ 1
Fuses
Main fuse 30 A
Signaling system fuse 10 A
Odometer fuse 5 A
Ignition fuse 10 A
Headlight fuse 15 A
Carburetor heater fuse 15 A
E_5el_Spec.fm Page 4 Monday, May 1, 2000 9:47 AM
