check engine YAMAHA YD110 2007 Owner's Guide

14. Location of Storage and Tool Kit compartments and their use.
15. Procedure of opening and closing of L. H. Side Panel.
16. Battery Maintenance : Checking of electrolyte level (To add only distilled water if required &
to maintain its Specified Level)
17. Correct Drive Chain Slackness (20 ~30 mm).
18. Correct type of Spark Plug and Spark Plug gap.
19. Engine Oil (in Gear Box), level checking and explaining the importance of replacing the Engine
Oil after every 2000 KMS Always use YAMALUBE 4T OIL SG Grade.
20. TFF oil to be replaced after every 10000 Kms.
21. Running- In Period/ Preventive Maintenance Schedule Instructions
22. Information of emission and safety norms alongith Catcon & AIS.
23. Importance and schedule of Free Services
24. Warranty Terms and Conditions.
INSTALLATION
IMPORTANT CAUTION
EXPLAINED BY:SIGNATURE :NAME :
MAIN SELLING DLR'S STAMP, SIGN & CODE
CUSTOMER’S SIGNATURE:10-36
SERVICE2.pmd10/15/2006, 8:54 AM 6

3.6 KEEP OUR ENVIRONMENT CLEAN.
Please follow simple steps
DO’S ()

1Always use genuine ‘spare parts’ purchased from YMIS Authorised Dealers.

2Always use only genuine oils
• 4T - 20W/40 SG grade - YAMALUBE 4T

3 Always keep your engine well turned. Save environment and also improve Fuel Efficiency

4 • ALWAYS GET YOUR MOTORCYCLE REPAIRED AND MAINTAINED ONLY AT YMIS AUTHORISED
DEALER.
• YMIS serves you through a wide network of Authorised Dealers.

5.Check the Following at every scheduled service:-
a) Spark Plug : Check/Reset Gap/Replace as per the recommendations
in this Owner’s Manual (page no 6-7)
b) Carburetor :Cleaning/Adjustment Every 4500 kmsc) Air Filter : Clean every 2000 kms as per the environment conditions.
d) Piston/Rings/Cylinder : Check / Clean / Replace if necessary
e) Exhaust System : Check / Replace if necessary
f) Valve Timing : Check / Adjust every 4500 kms
g) Compression pressure : Check / Diagnose.
DO’S AND DON’TS FOR THE MOTORCYCLE
2
greenbook.pmd10/15/2006, 8:51 AM 4

4. PROCEDURE FOR MEASUREMENT OF “CO” EMISSION LEVEL
4.1IMPORTANT : “CO” Measurement Equipment must be duty calibrated.
4.2 Check for “NO LEAKAGE” from Exhaust System.
4.3 Starter Lever should be in OFF position.
4.4 All Electricals should be in OFF position.
4.5 Set the Idle speed of the Engine in warmed up condition of Motorcycle as specified.
4.6 Insert the Sampling probe of the Exhaust Gas Analyser inside the Exhaust Muffler of the
Motorcycle.
4.7 • If the reading is within specified limits then it is acceptable.
• If the reading exceeds the norm of 3.5% (by volume) have it adjusted by YMI Authorised
Dealer.
4.8 YMI serve you through an extensive network of
• Authorised Dealers
• Authorised Service Points.
• Trained Private Workshop (Garage) Owner’s.‘CO’ EMISSION LEVEL MEASUREMENT
4
MODELIDLE R.P.M.
1300 - 1500 RPM
CRUX
greenbook.pmd10/15/2006, 8:51 AM 6