parking brake Abarth 500 2013 Owner handbook (in English)

54
SAFETY
DEVICES
CORRECT USE
OF THE
CAR
WARNING
LIGHTS AND
MESSAGES
IN AN
EMERGENCY
CAR
MAINTENANCE
TECHNICAL
SPECIFICATIONS
INDEX
YOUR CAR
Failure indications
A failure of the system is indicated by the
turning on warning light áon the instru-
ment panel together with the dedicated
message on the reconfigurable multifunc-
tional display (for versions/markets, where
provided); see section “Warning lights and
messages”.
IMPORTANT The Hill Holder system is
not a parking brake; therefore, never leave
the car without having engaged the hand-
brake, turned the engine off and engaged
the first speed.
If the spare wheel is used,
the ESP system keeps oper-
ating. The spare wheel, being smaller
than the original wheel provides less
grip.
For correct operation of the ESP and
ASR systems, the tyres must ab-
solutely be of the same brand and
type on all wheels, in perfect condi-
tions and, above all, of type, brand
and size specified.
WARNING
MSR system
(engine braking torque control)
It is an integral part of the ASR system that
in case of sudden gear downshifting, cuts
in providing torque to the engine thus pre-
venting excessive driving wheel drive that,
specially in poor grip conditions, can lead
to loss of stability.TTC SYSTEM
(Torque Transfer Control)
It is an integral part of the ESP system.
This system improves the transfer of dri-
ve torque to the wheels, guaranteeing
safer and more sporty driving, especially
when cornering, far more able to prevent
understeer.
The system is turned on by pressing the
button in the dashboard C-Fig. 58. The
LED in the TTC button is lit up when it
is on.
It is turned off by pressing the button again
or when the vehicle is switched off (igni-
tion key in STOP position). ASR SYSTEM
(Antislip Regulation)
It’s integral to the ESP system and auto-
matically intervenes in case of slip of one
or both drive wheels, helping the driver
to control the car.
The action of the ASR is particularly help-
ful in the following circumstances:
❒slipping of the inner wheel due to the
effect of dynamic load changes or ex-
cessive acceleration;
❒too much power transmitted to the
wheels also in relation to the conditions
of the road surface;
❒acceleration on slippery, snowy or
frozen surfaces;
❒in the case of loss of grip on a wet sur-
face (acquaplaning).
fig. 58F0S058Ab
046-062 ABARTH 500 1ed GB:046-064 ABARTH 500 GB 24-05-2012 9:50 Pagina 54

59
SAFETY
DEVICES
CORRECT USE
OF THE
CAR
WARNING
LIGHTS AND
MESSAGES
IN AN
EMERGENCY
CAR
MAINTENANCE
TECHNICAL
SPECIFICATIONS
INDEX
YOUR CAR
GENERALWARNINGS
❒When parking, take the utmost care
over obstacles that may be above or
under the sensors.
❒Objects close to the car, are not de-
tected under certain circumstances and
could therefore cause damage to the
car or be damaged.The following conditions may influence the
performance of the parking sensor system:
❒Reduced sensor sensitivity and a re-
duction in the parking assistance system
performance could be due to the pres-
ence on the surface of the sensor of:
ice, snow, mud, thick paint
❒The sensor may detect a non-existent
obstacle (echo interference) due to me-
chanical interference, for example when
washing the vehicle, in rain, (strong
wind), hail.
❒The signals sent by the sensors can al-
so be altered by the presence of ultra-
sonic systems (e.g. pneumatic brake sys-
tems or pneumatic drills) near the ve-
hicle.
❒Parking assistance system performance
can also be influenced by the position
of the sensors, for example due to a
change in the ride setting (caused by
wear to the shock absorbers, suspen-
sion), or by overloading the vehicle and
carrying out specific tuning operations
that require the vehicle to be lowered.
Parking manoeuvres howev-
er are always the driver’s re-
sponsibility. While manoeuvring, al-
ways make sure that no people (es-
pecially children) or animals are in
the area concerned. The parking sen-
sors are designed to assist drivers: in
any case, you must always pay the ut-
most attention during potentially
dangerous manoeuvres, even when
carried out at low speed.
WARNING
046-062 ABARTH 500 1ed GB:046-064 ABARTH 500 GB 24-05-2012 9:51 Pagina 59

81
WARNING
LIGHTS AND
MESSAGES
IN AN
EMERGENCY
CAR
MAINTENANCE
TECHNICAL
SPECIFICATIONS
INDEX
YOUR CAR
SAFETY
DEVICES
CORRECT USE
OF THE CAR
HANDBRAKE
The handbrake lever is located between
the two front seats.
Pull the lever upwards to operate the
handbrake.
PARKING THE CAR
Proceed as follows:
❒stop the engine and engage the hand-
brake;
❒engage a gear (on a slope, engage first
gear if the car is faced uphill or rever-
se if it is faced downhill) and leave the
wheels steered.
If the car is parked on a steep slope, it is
further advisable to block the wheels with
a wedge or stone.
Do not leave the ignition key on MARto
prevent draining the battery. Always re-
move the key when you leave the car.
Never leave children unattended in the
car. Always remove the ignition key when
leaving the car and take it out with you. HOW TO WARM UP THE
ENGINE AFTER IT HAS JUST
STARTED
Proceed as follows:
❒drive off slowly, letting the engine turn
at medium speed. Do not accelerate
abruptly;
❒do not demand maximum performan-
ce for the first few kilometres. Wait un-
til the engine coolant temperature gau-
ge starts moving.
STOPPING THE ENGINE
Turn the ignition to STOPwhile the en-
gine is idling.
IMPORTANT After a taxing drive, you
should allow the engine to “catch its
breath” before turning it off by letting it
idle to allow the temperature in the engi-
ne compartment to fall.
A quick burst on the accele-
rator before turning off the
engine serves absolutely no
practical purpose, it wastes
fuel and is damaging especially to tur-
bocharged engines.The car must be braked after
a few snaps of the lever,
otherwise, contact the Abarth Dea-
lership for regulation.
WARNING
When the handbrake lever is pulled up
and the ignition key is on MAR, the in-
strument panel warning light
xwill turn
on.
Proceed as follows to release the hand-
brake:
❒slightly lift the handbrake and press re-
lease button A-fig. 1;
❒hold button Apressed and lower the
lever. Warning light xon the instru-
ment panel will go out.
Press the brake pedal when carrying out
this operation to prevent the car from
moving accidentally.
fig. 1F0S076Ab
079-086 ABARTH 500 1ed GB:079-086 ABARTH 500 GBdx 24-05-2012 9:55 Pagina 81

147
WARNING
LIGHTS AND
MESSAGES
INDEX
YOU CAR
SAFETY
DEVICES
CORRECT USE
OF THE
CAR
IN AN
EMERGENCY
CAR
MAINTENANCE
TECHNICAL
SPECIFICATIONS
SUSPENSIONS
1.4 TB BZ ABARTH
Front
Rear
BRAKES
1.4 TB BZ ABARTH
Service brakes:
– front
– rear
Parking brake
IMPORTANT Water, ice and salt sprinkled on the roads may deposit on the brake disks reducing braking efficiency the first time
the brakes are applied.
STEERING
1.4 TB BZ ABARTH
Type
Diameter of steering
between platforms mwith Mc Pherson type independent wheels; consisting of a mechanical crosspiece,
shock absorbers, helical springs and stabilizer bar.
with torquing axle and interconnected wheels; consisting of torquing axle and
two tubular arms with shock absorbers and helical springs.
rack and pinion with dual strategy electric power steering (normal/sport)
10.8 disk type (self-ventilated disc)
solid disc
controlled by hand lever, acting on rear brakes
141-159 ABARTH 500 1ed GB:141-159 ABARTH 500 GB 24-05-2012 14:36 Pagina 147