bulb ACURA CSX 2006 Service Owner's Guide

Cavity Wire Test condition Test: Desired result Possible cause if desired result is not obtained
22-205
UNDER-DASH FUSE/RELAY BOX
CONNECTOR K (8P)
PNK
WHT BLK
PNK
UNDER-DASH FUSE/RELAY BOX
CONNECTOR R (20P)
UNDER-DASH FUSE/RELAY BOX
CONNECTOR T (34P)
4. Inspect the connector and socket terminals to be sure they are all making good contact.  If the terminals are bent, loose or corroded, repair them as necessary and recheck the system.
 IftheterminalslookOK,gotostep5.
5. With the connectors still disconnected, do this input test at the following connector.  If any test indicates a problem, find and correct the cause, then recheck the system.
 If all the input tests prove OK, go to step 6.






K4 PNK With the ceiling light
switch in the middle
position
With moonroof:
with the interior light
switch in DOOR
position Attach to ground:
The ceiling light and front
individual map lights should
come on.
Blown No. 22 (7.5 A) fuse in
the under-hood fuse/relay
box
Blown bulb(s)
Faulty ceiling light
Faulty front individual map
light
Faulty interior light switch
(with moonroof)
An open in the wire
(cont’d)
08/08/21 14:27:54 61SNR030_220_0207
ProCarManuals.com
DYNOMITE -2009-


(#'

)

Î
(#'

)
´
´
’06-07 models ’08-09 models
22-29322-293
Moonroof Switch Test/Replacement
CB
A
Terminal
Position
OPEN
CLOSE TILT
CLOSE AUTO OPEN AUTO 7269104 5 B
C A
Terminal
Position
OPEN
CLOSE TILT
CLOSE AUTO OPEN AUTO 5
8 4610
23
*1: Except Type S model
*2: Type S model *
*
1
2
1. Remove the front individual map lights (see page 22-196).
2. Disconnect the moonroof switch 10P connector (A) and map light switch 3P connector (B).
3. Remove the moonroof switch (C).
4. Check for continuity between the terminals in each switch position according to the table.
5. If the continuity is not as specified, replace the illumination bulb or the switch.
6. Install the moonroof switch and light in the r everse
order of removal. 1. Remove the front individual map lights (see page
22-196).
2. Disconnect the moonroof switch 12P connector (A) and map light switch 3P connector (B).
3. Remove the moonroof switch (C).
4. Check for continuity between the terminals in each switch position according to the table.
5. If the continuity is not as specified, replace the illumination bulb or the switch.
6. Install the moonroof switch and light in the reverse order of removal.
08/08/21 14:36:06 61SNR030_220_0295
ProCarManuals.com
DYNOMITE -2009-

(#'
/)
Restraints
Restraints
Seat Belts
SRS (Supplemental Restraint System)
................................................................ ................................................................
Special Tools . 24-2
..............................................................................
.......................................
..................................................................... ........................................
......................................
.......................................
.....................................................................
Component Location Index . 24-3
Front Seat Belt Replacement . 24-4
Rear Seat Belt Replacement . 24-7
Inspection . 24-9
.............................................................................. ......................
.................................................
................................................... ......................................... .......
....................................... ..............................
.....................................................
............................................................ ..........................................................................................
.............................................................. .........................................................
........................................... ..............................
..................................
.............................................
................................................ ................................
.............................. ......
............................................... .........................................
......................
........................................
...................................... ......................
.................................................
................................................... ......................................... .......
....................................... ..............................
.....................................................
............................................................ ..........................................................................................
.............................................................. .........................................................
........................................... ..............................
..................................
.............................................
................................................ ................................
.............................. ......
............................................... .........................................
......................
Component Location Index . 24-11
Precautions and Procedures . 24-13
General Troubleshooting Information . 24-22
ODS Unit Initialization . 24-26
ODS Unit Calibration . 24-27
ODS Unit Operation Check . 24-28
Driver’s Seat Position Sensor Operation Check . 24-29
DTC Troubleshooting Index . 24-30
Symptom Troubleshooting Index . 24-34
System Description . 24-35
Circuit Diagram . 24-40
DTC Troubleshooting . 24-48
Symptom Troubleshooting . 24-181
Component Replacement/Inspection After
Deployment . 24-185
Driver’s Airbag Replacement . 24-188
Front Passenger’s Airbag Replacement . 24-189
Side Airbag Replacement . 24-191
Side Curtain Airbag Replacement . 24-192
Airbag and Tensioner Disposal . 24-196
Cable Reel Replacement . 24-200
SRS Unit Replacement . 24-203
Side Impact Sensor (First) Replacement . 24-204
Side Impact Sensor (Second) Replacement . 24-205
Rear Safing Sensor Replacement . 24-206
Front Passenger’s Weight Sensor Replacement . 24-207
ODS Unit Replacement . 24-209
Front Impact Sensor Replacement . 24-210
Driver’s Seat Position Sensor Replacement . 24-211
Passenger’s Airbag Cutoff Indicator Illumination Bulb Test/Replacement . 24-212
08/08/21 13:54:05 61SNR030_240_0001
ProCarManuals.com
DYNOMITE -2009-

Î
(#')
24-11
SRS
Component Location Index
SRS INDICATOR
SIDE AIRBAG
CUTOFF INDICATOR
CABLE REEL
DRIVER’S AIRBAG
FRONT PASSENGER’S AIRBAG
PASSENGER’S AIRBAG CUTOFF INDICATOR
SRS UNIT OPDS SENSOR/SEAT-BACK
FRONT PASSENGER’S
SIDE AIRBAG
FRONT PASSENGER’S
SEAT BELT TENSIONER RIGHT SIDE
IMPACT SENSOR
(FIRST)
ODS UNIT
FRONT PASSENGER’S WEIGHT SENSORS
DRIVER’S SEAT BELT TENSIONER
LEFT SIDE IMPACT SENSOR (FIRST)
DRIVER’S SEAT POSITION SENSOR
DRIVER’S SIDE AIRBAG
DATA LINK
CONNECTOR (DLC) MEMORY ERASE
SIGNAL (MES)
CONNECTOR (2P)
(YELLOW)
FRONT PASSENGER’S SEAT BELT
BUCKLE TENSIONER
DRIVER’S SEAT BELT BUCKLE TENSIONER
(cont’d)
Troubleshooting, page 24-181
Troubleshooting, page 24-183
Replacement, page 24-200
Replacement, page 24-188
Disposal, page 24-196
Replacement, page 24-189
Disposal, page 24-196
Troubleshooting, page 24-184
Bulb Test/Replacement, page 24-212
Replacement, page 24-203 Replacement, page 20-122
Replacement,page 24-191
Disposal, page 24-196
Replacement, page 24-4
Disposal,
page 24-196 Replacement,
page 24-204
Initialization, page 24-26
Calibration, page 24-27
Operation Check, page 24-28
Replacement, page 24-209
Replacement, page 24-207
Replacement, page 24-4
Disposal, page 24-196
Replacement, page 24-204
Operation Check, page 24-29
Replacement, page 24-211
Replacement, page 24-188
Disposal, page 24-196Replacement, page 24-6
Replacement, page 24-6
08/08/21 13:54:16 61SNR030_240_0011
ProCarManuals.com
DYNOMITE -2009-

Î
(#'
)
24-212SRS
Passenger’s Airbag Cutoff Indicator Illumination Bulb Test/Replacement
B
A
C
1. Remove the center panel: Navigation unit, with navigation system.– ’06-08 models (see page 23-256)
– ’09 model (see page 23-355)
 Audio unit, without navigation system. – ’06-08 models (see page 23-80)
– ’09 model (see page 23-155)
2. Remove the screws (A) and the passenger’s airbag cutoff indicator (B) from the center panel.
3. Check for continuity between the No. 2 and No. 3 terminals of the indicator. If there is no continuity,
replace the bulb (C).
4. Reinstall the parts in the reverse order of removal.
08/08/21 14:02:11 61SNR030_240_0212
ProCarManuals.com
DYNOMITE -2009-