lock Acura Integra 2000 Sedan Owner's Guide
[x] Cancel search | Manufacturer: ACURA, Model Year: 2000, Model line: Integra, Model: Acura Integra 2000Pages: 273, PDF Size: 4.4 MB
Page 72 of 273

Key
s an d Lock s
Key s
Your car comes with two master
keys and a valet key.
The master key fits all the locks on
your car: Ignition
Doors
Trunk
Trunk release handle
Rear seat trunk access
Glove box
The valet key works only in the
ignition and the door locks. You can
keep the trunk, trunk release handle,
rear seat trunk access and the glove
box locked when you leave your car
and the valet key at a parking facility.
You should have received a key
number plate with your keys. You
will need this key number if you ever have to get a lost key replaced. Keep
the plate stored in a safe place. If youneed to replace a key, use only an
Acura-approved key blank.
Immobilize r Syste m
The Immobilizer System protects
your car from theft. A properly- coded master or valet key must be
used in the ignition switch for the
engine to start. If an improperly- coded key (or other device) is used,
the engine's fuel system is disabled. When you turn the ignition switch to
ON (II), the Immobilizer System
indicator should come on for a few
seconds, then go out. If the indicator
starts to blink, it means the system
does not recognize the coding of the
key. Turn the ignition switch to
LOCK (0), remove the key, reinsert
it, and turn the switch to ON (II)
again.
The system may not recognize your key's coding if another immobilizerkey or other metal object is near the
ignition switch when you insert the
key. To make sure the system
recognizes the key code: Do not keep other immobilizer
keys on the same key ring. Use a plastic or leather key fob,
not metal. Keep other keys away from your
vehicle's key and the ignition
switch while trying to start the
engine.
CONTINUED
Instrument s an d Control s
MASTE
R KE Y
(GRAY )
VALE
T KE Y
(BLACK )
KE
Y
NUMBE R
PLAT E
Page 73 of 273

Key
s an d Lock s
If the system repeatedly does not
recognize the coding of your key, contact your Acura dealer.
This indicator will also blink several times when you turn the ignition
switch from ON (II) to ACCESSORY
(I) or LOCK (0).
Do not attempt to alter this system
or add other devices to it. Electrical
problems could result that may make your car undriveable.
If you have lost your key and you cannot start the engine, contact your
Acura dealer. As required by the FCC:
This device complies with Part 15 of the
FCC rules. Operation is subject to the
following two conditions: (1) This device
may not cause harmful interference, and (2) this device must accept any
interference received, including
interference that may cause undesired
operation.
Changes or modifications not expressly approved by the party responsible for
compliance could void the user's
authority to operate the equipment.
This device complies with Industry
Canada Standard RSS-210.
Operation is subject to the following two
conditions: (1) this device may not cause interference, and (2) this device must
accept any interference that may cause undesired operation of the device. Ignitio
n Switc h
The ignition switch is on the right
side of the steering column. It has
four positions: LOCK (0)
ACCESSORY (I)
ON (II)
START (III)
Instrument s an d Control s
Page 74 of 273

Key
s an d Lock s
LOC K (0 ) — You can insert or
remove the key only in this position.
To switch from ACCESSORY to LOCK, you must push the key in
slightly as you turn it. If your car has
an automatic transmission, the shift
lever must also be in Park. The anti-
theft lock will lock the steering
column when you remove the key. If the front wheels are turned, the
anti-theft lock may sometimes make
it difficult to turn the key from
LOCK to ACCESSORY. Firmly turn
the steering wheel to the left or to
the right as you turn the key. ACCESSOR
Y (I ) — In this position,
you can operate the audio system and the cigarette lighter.
O N (II ) — This is the normal key
position when driving. All features
and accessories on the car are usable. Several of the lights on the instru-
ment panel come on as a test when
you turn the ignition switch from ACCESSORY to ON. STAR
T (III ) — Use this position
only to start the engine. The switch
returns to ON (II) when you let go of
the key.
The engine will not start if the Immobilizer System does not
recognize the key's coding (see page 69).
You will hear a reminder beeper if
you leave the key in the ignition switch in the LOCK (0) or
ACCESSORY (I) position and open
the driver's door. Remove the key to
turn off the beeper.
Instrument s an d Control s
Removing the key from the
ignition switch while driving
locks the steering. This can cause you to lose control.
Remove the key from the
ignition switch only when
parked.
Page 75 of 273

Key
s an d Lock s
Powe r Doo r Lock s
Each front door has a master door
lock switch. Either switch locks and unlocks all doors. Push the switch
down to lock all doors, and up to
unlock them. Each door has a lock tab above the
inside door handle. When you push
in the lock tab on the driver's door,
all doors lock. Pulling out the lock
tab on the driver's door only unlocks
that door. To lock any passenger's door when
getting out of the car, push the lock
tab in and close the door. To lock the
driver's door, pull the outside door
handle and push the lock tab in or
push the master switch down.
Release the handle, then close the
door.
Instrument s an d Control s
Page 76 of 273

Key
s an d Lock s
All doors can be locked from the outside by using the key in either
front door. To unlock only the driver's door from the outside, insert the key
in the driver's door lock, turn the key and release it. If you turn the key
and hold it, all doors will unlock. All
four doors will unlock when you
unlock the passenger's door with the
key. Childproo
f Doo r Lock s
The childproof door locks are designed to prevent children seated
in the rear from accidentally opening
the rear doors. Each rear door has a
lock lever near the edge. With the lever in the LOCK position, the door
cannot be opened from the inside
regardless of the position of the lock
tab. To open the door, pull the lock
tab up and use the outside door
handle.
Trun
k
You can open the trunk in two ways: Pull the trunk release handle to
the left of the driver's seat.
Use the master key to open the
trunk lock. The valet key does not
work in this lock.
CONTINUED
Instrument s an d Control s
LEVE
R
TRUN
K RELEAS E
HANDL E
Page 77 of 273

Key
s an d Lock s
To close the trunk, press down on the trunk lid.
See page 128 for cargo loading and
weight limit information. Keep the
trunk lid closed at all times while
driving to avoid damaging the lid,
and to prevent exhaust gas from
getting into the interior. See Carbo n
Monoxid e Hazar d on page 49 . To protect items in the trunk when
you need to give the key to someone
else, lock the trunk release handle
with the master key and give the other person the valet key.
Instrument s an d Control s
MASTE
R KE Y
MASTER
KE Y
Page 78 of 273

Key
s an d Locks , Sea t Adjustment s
Glov e Bo x
Open the glove bohx by pulling the
bottom of the handle. Close it with a
firm push. Lock or unlock the glove
box with the master key. The glove box light comes on only
when the instrument panel lights are
on.
Sea
t Adjustment s
See pages 12 — 13 for important safety
information and warnings about how to properly position seats and seat-backs.
Adjust the seat before you start
driving.
To adjust the seat forward and
backward, pull up on the lever under the seat cushion's front edge. Move
the seat to the desired position and
release the lever. Try to move the seat to make sure it is locked in
position.
Instrument s an d Control s
CONTINUED
An open glove box can cause
serious injury to your passenger
in a crash, even if the
passenger is wearing the seat
belt.
Always keep the glove box
closed while driving.
Page 81 of 273

Foldin
g Rea r Sea t
To fold down the seat-back from
inside the car, insert the master key
in the lock on the rear shelf. Turn
the key clockwise, pull down the top of the seat-back, then release the
key. To release the seat-back from inside
the trunk, pull the release loop under
the rear shelf.
To lock the seat-back upright, push it
firmly against the rear shelf. Make
sure it is latched in place by pulling
on the top of the seat. Make sure all items in the trunk, or
items extending through the opening
into the back seat, are secured.
Loose items can fly forward and
cause injury if you have to brake
hard. See Carryin
g Carg o on page
127.
Never drive with the seat-back
folded down and the trunk lid open. See Carbo n Monoxid e Hazar d on
page 49 .
Instrument s an d Control s RELEAS
E
Pul
l
MASTE
R KE Y
Page 86 of 273

Digita
l Cloc k
The digital clock displays the time
with the ignition switch ON (II). To see the time with the ignition off,
press and hold the wide button next
to the clock. To set the clock:
1. Turn the ignition switch ON (II) to
display the time.
2. Swing down the front cover of the wide button next to the clock
display. You will see H, M, and
RESET buttons.
3. Press and hold the H button until
the hour advances to the desired
hour.
4. Press and hold the M button until the numbers advance to the
desired minutes.
You can use the RESET button to quickly set the time to the nearest
hour. If the displayed time is before
the half hour, pressing RESET
button sets the clock back to the previous hour. If the displayed time
is after the half hour, pressing the RESET button sets the clock for- ward to the beginning of the next
hour.
For example: 1:06 would RESET to 1:00. 1:52 would RESET to 2:00.
Instrument s an d Control s
RESE
T
HM
Page 128 of 273

Accessorie
s an d Modification s
Modifying your car, or installing some non-Acura accessories, can
make your car unsafe. Before you
make any modifications or add any
accessories, be sure to read the following information.
Accessorie s
Your dealer has Genuine Acura
accessories that allow you to
personalize your car. These accessories have been designed and
approved for your car, and are
covered by warranty.
Non-Acura accessories are usually
designed for universal applications.
Although aftermarket accessories
may fit on your car, they may not
meet factory specifications, and
could adversely affect your car's
handling and stability. (See
"Modifications" on the page 126 for
additional information.) When properly installed, cellular
phones, alarms, two-way radios, and
low-powered audio systems should not interfere with your car's
computer-controlled systems, such
as the SRS and anti-lock brake
system.
However, if electronic accessories
are improperly installed, or exceed your car's electrical system capacity,
they can interfere with the operation of your car, or even cause the
airbags to deploy.
Before installing any accessory:
Make sure the accessory does not
obscure any lights, or interfere
with proper car operation or
performance. Be sure electronic accessories do
not overload electrical circuits (see page 236 ). Have the installer contact your
Acura dealer for assistance before
installing any electronic accessory.
If possible, have your dealer inspect
the final installation.
Before Drivin g
Improper accessories or
modifications can affect your
car's handling, stability and performance, and cause a
crash in which you can be hurt
or killed.
Follow all instructions in this
owner's manual regarding
accessories and modifications.