Acura MDX 2002 Owners Manual

Theremotetransmitterswillalso
activate the Driving Position
Memory System (see page ).
When you open the driver’s door
after unlocking it with the remote
transmitter, you will hear a beep.
The driver’s seat and outside mirrors
move to the positions stored in that
memory location. You will hear two
beeps when the movement iscomplete.
If the seat and mirrors are already in
the proper positions, you will hear
three beeps when you open the door.
The driving position memory
activated (Memory 1, Memory 2) is
shownonthebackof each
transmitter. Make sure you store
your desired driving position in the
memory that is activated by the
transmitter you normally carry.
To turn it back on, repeat this
procedure. The LED will come on
f or one second to indicate the
f eature has been turned on. You can turn the driving position
memory activation off and on. To
turn it of f , press and hold the LOCK
and UNLOCK buttons at the same
time f or about one second. The LED
in the remote transmitter will blink
twice. Then release the buttons.
107
On Touring Model
Recalling a Memorized Driving
Position
Keys and Locks
Inst rument s and Cont rols87
W Wi itth h M
M e
emm o
or
ryy 2
2
W
Wi itth h M
M e
emm o
or
ryy 1
1
01/09/07 12:09:40 31S3V610_092

See page for information on
cargo loading. Keep the tailgate
closed at all times while driving to
avoid damaging the tailgate, and to
prevent exhaust gas f rom getting
into the interior. Seeon page .
To open the tailgate, pull the handle,
then lif t up the tailgate.
The childproof door locks are
designed to prevent children seated
in the rear f rom accidentally opening
the rear doors. Each rear door has a
lock lever near the edge. With the
lever in the LOCK position, the door
cannot be opened f rom the inside
regardless of the position of the lock
tab. To open the door, pull the lock
tab up and use the outside door
handle. To close the tailgate, use the inner
handle to pull the tailgate down, then
press down on the back edge.
203
56
Carbon
Monoxide Hazard
Childproof Door L ocks T ailgate
Keys and Locks
Inst rument s and Cont rols88
L LO
OC CKK L
LEE V
V E
ER
R H
HA
AN
ND DL
LEE
01/09/07 12:09:50 31S3V610_093

Open the glove box by squeezing the
handle. Close it with a f irm push.
Lock or unlock the glove box with
the master key. Glove Box
Keys and Locks
Inst rument s and Cont rols89
G GLLOOV VE
E B
BOOX X
An open glove box can cause
serious injury to your passenger
inacrash,evenifthe
passenger is wearing the seat
belt.
Always keep the glove box
closed while driving.
01/09/07 12:09:57 31S3V610_094

µ
Pull up or push down on the f ront of
the switch to move the seat bottom’s
f ront edge up or down. Pull up or
push down on the rear of the switch
to move the rear of the seat bottom
up or down.
Push the horizontal switch forward
or backward to move the seat
forward or backward. The long horizontal switch adjusts
the seat bottom in several directions.
The short vertical switch adjusts the
seat-back angle.
Your Acura has power adjustments
f or the driver’s seat. The two power
seat adjustment switches are on the
outside edge of the seat bottom.
You can adjust the seat with the
ignition switch in any position. Make
all seat adjustments bef ore you start
driving. The Touring package also has power
adjustments f or the f ront passenger’s
seat. The MDX without the Touring
package has manual adjustments.
Thesecondandthirdrowseatsin
both models have manual
adjustments.
See pages f or important saf ety
inf ormation and warnings about how toproperly position seats and seat-backs. 12 13
Inst rument s and Cont rols
Seats
Power Seat A djustments
90
01/09/07 12:10:09 31S3V610_095

Pull the center of the horizontal
switch up to raise the seat. Push it
down to lower the seat.Adjust the seat-back angle by
pushing the rear switch in the
direction you want to move.
Vary the lumbar support by moving
the lever on the right side of the
seat-back. Move the lever forward or
backward to adjust the lumbar
support through its f ull range.
Inst rument s and Cont rols
Seats
Driver’s L umbar Support
91
01/09/07 12:10:18 31S3V610_096

µ
To adjust the seat forward and
backward, pull up on the lever under
the seat cushion’s f ront edge. Move
the seat to the desired position and
releasethelever.Trytomovethe
seat to make sure it is locked in
position.To change the seat-back angle of the
f ront seats, pull up on the lever on
the outside of the seat bottom.
Make all seat adjustments bef ore
you start driving.
See pages f or important saf ety
inf ormation and warnings about how toproperly position seats and seat-backs. 12 13
Inst rument s and Cont rols
Seats
Manual Seat Adjustments
92
01/09/07 12:10:26 31S3V610_097

To change the seat-back angle of the
seats in the second row, pull up on
thehandleontheoutsideof theseat-
back.To adjust the seat-back angle of the
third seat, pull on the handle on the
back of the seat-back, move the seat-
back to the desired position, and
release the handle. Let the seat-back
latch in the new position.
Seats
Inst rument s and Cont rols
Second and T hird Row Seat
Adjustments
93
H H
A
AN
ND DL
LEE
S
SE
EC
CO ON NDD
S
SE EA
A T
T T
T
H
H I
IRRD D
S
SE EA
A T
T
01/09/07 12:10:34 31S3V610_098

See page f or important saf etyinf ormation and a warning about how toproperly position the head restraints. 14
To remove a head restraint f or
cleaning or repair, pull it up as f ar as
it will go. Push the release button
and pull the restraint out of the seat-
back.
The head restraints adjust f or height.
You need both hands to adjust the
restraint. Do not attempt to adjust it
while driving. To raise it, pull upward.
To lower the restraint, push the
release button sideways and push
the restraint down.
The head restraints help protect you
and your passengers f rom whiplash
and other injuries. They are most
ef f ective when you adjust them so
the back of the occupant’s head rests
against the center of the restraint. A
taller person should adjust the
restraint as high as possible. Your vehicle is equipped with head
restraints in all seating positions.
Seats
Inst rument s and Cont rols
Head Restraints
94
R RE
EL
LEE A
A S
SEE B
BUUT TT
TO
ON N
01/09/07 12:10:42 31S3V610_099

To get into the third row seats, pull
upontheleveronthesideof the
passenger’s side second row seat-
back. The seat-back will tilt f orward,
and the seat will slide f orward.
After you return the seat-back to the
upright position, push the whole seat
backwards until it latches. Make
sure the seat is f ully latched bef ore
sitting in it.The lef t and right halves of the
second seat can be f olded up
separately to create more cargo
space.
If you are f olding the lef t half of
the seat, use the ignition key to
release the seat belt from the
detachable anchor. Allow the seat
belt to retract into the roof . Insert
the latch plate into the roof holder.
Lower the head restraint to its
lowest position.
Pull up on the handle on the
outside of the seat-back. Fold the seat-back forward.
Reverse this procedure to return the
seat to the upright position. Make
sure the seat is locked securely
bef ore driving.
(Lef t half ) Remove the seat belt
f rom its holder in the roof , and
connect it to the detachable anchor
(see page ).
2.
3. 1.
4.
98
Seats
Inst rument s and Cont rols
Rear Seat A ccess Folding the Second Seat
95
R REEL
LEE A
A S
SEE L
LEE V
V E
ER
R H
H
A
AN
ND DL
LEE
01/09/07 12:10:55 31S3V610_100

Store the head restraints in the
storage compartment under the
cargo area f loor. Insert the shaf ts
of the head restraints into the
holes in the sides of the storage
compartment.Use the ignition key to release the
seat belt from the detachable
anchor.
To create more cargo space, you can
fold the third seat forward.
To fold the third seat:
Remove the head restraints by
pushing the release buttons and
pulling the restraints out.
1. 2. 3.
Folding the T hird Seat
Inst rument s and Cont rols
Seats
96
R RE
EL
LEE A
A S
SEE B
BUUT TT
TO
ON N
01/09/07 12:11:05 31S3V610_101