display Acura MDX 2007 User Guide

This indicator normally comes on for
a few seconds when you turn the
ignition switch to the ON (II)
position. If this indicator comes on at
any other time, there is a problem in
the SH-AWD system. You will also
see a ‘‘CHECK SH-AWD SYSTEM’’
message on the multi-information
display(seepage ).Takeyour
vehicle to a dealer to have it checked.
For more information, see page .Pull
to the side of the road wh en it is
safe, shift to Park, and let the engine
idle until the indicator goes out. This
indicator comes on briefly when
you turn the ignition switch to the
ON (II) position. It will then go off if
you have inserted a properly-coded
ignition key. If it is not a properly-
coded key, the indicator will blink,
and the engine’s fuel system will be
disabled. (see page ).
If
the indicator blinks while driving,
it indicates the differenti al
temperature is too high.
You will also see a ‘‘SH-AWD DIFF
TEMP. HIGH’’ message on the
multi-info rmation display (see page
).
82 82
128
340
SH-AWD Indicator Immobilizer System
Indicator
Instrument Panel Indicators
Inst rument s and Cont rols
69
Continuing to drive with the SH-AWD
indicator blinking may cause serious
damage to the system.
——y
y
()-yy

Thisindicatornormallycomeson
when you turn the ignition switch to
theON(II), and remains on until the
engine starts.Ifthisindicato rcomes
on at anyothertime,thereisa
problem in thesystem.Whilethis
indicator is on, thecomfortbutton
will not work, and thesystemwill
not function.Youwill also see a
"CHECK ADSSYSTEM" message on
the multi-info rmation display. Have
the vehicl echeckedby your dealer as
soonaspossible.For more
info rmation,seep age. Thisindicato
rcomesonasa
reminderthatyoumustrefuelsoon.
Whentheindicatorcomeson,t here
isabout1.8USgal(7.0
)offuel
remainingi nthetankbeforethe
needlereachesE.Thereisasmall
reserveoffuelremaininginthetank
whentheneedledoesreachE. You T
hi
si ndic at orc
omesonwhenthe
securitysystemisset.Seepage formoreinformationonthe
securitysystem.
353
265
Active Damper System
Indicator
Low Fuel Indic
ator Security System Indicator
Instrument Panel Indicators
Instrument sand Cont ro ls
71
LOW FUEL INDICATOR SECURITY SYSTEM INDICATOR
——y
y
()-yy
will also see a "LOW FUEL" message
on the multi-information display (see
page 82).

ÛÝÛÝ
ÛÝThe
multi -information display in the
instrument panel displays various
inform ation and messages when the
ignition switch is in the ON (II)
position. Some of the messages help
you operate your vehicle more
comfortably.
Others help to keep you aware of the
periodic maintenance your vehicle
needs for continued trouble-free
driving.
When you open the driver’s door, a
‘‘Welcome’’ message is shown on the
multi-info rmation display. When you
turn the ignition switch from the ON
(II) position to the ACCESSORY (I)
position, a ‘‘Goodbye’’ message is
shownonthedisplay. To
change the display, press the
INFO( / )buttononthesteering
wheel repeatedly until the main
menu appears (see page ). With
the ignition switch in the ON
(II) position, the multi -information
display changes as shown in the next
page each time you press the INFO
( / ) button or SEL/RESET
button.
Wh en you turn the ignition switch to
the ON (II) position, what you last
selected is displayed.
In the multi-information display, the
system message is also displayed
(see page ) and you can
customize your vehicle control
settings (see page ).
74 80
83
CONT INUED
Multi-Inf ormation Display
Inst rument s and Cont rols
73
INFO ( / )
BUTTON
SEL/
RESET
BUTTON
——y


y
()-yy

Multi-Information Display
74
Main MenuINFO buttonSEL/RESET button
(See page 75)
Go to Customize Menu (See page 83)
Go to HandsFreeLink Menu (See page 276)
Trip Computer (See page 78)
(See page 75)
(See page 75)
Tire Pressure for each tire (See page 77)
——y


y
()-yy

When the main menu is blank,
SH-AWD or TIRE PRESSURE,
pressing the SEL/RESET button
changes the display to ‘‘trip meter/
odometer’’ ‘‘outside temperature/
odometer’’ and ‘‘engine oil lif e/
odometer’’.The odometer shows the total
distance your vehicle has been
driven. It measures miles in U.S.
models and kilometers in Canadian
models. It is illegal under U.S.
federal law and Canadian provincial
regulations to disconnect, reset, or
alter the odometer with the intent to
change the number of miles or
kilometers indicated.This meter shows the number of
miles (U.S.) or kilometers (Canada)
driven since you last reset it. There
are two trip meters: Trip A and Trip
B. Each trip meter works
independently, so you can keep track
of two dif f erent distances.
To reset a trip meter, display it, and
then press and hold the SEL/RESET
button until the number resets to
‘‘0.0.’’
CONT INUED
Multi-Inf ormation Display
Trip Meter
Odometer
Inst rument s and Cont rols
75
ODOMETER TRIP METER
——y
y
()-yy

The temperature sensor is in the
front bumper. The temperatu re
reading can be affected by heat
reflection from the road surface,
engine heat, and the exhaust from
surrounding traffic. This can cause
an incorrect temperature reading
when your vehicle speed is under
19 mph (30 km/h). When you start
your trip, the sensor is not fully
acclimatized, therefore it may take
several minutes until the proper
te mperature is displayed.
In certain weather conditions,
temperature readings near freezing
(32°F, 0°C) could mean that ice is
forming on the road surface.
You can adjust the outside
temperature display (see page ).
This
shows the outside Fahrenheit
te mperature in U.S. models, and
Centigrade temperature in Canadian
models.
When
you reset Trip A, average fuel
economy A is reset at the same time.
When you reset Trip B, average fuel
economy B is reset.
In the customizing mode, you can set
Trip A and average fuel economy A
to reset at the same time when you
refuel your vehicle (see page ).
92
91
Outside Temperature
Multi-Inf ormation Display
76
OUTSIDE TEMPERATURE
U.S.
CANADA
——y


y
()-y
y

Whenthetirepressuremonitoris
shown on the multi-info rmation
display, press the SEL/RESET
button. The display changes as
shown.
You can see the pressure of each tire
in this monito r. If one or more tires
are low, inflate them to the correct
pressure. For more information, see
page .
This
monitor shows how much
to rque is being delivered to each
wheel. For more information, see
page .
This
shows the remaining life of the
engine oil. It shows 100% after the
engine oil is replaced and the display
is reset. The engine oil life is
calculated based on engine operating
conditions and accumulated engine
revolutions. For more information,
see page .
375 340
343
Tire Pressure Monitor
SH-AWD T orque Distribution
Monitor
Engine Oil L if e
Multi-Inf ormation Display
Inst rument s and Cont rols
77
U.S.
Canada
ENGINE OIL LIFE
——y

y
()-yy

You can receive or make phone calls
from your cellphone through your
vehicle’s HandsFreeLink (HFL)
system without touching your
cellphone. To
use the system, your cellphone
and the HFL system must be linked.
Not all cellphones are compatible
with this system. Ref er to page for instructions on how to link
your cellphone to the HFL and how
to receive or make phone calls, or
visit the handsf reelink.com website.
When the main menu displays Trip
Computer, pressing the SEL/RESET
button changes the display to
‘‘AVERAGE FUEL A/RANGE’’ to
‘‘AVERAGE FUEL B/RANGE’’ and
to ‘‘AVERAGE SPEED/ELAPSED
TIME’’.
276
HandsFreeL ink T rip Computer
Multi-Inf ormation Display
78
TM
——y

y
()-yy

This shows the estimated distance
you can travel on the fuel rema ining
in the fuel tank. This distan ce is
estimated from the fuel economy
you received over the last several
miles(U.S.) or kilometers (Canada),
so it will vary with changes in speed,
traffic, etc.
This
shows your vehicle’s average
fuel economy in mpg (U.S. model s)
or liter/100 km (Canadian models)
since you last reset the Trip A or
Trip B.
You can customize the Trip A and
AVERAGE FUEL A reset condition
in the multi-information display (see
page ).
This shows the average speed you
are traveling in miles per hour (mph)
forU.S.modelsorkilometersper
hour (km/h) for Can adian models.
To reset the AVERAGE SPEED you
have traveled, press and hold the
SEL/RESET button until the
number resets. This
shows the time passed traveled
since you last reset it. When you turn
the ignition switch to the ON (II)
pos ition, ELAPSED TIME is reset.
If you want to reset the ELAPSED
TIME manually, go to the trip
computer’s ELAPSED TIME display,
andpressandholdtheSEL/RESET
button until the number resets.
You can customize the ELAPSED
TIME reset condition in the multi-
inf ormation display (see page ). 94
92
AVERAGE FUEL A/B
RANGE
A VERA GE SPEED EL A PSED T IME
Multi-Inf ormation Display
Inst rument s and Cont rols
79
——y

y
()-yy

ÛÝÛÝ
ÛÝ
If there is a problem with your
vehicle, f or example, the engine oil
level is low or a door is not f ully
closed, the multi-inf ormation display
will show you the problem. It does
this by interrupting the current
display with one or more messages. The system message(s) triggers the
appropriate indicator(s) on the
instrument panel, including the
system message indicator, to come
on. The system message indicator
does not go of f until the problem(s)
is corrected.
You will also hear a beep when the
system message indicator comes on
for the first time.
Most of the messages are displayed
f or about 5 seconds, and then the
normal display returns. If there are
several system messages to be
shown, the display switches these
messages every 5 seconds.
To cancel the message(s) bef ore 5
seconds elapsed, press the INFO
( / ) button on the steering wheel.
Even if you press the INFO ( / )
button, some messages stay on or
come on again at regular intervals
until the problem is corrected.
You can see the message(s) again by
pressing the INFO ( / ) button
repeatedly if the system message
indicator remains lit on the
instrument panel.
Here is a list of all messages:
Multi-Inf ormation Display
System Messages
80
SYSTEM MESSAGE INDICATOR
——y


y
()-yy