Acura MDX HYBRID 2019 Owner's Manual
Manufacturer: ACURA, Model Year: 2019, Model line: MDX HYBRID, Model: Acura MDX HYBRID 2019Pages: 685, PDF Size: 36.92 MB
Page 601 of 685

600
Maintenance
12-Volt Battery
Checking the 12-Volt Battery
The condition of the battery is monitored by a 
sensor located on the negative terminal of the 
battery. If there is a problem with this sensor, 
the multi-information display (MID) will 
display a warning message. If this happens, 
have you vehicle inspected by a dealer.
Check the battery terminals for corrosion 
monthly.
If your vehicle’s battery is disconnected or goes dead:
• The audio system is disabled.
2 Audio System Theft Protection P. 240
•The clock resets.
2 Clock  P. 142
Charging the 12-Volt Battery
Disconnect both battery cables  to prevent damaging your vehicle’s electrical system.
Always disconnect the negative (−) cable first, and reconnect it last.
1 12-Volt Battery
WARNING: Battery post, terminals, 
and related accessories contain lead 
and lead compounds.
Wash your hands after handling.
When you find corrosion, cl ean the battery terminals 
by applying a baking powder and water solution. 
Clean the terminals with a damp towel. Cloth/towel 
dry the battery. Coat the terminals with grease to 
help prevent future corrosion.
When replacing the battery,  the replacement must be 
of the same specifications.
Consult a dealer for more information.
3WARNING
The battery gives off explosive hydrogen 
gas during normal operation.
A spark or flame can cause the battery to 
explode with enough force to kill or 
seriously hurt you.
When conducting any battery 
maintenance, wear prot ective clothing and 
a face shield, or have a skilled technician do 
it.
Battery
19 ACURA MDX E-AWD-31TRX6200.book  600 ページ  2018年6月22日 金曜日 午後7時42分 
Page 602 of 685

601
Maintenance
Remote Transmitter Care
Replacing the Button Battery
If the indicator does not come on when the button is pressed, replace the battery.
1. Remove the built-in key.
u As a convenience, lightly place masking 
tape over the remote buttons to hold 
them in place.
2. Remove the upper half of the cover by 
carefully prying on the edge with a coin.
u Wrap a coin with a cloth to prevent 
scratching the transmitter.
3. Press down on the center of the assembly 
and remove the battery.
u When removing the button battery, be 
careful not to touch parts around it.
4. Make sure to replace the battery with the 
correct polarity.1Replacing the Button Battery
NOTICE
An improperly disposed of  battery can damage the 
environment. Always conf irm local regulations for 
battery disposal.
Replacement batteries are commercially available or 
at a dealer.
NOTICE
The Remote transmitter  is equipped with two 
batteries: A standard  replaceable CR2032 coin 
button battery and an in tegral non-replaceable 
rechargeable battery. To prevent permanent damage 
to the rechargeable battery, replace the CR2032 
battery every three to four years.
3WARNING
CHEMICAL BURN HAZARD
The battery that powers the remote 
transmitter can cause severe internal burns 
and can even lead to  death if swallowed.
Keep new and used batteries away from 
children.
If you suspect that a child has swallowed 
the battery, seek medical attention 
immediately.
Battery type: CR2032
Battery
19 ACURA MDX E-AWD-31TRX6200.book  601 ページ  2018年6月22日 金曜日 午後7時42分 
Page 603 of 685

602
Maintenance
Remote Control and Wireless Headphone Care*
Replacing the Battery
If it takes several pushes on the remote control buttons to operate the rear 
entertainment system, replace the battery.
1.Remove the cover.
2. Make sure to replace  the battery with the 
correct polarity.
■Remote Control
Models with Rear Entertainment System
1 Replacing the Battery
NOTICE
An improperly disposed of  battery can damage the 
environment. Always conf irm local regulations for 
battery disposal.
Replacement batteries are commercially available or 
at a dealer.
Make sure to replace all the batteries at once.
3WARNING
CHEMICAL BURN HAZARD
The battery that powers the remote control 
can cause severe internal burns and can 
even lead to d eath if swallowed.
Keep new and used batteries away from 
children.
If you suspect that a child has swallowed 
the battery, seek medical attention 
immediately.
Battery type: BR3032
* Not available on all models
19 ACURA MDX E-AWD-31TRX6200.book  602 ページ  2018年6月22日 金曜日 午後7時42分 
Page 604 of 685

603
uuRemote Control and Wireless Headphone Care*uReplacing the Battery
Maintenance
If there is no sound coming from the wireless headphone, replace the battery.
1.Remove the screw.
2. Open the cover.
3. Make sure to replace the battery with the 
correct polarity.
■Wireless Headphone
Battery type: AAA
Cover
Battery
19 ACURA MDX E-AWD-31TRX6200.book  603 ページ  2018年6月22日 金曜日 午後7時42分 
Page 605 of 685

604
Maintenance
Climate Control System Maintenance
Dust and Pollen Filter
The climate control system is equipped with a dust and pollen filter that collects 
pollen, dust, and other debris in the air. The Maintenance MinderTM messages will let 
you know when to replace the filter.
We recommend that you replace the dust a nd pollen filter sooner when using your 
vehicle in areas with high concentrations of dust.
1 Dust and Pollen Filter
If the airflow from the climate control system 
deteriorates noticeably, and the windows fog up 
easily, the filter may need to be replaced. Please 
contact a dealer for replacement.
19 ACURA MDX E-AWD-31TRX6200.book  604 ページ  2018年6月22日 金曜日 午後7時42分 
Page 606 of 685

605Continued
Maintenance
Cleaning
Interior Care
Use a damp cloth with a mixture of mild detergent and warm water to remove dirt. 
Use a clean cloth to remove detergent residue.
Use a soft brush with a mixture of mild soap  and warm water to clean the seat belts. 
Let the belts air dry. Wipe the openings of  the seat belt anchors using a clean cloth.
■Cleaning Seat Belts
1Interior Care
Do not spill liquids inside the vehicle. Electrical 
devices and systems may ma lfunction if liquids are 
splashed on them.
Do not use silicone  based sprays on electrical devices 
such as audio devices and switches. Doing so may 
cause the items to malfunction  or cause a fire inside 
the vehicle.
If a silicone based spray is inadvertently used on 
electrical devices,  consult a dealer.
Depending on their compos ition, chemicals and 
liquid aromatics may cause  discoloration, wrinkles, 
and cracking to resin-ba sed parts and textiles.
Do not use alkali solvents or organic solvents such as 
benzene or gasoline.
After using chemical s, make sure to gently wipe them 
away using a dry cloth.
Do not place used cloths on top of resin based parts 
or textiles for long periods  of time without washing.
Opening
19 ACURA MDX E-AWD-31TRX6200.book  605 ページ  2018年6月22日 金曜日 午後7時42分 
Page 607 of 685

uuCleaning uInterior Care
606
Maintenance
Wipe using a glass cleaner.
The front and second row passenger’s floor 
mats hook over floor anchors, which keep 
them from sliding forward. To remove a mat 
for cleaning, turn the  anchor knobs to the 
unlock position. When reinstalling the mat 
after cleaning, turn the knobs to the lock 
position.
Do not put additional  floor mats on top of 
the anchored mats.
To properly clean leather:
1. Use a vacuum or soft dry cloth first to remove any dirt or dust.
2. Clean the leather with a soft cloth dampen ed with a solution comprised of 90% 
water and 10% neutral soap.
3. Wipe away any soap residu e with a clean damp cloth.
4. Wipe away residual water and allow  leather to air dry in the shade.
■Cleaning the Window
■Floor Mats
1Cleaning the Window
Wires are mounted to the in side of the rear window. 
Wipe along the same direct ion as the wires with a 
soft cloth so as not to damage them.
Be careful not to spill fluids, such as water or glass 
cleaner, on or around the co ver of both the front 
sensor camera and the  rainfall/light sensor.
2 Automatic Operation (automatic lighting 
control)  P. 177
2 Automatic Intermittent Wipers P. 184
2 Front Sensor Camera  P. 475
1Floor Mats
If you use any floor mats  that were not originally 
provided with your vehicle, make sure they are 
designed for your specific ve hicle, fit correctly, and 
are securely anchored by the floor anchors.
Position the rear seat floor  mat properly. If they are 
not properly positioned, th e floor mat can interfere 
with the front seat functions.
Lock
Unlock
■Maintaining Genuine Leather1
Maintaining Genuine Leather
It is important to clean or  wipe away dirt or dust as 
soon as possible. Spills can  soak into leather resulting 
in stains. Dirt or dust ca n cause abrasions in the 
leather. In addition, pl ease note that some dark 
colored clothing can rub  onto the leather seats 
resulting in discol oration or stains.
19 ACURA MDX E-AWD-31TRX6200.book  606 ページ  2018年6月22日 金曜日 午後7時42分 
Page 608 of 685

607
uuCleaning uExterior Care
Continued
Maintenance
Exterior Care
Dust off the vehicle body after you drive.
Regularly inspect your vehicle for scratches on painted surfaces. A scratch on a 
painted surface can result in body rust. If  you find a scratch, promptly repair it.
Wash the vehicle regularly. Wash more fr equently when driving in the following 
conditions:
• If driving on roads with road salt.
• If driving in coastal areas.
• If tar, soot, bird droppings, insects,  or tree sap are stuck to painted surfaces.
• Make sure to follow the instructions  indicated on the automated car wash.
• Fold in the door mirrors.
• For models equipped with automatic intermittent wipers, turn the wipers off.
■Washing the Vehicle
■Using an Automated Car Wash
1Washing the Vehicle
Do not spray water into the air intake vents. It can 
cause a malfunction.
Do not spray water onto the capless unit when the 
fuel fill door is open. It ca n cause damage to the fuel 
system or engine.
Air Intake Vents
1 Using an Automated Car Wash
When using an automated  car wash that pulls the 
vehicle through with a conveyor, make sure vehicle is 
in car wash mode.
2 If you want to keep the transmission in 
(N 
position [car wash mode]  P. 469
19 ACURA MDX E-AWD-31TRX6200.book  607 ページ  2018年6月22日 金曜日 午後7時42分 
Page 609 of 685

uuCleaning uExterior Care
608
Maintenance
• Keep sufficient distance  between the cleaning nozzl e and the vehicle body.
• Take particular care around the windows. St anding too close may cause water to 
enter the vehicle interior.
• Do not spray high pressure water directly into the engine compartment. Instead, 
use low pressure water and a mild detergent.
A good coat of automotive body wax helps protect your vehicle’s paint from the 
elements. Wax will wear off over time  and expose your vehicle’s paint to the 
elements, so reapply as necessary.
If you get gasoline, oil, engine coolant, or battery fluid on resin coated parts, they 
may be stained or the coating may peel. Prom ptly wipe it away using a soft cloth and 
clean water.
Wipe using a glass cleaner.
■Using High Pressure Cleaners
■Applying Wax
■Maintaining the Bumpers and Other Resin Coated Parts
■Cleaning the Window
1 Applying Wax
NOTICE
Chemical solvents and st rong cleaners can damage 
the paint, metal, and plasti c on your vehicle. Wipe 
away spills immediately.
1 Maintaining the Bumpers an d Other Resin Coated Parts
Ask a dealer about the correct coating material when 
you want to repair the painted surface of the parts 
made of resin.
19 ACURA MDX E-AWD-31TRX6200.book  608 ページ  2018年6月22日 金曜日 午後7時42分 
Page 610 of 685

609
uuCleaning uExterior Care
Continued
Maintenance
Aluminum is susceptible to deterioration caused by salt and other road 
contaminants. When necessary, as early as  possible use a sponge and mild detergent 
to wipe away these contaminants. Do no t use a stiff brush or harsh chemicals 
(including some commercial wheel cleaners).  These can damage the protective finish 
on aluminum alloy wheels, resulting in corrosion. Depending on the type of finish, 
the wheels also may lo se their luster or appear burn ished. To avoid water stains, 
wipe the wheels dry with a cloth while they are still wet.
The inside lenses of exterior lights (headlights, brake light s, etc.) may fog temporarily 
if you have driven in the rain, or after the vehicle has been run through a car wash. 
Dew condensation also may build up inside  the lenses when there is a significant 
enough difference between the ambient and  inside lens temperatures (similar to 
vehicle windows fogging up in rainy conditions). These conditions are natural 
processes, not structural design problems in the exterior lights.
Lens design characteristics ma y result in moisture developing on the light lens frame 
surfaces. This also is not a malfunction.
However, if you see large amounts of wa ter accumulation, or large water drops 
building up inside the lenses, have your vehicle inspected by a dealer.
■Maintaining Aluminum Wheels
■Fogged Exterior Light Lenses
19 ACURA MDX E-AWD-31TRX6200.book  609 ページ  2018年6月22日 金曜日 午後7時42分