brake Acura RSX 2003 Service Manual

µ
Î
Ì
ÌÌÎ
Ì
Maint enance200
Service at the indicated distance or time whichever comes first. miles x 1,000
km x 1,000
months
At 120,000 miles (192,000 km) or 10 years,
then every 60,000 miles (96,000 km) or 5 years
Inspect every 110,000 miles (176,000 km), otherwise adjust only if noisy
Every 110,000 miles (176,000 km)
Service the following items at the recommended intervals.
See information on maintenance and emissions warranty, last column, page . Replace every 5,000 miles (8,000 km) or 6 months
Check oil and coolant at each fuel stop
See dust and pollen filter on page for replacement information under special driving conditions. 10
16
20
3230
4840
6450
8060
9670
112 80
128 90
144 100
160110
176120
192
Every 160,000 miles (256,000 km) or 8 years Every 3 years (independent of mileage)
Check engine oil and coolant
Replace engine oil
Rotate tires (Check tire inflation and condition at least once per month)
Replace engine oil filter
Inspect front and rear brakes
Lubricate all hinges, locks, and latches
Visually inspect the following items:
Tie rod ends, steering gear box and boots, suspension components
Driveshaft boots
Check parking brake adjustment
Visually inspect the following items: Brake hoses and lines (including ABS)
All fluid levels and condition of fluidsExhaust system, fuel lines and connections
Lights and controls, vehicle underbody
Inspect and adjust drive belts
Replace dust and pollen filter
Replace transmission fluid
Clean or replace air cleaner element
Replace spark plugs
Inspect valve clearance Inspect idle speed
Replace engine coolant
Replace brake fluid 24
4872
12 3660
1: : 197
M/T
A/T
232
Clean every 15,000 miles (24,000 km), and replace every 30,000 miles (48,000 km) (Use normal schedule except in dusty conditions)
1
Maintenance Schedule for Severe Conditions

µµ
Ø
Ø
Ø
Ø
Ø
Ø
Ø
Ø
Ø Ø
Ø
Ø
Ø
Ø
Ø
Ø
Ø
Ø
Ø
Ø
Ø
Ø
Ø
Ø
Ø
Ø
Ì
Ì
Î
CONT INUED
Maint enance201
U.S. Owners
Canadian Owners A, B, C, D
A
B
C
D
Refer to page to determine which schedule to use.
Use the Maintenance Schedule for Severe Conditions.
5,000 mi/8,000 km/6 mos
10,000 mi/16,000 km/1 yr
15,000 mi/24,000 km
15,000 mi/24,000 km/1-½ yrs
20,000 mi/32,000 km/1 yr
25,000 mi/40,000 km/2 yrs
30,000 mi/48,000 km
30,000 mi/48,000 km/2 yrs
35,000 mi/56,000 km/2-½ yrs
40,000 mi/64,000 km/2 yrs
3yrs
45,000 mi/72,000 km
45,000 mi/72,000 km/3 yrs
50,000 mi/80,000 km/3 yrs
55,000 mi/88,000 km/3-½ yrs
60,000 mi/96,000 km
60,000 mi/96,000 km/3 yrs
65,000 mi/104,000 km/4 yrs
70,000 mi/112,000 km/4 yrs
75,000 mi/120,000 km
75,000 mi/120,000 km/4-½ yrs
80,000 mi/128,000 km/4 yrs
85,000 mi/136,000 km/5 yrs
90,000 mi/144,000 km
90,000 mi/144,000 km/5 yrs Do items in A.
Do items in A, B.
Clean air cleaner element (independent of
time).
Do items in A.
DoitemsinA,B,C.
Do items in A. Replace air cleaner element (independent of
time).
DoitemsinA,B,D.
Do items in A.
DoitemsinA,B,C. Replace brake fluid (independent of mileage).
Clean air cleaner element (independent of
time).
Do items in A.
Do items in A, B.
Do items in A. Replace air cleaner element (independent of
time). Replace transmission fluid (M/T, A/T).
DoitemsinA,B,C,D.
Do items in A.
Do items in A, B. Clean air cleaner element (independent of
time).
Do items in A.
DoitemsinA,B,C.
Do items in A. Replace air cleaner element (independent of
time). Replace transmission fluid (A/T).
DoitemsinA,B,D.
Service at the indicated distance or time, whichever comes first. Do the items in as required for each distance/time.
Replace engine oil.
Inspect front and rear brakes.
Rotate tires (follow pattern on page238).
Lubricate all hinges, locks, and latches.
Replace engine oil filter.
Inspect tie rod ends, steering gear box and boots.
Inspect suspension components.
Inspect driveshaft boots.
Check parking brake adjustment.
Inspect brake hoses and lines (including ABS).
Check all fluid levels, condition of fluids, and check
for leaks. Inspect exhaust system.
Inspect fuel lines and connections.
Check all lights.
Inspect the underbody.
Inspect and adjust drive belts.
Replace dust and pollen filter.
196
1
Maintenance Schedule for Severe Conditions (listed by distance/time)

Ø
Ø
Ø
Ø
Ø
Ø
Ø
Ø
Ø
Ì
Î
Ì
Maint enance202
See information on maintenance and emissions warranty, last
column, page .
Check engine oil and coolant at each fuel stop.
Check and adjust valve clearance, cold engine, only if noisy. See dust and pollen filter on page for replacement information
under special driving conditions.
NOTE: 1:
: 197 232
95,000 mi/152,000 km/5-½ yrs
100,000 mi/160,000 km/5 yrs
6yrs
105,000 mi/168,000 km
105,000 mi/168,000 km/6 yrs
110,000 mi/176,000 km
110,000 mi/176,000 km/6 yrs
115,000 mi/184,000 km/6-½ yrs
120,000 mi/192,000 km
120,000 mi/192,000 km/6 yrs
9yrs
120,000 mi/192,000 km/10 yrs
160,000 mi/256,000 km/8 yrs Do items in A.
DoitemsinA,B,C.
Replace brake fluid (independent of mileage).
Clean air cleaner element (independent of
time).
Do items in A. Inspect valve clearance, cold engine.
Replace spark plugs.
Do items in A, B.
Do items in A. Replace air cleaner element (independent of
time). Replace transmission fluid (M/T, A/T).
DoitemsinA,B,C,D. Replace brake fluid (independent of mileage).
Replace engine coolant.Inspect idle speed.
Maintenance Schedule for Severe Conditions (listed by distance/time)

µµ µ
µ
µ
µ µ
Engine oil level Check every
time you fill the fuel tank. See
page .
Engine coolant level Check the
radiator reserve tank every time
you f ill the f uel tank. See page . Tires Check the tire pressure
monthly. Examine the tread f or
wear and foreign objects. See page
.
Windshield washer f luid Check
the level in the reservoir monthly.
If weather conditions cause you to
use the washers f requently, check
the reservoir each time you stop
f or f uel. See page .
Automatic transmission Check
the f luid level monthly. See page .
Youshouldcheckthefollowing
items at the specif ied intervals. If
you are unsure of how to perf orm
any check, turn to the page given.
Brakes Check the f luid level
monthly. See page .Lights Check the operation of
the headlights, parking lights,
taillights, high-mount brake light,
turn signals, brake lights, and
license plate lights monthly. See
page .
159
216
217 219 235
244
160
Owner Maintenance Checks
Maint enance205

Fluid Locations
Maint enance206
ENGINE OIL
FILL CAP
(Black cap)POWER STEERING
FLUID (Red cap)
ENGINE COOLANT
RESERVOIR
RADIATOR CAP BRAKE FLUID
(Gray cap)
(Manual Transmission only)
CLUTCH FLUID
(Gray cap)
AUTOMATIC
TRANSMISSION
FLUID DIPSTICK
(Yellow loop)
WASHER FLUID
(Blue cap)
ENGINE OIL DIPSTICK
(Orange loop)

Check the f luid level in the reser-
voirs monthly. There are up to two
reservoirs, depending on the model.
They are:Brake f luid reservoir (all models)
Clutch f luid reservoir
(manual transmission only)
The brake f luid should be replaced
according to the time recommenda-
tion in the maintenance schedule.
Check the f luid level with the
transmission at normal operating
temperature and the car sitting on
level ground. Remove the
transmission f iller bolt and caref ully
f eel inside the bolt hole with your
f inger. The f luid level should be up
to the edge of the bolt hole. If it is
not, add Honda Manual Transmis-
sion Fluid (MTF) until it starts to
run out of the hole. Reinstall the
f iller bolt and tighten it securely. If Honda MTF is not available, you
may use an SAE 10W-30 or 10W-40
viscosity motor oil with the API
Certif ication seal that says ‘‘FOR
GASOLINE ENGINES’’ as a
temporary replacement. However,
motor oil does not contain the proper
additives and continued use can
cause stiffer shifting. Replace as
soon as it is convenient.
The transmission should be drained
and ref illed with new f luid according
to the time and distance recommen-
dations in the maintenance schedule.
CONT INUED
Brake and Clutch Fluid
Manual Transmission
Transmission Fluid, Brake and Clutch Fluid
Maint enance219
Correct level
FILLER BOLT

The f luid level should be between
theMINandMAXmarksontheside
of the reservoir. If the level is at or
below the MIN mark, your brake
system needs attention. Have the
brake system inspected f or leaks or
worn brake pads.
Always use Honda Heavy Duty
Brake Fluid DOT 3. If it is not
available, you should use only DOT 3
or DOT 4 f luid, f rom a sealed
container, as a temporary
replacement. However, the use of
any non-Honda brake fluid can cause
corrosion and decrease the lif e of the
system. Have the brake system
f lushed and ref illed with Honda
Heavy Duty Brake Fluid DOT 3 as
soon as possible.
The f luid level should be between
theMINandMAXmarksontheside
of the reservoir. If it is not, add
brake f luid to bring it up to that level.
Use the same fluid specified for the
brake system.
Low f luid level can indicate a leak in
the clutch system. Have this system
inspected as soon as possible.
Brake f luid marked DOT 5 is not
compatible with your car’s braking
system and can cause extensive
damage. Brake System
Clutch System
Brake and Clutch Fluid
Maint enance220
MAX
MIN MAX
MIN

Mount snow chains on your car
when warranted by driving condi-
tions or required by local laws. Make
sure the chains are the correct size
f or your tires. Install them only on
the front tires.
Use only SAE class ‘‘S’’ chains. Only
certain brands of chains will f it your
Acura without coming in contact
with the body or causing mechanical
damage. Bef ore buying any types of
chains, you should consult with your
Acura dealer about the designs and
brands that will work on your Acura.
Also,makesureyoupurchasethe
correct size f or your tires.
If you mount snow tires on your
Acura, make sure they are radial
tires of the same size and load range
as the original tires. Mount snow
tiresonallfourwheelstobalance
your car’s handling in all weather
conditions. Keep in mind the traction
provided by snow tires on dry roads
may not be as high as your car’s
original equipment tires. You should
drive cautiously even when the roads
areclear.Checkwiththetiredealer
f or maximum speed recommen-
dations.
When installing chains, f ollow the
manufacturer’s instructions and
mount them as tightly as you can.
Drive slowly with chains installed. If
you hear them contacting the body
or chassis, stop and investigate.
Make sure the chains are installed
tightly, and that they are not
contacting the brake lines or
suspension. Remove the chains as
soonasyoustartdrivingoncleared
roads.
Snow T ires
T ire Chains
Tires
Maint enance241
Chains of the wrong size or that are
improperly installed can damage your
car’s brake lines, suspension, body, and
wheels. Stop driving if you hear the
chains hitting any part of the car.

Check the f ollowing:Headlights (low and high beam)
Parking lights
Taillights
Brake lights
High-mount brake light
Turn signals
Back-up lights
Hazard light f unction
License plate light
Side marker lights
Daytime running lights
(Canadian models)
If you f ind any bulbs are burned out,
replace them as soon as possible.
Refer to the chart on page to
determine what type of replacement
bulb is needed. 290
Lights
Maint enance243
TURN SIGNAL LIGHT BACK-UP LIGHT
HIGH-MOUNT
BRAKE LIGHT
SIDE MARKER LIGHT LICENSE PLATE LIGHT
TAIL/BRAKE LIGHT

Open the hood. The f ront parking
light is next to the headlight bulb.
Remove the socket from the
headlight assembly by turning it
one-quarter turn counterclockwise.Pull the bulb straight out of its
socket.
Push the new bulb straight into
the socket until it bottoms.
Insert the socket back into the
headlight assembly. Turn it
clockwise to lock it in place.
Turn on the parking lights and
check that the new bulb is
working.
Open the hatch.
Remove the high-mount brake
light cover by pivoting it toward
the back of the car.
Remove the socket by turning it
one-quarter turn counterclockwise.
1.
3.
2. 3.
4.
5.
1.
2.
CONT INUED
Lights
Maint enance
Replacing a High-mount Brake
Light Bulb
Replacing a Front Parking L ight
Bulb
247
BULB
BULB
COVER