lock Alfa Romeo 159 2007 Owner handbook (in English)

208
SAFETY
DEVICES
WARNING
LIGHTS AND
MESSAGES
CAR
MAINTENANCE
TECHNICAL
SPECIFICATIONS
INDEX
CORRECT USE
OF THE CAR
DASHBOARD
AND
CONTROLS
IN AN
EMERGENCY
BOOT LIGHT
To change the bulb, proceed as follows:
❒open the tailgate;
❒remove the light unit A-fig. 50lev-
ering in the point shown by the ar-
row;
❒open the protection cover B-fig. 51
and replace the bulb releasing it from
the side contacts making sure that
the new bulb is correctly clamped be-
tween the contacts;
❒re-close the protective cover B;
❒refit the light unit inserting first one
side and then the other one until
hearing the locking click.
❒close protection B-fig. 53on light
unitA-fig. 52;
❒refit the light unit inserting first one
side and then the other one until
hearing the locking click.
A0E0205mfig. 50A0E0075mfig. 52A0E0204mfig. 51
PUDDLE LIGHT
To change the bulb, proceed as follows:
❒open the door and remove lens A-
fig. 52levering in the point shown
by the arrow;
❒raise protectionB-fig. 53and re-
place the snap-fitted bulb;
A0E0235mfig. 53

215
SAFETY
DEVICES
WARNING
LIGHTS AND
MESSAGES
CAR
MAINTENANCE
TECHNICAL
SPECIFICATIONS
INDEX
CORRECT USE
OF THE CAR
DASHBOARD
AND
CONTROLS
IN AN
EMERGENCY
USERS FUSE AMPERE FIGURE
Climate control system fan F02 (MAXI-FUSE) 40 60
Electric steering lock F03 (MAXI-FUSE) 20 60
Brake branch point (pump) F04 (MAXI-FUSE) 40 60
Brake branch point (solenoid valve) F05 (MAXI-FUSE) 40 60
Radiator fan (low speed) F06 (MAXI-FUSE) 40 60
Radiator fan (high speed) F07 (MAXI-FUSE) 50 60
Headlight washer F09 20 60
Horns F10 15 60
Electronic injection sundry secondary services F11 15 60
+ INT for electronic injection system F16 7.5 60
Electronic injection primary services F17 10 60
Engine control branch point F18 15 60
Climate control system compressor F19 7.5 60
Rear window heating F20 20 60
Fuel pump supply F21 20 60
Ignition coils/injectors (petrol versions) F22 15 60
Electronic injection primary services diesel versions) F22 20 60
Sound system/radionavigation system power F23 15 60
Body Computer branch point/Headlight washer relay coil F31 7.5 56
Driver’s door branch point/passenger’s door branch point/
ignition device F32 15 56
Rear left power window F33 20 56
Rear right power window F34 20 56

216
SAFETY
DEVICES
WARNING
LIGHTS AND
MESSAGES
CAR
MAINTENANCE
TECHNICAL
SPECIFICATIONS
INDEX
CORRECT USE
OF THE CAR
DASHBOARD
AND
CONTROLS
IN AN
EMERGENCY
USERS FUSE AMPERE FIGURE
Water in diesel fuel filter sensor/flow meter F35 7.5 56
Brake light switch/central console control panel F35 7.5 56
Cruise Control F35 7.5 56
AQS sensor F35 7.5 56
Boot branch point/front door branch point power F36 20 56
Instrument panel branch point F37 7.5 56
Front headlight control unit/Power to control unit for gas-discharge
headights (Bixenon) (where provided) F37 7.5 56
Boot locking/unlocking gearmotor F38 15 56
EOBD system diagnostic socket F39 10 56
T.P.M.S. control unit F39 10 56
Mobile phone presetting F39 10 56
Alarm system control unit (where provided) F39 10 56
Climate control system F39 10 56
Heated rear window F40 30 56
Windscreen washer/rear window washer nozzle demister F41 7.5 56
Heated mirror demister F41 7.5 56
Brake branch point power (ABS/VDC) –
Steering angle branch point – Yawing sensor F42 7.5 56
Windscreen wiper/washer F43 30 56

222
SAFETY
DEVICES
WARNING
LIGHTS AND
MESSAGES
CAR
MAINTENANCE
TECHNICAL
SPECIFICATIONS
INDEX
CORRECT USE
OF THE CAR
DASHBOARD
AND
CONTROLS
IN AN
EMERGENCY
Do not start the engine
when towing the car.
WARNING
Before fitting the hook,
clean accurately its
threaded seat. Before starting
to tow, make sure to have
tighten the hook.
WARNING
Before starting to tow,
disengage the steering
lock (see paragraph “Ignition de-
vice” in section “Dashboard and
controls”). When towing, re-
member that without the help of
the brake booster and power
steering, a greater effort is re-
quired on the pedal and steer-
ing wheel. Do not use flexible ca-
bles for towing and avoid jerks.
During towing operations make
sure that fastening the joint to
the car does not damage the
components in contact with it.
When towing the car, you must
comply with the specific traffic
regulations regarding the tow
ring and how to tow on the road.
WARNING
Rear
The tow hook A-fig. 66for the rear
bumper is fixed.
A0E0176mfig. 66
❒remove the snap-fitted plug A-fig. 65
from the front bumper. If using the flat
blade screwdriver B-fig. 64 provided
as standard, protect its tip with a soft
cloth to prevent damaging the car.
❒tighten the tow hook in its seat.
A0E0230mfig. 65

225
SAFETY
DEVICES
WARNING
LIGHTS AND
MESSAGES
IN AN
EMERGENCY
TECHNICAL
SPECIFICATIONS
INDEX
CORRECT USE
OF THE CAR
DASHBOARD
AND
CONTROLS
CAR
MAINTENANCE
30 60 90 120 150 180
●●●●●●
●●●●●●
●●●●●●
●●●●●●
●●●●●●
●●●
●●●●●●
●●●●●●
●●●●●●
●●●
●●
●●
●●
SERVICE SCHEDULE
Thousands of km
Check tyre conditions/wear and
adjust pressure if required
Check light system operation (headlights,
direction indicators, hazard lights, boot lights, passenger
compartment lights, glovebox lights, warning lights, etc.)
Check windscreen wiper/washer operation,
adjust nozzles if required
Check windscreen/rear window blade
position/wear
Check front disk brake pad conditions and wear
and wear indicator operation
Check rear disk brake pad conditions and wear
Sight inspect the conditions of: body external parts,
underbody protection, pipes and hoses
(exhaust - fuel - brakes), rubber parts
(boots, sleeves, bushes, etc.)
Check cleanness of locks, bonnet and boot and lever cleanness
and lubrication
Check and top up, if required, fluid levels
(brakes/hydraulic clutch, power steering, windscreen washer,
battery, engine coolant, etc.)
Check and adjust handbrake lever stroke
Sight inspect accessory drive belt conditions
Sight inspect accessory drive belt conditions (1.8 version)
Sight inspect timing belt conditions (1.8 version)

227
SAFETY
DEVICES
WARNING
LIGHTS AND
MESSAGES
IN AN
EMERGENCY
TECHNICAL
SPECIFICATIONS
INDEX
CORRECT USE
OF THE CAR
DASHBOARD
AND
CONTROLS
CAR
MAINTENANCE
USE OF THE CAR
UNDER HEAVY
CONDITIONS
Should prevailing use of the car be un-
der one of the following specially heavy
conditions:
❒ trailer or caravan towing;
❒ dusty roads;
❒ short distances (less than 7-8 km)
and repeated with external temper-
atures below zero;
❒ frequently idling engines or long dis-
tance low speed driving (e.g.: door-
to-door deliveries) or in case of a long
term inactivity;
❒ urban routes;
carry out checks more frequently than
required on Service Schedule:
❒ check front disk brake pad conditions
and wear;
❒ check cleanness of bonnet and boot
locks and lever cleanness and lubri-
cation;
❒ sight inspect the conditions of: en-
gine, gearbox, transmission, pipes
and hoses (exhaust - fuel - brakes),
rubber parts (boots, sleeves, bushes,
etc.);
❒ check battery charge and fluid level
(electrolyte);
❒ visual check on various drive belt con-
ditions;
❒ change engine oil and oil filter, if re-
quired;
❒ check and replace pollen filter, if re-
quired;
❒ check and replace air cleaner, if re-
quired.
PERIODICAL CHECKS
Every 1,000 km or before long jour-
neys, check and top up if required:
❒engine coolant fluid level;
❒brake fluid level;
❒windscreen washer fluid level;
❒ tyre pressure and conditions.
❒ check light system operation (head-
lights, direction indicators, hazard
lights, etc.);
❒ check windscreen wiper/washer op-
eration and windscreen/rear window
blade position/wear;
Every 3,000 km check and top up if re-
quired: engine oil level.
You are recommended to use FL Se-
leniaproducts, designed and produced
specifically for Alfa Romeo cars (see
table “Capacities” in section “Techni-
cal specifications”).

Upholstery of your car
has been designed to
withstand wear deriv-
ing from common use of the car.
You are however recommended
to avoid strong and/or contin-
uous scratching with clothing
accessories such as metallic
buckles, studs, Velcro fasten-
ings and the like, since these
items cause circumscribed stress
of the cover fabric that could
lead to yarn breaking, and dam-
age the cover as a consequence.
248
SAFETY
DEVICES
WARNING
LIGHTS AND
MESSAGES
IN AN
EMERGENCY
TECHNICAL
SPECIFICATIONS
INDEX
CORRECT USE
OF THE CAR
DASHBOARD
AND
CONTROLS
CAR
MAINTENANCE
INTERIOR PLASTIC PARTS
Clean plastic parts with a cloth moist-
ened with water and non-abrasive neu-
tral detergent. To remove grease or hard
stains, use appropriate products de-
signed to preserve the appearance of
components.
IMPORTANTNever use spirit or pe-
troleum to clean the instrument panel
or other plastic parts.
Never use flammable
products like oil ether
or rectified petrol for cleaning
car interiors. Electrostatic dis-
charges generated by rubbing
during cleaning operations
could cause fire.
WARNING
Do not keep aerosol
cans in the car: they
might explode. Aerosol cans
must never be exposed to a
temperature above 50°C. The
temperature inside the car ex-
posed to the sun may go well
beyond that figure.
WARNING
STEERING WHEEL/
GEAR LEVER KNOB WITH
GENUINE LEATHER
COVERING
These components shall only be cleaned
with water and neutral soap. Never use
spirit or alcohol-based products.
Before using special products for clean-
ing interiors, read carefully label in-
structions and indications to make sure
they are free from spirit and/or alcohol-
based substances.
If when cleaning the windscreen with
special glass products, some drops fall
on the leather covering of the steering
wheel/gear lever knob remove them
immediately and then clean with wa-
ter and neutral soap.
IMPORTANTTake the utmost care
when engaging the steering lock to pre-
vent scratching the leather covering.

SPRAY NOZZLE
If the jet of fluid is inadequate, firstly
check that there is fluid in the reservoir
(see "Checking fluid levels" in section
"Car maintenance").
Then check that the nozzle holes A-
fig. 3are not clogged, if necessary use
a needle to clean them.
277
ALFA 159 SPORTWAGON
A0E0269mfig. 4
A0E0263mfig. 5
A0E0268mfig. 3
BOOT
TAILGATE EMERGENCY
OPENING FROM THE INSIDE
To open the tailgate from the inside if
the battery is flat or the electric tailgate
lock is failing, proceed as follows:
❒tilt the rear seats completely (see
paragraph "Extending the boot" in
section "Dashboard and controls");
❒remove the rear head restraints;
❒take the screwdriver from the tool
container and working inside the
boot (on the rear part), fit it into seat
A-fig. 4and then operate lever B-
fig. 5.

287
ALFA 159 SPORTWAGON
Taillight bulb on tailgate
To replace the bulbs proceed as follows:
❒open the tailgate;
❒remove the cover A-fig. 31work-
ing in the point shown by the arrow;
❒remove the bulb holder unit by press-
ing the retaining tabs B-fig. 32;
❒remove and replace the burnt-out
bulb by pressing it slightly and turn-
ing it counterclockwise fig. 33:
C: reversing light bulb on passenger
side or right side;
C: rear fog light bulb on driver side or
left side;
❒refit the bulb holder unit securing it
properly using the retaining tabs B-
fig. 32;
❒close cover A-fig. 31.
A0E0294mfig. 33
❒remove and replace the burnt-out
bulb by pressing it slightly and turn-
ing it counterclockwise fig. 33:
D: taillight bulb on right/left headlight
❒refit the bulb holder unit securing it
properly using the retaining tabs B-
fig. 32;
❒close cover A-fig. 31.

288
ALFA 159 SPORTWAGON
Direction indicators/
Taillights/Brake lights
To replace the bulbs proceed as follows:
❒open the tailgate;
❒on certain versions, open the side lid;
❒remove the protection cover by op-
erating device A-fig. 34;
❒remove the bulb holder unit by press-
ing the retaining tabs B-fig. 35;
A0E0296mfig. 35A0E0297mfig. 36
A0E0298mfig. 37
❒remove and replace the burnt-out
bulb by pressing it slightly and turn-
ing it counterclockwise fig. 36:
E: taillight/brake light bulb;
F: direction indicator bulb
❒refit the bulb holder unit securing it
properly using the retaining tabs B-
fig. 35;
❒refit the protection cover.
A0E0295mfig. 34
ADDITIONAL BRAKE LIGHT
(THIRD STOP)
The additional brake light is made up of
LEDs and it is built into the rear spoiler
fig. 37.
Contact Alfa Romeo Authorized Services
to have the third brake light replaced.