ECU Alfa Romeo 159 2009 Owner handbook (in English)

88
SAFETY
DEVICES
WARNING
LIGHTS AND
MESSAGES
IN AN
EMERGENCY
CAR
MAINTENANCE
TECHNICAL
SPECIFICATIONS
INDEX
CORRECT USE
OF THE CAR
DASHBOARD
AND
CONTROLS
ODDMENTS COMPARTMENTS
(where provided) fig. 84
They are located on the central console
between the front seats.
SUN VISORS
These are positioned to the sides of the
rear-view mirror. They can swing to the
sides and up or down.
On certain versions, sun visors are fitted
on the back with a courtesy mirror and
a light which enables to use the mirror
also with poor sunlight.
A0E0154mfig. 84A0E0102mfig. 85
To use the mirror open cover A-fig.
85.
Mirror lights will turn on automatically
when lifting the cover and they will turn
off when lowering it or few minutes af-
ter removing the electronic key from the
ignition device.
SUN VISORS
(where provided)
Certain versions are provided with sun-
visors behind the rear seats.
To use it, take the tab A-fig. 82, pull it
forwards and secure it to the hooks set on
the top of the car roof (see fig. 83).
A0E0197mfig. 82
A0E0198mfig. 83
083-128 Alfa 159 GB 4-06-2008 9:40 Pagina 88

104
SAFETY
DEVICES
WARNING
LIGHTS AND
MESSAGES
IN AN
EMERGENCY
CAR
MAINTENANCE
TECHNICAL
SPECIFICATIONS
INDEX
CORRECT USE
OF THE CAR
DASHBOARD
AND
CONTROLS
ANCHORING THE LOAD
The boot houses 4 hooks A-fig. 97
for anchoring ropes in order to guaran-
tee perfect load anchoring.
A0E0131mfig. 97
A heavy load that has
not been secured may
cause serious harm.
WARNING
If you want to carry
reserve fuel in a can,
follow law regulations, only
using a certified can, suitably
fastened to the load securing
eyelets. Even in this way the
risk of fire is increased in the
case of an accident.
WARNINGTO RETURN THE REAR SEAT
BACK TO ITS ORIGINAL
POSITION
Move aside the seat belts, check that
they are not twisted.
Raise the seat backrests and push them
back until hearing the locking click of
both retainers; the “red band” Baside
the levers Ashall no longer be visible.
The “red band” Bactually indicates that
the backrest is not properly secured.
IMPORTANTMake sure the head re-
straints are properly positioned.
Make sure the backrest
is properly secured at
both sides (“red bands” B-
fig. 96 not visible) to prevent
it moves forward in the event
of sharp braking causing in-
juries to passengers.
WARNING
083-128 Alfa 159 GB 4-06-2008 9:40 Pagina 104

131
WARNING
LIGHTS AND
MESSAGES
IN AN
EMERGENCY
CAR
MAINTENANCE
TECHNICAL
SPECIFICATIONS
INDEX
CORRECT USE
OF THE CAR
DASHBOARD
AND
CONTROLS
SAFETY
DEVICES
IMPORTANT On certain versions, cor-
rect backrest fastening is guaranteed
when the “red band” A-fig. 3aside
leversBis no longer visible. The “red
band” actually indicates that the back-
rest is not properly secured.
IMPORTANTAfter putting the seats
back to their travelling position, restore
the seat belt position to make them
ready for use.
Make sure the backrest
is properly secured at
both sides (red band A-fig. 3
not visible) to prevent it moves
forward in the event of sharp
braking causing injuries to pas-
sengers.
WARNING
Remember that in the
event of a violent colli-
sion, back seat passengers not
wearing seat belts also repre-
sent a serious danger for the
front seat passengers.
WARNING
A0E0085mfig. 3
S.B.R. SYSTEM
(Seat Belt Reminder)
The car is fitted with the S.B.R. system
(Seat Belt Reminder), consisting of a
buzzer which, together with the turning
on of warning light
<, warns the driver
and the front passenger to fasten the
seat belt.
The buzzer can be muted temporarily by
the following procedure:
❒fasten the front seat belts;
❒fit the electronic key into the ignition de-
vice;
❒wait for over 20 seconds but less than
1 minute and then unfasten one of the
front seat belts.
This procedure will stand valid till next en-
gine switching off.
For permanent deactivation, contact Alfa
Romeo Authorized Services. The S.B.R.
system can only be reset through the set-
up menu (see paragraph “Reconfigurable
multifunction display“ in section “Dash-
board and controls”).
129-148 Alfa 159 GB 4-06-2008 9:41 Pagina 131

185
SAFETY
DEVICES
WARNING
LIGHTS AND
MESSAGES
CAR
MAINTENANCE
TECHNICAL
SPECIFICATIONS
INDEX
CORRECT USE
OF THE CAR
DASHBOARD
AND
CONTROLS
IN AN
EMERGENCY
Please note:
❒the jack weight is 1.76 kg;
❒the jack requires no adjustment;
❒the jack cannot be repaired. If it
breaks it must be replaced with a
new jack;
❒no tool other than its cranking device
may be fitted on the jack.To change a wheel proceed as follows:
❒Stop the car in a position that is not
dangerous for oncoming traffic where
you can change the wheel safely. The
ground should be flat and adequate-
ly firm;
❒Turn the engine off, pull up the hand-
brake and engage first gear or re-
verse;
❒Using handle A-fig. 2, lift the stiff
coverBand secure it as shown in
fig. 3;
Never tamper with the
inflation valve. Never
place tools between the rim
and tyre. Check and restore, if
required, the pressure of tyres
and spare wheel to the values
given in section “Technical
Specifications”.
WARNING
A0E0132mfig. 2A0E0133mfig. 3
181-222 Alfa 159 GB 4-06-2008 9:43 Pagina 185

199
SAFETY
DEVICES
WARNING
LIGHTS AND
MESSAGES
CAR
MAINTENANCE
TECHNICAL
SPECIFICATIONS
INDEX
CORRECT USE
OF THE CAR
DASHBOARD
AND
CONTROLS
IN AN
EMERGENCY
Main beam headlights
(halogen bulbs)
On some versions a special brake ser-
vo vacuum unit is fitted which has to be
removed in order to be able to replace
the left main beam headlamp halogen
bulb. The vacuum unit is located next to
the battery drip tray (fig. 25).
IF AN EXTERIOR
LIGHT BURNS OUT
For the type of bulb and power rating,
see “When needing to change a bulb”.
FRONT LIGHT UNITS
The front light units contain main beam,
sidelights, direction indicator and dipped
beam bulbs.
To change the bulbs, turn cap counter-
clockwise and then remove it.
The bulbs are arranged inside the light
unitfig. 25/aas follows:
AMain beam headlights
BSidelights/direction indicators
CDipped beam headlights
After replacement, re-
fit the covers correctly
checking that they are proper-
ly secured.
WARNING
On versions with a brake servo vacuum
unit, the description is given purely as
an example; this operation must be car-
ried out by Alfa Romeo Authorized Ser-
vices.
To change the bulb, proceed as follows:
❒remove cover A-fig. 25/aby turn-
ing it counter-clockwise;
❒disconnect the electric connectorA-
fig. 26;
❒release the bulb holder catch B;It should be remem-
bered that the vacuum
unit operates at high tempera-
tures: avoid touching it with
your hands, danger of scalding!
Any operations not carried out
following the rules could ad-
versely affect the operation of
the braking system and there-
fore the safety of the vehicle.
WARNING
A0E0191mfig. 25/aA0E0540mfig. 25
181-222 Alfa 159 GB 4-06-2008 9:43 Pagina 199

203
SAFETY
DEVICES
WARNING
LIGHTS AND
MESSAGES
CAR
MAINTENANCE
TECHNICAL
SPECIFICATIONS
INDEX
CORRECT USE
OF THE CAR
DASHBOARD
AND
CONTROLS
IN AN
EMERGENCY
❒remove and replace the burnt-out
bulb by pressing it slightly and turn-
ing it counterclockwise fig. 35:
D:reversing light bulb on passenger
side (or right side);
D:reversing light bulb on driver side (or
left side)
❒refit the bulb holder unit securing it
properly using the retaining tabs C-
fig. 34;
❒close lidB-fig. 33.
A0E0167mfig. 35A0E0170mfig. 37
Taillight bulb on tailgate
To replace the bulbs proceed as follows:
❒open the tailgate;
❒turn deviceA-fig. 33 to open lid
B;
❒lower the lid and remove the bulb
holder unit by pressing the retaining
tabsC-fig. 34;
A0E0229mfig. 36
❒remove and replace the burnt-out
bulb by pressing it slightly and turn-
ing it counterclockwisefig. 36:
D: taillight bulb on right/left headlight
❒refit the bulb holder unit securing it
properly using the retaining tabs C-
fig. 34;
❒close lidB-fig. 33.
181-222 Alfa 159 GB 4-06-2008 9:43 Pagina 203

204
SAFETY
DEVICES
WARNING
LIGHTS AND
MESSAGES
CAR
MAINTENANCE
TECHNICAL
SPECIFICATIONS
INDEX
CORRECT USE
OF THE CAR
DASHBOARD
AND
CONTROLS
IN AN
EMERGENCY
Direction indicators/
Taillights/Brake lights
To replace the bulbs proceed as follows:
❒open the tailgate;
❒loosen screw A-fig. 37and remove
the protection cover B;
❒remove the bulb holder unit C-
fig. 38by pressing the retaining
tabsD.
A0E0040mfig. 38
❒remove and replace the burnt-out
bulb by pressing it slightly and turn-
ing it counter-clockwisefig. 39:
Etaillight/brake light bulb;
Fdirection indicator bulb.
❒refit the bulb holder unit securing it
properly using the retaining tabs D-
fig. 38;
❒refit the protection cover B-fig. 37
and tighten screw A.Number plate light
To replace the bulbs proceed as follows:
❒operate with a flat blade screwdriver pro-
tected by a soft cloth on device A-fig.
40to remove the light unit B;
❒remove the bulb holderC-fig. 41by
turning it slightly and replace the snap-
fitted bulb D.
A0E0041mfig. 39A0E0168mfig. 40
181-222 Alfa 159 GB 4-06-2008 9:43 Pagina 204

250
SAFETY
DEVICES
WARNING
LIGHTS AND
MESSAGES
IN AN
EMERGENCY
CAR
MAINTENANCE
INDEX
CORRECT USE
OF THE CAR
DASHBOARD
AND
CONTROLS
TECHNICALSPECIFICATIONS
IDENTIFICATION LABEL
This is to be found in the engine com-
partment, aside the upper right shock-
absorber connection and it bears the fol-
lowing identification data:
A.Space for details of national ho-
mologation
B.Space for punching the consecutive
chassis number
IDENTIFICATION
DATA
You are advised to note the identifica-
tion codes. The identification data
stamped and given on the plates and
their position are the following fig. 1:
1- Identification label
2- Body label
3- Bodywork paint identification label
4- Engine label.C.Space available for maximum
weights authorised by various national
regulations
D.Space for version and any supple-
mentary indications to those specified
E.Space for smoke coefficient (diesel
versions only)
F.Space for punching the Manufactur-
er’s name.
A0A0045mfig. 1A0E0013mfig. 2
249-270 Alfa 159 GB 4-06-2008 9:44 Pagina 250

To return the rear seat back
to its original position
Raise the seat backrests and push them
back until hearing the locking click of
both retainers.
Position seat belt buckles upwards.
IMPORTANTWhen the backrest is
properly secured, the “red band” B-
fig. 6on levers Ashall no longer be
visible. The “red band” actually indicates
that the backrest is not properly secured.
Make sure the head restraints are prop-
erly positioned.
Make sure the backrest is properly se-
cured at both sides (red bands not visi-
ble) to prevent it moves forward in the
event of sharp braking causing injuries
to passengers.
279
ALFA 159 SPORTWAGON
ANCHORING THE LOAD
The boot houses 4 hooks (see fig. 8
andfig. 9) for anchoring ropes in or-
der to guarantee perfect load anchoring.
Hooks shall also be used to secure the
luggage retaining net (available as op-
tional, for versions/markets where ap-
plicable, at Alfa Romeo Authorised Ser-
vices).
A0E0270mfig. 8A0E0271mfig. 9
If you want to carry
reserve fuel in a can,
follow law regulations, only
using a certified can, suitably
fastened to the load securing
eyelets. Even in this way the
risk of fire is increased in the
case of an accident.
WARNING
A heavy load that has
not been secured may
cause serious harm.
WARNING
271-292 Alfa 159 GB 4-06-2008 9:45 Pagina 279

LUGGAGE NET
(optional for versions/
markets where applicable)
The left and right sides of the boot are
quipped with a luggage retainer net.
–fig. 13- version with side lid
(where provided)
–fig. 14- version without side lid
–fig. 15- fixing elastic.
As optional, for versions/markets where
applicable, an additional luggage re-
tainer net can be fitted.
Use the seats A-fig. 16located in the
front part of the boot to hook the net as
shown in fig. 19.
281
ALFA 159 SPORTWAGON
A0E0281mfig. 13A0E0282mfig. 14
A0E0275mfig. 16
A0E0476mfig. 15
Using seats B-fig. 17to secure the net
to the rear side of the boot.
To secure the net, fit hooks A-fig. 18
into seats Band press downwards.
To release the net, take it out upwards
while keeping button Cpressed.
271-292 Alfa 159 GB 4-06-2008 9:45 Pagina 281