battery Alfa Romeo 166 2007 Owner handbook (in English)

4
ACCESSORY ELECTRICAL DEVICES
If after purchasing the car you wish to install accessories that need an electrical supply (with the risk of gradually draining
the battery), contact Alfa Romeo Authorised Services who will assess the overall electrical absorption and check whether the
car system is able to withstand the load required.

CODE CARD
Keep it in a safe place, not in the car. It is advisable to always keep the electronic code on the CODE card with you in case
emergency starting is necessary.
SCHEDULED SERVICING
Correct maintenance makes it possible to preserve vehicle peformance levels and safety, respect for the environment and
low running costs unaltered over the course of time.
THE OWNER HANDBOOK...
…you will find important information, advice and warnings for correct use, driving safety and vehicle maintenance over
time. Pay particular attention to the symbols
"(personal safety) #(protecting the environment) â(vehicle safety).
RESPECTING THE ENVIRONMENT
The vehicle is fitted with a system that allows continuous diagnosis of the components correlated with emissions to ensure
better respect for the environment.

6 SYMBOLS
Special coloured labels have been attached near to or actually
on some of the components making up your Alfa 166.
These labels bear symbols that remind you of the precautions to
be taken as regards that particular component.
A list of the symbols to be found on your Alfa 166is
given below, with the name of the component to which it relates
at the side of it.
These symbols are divided into the following four categories:
danger, prohibition, warning and obligation.
DANGER SYMBOLS
Battery
Explosion.
Fan
May cut in automatically when the engine is off.
Expansion tank
Do not remove the cap when the coolant is boil-
ing.
Battery
Corrosive fluid.
Coil
High voltage.

WARNING SYMBOLS
Power steering
Do not exceed the maximum fluid level in the
reservoir. Use only the recommended fluid; see
table “Specifications of fluids and lubricants”.
Brake circuit
Do not exceed the maximum fluid level in the
reservoir. Use only the recommended fluid; see
table “Specifications of fluids and lubricants”. Catalytic converter
Do not park over inflammable materials. See para-
graph “Protecting emission reducing devices”. Belts and pulleys
Moving parts; keep limbs and clothing away.
Jack
See the owner Handbook.
Climate control tubing
Do not open.
Gas under high pressure.
PROHIBITION SYMBOLS
Battery
Keep away from children. Battery
Keep away from naked flames.
Heat shields - belts - pulleys - fan
Do not touch.
AIRBAG
Passenger’s Air bag
Do not install a child’s seat on the front passen-
ger’s seat with operational air bag.
7

OBLIGATION SYMBOLS
DIESEL
Diesel vehicle
Use only diesel fuel.
Battery
Protect your eyes.
Battery - Jack
See the Owner Handbook.
Expansion tank
Use only the recommended fluid; see table “Speci-
fications of fluids and lubricants”.
Windscreen wiper
Use only the recommended fluid; see table
“Specifications of fluids and lubricants”.
Engine
Use only the recommended lubricant; see table
“Specifications of fluids and lubricants”.
Unleaded petrol vehicle
Use only unleaded petrol with RON 95.
8

18
To insert the metallic insert in the key
grip, keep button (B-fig. 6) pressed
and turn the insert on the direction of the
arrow until it clicks into place, then re-
lease the button (B).
To open/close the doors by remote con-
trol, press button (C). On cars fitted with
electronic alarm system, pressing button
(C) also turns the electronic alarm on/off
and the led (D) (where required) flashes
while the transmitter sends the code to
the receiver. This rolling code changes at
each transmission.
IMPORTANTIf led (D) (where re-
quired) flashes only once briefly when
button (C) is pressed, the battery need
changing as described below.Opening the boot
The boot can be opened by remote
control from outside pressing button (E-
fig. 6), also when the electronic alarm
(where fitted) is on.
In this case the alarm disengages the
boot control sensor, the system (with the
exception of versions for certain markets)
sounds two beeps and the direction indi-
cators light up for about three seconds.
When the boot is closed again the con-
trol function is restored, the system (with
the exception of versions for certain mar-
kets) sounds two beeps and the direction
indicators light up for about three sec-
onds.
When button (B) is pres-
sed, take the utmost care
to prevent the metal insert from
causing injury or damage when it
comes out. Button (B) must only be
pressed when the key is away
from the body, in particular the
eyes, and from objects that could
be spoilt (e.g. clothes).
Never leave the key unattended to
prevent anyone, especially chil-
dren, from holding it and pressing
button (B) inadvertently.
WARNING

19
KEY BATTERY CHANGE
If pressing the remote control buttons
(AorB-fig. 7), the led (C-fig. 7)
(where required) gives only one brief
flash and the alarm system led (where
fitted) (A-fig. 8) on the dashboard s-
tays on glowing steadily for about 2 min-
utes (after turning off the alarm and with
the ignition switch off), it is necessary to
replace the battery with a new one of the
equivalent type to be found c/o normal
retailers.
To replace the battery, remove the plas-
tic lid (A-fig. 9), insert the new battery
according to the correct polarity and put
the lid back on.For further information contact Autho-
rised Alfa Romeo Services.
OPERATION
Each time the ignition key is turned to
theSTOPposition, the Alfa Romeo
CODE system deactivates the functions of
the engine electronic control unit.Each time the engine is started, turning
the key to the MARposition, the control
unit of the Alfa Romeo CODE system
sends a recognition code to the engine
control unit to deactivate the inhibition of
the functions.
The recognition code, which is crypted
and variable between over 4 billion com-
binations, is only sent if the system con-
trol unit has recognised the code sent to
it by the key, which contains an electronic
transmitter, through an aerial in the igni-
tion switch. Dead batteries consti-
tute a hazard for the
environment and must
be disposed of in the special con-
tainers as specified by the rela-
tive laws.
fig. 7
1011PGSm
fig. 9
1034PGSm
fig. 8
305PGSm

22 ELECTRONIC ALARM
(optional for versions/markets where
applicable)
DESCRIPTION
The system certified in accordance with
EC Directive 95/56 comprises: transmit-
ter , receiver, control unit with siren and
volumetric sensors. The electronic alarm
is controlled by the receiver and it is
turned on and off through the remote
control incorporated in the key which
sends the crypted, variable code. The
electronic alarm monitors: unlawful open-
ing of the doors, bonnet and boot
(perimetral protection), operation of the
ignition key, battery and emergency key
cable cutting, the presence of moving
bodies in the passenger compartment
(volumetric protection) and operates the
central door locking system. Is also
makes it possible to cut off volumetric
protection and/or the siren.
IMPORTANTThe engine inhibitor
function is guaranteed by the Alfa Romeo
CODE system which is activated automati-
cally when the ignition key is removed
from the lock.
REMOTE CONTROL (fig. 11)
The remote control is incorporated in the
key and it is fitted with a button (A) and
a led (B); the button activates the con-
trol, the led flashes while the transmitter
sends the code to the receiver. This code
(rolling code) changes at each transmis-
sion.
IMPORTANTIf, when pressing the
push-button (A), the led (B) issues just a
short flash, replace the batteries as
shown in the previous paragraph.Request for additional remote
controls
The receiver can recognise up to 5 re-
mote controls.
If during the life of the car a new re-
mote control is needed for any reason
whatsoever, contact Alfa Romeo Autho-
rized services directly, taking with you the
CODE card, a personal identity document
and the car’s possession documents.
fig. 11
1013PGSm

24
3 flashes: right rear door
4 flashes: left rear door
5 flashes: volumetric sensors
6 flashes: bonnet
7 flashes: boot
8 flashes: tampering with car starting
cables
9 flashes: tampering with battery cables
or cutting emergency key cables
10 flashes: at least three causes of alarm.WHEN THE ALARM IS
TRIGGERED
When the alarm is engaged it will sound
when:
– One of the doors, the bonnet or the
boot is opened.
– The battery is disconnected or the
electric cables are cut, or the emergency
key cables are cut.
– Intrusion into the passenger compart-
ment, e.g. window being broken (volu-
metric protection).
– Attempt to start the engine (key at
MAR).
Depending on the markets, the trigger-
ing of the alarm will activate the siren
and the hazard warning lights (for about
26 seconds). The methods of operation
and the number of cycles may vary de-
pending on the versions/markets. How-
ever a maximum number of cycles is fore-
seen. Once the alarm cycle has come to
an end the system will return to its nor-
mal monitoring state.
SWITCHING OFF THE ALARM
To switch off the alarm, press the re-
mote control button on the key. If the
alarm does not turn off due to a flat re-
mote control battery or system fault,
open the door after unlocking with the
lock key, then place the key in the igni-
tion switch and turn it to MAR.
To turn on the alarm again, turn the key
toSTOPand remove it, then press the
remote control button after leaving the
car and shutting the doors. If the alarm
does not turn on and the led on the re-
mote control gives only one brief flash
while the led on the dashboard stays on
glowing steadily for about 2 minutes, the
key battery should be replaced by a new
one of the equivalent type on sale c/o
normal retailers. To change the battery
follow the instructions given at paragraph
“Key battery change” on previous pages.
If it is not possible to switch on the
alarm with a new remote control battery,
contact Alfa Romeo Authorised Services
to have the system checked.

25
IMPORTANTIf the car is to remain i-
nactive for a prolonged length of time
(over three weeks) and security condi-
tions permitting, it is advisable to operate
central locking turning the key in the door
lock to avoid engaging the alarm and
draining the battery.VOLUMETRIC PROTECTION
To guarantee correct operation, all the
windows and the sunroof (optional for
versions/markets where applicable)
should be closed. This function can be ex-
cluded (for example when leaving ani-
mals on-board the vehicle) by performing
the following operations in quick succes-
sion: when the ignition key is at the
MARposition, move the key to the
STOPposition and then return the key
to the MARand then once again to the
STOPposition. Remove the ignition key.
The led in the vehicle will come on for
about 2 seconds to confirm that the func-
tion has been excluded.
To restore volumetric protection move
the ignition key to the MARposition
and hold it in this position for more than
30 seconds.
If requiring to activate an electric control
operated by the ignition key at MAR
(e.g. electric windows) with the volumet-
ric protection deactivated, turn the igni-
tion key to MAR, operate the control
and return the key to STOPwithin a
maximum time of 30 seconds. This way
volumetric protection is not restored.
CUTTING OUT OPERATION OF
THE SIREN
(optional for versions/markets where
applicable)
When requiring to dispense with the
siren acoustic signalling in the alarm con-
dition, simply keep the remote control
button (A-fig. 13) pressed for 4 sec-
onds when engaging the system.
This condition is shown by a series of 5
beeps in quick succession after the nor-
mal acoustic/visual signals when the sys-
tem is operated.
The next time the system is activated,
normal operation of the siren is restored
automatically.
fig. 13
1014PGSm

30
–From inside: with the doors closed,
press the button (A-fig. 20) on the
centre console or one of the knobs
(B-fig. 19) on the front doors to en-
gage (lock) central locking.
By pressing the knob (A-fig. 21) on
one of the rear doors only that particular
door will be locked.
To unlock central locking press the button
again (A-fig. 20).
IMPORTANT For the front doors it is
not possible to keep the knob (B-
fig. 19) down if the door has not been
shut properly.
IMPORTANT If the power supply is
interrupted (burnt fuse, battery discon-
nected etc.) each door can be opened
manually from both inside and outside
the vehicle.
IMPORTANT The centralized locking
system can be deactivated, thus unlock-
ing all doors, by lifting the door opening
lever on one of the two front doors.CHILD SAFETY LOCK (fig. 22)
The rear doors are equipped with a spe-
cial device which prevents the door being
opened from inside.
The device can be engaged when the
door is open by acting on the relative con-
trol using the ignition key.
Position1= Device inactive
Position2= Device engaged.
This device should be used when chil-
dren are in the back seat to prevent them
from opening the door whilst the car is
moving.IMPORTANT Do not overlook child
safety; the following recommendations
should be heeded:
– Engage the child safety device.
– Do not leave a child alone in the vehi-
cle.
– Follow the current laws regarding
child restraint and safety systems.
After activating the safety
device check that it is
working correctly by pulling on the
inner lever used to open the door.
WARNING
fig. 22
1006PGSm