engine overheat Alfa Romeo 4C 2020 Owner handbook (in English)
[x] Cancel search | Manufacturer: ALFA ROMEO, Model Year: 2020, Model line: 4C, Model: Alfa Romeo 4C 2020Pages: 156, PDF Size: 3.06 MB
Page 44 of 156

KNOWING THE INSTRUMENT PANEL TOOLS
42
Warning lights on panelMeaningWhat to do
HOT ENGINE COOLANT
The digital warning light switches on when the key is
turned to MAR-ON, but it should switch off after a few
seconds. The warning light turns on when the engine is
overheated.
The associated message appears on the display.
ALTERNATOR FAULT
The digital warning light comes one with the engine
running only when an alternator fault is detected.Contact a dedicated
Alfa Romeo Dealership as soon as possible.
In normal driving conditions: stop the car, switch off the
engine and check that the water level in the reservoir is
not below the MIN mark. In this case, wait for the engine
to cool down, then slowly and carefully open the cap, top
up with coolant and check that the level is between the
MIN and MAX marks on the reservoir itself. Also check
visually for any fluid leaks.
Should the warning light turn on again at the next
start-up, contact a dedicated Alfa Romeo Dealership.
If the car is used under demanding conditions
(e.g. in high-performance driving): slow down and, if the
warning light stays on, stop the car.
Wait for 2 or 3 minutes with the engine running and
slightly accelerated to further favour the coolant
circulation. Then stop the engine.
Check that the coolant level is correct as described
above.
IMPORTANT On particularly demanding journeys, it is
advisable to keep the engine on and slightly accelerated
for a few minutes before switching it off.
Page 45 of 156

43
Warning lights on panelMeaningWhat to do
TCT FAULT
The digital warning light switches on when the key is
turned to MAR-ON, but it should switch off after a few
seconds.
The digital warning light flashes (together with a message
in the display and an acoustic signal) to indicate that the
TCT is faulty.
The warning light or symbol switches on in the case of
transmission overheating, after a particularly demanding
use; engine performance is limited in this case.
DOOR OPEN
(where provided)
The digital warning light on the display switches on when
one or more doors are not properly shut. A buzzer will
sound when doors/tailgate are open and the car is moving.
BRAKE PAD WEAR
(where provided)
The digital warning light switches on when the front or
rear brake pads show signs of wear.
The associated message appears on the display.Replace the pad as soon as possible.
ALFA ROMEO CODE SYSTEM FAULT
(where provided)
The digital warning light (or symbol on the display) will
come on (on some versions, with a message on the
display) to indicate an Alfa Romeo CODE system or alarm
fault.Contact a dedicated
Alfa Romeo Dealership as soon as possible.
Contact a dedicated
Alfa Romeo Dealership as soon as possible.
If you need to start the engine in presence of a faulty
gearbox, follow the procedure shown in the
“TCT twin clutch transmission”, paragraph in the “Starting
the engine” section, “Starting and driving” chapter.
Page 48 of 156

KNOWING THE INSTRUMENT PANEL TOOLS
46
Warning lights on panelMeaningWhat to do
GENERIC FAILURE INDICATION
(where provided)
The symbol appears on the display together with the
events shown below.
Engine oil pressure sensor
The symbol appears when a failure is detected in the
engine oil pressure sensor. The display shows the
dedicated message.In this case, go to a dedicated
Alfa Romeo Dealership as soon as possible to have the
fault corrected.
Clutch overheating message
The
symbol, together with a message on the display,
lights up to indicate clutch overheating.
If you continue driving, the symbol
will disappear and
the warning light will come on (on some versions
together with a message on the display) to indicate a
gearbox fault.
If the symbol comes on together with a message on
the display, limit the gear shifting and/or change the
condition of use, until normal operating conditions are
restored.
If the warning light lights up (a message will appear on
the display, on some versions) stop immediately, operate
the handbrake, switch off the engine and wait 5 minutes:
after this, normal transmission operating conditions will
be restored.
Should the transmission failure condition persist, contact
the dedicated Alfa Romeo Dealership.
FUEL CUT-OFF SYSTEM
The symbol and the corresponding message are shown on
the display in the following cases:
❒ fuel cut-off system intervention:
the yellow symbol lights up;
❒ fuel cut-off system failure:
the red symbol lights up.For reactivating the fuel cut-off system, refer to the
description in the
“Fuel cut-off system” section in the “In an emergency”
chapter. If it is not possible to restore the fuel supply,
contact a dedicated Alfa Romeo Dealership.
s è
Page 76 of 156

STARTING AND DRIVING
74
The car always starts in neutral. When
1st gear is requested, the system forces
the selection of AUTO mode.
IMPORTANT If 10 seconds elapse with
the ignition key in the MAR position and
the display does not show the gear
engaged, turn the key to the STOP
position, wait for the display to go out
and then repeat the manoeuvre.
If the fault persists, contact a dedicated
Alfa Romeo Dealership.
ACOUSTIC SIGNAL
For safety reasons, there is a buzzer
warning when parking the car with the
gearbox in neutral (N) (the warning is
heard when the ignition key is turned to
the STOP position).
With the vehicle stationary, the engine
started and (1st) or (R) engaged, the
system activates the buzzer and
automatically put the gearbox in neutral
(N) when:
❒ the accelerator and/or the brake
pedal are not operated for at least 3
minutes;
❒ the brake pedal is pressed for longer
than 10 minutes;❒ the driver’s door is opened and the
accelerator pedal or the brake pedal are
not operated for at least 1.5 seconds;
❒ a fault is detected in the gearbox.
PARKING THE CAR
When parking and leaving the car,
proceed as follows:
❒ engage the gear (on a slope, engage
first gear if the vehicle is facing uphill or
reverse if it is facing downhill) and leave
the wheels steered;
❒ stop the engine and engage the
handbrake.
Block the wheels with a wedge or a stone
if the car is parked on a steep slope.
Wait until the indication of the gear
engaged disappears on the display
before releasing the brake pedal.
IMPORTANT: NEVER leave the car with
the transmission in neutral.
IMPORTANT NOTES
❒ With car stationary and gear engaged,
always keep the brake pedal pressed
until you decide to set off, then release
the brake and accelerate gradually.
❒ During prolonged stops with the
engine running, it is advisable to keep the
gearbox in neutral (N).❒ In order to safeguard the efficiency of
the clutch, do not use the accelerator to
keep the car stationary (e.g. when
stopped on an incline). Clutch overheating
could damage it:
use the brake pedal instead or the
handbrake and only press the accelerator
pedal when you wish to set off.
❒ If, with reverse gear (R) engaged, you
have to engage 1st gear or vice versa,
only do this when the car is completely
stationary and with the brake pedal
pressed.
❒ Although it is strongly discouraged, if
you are going downhill and for unknown
reasons you let the car move forward
with the gearbox in neutral (N), when
there is a request to engage a gear the
system will automatically engage the
best gear in relation to the speed of the
actual to allow the correct transmission
of the drive torque to the wheels;.