technical specifications Alfa Romeo Giulietta 2010 Owner handbook (in English)

122
GETTING
TO KNOW
YOUR CAR
SAFETY
STARTING
AND DRIVING
IN AN
EMERGENCY
SERVICING AND
MAINTENANCE
TECHNICAL
SPECIFICATIONS
CONTENTS
CAR RADIO SET-UP
(for versions/markets, where provided)
If no car radio was requested at the time of purchase, the vehicle
is provided with a compartment on the dashboard fig. 86.
The radio set-up is composed of:
❍car radio power supply cables, front and rear loudspeakers and
an aerial;
❍radio compartment;
❍aerial on the roof.
fig. 86A0K0134m
Fit the car radio in the compartment A-fig. 86 which can be reached
by pressing the two tabs B located in the compartment itself: the
power wires are located in the compartment.
When connecting a car radio to the radio wiring
contact Alfa Romeo Authorized Services to prevent
any faults from occurring that might compromise
the safety of your car.
001-130 Alfa Giulietta EN 5ed 26-07-2010 16:34 Pagina 122

123
GETTING
TO KNOW
YOUR CAR
SAFETY
STARTING
AND DRIVING
IN AN
EMERGENCY
SERVICING AND
MAINTENANCE
TECHNICAL
SPECIFICATIONS
CONTENTS
INSTALLING ELECTRICAL/
ELECTRONIC DEVICES
Electric and electronic devices installed after buying the car in the
context of after-sales service must carry the following label:
eCE.
Fiat Group Automobiles S.p.A. authorises the installation of trans-
ceiving devices provided that they are installed by a specialised cen-
tre according to rules of good engineering practice in compliance
with the manufacturer’s instructions.
IMPORTANT Traffic police may not allow the car on the road if de-
vices have been fitted which modify the features of the car. This
may also invalidate the warranty if faults occur that are either di-
rectly or indirectly related to the installation of these devices.
Fiat Group Automobiles S.p.A. shall not be liable for damage caused
by the installation of accessories either not supplied or recommended
by Fiat Group Automobiles S.p.A. and/or not installed in compli-
ance with the provided instructions.
PORTABLE NAVIGATION SYSTEM
SETUP
(for versions/markets, where provided)
On cars equipped with theBlue&Me™system, a setup for in-
stalling aBlue&Me™TomTom
®portable navigation system may
be provided (optional). The system is available from Lineacces-
sori Alfa Romeo.
Install the navigation system by inserting the specific support brack-
et into the housing shown in fig. 87.
fig. 87A0K0143m
001-130 Alfa Giulietta EN 5ed 26-07-2010 16:34 Pagina 123

124
GETTING
TO KNOW
YOUR CAR
SAFETY
STARTING
AND DRIVING
IN AN
EMERGENCY
SERVICING AND
MAINTENANCE
TECHNICAL
SPECIFICATIONS
CONTENTS
RADIO TRANSMITTERS AND CELLULAR PHONES
Radio transmitting equipment (vehicle mobile phones, CB radios,
amateur radio etc.) shall not be used inside the car unless a sep-
arate aerial is mounted on the roof.
IMPORTANT The use of these devices inside the passenger com-
partment (without a separate aerial) may cause the vehicle elec-
trical systems to malfunction. This could compromise safety in ad-
dition to constituting a potential hazard for passengers’ health.
In addition, transmission and reception of these devices may be af-
fected by the shielding effect of the car body. As far as the use of
EC-approved mobile phones is concerned (GSM, GPRS, UMTS), fol-
low the instructions for use provided by the mobile phone manu-
facturer.
PARKING SENSORS
(for versions/markets, where provided)
The parking sensors are located on the rear bumper fig. 88 and
their function is to inform the driver, through an intermittent beep-
ing, of the presence of obstacles behind the car.
TURNING THE SENSORS ON
The sensors are turned on when reverse gear is engaged. As the
distance from the obstacle behind the car decreases, the beeping
becomes more frequent.
fig. 88A0K0060m
001-130 Alfa Giulietta EN 5ed 26-07-2010 16:34 Pagina 124

125
GETTING
TO KNOW
YOUR CAR
SAFETY
STARTING
AND DRIVING
IN AN
EMERGENCY
SERVICING AND
MAINTENANCE
TECHNICAL
SPECIFICATIONS
CONTENTS
DISPLAY INDICATIONS
(for versions/markets, where provided)
When the sensor is activated, the "Reconfigurable multifunctional
display" (for versions/markets where provided) shows the screen
illustrated in fig. 88a; the information about the presence of and
distance from the obstacle is given by the buzzer and also by a
visual indication on the instrument panel display. If there are se-
veral obstacles, the closest one is indicated.
BUZZER WARNINGS
When reverse gear is engaged a buzzer warning is automatically
activated if there is an obstacle within the range of operation.
The acoustic signal:
❍increases as the distance between the car and the obstacle de-
creases;
❍becomes continuous when the distance between the car and
the obstacle is less that 30 cm and stops immediately if the
distance increases;
❍remains constant if the distance between the vehicle and the
obstacle remains unchanged, whilst if this situation occurs for
the side sensors, the signal is interrupted after about 3 seconds,
for example, to prevent signals in the case of manoeuvres along-
side walls.
IMPORTANT The volume of the audible signal can be adjusted th-
rough the option "Warnings volume" of the "Set-Up menu".
OPERATION WITH TRAILER
Parking sensor operation is automatically turned off when the trail-
er electric cable plug is fitted into the car tow hook socket. The sen-
sors are automatically enabled again when the trailer cable plug
is removed.
The sensor must be free of mud, dirt, snow or ice
in order for the system to work. Be careful not to
scratch or damage the sensors while cleaning them.
Avoid using dry, rough or hard cloths. The sensors should
be washed using clean water with the addition of car sham-
poo if necessary. In washing stations, clean sensors quick-
ly keeping the vapour jet/high pressure washing noz-
zles at a distance of at least 10 cm from the sensors.
fig. 88aA0K0059m
001-130 Alfa Giulietta EN 5ed 26-07-2010 16:34 Pagina 125

126
GETTING
TO KNOW
YOUR CAR
SAFETY
STARTING
AND DRIVING
IN AN
EMERGENCY
SERVICING AND
MAINTENANCE
TECHNICAL
SPECIFICATIONS
CONTENTS
GENERAL WARNINGS
During parking manoeuvres, pay the utmost attention to any ob-
stacles that could be located above or below the sensors.
Sometimes, objects located close to the rear part of the car may
not be detected by the system and may damage the car or become
damaged themselves.
The ultimate responsibility when parking and car-
rying out other dangerous manoeuvres still rests
with the driver. When carrying out such manoeu-
vres, always ensure that the manoeuvring area is free
of people (particularly children) and animals. Parking sen-
sors are designed to assist drivers; however, you must al-
ways concentrate fully during potentially dangerous ma-
noeuvres, even if carried out at low speeds.
Here below are some conditions that may influence the perfor-
mance of the parking system:
❍Reduced sensor sensitivity and a reduction in the parking as-
sistance system performance could be due to the presence on
the surface of the sensor of: ice, snow, mud, thick paint.
❍the sensor may detect a non-existent obstacle (echo noise) due
to mechanical noises, for example when washing the vehicle,
in case of rain, strong wind, hail.
❍the signals sent by the sensors can also be altered by the pres-
ence of ultrasound devices (e.g. pneumatic brake systems or
pneumatic drills) near the car;
❍sensor performance can also be influenced by the position of
the sensors. For example by a change in the ride setting (caused
by the wear of the shock absorbers, suspension), overloading
the car and carrying out specific tuning operations that require
thecartobelowered;
❍the detection of obstacles at the top part of the vehicle may
not be guaranteed because the system detects obstacles that
could cause an impact with the vehicle in the bottom part.
For repainting the bumpers or retouching the paint-
work around the sensors contact Alfa Romeo
Authorized Services. Incorrect application of paint
may compromise the operation of the parking sensors.
001-130 Alfa Giulietta EN 5ed 26-07-2010 16:34 Pagina 126

127
GETTING
TO KNOW
YOUR CAR
SAFETY
STARTING
AND DRIVING
IN AN
EMERGENCY
SERVICING AND
MAINTENANCE
TECHNICAL
SPECIFICATIONS
CONTENTS
REFUELLING THE CAR
Switch off the engine before refuelling.
PETROL ENGINES
Only use unleaded petrol. The petrol octane rating (RON) must not
be lower than 95.
In order to prevent damage to the catalytic converter never intro-
duce even the smallest amount of leaded petrol, even in the event
of an emergency.
DIESEL ENGINES
Only use diesel fuel compliant with European specification EN590.
The use of other products or mixtures may damage the engine
beyond repair and consequently invalidate the warranty, depend-
ing on the damage caused.
Operation at low temperatures
If the outside temperature is very low, the diesel thickens due to
the formation of paraffin clots with consequent defective operation
of the fuel supply system.
In order to avoid these problems, different types of diesel are dis-
tributed according to the season: summer type, winter type and
arctic type (cold, mountain areas). If refuelling with diesel fuel
whose features are not suitable for the temperature of use, it is ad-
visable to mix TUTELA DIESEL ART additive with the fuel, in the pro-
portions shown on the container. Pour the additive into the tank
before the fuel.
When parking or storing the car for a long time in the mountains
or cold areas, it is advisable to refuel using locally available fuel.
In this case, it is also advisable to keep the tank over 50% full.
001-130 Alfa Giulietta EN 5ed 26-07-2010 16:34 Pagina 127

128
GETTING
TO KNOW
YOUR CAR
SAFETY
STARTING
AND DRIVING
IN AN
EMERGENCY
SERVICING AND
MAINTENANCE
TECHNICAL
SPECIFICATIONS
CONTENTS
fig. 89A0K0115mfig. 90A0K0222m
FUEL FILLER CAP
The fuel cap is unlocked when the central locking system is released
and automatically locked when the central locking system is ap-
plied.
To open
Press the flap A-fig. 89 to release it and reach the fuel filler cap
B. Then press the cap B and turn it anticlockwise.
The cap has a loss prevention device C which secures it to the flap
so that it cannot be lost. Attach the cap to device D during refu-
elling.
How to open the flap in an emergency
In case of emergency, pull the cord A-fig. 90 on the right-hand side
of the boot to open the fuel flap.
Closing
Release the cap B from the device D and insert it in its housing.
Tighten the cap in a clockwise direction until one or more clicks are
heard. Finally, close the flap A and check that is it correctly locked.
The hermetic seal may cause a slight increase in pressure in the
tank. A suction noise when you release the cap is therefore entirely
normal.
Do not place naked flames or lit cigarettes near
to the fuel filler: fire risk. Keep your face away
from the fuel tank opening to avoid breathing in
harmful vapours.
001-130 Alfa Giulietta EN 5ed 26-07-2010 16:34 Pagina 128

129
GETTING
TO KNOW
YOUR CAR
SAFETY
STARTING
AND DRIVING
IN AN
EMERGENCY
SERVICING AND
MAINTENANCE
TECHNICAL
SPECIFICATIONS
CONTENTS
The catalytic converter and particulate filter (DPF)
reach very high temperatures during operation.
Do not park the vehicle on grass, dry leaves, pine
needles or other flammable material: fire hazard.
PROTECTING THE ENVIRONMENT
The devices for reducing petrol engine emissions are the following:
catalytic converter, lambda sensors and anti-evaporation system.
The following devices are used for reducing diesel fuel engine emis-
sions: oxidising catalytic converter, exhaust gas recirculation (EGR)
and particulate filter (DPF).
DIESEL PARTICULATE FILTER (DPF)
(for versions/markets, where provided)
This is a mechanical filter, fitted in the exhaust system, which al-
most completely eliminates carbon particle emissions.
001-130 Alfa Giulietta EN 5ed 26-07-2010 16:34 Pagina 129

131
GETTING
TO KNOW
YOUR CAR
SAFETY
STARTING
AND DRIVING
IN AN
EMERGENCY
SERVICING AND
MAINTENANCE
TECHNICAL
SPECIFICATIONS
CONTENTS
fig. 93A0K0161mfig. 92A0K0160m
Never press button C-fig. 92 when travelling.
The rear seat is fitted with inertia seat belts with three anchor points
and a reel. Fasten the rear seat belts as shown in fig. 93
SAFETY
SEAT BELTS
USING THE SEAT BELTS
Wear the belt keeping the chest straight and rested against the back-
rest. To fasten the seat belts, hold tongue A-fig. 92 and insert it
into buckle B, until the locking click is heard.
If the seatbelt jams when pulling it out, let it rewind for a short
stretch and then pull it out again without jerking.
To unfasten the seat belts, press button C. Guide the seat belt
with your hand while it is rewinding, to prevent it from twisting.
131-150 Alfa Giulietta EN 4ed 27-04-2010 11:15 Pagina 131

132
GETTING
TO KNOW
YOUR CAR
SAFETY
STARTING
AND DRIVING
IN AN
EMERGENCY
SERVICING AND
MAINTENANCE
TECHNICAL
SPECIFICATIONS
CONTENTS
Remember that, in the event of a violent collision,
backseat passengers not wearing seat belts rep-
resent a serious danger to the front-seat passen-
gers as well as to themselves.
IMPORTANT The backrest is correctly secured when the “red band”
B-fig. 94 in the backrest lowering levers A disappears. This red band
indicates that the backrest is not secured. IMPORTANT When putting the back seats back to their normal po-
sition, make sure the seat belts are positioned so they are ready
to use. Make sure the backrest is properly secured on both
sides (red bands B-fig. 94 not visible) to prevent it
from moving forward in the event of sharp brak-
ing, which may cause injuries to passengers.
fig. 94A0K0110m
131-150 Alfa Giulietta EN 4ed 27-04-2010 11:15 Pagina 132