lock AUDI A4 1999 B5 / 1.G Generator Workshop Manual
Page 1 of 14
27-26
Generator, removing and
installing
CAUTION!
Disconnect the battery Ground (GND) strap
before working on the electrical system.
Notes:
Before disconnecting the battery, determine the
correct coding for the anti-theft radio.
Once the battery is reconnected, check and
activate the vehicle's electrical equipment
(radio, clock, comfort and convenience
features, etc.) as described in this Repair
Manual or the Owners Manual.
Pa
ge 1 of 14 Generator, removin
g and installin
g
11/20/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.EE01.27.2
Page 6 of 14
27-31
Repair Manual, Body Exterior, Repair Group 63
Repair Manual, Body Exterior, Repair Group 50 - Remove noise insulation panel (arrows).
- Remove front bumper.
- Move lock carrier to service position.- Remove cover for engine and ribbed belt.
- Rotate tensioner for ribbed belt toward right using box wrench until
both holes are in alignment (lower arrows), and secure in place using
3204 drift.
- Remove ribbed belt from generator pulley.
Pa
ge 6 of 14 Generator, removin
g and installin
g
11/20/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.EE01.27.2
Page 9 of 14
27-34
- Disconnect air duct from generator fitting -3-.
- Disconnect wire on terminal 30/B + by removing nut -2-.
Tightening torque: 16 Nm (12 ft lb)
- Disconnect wire on terminal D+ by removing nut -1-.
Tightening torque: 4 Nm (35 in. lb)
CAUTION!
When removing the generator, be careful not to damage the
refrigerant lines. - Remove socket head bolt -1- and lock nut -2-.
Tightening torque: 45 Nm (33 ft lb)
- Loosen bolt -3-.
Tightening torque: 22 Nm (16 ft lb)
- Remove generator -4- from below.
Pa
ge 9 of 14 Generator, removin
g and installin
g
11/20/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.EE01.27.2