AUDI S4 1996 B5 / 1.G 01E Transmission Final Drive Flange Seals Workshop Manual

39-1


Drive flange seal, replacing

Special tools, testers and auxiliary items
required:

Arbor VW 195

Extractor lever VW 681
Pa
ge 1 of 3 Drive flan
ge seal, re
placin
g
11/19/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.TM03.39.1

39-2


Removing
Note:
Drip tray V.A.G 1306 Transmission installed Illustrated, removing and installing oil seal on left-hand side. Procedure for removing oil seal on left and right-hand sides is
identical.
- Remove heat shield.
- Disconnect drive axle.
- Place a drip tray underneath.
- Remove drive flange, secure with a drift to prevent it turning.

- Pull seal out with lever VW 681.
Pa
ge 2 of 3 Drive flan
ge seal, re
placin
g
11/19/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.TM03.39.1

39-3

Installing

- Fill space between sealing and dust lips with
sealing grease G52 128 A1.

- Lightly oil outer circumference of seal.

Tightening torques 1) 90 equals to a quarter turn - Drive in seal for drive flange.

Pressing-in depth (factory): 5.5 mm
Pressing-in depth when re-installing a used drive flange (repairs):
6.5 mm
- Install drive flange and drive axle.
Component
Nm
Drive flange to transmission
10 + 90
1)
Drive axle to drive flange M10 80
Heat shield for drive axle 25
Pa
ge 3 of 3 Drive flan
ge seal, re
placin
g
11/19/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.TM03.39.1