CADILLAC FLEETWOOD 1996 2.G Owners Manual

Downloaded from www.Manualslib.com manuals search engine Mirrors
Electrochromic Mirror
Your Cadillac has an automatic inside rearview mirror.
During the day
it works like a regular mirror, but at
night it adjusts for the glare of headlamps behind you.
The
mirror delays before switching from day to night
mode.
This change may take a few seconds. This delay
prevents rapid changing of the mirror as you drive under
lights and through traffic.
On/Off Switch
Press the switch located at the base of the mirror to turn
on the auto-dimming feature. Press it
again to turn off.
Reverse Gear Day Mode
When the shift lever is placed in REVERSE (R), the
mirror changes to the daytime mode for a bright image
in the mirror as you back up.
Front Reading Lamps
There are two reading lamps located on the rearview
mirror.
Press the switch next to the lamp that you want
to turn on
or off.

Downloaded from www.Manualslib.com manuals search engine .. . ,

Downloaded from www.Manualslib.com manuals search engine

Downloaded from www.Manualslib.com manuals search engine

Downloaded from www.Manualslib.com manuals search engine Ashtrays and Cigarette Lighter
To remove the rront center ashtray for cleaning, lift it
out by pulling on the snuffer. If it won’t come out, reach
under the drawer and push up on the ashtray bowl and
remove it
.
The rear ashtrays are located on the door armrests. To
remove the ashtrays for cleaning, lift the cover and pull
up on the snuffer.
To reinstall, push down firmly.
NOTICE:
Don’t put papers or other flammable things into
your
ashtrays. Hot cigarettes or other smoking
materials could ignite them, causing damage.
Lighters are near the ashtrays. To use a lighter, push it in
all the way. When it’s ready, it will pop back out by itself.
NOTICE:
If you hold a cigarette lighter in with your hand
while it
is heating, it won’t be able to back away
from the heating element when
it’s ready. That
can make
it overheat, damaging the lighter and
the heating element.
2-46

Downloaded from www.Manualslib.com manuals search engine Sun Visors
Visor Vanity Mirror
Turn the sunshade down and lift the cover to see the
mirror. Move the switch up
or down to brighten or dim
the lamps.
Rear Visor Vanity Mirrors
(Fleetwood Brougham)
If your vehicle is equipped with an astroroof, it does not
have these mirrors. Pull a mirror down. Move the switch
up or down to brighten or dim the lamps.
Floor Mats
Your Cadillac is equipped with rubber-backed front and
rear floor mats. Keep floor mats vacuumed and use a
spot cleaner,
if necessary. Do not maclune wash.

Downloaded from www.Manualslib.com manuals search engine Universal Transmitter (Option)
I€ you have this option, you have a safety glass panel
and a sunshade.
You can slide your sunshade open or
closed with the handle. When your ignition is in
RUN,
move the switch toward the rear of the car to open the
roof. To close it, move the switch toward the fiont
of
your car. Once the roof is clo-sed, you can let go of the
switch and then
push the front of it again. This opens the
roof at the rear to a vent position. You can operate the
Astroroof
for up to 10 minutes after the ignition is
turned off or until any door is opened.
This transmitter allows you to consolidate the functions of
up to three individual hand-held transmitters. It will
operate garage doors and gates, or with the accessory
package, other devices controlled by radio frequency such as home/office lighting systems
and security systems.
The transmitter will leam and .transmit the frequencies
of most current transmitters and
is powered by your
vehicle’s battery and charging system.
2-48

Downloaded from www.Manualslib.com manuals search engine This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) Th~s device may not cause harmful interference, and
(2) This device must accept any interference received,
including interference that may cause undesired operation.
Programming the Transmitter
Do not use the transmitter with any garage door opener
that does not have the “stop and reverse’’ safety feature.
This includes any garage door opener model
manufactured before April
1, 1982.
Be sure that people and objects are clear of the garage
door
you are programming!
Your vehicle’s engine should be turned off while
programming your transmitter. Follow these steps to
program up to three channels:
1. If you have not previously programmed a channel,
proceed to Step
2. Otherwise, hold down the two
outside buttons on the transmitter until the red light
begins to flash rapidly (approximately
20 seconds).
Then release the buttons. This procedure initializes
the memory and erases any previous settings for all
three channels.
2. Hold the end of your hand-held transmitter against
the bottom surface
of the transmitter so that you can
still see the red light.
3. Decide which one of the three channels you want to
program. Using both hands, press the hand-held
transmitter button and the desired button on the
transmitter. Continue to hold both buttons through
Step
4.
4. Hold down both buttons until you see the red light
on the transmitter flash rapidly. The rapid flashing,
which could take up to
90 seconds, indicates that the
transmitter has been programmed. Release both
buttons once the light starts to flash rapidly.
If you have trouble programming the transmitter, make
sure that you have followed the directions exactly as
described and that the batteries in the hand-held
transmitter
are not dead. If you still cannot program it,
rotate your hand-held transmitter end over end and try
again. The transmitter may not work with older garage
door openers that do not meet current Federal Consumer
Safety Standards. If you cannot program the transmitter
after repeated attempts, consult your Cadillac dealer.
Be sure to keep your original hand-held transmitter in
case you need to erase and reprogram the transmitter.

Downloaded from www.Manualslib.com manuals search engine Note to Canadian Owners: During programming, your
hand-held transmitter may stop transmitting after one or
two seconds.
If you are programming from one of these
transmitters, the indicator light may prompt you to
re-activate your hand-held transmitter with a series of double blinks. After you re-activate your hand-held
transmitter, the light should flash rapidly. If it flashes
slowly, continue to periodically re-activate your
hand-held transmitter until the light flashes rapidly.
Operating the Transmitter
Press and hold the appropriate button on the Universal
transmitter. The red light comes on while the signal
is
being transmitted.
Note that the effective transmission range of the
transmitter may differ from your hand-held transmitter
and
from one channel to another.
Erasing Channels
To erase all three programmed channels, hold down the
two outside buttons until the red light begins to flash.
Individual channels cannot be erased, but can be
reprogrammed using the procedure for programming the
transmitter explained earlier.
Accessories
Accessories for your Universal Transmitter are available
from the manufacturer
of the unit. If you would like
additional information please call 1-800-355-3515.
2-50

Downloaded from www.Manualslib.com manuals search engine Instrument Panel
1. Side Vents
2. Main Lamp Control
3. Instrument Cluster
4. Center Vents
5. Comfort Controls
6. Glove Box
7. Ashtray and Cigarette Lighter
8. Audio System
9. Transmission Shift Lever
10. Horn
11. Multifanction Lever
2-51