radio controls CHEVROLET CAMARO 1967 1.G Chassis Workshop Manual

HEATER AND AIR CONDITIONING 1A-65

Fig.
92—Chevrolet Four-Season Ducts

Installation

Reverse

assembly.
the removal procedure to reinstall the duct

Left Outlet Duct

Removal

1.
Remove the two parking brake lever bracket to

dash brace attaching screws and move the lever and

cable so they will not interfere with the duct

removal.

2.
Remove the screw and lock washer attaching the duct

outer bracket to the hinge pillar support.

3.
Remove the screws and lock washers attaching the

duct assembly to the dash brace bracket.

4.
Carefully pull the outer end of the duct downward,

detaching the courtesy light from its bracket.

5. Loosen the screws clamping the outlet duct to dis-

tributor assembly flexible tubing at the outlet duct.

The outlet duct may now be removed from beneath

the instrument panel.

6. The duct extension assembly and the deflector as-

sembly may be removed, if desired, as seen in

Figure 95.

Installation

The duct assembly is installed by reversing the re-

moval instructions.

Center Outlet Duct

Removal

1.
Remove the right and left console trim panels.

2.
Remove the radio receiver.

3.
Remove the electric clock.
4.
Remove the knobs, nuts and bezels from the two

air conditioning controls above the clock, AIR COND.

PULL and COLD IN-HOT PULL.

5. Carefully pull the outlet duct and control cables

loose from the rear of the center console and work

it down and out from under the dash. The left hand

control cable runs through the left hand flexible

tubing and may be left in the tubing after it is dis-

engaged from the duct. The right hand control cable

must also be pulled from the duct assembly as the

duct is removed.

6. The center deflector barrel assembly may now be

removed if necessary. Snap off the hairpin clips to

remove the barrel and spacer washers.

Installation

Reverse the removal procedure for installation.

AIR DISTRIBUTOR ASSEMBLY

Removal

1.
Drain the cooling system radiator.

2.
Remove the heater hoses from the core pipes and

remove the cover attaching nuts and cover surround-

ing the core pipes.

3.
Remove the glove compartment assembly and the

glove compartment door.

NOTE:.
See "Section 1 - Body" for removal

and installation of body items.

4.
Remove the right kick pad.

5. Remove the right and left center console trim panels.

6. Remove the radio receiver assembly.

7. Remove the defroster duct.

CHEVROLET CHASSIS SERVICE MANUAL