engine CHEVROLET TRACKER 1996 Owners Manual
Page 342 of 387
I Long TripYHighway Maintenance Schedule I
52,500 Miles (87 500 km)
Change engine oil and filter (or every
7.5 months, whichever occurs first).
An Emission Control Service.
0 Rotate tires. See “Tire Inspection and
Rotation” in the Index for proper rotation
pattern and additional information. During tire rotation, check brake calipers for
freedom of movement. Refer to the
appropriate
GM service manual €or proper
caliper service procedures.
0 Inspect the locking front hubs (if equipped)
for correct operation (or every
3 months,
whichever occurs first). Repair or replace
if necessarv.
DATE ACTUAL MILEAGE SERVICED BY:
60,000 Miles (100 000 km)
0 Change engine oil and filter (or every
7.5 months, whichever occurs first).
An Emission Control Service.
0 Clean and repack the front wheel bearings
(or at each brake relining, whichever
occurs first).
0 Rotate tires. See “Tire Inspection and
Rotation”
in the Index for proper rotation
pattern and additional infomation.
During
tire rotation, check brake calipers for
freedom
of movement. Refer to the
appropriate
GM service manual for proper
caliper service procedures.
every
24 months, whichever occurs first).
An Emission Control Service.
0 Inspect engine accessory drive belts (or
(Continued)
7-39
ProCarManuals.com
Page 343 of 387
Long Trip/Highway Maintenance Schedule
60,000 Miles (100 000 km) (Continued)
0 Drain, flush and refill cooling system (or
every
30 months, whichever occurs first).
See “Engine Coolant”
in the Index for
what to use. Inspect hoses. Clean radiator,
condenser, pressure cap and neck. Pressure
test the cooling system and pressure cap.
An Emission Control Service.
0 Replace spark plugs.
An Emission Control Service.
Replace air cleaner filter.
An Emission Control Service.
Inspect fuel tank, cap and lines and any
hoses for damage. Replace fuel tank cap
gasket.
An Emission Control Service,
17 Change manual transmission fluid (or every
30 months, whichever occurs first).
0 Replace fuel filter (or every 30 months,
whichever occurs first).
An Emission Control Service.
17 Inspect the locking front hubs (if equipped)
for correct operation (or every
3 months,
whichever occurs first). Repair or replace
as necessary.
0 Inspect the valve lash and adjust if
necessary.
An Emission Control Service.
0 Check engine idle speed and adjust it to
underhood label specifications.
An Emission Control Service.?
7-40
ProCarManuals.com
Page 344 of 387
I Long Trip/Highway Maintenance Schedule I
Adjust engine timing to underhood label
specifications. Inspect the inside and
outside of the distributor cap and rotor for
cracks, carbon tracking and corrosion.
Clean or replace as needed.
An Emission Control Service. -t
0 Inspect emission system hoses and replace
as necessary.,
An Emission Control Service. -f
Inspect propeller shafts and u-joints for
looseness and damage (or every 15 months,
whichever occurs first). Inspect more
frequently
if used off-road or for pulling
a trailer. Tighten u-joint flange bolts
if necessary.
0 Inspect the underhood wiring harness for
loose connections, chafed wires and
damage (or every
60 months, whichever
occurs first).
An Emission Control Service.
0 Replace the camshaft timing belt.
0 Replace spark plug wires (or every
60 months, whichever occurs first).
An Emission Control Service.
An Emission Control Service.
0 Drain, refill and bleed the brake system.
DATE ACTUAL MILEAGE SERVICED BY
7-41
ProCarManuals.com
Page 345 of 387
67,500 Miles (112 500 km)
Change engine oil and filter (or every
7.5 months, whichever occurs first).
An Ernissiun Control Service.
c] Rotate tires. See “Tire Inspection and
Rotation’’ in the
Index for proper rotation
pattern and additional information. During
tire rotation, check brake calipers for
freedom of movement. Refer to the
appropriate
GM service manual for proper
caliper service procedures,
€2 Inspect the locking front hubs (if equipped)
for correct operation (or every
3 months,
whichever occurs first). Repair or replace
if necessarv.
I DATE 1 ACTUAL MILEAGE ISERVICED BY: I
75,000 Miles (125 000 km)
0 Change engine oil and filter (or every
7.5 months, whichever occurs first).
An Emission Control Service.
Rotate tires. See “Tire Inspection and
Rotation”
in the Index for proper rotation
pattern and additional information. During
tire rotation, check brake calipers for
freedom of movement. Refer to the
appropriate GM service
manual for proper
caliper service procedures.
17 Inspect the locking front hubs (if equipped)
for correct operation (or every 3 months,
whichever occurs first).
Repair or replace
if necessary.
Inspect the valve lash and adjust if
necessary.
An Emission Control Service.
7-42
ProCarManuals.com
Page 346 of 387
t -1
Long TriplHighway Maintenance Schedule
0 Check engine idle speed and adjust it to
underhood label specifications.
An Emission Control Service.?
Inspect propeller shafts and u-joints for
looseness and damage (or every 15 months,
whichever occurs first). Inspect more
frequently
if used off-road or for pulling
a trailer. Tighten u-joint flange bolts
if necessary.
82,500 Miles (137 500 km)
0 Change engine oil and filter (or every
7.5 months, whichever occurs first).
An Emission Control Service.
0 Rotate tires. See “Tire Inspection and
Rotation’’ in the Index for proper rotation
pattern and additional information. During
tire rotation,’ check brake calipers for
freedom of movement. Refer to the
appropriate GM service manual for proper
caliper service procedures.
0 Inspect the locking front hubs (if equipped)
for correct operation (or every
3 months,
whichever occurs first). Repair or replace
if necessarv.
DATE ACTUAL MILEAGE SERVICED BY:
7-43
ProCarManuals.com
Page 347 of 387
I Long Trip/Highway Maintenance Schedule
90,000 Miles (150 000 km)
0 Change engine oil and filter (or every
7.5 months, whichever occurs first).
An Emission Control Service.
0 Clean and repack the front wheel bearings
(or at each brake relining, whichever
occurs first).
0 Inspect engine accessory drive belts (or
every
24 months, whichever occurs first).
An Emission Control Service.
0 Inspect camshaft timing belt.
0 Drain, flush and refill cooling system (or
every
30 months, whichever occurs first).
See “Engine Coolant”
in the Index for
what to use. Inspect hoses. Clean radiator,
condenser, pressure cap and neck. Pressure
test the cooling system and pressure cap.
An Emission Control Service.
An
Emission Control Service.
Replace spark plugs.
An Emission Control Service.
0 Replace air cleaner filter.
An Emission Control Service.
0 Inspect fuel tank, cap and lines and any
hoses for damage. Replace fuel tank cap
gasket. An Emission Control Service.
CI Change manual transmission fluid (or every
30 months, whichever occurs first).
[7 Replace fuel filter (or every 30 months,
whichever occurs first).
An Emission Control Service.
0 Inspect the locking front hubs (if equipped)
for correct operation (or every 3 months,
whichever occurs first). Repair or replace
if necessary.
0 Inspect the valve lash and adjust if
necessary. An Emission Control Service.
7-44
ProCarManuals.com
Page 348 of 387
I Long Trip/Highway Maintenance Schedule 1
‘c1 Check engine idle speed and adjust it to
underhood label specifications.
An Emission Control Service.?
looseness and damage (or every 15 months,
whichever occurs
first). Inspect more frequently
if used off-road or for pulling a trailer. Tighten
u-joint flange bolts
if necessary.
Rotate tires. See “Tire Inspection and Rotation”
in the Index for proper rotation pattern and
additional mfoqation. During tire rotation,
check brake calipers for freedom
of movement.
Refer to the appropriate GM service manual for
proper caliper service procedures.
0 Inspect propeller shafts and u-joints for
..
DATE SERVICED BY: ACTUAL MILEAGE
97,500 Miles (1 62 500 k 1)
Change engine oil and filter (or every
7.5 months, whichever occurs first).
An Emission Control Service.
0 Rotate tires. See “Tire Inspection and
Rotation’’
in the Index for proper rotation
pattern and additional information. During
tire rotation, check brake
calipers for
freedom
of movement. Refer to the
appropriate GM service manual for proper
caliper service procedures.
0 Inspect the locking front hubs (if equipped)
for correct operation (or every
3 months,
whichever occurs first). Repair or replace
if necessarv.
7-45
ProCarManuals.com
Page 350 of 387
Part B: Owner Checks and Services
Listed below are owner checks and services which
should be performed at the intervals specified to help
ensure the safety, dependability and emission control
performance
of your vehicle.
Be sure any necessary repairs are completed at once.
Whenever any fluids
or lubricants are added to your
vehicle, make sure they are the proper ones, as shown
in Part
D.
At Each Fuel Fill
It is important for you or a service station attendant to
perform these underhood checks
at each fuel fill.
Engine Oil Level Check
Check the engine oil level and add the proper oil
if necessary. See “Engine Oil” in the Index for
further details.
Engine Coolant Level Check
Check the engine coolant level and add the proper
coolant mix if necessary. See “Engine Coolant” in the
Index for further details.
Windshield Washer Fluid Level Check
Check the windshield washer fluid level in the
windshield washer tank and add the proper fluid
if
necessary. See “Windshield Washer Fluid” in the
Index for further details.
Hood Latch Operation Check
Pull the primary hood latch release handle inside the
vehicle. The secondary latch should keep the hood from
opening all the way when the primary latch is released.
Make sure the hood closes firmly. See “Hood Release”
in the Index
for further details.
At Least Once a Month
Tire Inflation Check
Make sure tires are inflated to the correct pressures.
See “Tires” in the Index for further details.
Cassette Deck Service
Clean cassette deck. Cleaning should be done every
50 hours of tape play. See “Audio Systems” in the Index
for further details.
7-47
ProCarManuals.com
Page 352 of 387
Starter Switch Check Brake-Transmission Shift Interlock (BTSI) Check
(Automatic Transmission)
When
you are doing this check, the vehicle could
move suddenly. If it does, you or others could be
injured. Follow the steps below.
1. Before you start, be sure you have enough room
2. Firmly apply both the parking brake (see “Parking
Brake” in
the Index if necessary) and the regular brake.
NOTE:
Do not use the accelerator pedal, and be
ready to turn off the engine immediately
if it starts.
3. On automatic transmission vehicles, try to start the
engine in each gear. The starter should work only in
PARK
(P) or NEUTRAL (N). If the starter works in
any other position, your vehicle needs service.
On manual transmission vehicles, put the shift lever
in NEUTRAL (N), push the clutch down halfway
and try to
start the engine. The starter should work
only when the clutch
is pushed down all the way to
the floor.
If the starter works when the clutch isn’t
pushed all the way down, your vehicle needs service.
around the vehicle.
When you are doing this check,
the vehicle could
move suddenly.
If it does, you or others could be
injured. Follow the steps below.
I. Before you start, be sure you have enough room around
the vehicle. It should
be parked on a level surface
2. Firmly apply the parking brake (see “Parking Brake”
in the Index
if necessary).
NOTE: Be ready to apply the regular brake
immediately if the vehicle begins to move.
3. With the engine off, turn the key to the ON position,
but don’t start the engine. Without applying the
regular brake,
try to move the shift lever out of
PARK (P) with normal effort. If the shift lever moves
out of
PARK (P), your vehicle’s BTSI needs service.
7-49
ProCarManuals.com
Page 353 of 387
Steering Column Lock Check
While parked, and with the parking brake set, try to turn
the
key to LOCK in each shift lever position.
With an automatic transmission, the key should turn
to LOCK only when the shift lever is in PARK (P).
With a manual transmission, the key should turn to
LOCK only if you push the key in farther, while
turning it towards
LOCK.
On vehicles with a key release lever, try to turn the key
to LOCK without pressing the lever. The key should
turn to LOCK only when you press the key lever.
On all vehicles, the key should come out only in LOCK.
Parking Brake and Automatic Transmission
PARK (P) Mechanism Check
/d CAUTION:
When you are doing this check, your vehicle
could begin to
move. You or others could be
injured and property
could be damaged. Make
sure there
is room in front of your vehicle in case
it begins
to roll. Be ready to apply the regular
brake at once should the vehicle begin to move.
Park on a fairly steep hill, with the vehicle facing
downhill. Keeping your foot on the regular brake, set the
parking brake.
To check the parking brake: With the engine running
and transmission in NEUTRAL (N), slowly remove
foot pressure from the regular brake pedal.
Do this
until the vehicle is held by the parking brake only.
To check the PARK (P) mechanism’s holding ability:
Shift to
PARK (P). Then release all brakes. If your
vehicle is four-wheel
drive, be sure the transfer case
is not in NEUTRAL (N).
Underbody Flushing Service
At least every spring, use plain water to flush any
corrosive materials from the underbody. Take care to
clean thoroughly any areas where mud and other debris
can collect.
7-50
ProCarManuals.com