Citroen BERLINGO FIRST DAG RHD 2010 1.G Service Manual (123 Pages)

43SEATS-
To fold the rear bench seat:
- lower the head restraint,
- press control 1 to unlock the seat
back 2 ,
- fold the seat back 2 onto the seat,
- place the seat in the "folded" posi- tion. When repositioning:
- tilt the folded seat rearwards,
- lift the seat back,
- check that the seat is locked cor-
rectly.

Take care not to trap the seat belts.
REAR BENCH SEAT(5 SEAT VERSION)
HEAD RESTRAINT
This is of the "comma" type.
High position: press the two tabs at
the same time, lift the head restraint
and raise it.
Low position: push the two tabs at
the same time and press the top to
lower the head restraint.
To remove the head restraint: place
it in the high position, lift it then re-
move it.
Store it inside the vehicle, securing
it ﬁ rmly.
To install the head restraint: engage
the rods of the head restraint in the
holes keeping it in line with the seat
back.

SEATS44-
REAR BENCH SEATS (7 SEAT VERSION)
The bench seats of row 2 and row 3
are independent and adjustable.
Row 2 bench seat
Placing the bench seat in the
table position
- Lower the head restraints fully.
- Operate the control to fold the seat back onto the bench seat
cushion.
Returning the seat back to
the sitting position
- Return the seat back to its original position and check that it is se-
cured on the pillar of the vehicle. Placing the bench seat in the fully
folded position
- Place the seat in the table posi-
tion.
- Pull the handle, located behind the bench seat, to release the
feet from their anchorage on the
ﬂ oor.
- Tilt the bench seat forwards.
Returning the bench seat to its
original position
Before folding the bench seat,
ensure that:
- in row 3, no passenger's foot is at one of the bench seat anchorages
on the ﬂ oor,
- the seat belt is available for the side passenger.
- fold back the bench seat.

45SEATS-
Row 3 bench seat
Placing the seat back in the table
position
- Lower the head restraints fully.
- Operate the two controls simulta-neously to fold the seat back onto
the bench seat cushion.
Returning the seat back to the
sitting position
- Return the seat back to its original position and check that it is se-
cured on the pillars of the vehicle. Placing the bench seat in the fully
folded position
- Place the seat in the table position.
- Raise the handle, located behind
the bench seat, to release the
feet from their anchorage on the
ﬂ oor.
- Tilt the bench seat forwards.
Returning the bench seat to its
original position
- Before folding back the bench seat, ensure that the seat belt
is available for the side passen-
gers.
- Fold back the bench seat.
Access to row 3
From the vehicle's right-hand sliding
door, a passage next to the row 2
bench seat provides access to the
row 3 bench seat.
Good practice
Do not place hard or heavy
objects on the seat backs
forming a table, they could
become dangerous projectiles in the
event or sharp braking or impact.
Following the various operations:
- do not remove a head restraint without storing it, ﬁ x it to a sup-
port in the vehicle,
- do not block the passage to row 3,
- ensure that the passengers can always access the seat belts and
fasten them easily,
- a passenger must never take his seat without adjusting and fasten-
ing his seat belt.
- a passenger seated in row 3 must ensure that he does not obstruct
the row 2 bench seat anchoring
recesses.

SEATS46-
GENERAL POINTS RELATING TO CHILD SEATS
Although one of CITROËN's main
criteria when designing your vehicle,
the safety of your children also de-
pends on you.
For maximum safety, please follow
these precautions:
- all children under the age of 12
or less than one metre ﬁ fty tall
must travel in approved child
seats suited to their weight ,
on seats ﬁ tted with a seat belt or
ISOFIX mountings * .
- a child weighing less than 9 kg
must travel in the "rearwards-
facing" position in the front.
SEAT BELT
"Forwards-facing"
When a "forwards-facing" child seat
is installed on the front passenger
seat , adjust the vehicle's seat to the
intermediate longitudinal position
with the seat back upright and leave
the passenger air bag armed.
* The rules for transporting chil- dren are speciﬁ c to each country.
Consult the current legislation in
your country. Intermediate longitudinal
position
"Rearwards-facing"
When a "rearwards-facing" child seat
is installed on the
front passenger
seat , it is essential that the passen-
ger air bag * is disarmed. Otherwise,

the child would risk being seri-
ously injured or killed if the air bag
were to inﬂ ate .

47SEATS-
CHILD SEATS RECOMMENDED BY CITROËN
CITROËN offers a complete range of recommended child seats which are
secured using a three point seat belt :

Group 0: from birth to 10 kg
Group 0+: from birth to 13 kg

L1
"ROMER Baby-Safe Plus"
Installed in the rear-facing position.

Groups 1, 2 and 3: from 9 to 36 kg

L2
"KIDDY Life"
The use of the restraining cushion is compulsory for transporting young children (from 9 to 18 kg).

Groups 2 and 3: from 15 to 36 kg

L3
"RECARO Start''.
L4
"KLIPPAN Optima"
From the age of 6 years
(approximately 22 kg), the booster is used on its own.
Passenger airbag OFF

SEATS48-
INSTALLING CHILD SEATS SECURED USING THE SEAT BELT
In accordance with European regulations, this table indicates the options for the installation of child seats secured using the
seat belt and universally approved (a), in accordance with the w eight of the child and the seat in the vehicle:

Weight of the child and indicative age

Seat
Below 13 kg
(groups 0 (b) and 0+)
Up to 1 year approx
From 9 to 18 kg
(group 1)
From 1 to 3 years approx

From 15 to 25 kg
(group 2)
From 3 to 6 years approx

From 22 to 36 kg
(group 3)
From 6 to 10 years approx
Front passenger (c) U U U U

Row 2 Side
U U U U
Centre U U U U

Row 2 * Right
U U U U
Left U U U U
Row 3 * Side
U U U U
Centre U U U U

49SEATS-
"ISOFIX" MOUNTINGS
These are two rings located between
the seat back and the seat cushion.
This ISOFIX mounting system gua-
rantees reliable, safe and fast ﬁ tting
of the child seat in your vehicle.
The ISOFIX child seats are ﬁ tted
with two locks which are secured
easily on these rings.
Your vehicle has been approved in ac-
cordance with the ISOFIX
regulation .
The seats, represented below, are ﬁ t-
ted * with regulation ISOFIX mountings:
(a) Universal child seat: child seat
which can be installed in all ve-
hicles using the seat belt.
(b) Group 0: from birth to 10 kg.
(c) Consult the legislation in force in your country before installing
your child on this seat.

U Seat suitable for the installation of
a child seat secured using a seat
belt and universally approved,
"rear facing" and/or "forward
facing".
* Ludospace 7 seat version: mountings not available.

50-
ISOFIX CHILD SEAT RECOMMENDED BY CITROËN AND APPROVED FOR YOUR VEHICLE

Isoﬁ x KIDDY

Group 0+: from birth to 13 kg Group 1: from 9 to 18 kg
Installed in the rear facing position, on the rear side seat only. Installed in the forwards facin g position.
The body of this child seat must be in contact
with the back of the vehicle's front seat. It is imperative that the vehicle's front seat is adjusted
to the intermediate longitudinal position.
This child seat can also be used on
seats which are not ﬁ tted with ISOFIX
mountings. In this case, it is compulsory to secure
the child seat to the vehicle's seat
using the three-point seat belt.

Follow the instructions for ﬁ tting
the child seat indicated in the seat
manufacturer's installation guide.

Citroen BERLINGO FIRST DAG RHD 2010 1.G Service Manual

Page 41 of 123

Page 42 of 123

Page 43 of 123

Page 44 of 123

Page 45 of 123

Page 46 of 123

Page 47 of 123

Page 48 of 123

Page 49 of 123

Page 50 of 123

CITROEN Manuals