key Citroen C CROSSER 2009.5 1.G User Guide

Page 78 of 230

III
!
A C C E S S
76
Do not throw the remote control batteries away, they contain metals which are harmful to the environment.
Take them to an approved collection point.
Keys
Make a careful note of the number of each key. This number is coded on the label attached to the key.
If the keys are lost, a CITROËN dealer can supply you with ne w keys.
Remote control
The high frequency remote control is a sensitive system; do not o perate it while it is in your pocket as there is a possibility
that it may unlock the vehicle, without you being aware of it.
Do not repeatedly press the buttons of your remote control out of range and out of sight of your vehicle. You run the risk
of stopping it from working.
The remote control does not operate when the key is in the i gnition, even when the ignition is switched off.
Locking the vehicle
Driving with the doors locked may make access to the passenger compart ment by the emergency services more diffi cult
in an emergency.
As a safety precaution (with children on board), remove the key fro m the ignition when you leave the vehicle, even for a
short time.
Anti-theft protection
Do not make any modifi cations to the electronic engine immobi liser system, this could cause malfunctions.
When purchasing a second-hand vehicle
Have the key codes memorised by a CITROËN dealer, to ensure tha t the keys in your possession are the only ones which
can start the vehicle.

Page 79 of 230

III
A C C E S S
75
Starting the vehicle

 Insert the key in the ignition switch.

 Operate the starter by turning the
key to position 4 (START) .

 When the engine turns over, release
the key. The ignition switch is placed
in position 3 (ON) automatically.
Switching the vehicle off

 Park the vehicle.

 While pressing the key, turn it
towards you to position 1 (LOCK) .

 Remove the key from the ignition
switch. Changing the battery
Battery reference: CR1616/3 volts.

 Unclip the casing using a coin at the
notch.

 Slide the fl at battery out of its housing.

 Slide the new battery into its hous-
ing observing the original direction.

 Clip the casing.
Key in ignition
A buzzer sounds on opening the
driver's door, if the key has been left
in the ignition.

Page 81 of 230

III
!
A C C E S S
78
Disarming the passenger and rear
electric window switches Reinitialising the electric windows
Following reconnection of the battery or
after the safety auto-reverse has been
triggered three times in succession, you
must reinitialise the safety auto-reverse
function:


with the door closed, lower the window
completely then raise it again, it will rise
in steps of a few centimetres each time
the switch is pressed, repeat the op-
eration until the window is fully closed,

 continue to press the switch for at least
one second after reaching the window
closed position.
Always remove the key from the
ignition when leaving the vehi-
cle, even for a short time.
In the event of contact during opera-
tion of the windows, you must reverse
the movement of the window. To do
this, press the switch concerned.
When the driver operates the passen-
ger electric window switches, he must
ensure that no one is preventing cor-
rect closing of the windows.
The driver must ensure that the pas-
sengers use the electric windows
correctly.
Be aware of children when operating
the windows.

 For the safety of your children, press
switch 5 to prevent operation of the
passenger and rear electric windows
irrespective of their position.
When the button is pressed down,
disarming is active.
When the button is raised, disarming is
deactivated.
When the button is pressed down, you
can open or close all of the windows
using the switches on the driver's
door.
The safety auto-reverse function is
not active during these operations.

Page 82 of 230

III
A C C E S S
79
DOORS
From outside

 After unlocking the vehicle using the
remote control or the key, pull the
door handle. From inside

 Pull the front or rear door control to
open the door.
If the doors are locked, opening the
driver's door unlocks all of the doors.
The front passenger door or the rear
doors must fi rst be unlocked manually
using the locking control before being
opened.
Closing
If a door is not closed correctly,
this warning light comes on on
the instrument panel display
until the door concerned is
closed.
Manual centralised control
System which provides full manual
locking or unlocking of the doors and
tailgate from the inside.
Locking

 Press the front of button A to lock
the vehicle.
If the driver's door is open when
you operate the central locking from
inside, all of the doors lock with the
exception of the driver's door.
Unlocking

 Press the rear of button A to unlock
the vehicle.
Opening

Page 83 of 230

III
A C C E S S
80
Opening

 After unlocking the vehicle using the
remote control or the key, press the
handle A and raise the tailgate.
TAILGATE
Closing

 Pull the handle B downwards to
guide the tailgate,

 release the handle and press the
exterior surface of the tailgate gently
to close it.
Emergency control
System which locks or unlocks the
doors mechanically in the event of a
malfunction of the central locking.
Locking the driver's door

 Insert the key in the lock, then turn it
to the left.
Unlocking the driver's door

 Insert the key in the lock, then turn it
to the right. Unlocking the front and rear doors
(from inside)

 Tilt the interior control B rearwards.
Using the key
Locking the front passenger door
and the rear doors (from inside)

 Tilt the interior control B forwards.

Page 84 of 230

III
A C C E S S
80
Opening

 After unlocking the vehicle using the
remote control or the key, press the
handle A and raise the tailgate.
TAILGATE
Closing

 Pull the handle B downwards to
guide the tailgate,

 release the handle and press the
exterior surface of the tailgate gently
to close it.
Emergency control
System which locks or unlocks the
doors mechanically in the event of a
malfunction of the central locking.
Locking the driver's door

 Insert the key in the lock, then turn it
to the left.
Unlocking the driver's door

 Insert the key in the lock, then turn it
to the right. Unlocking the front and rear doors
(from inside)

 Tilt the interior control B rearwards.
Using the key
Locking the front passenger door
and the rear doors (from inside)

 Tilt the interior control B forwards.

Page 88 of 230

III
!
!
A C C E S S
83
SHUTTER
The shutter is manual, slide it.
It is stored automatically when the roof
is opened. Check that the sunroof is not
open in tilt mode before clos-
ing the shutter.
The shutter cannot be closed when
the sunroof is open in sliding
mode .
Always remove the key from the
ignition when leaving the vehicle,
even for a short time.
If the roof meets an obstacle during
operation, you must reverse the move-
ment of the roof. To do this, press the
control concerned.
When the driver operates the roof
control, he must ensure that no one
is preventing the roof from closing
correctly.
The driver must ensure that passen-
gers use the sunroof correctly.
Be aware of children when operating
the roof.

Page 89 of 230

III
!
!
A C C E S S
83
SHUTTER
The shutter is manual, slide it.
It is stored automatically when the roof
is opened. Check that the sunroof is not
open in tilt mode before clos-
ing the shutter.
The shutter cannot be closed when
the sunroof is open in sliding
mode .
Always remove the key from the
ignition when leaving the vehicle,
even for a short time.
If the roof meets an obstacle during
operation, you must reverse the move-
ment of the roof. To do this, press the
control concerned.
When the driver operates the roof
control, he must ensure that no one
is preventing the roof from closing
correctly.
The driver must ensure that passen-
gers use the sunroof correctly.
Be aware of children when operating
the roof.

Page 125 of 230

VII
D R I V I N G
118
"Normal" automatic mode
Select position D .

"D" appears on the instrument panel
display.
The gearbox then operates in automatic
mode, without any action on the part of
the driver.
To optimise driving comfort and obtain
the most suitable gear, avoid sharp vari-
ations in the pressure on the accelera-
tor pedal.
"Temporary" manual mode
In the automatic mode, you can resume
control temporarily at any time using
the steering wheel controls.
The use of these controls permits man-
ual selection of the gears in situations
which require a faster changedown than
that offered in automatic mode (arrival
at a roundabout, exit from a car park
with a steep gradient, overtaking...).
The gearbox engages the gear re-
quested if the engine speed permits it.
The gear engaged appears.
To return to the automatic mode, press
the back of the "+/OFF" control for at
least 2 seconds.
"Sport" automatic mode
From the automatic mode, you can en-
gage the "Sport" mode.
With the vehicle moving or stationary,
push the dial A forward.

"SPORT" appears on the instrument
panel display.
Switching off the "Sport" automatic
mode
You can return to the "Normal" auto-
matic mode at any time:
Push the dial A rearward once. Before switching off the engine, you
must engage position
P or N to place
the gearbox in neutral.
It is imperative that you apply the hand-
brake to immobilise the vehicle.
In order to remove the key from the igni-
tion, the gear lever must be in position P .
Stopping the vehicle
Stopping - Starting on a hill
To assist you when starting on a hill,
your vehicle is fi tted with a system
which immobilises it briefl y (approxi-
mately 2 seconds), the time required to
move your foot from the brake pedal to
the accelerator pedal. This function is
only active when the vehicle has been
completely immobilised with your foot
on the brake pedal and on certain gra-
dients.

Do not get out of the vehicle during
the hill start assistance temporary
immobilisation phase.
To immobilise the vehicle on a hill for a
longer period, you must use the hand-
brake, not the accelerator.
When starting on a hill, accelerate grad-
ually while releasing the handbrake.

Page 195 of 230

XI
A U D I O E Q U I P M E N T a n d T E L E M A T I C S
186
Press Explanations Result
Press the MENU button.
Press [Address/Junction]. Press [Country] and enter the name of the country using the to uch
keypad.
When a character of the name of the country is entered, if 5 countries
or fewer are recognised, you can select a country from a list which is
displayed or press [List].
You can select one of the 5 most recently selected countries by
pressing [Last 5] on the "Country" line.
Press [City] then [Keyword] and enter the name of the city usin g the touch
keypad.
When a character of the name of the city is entered, if 5 ci ties or fewer are
recognised, you can select a city from a list which is displayed or press
[List].
You can select a city using the post code.
Press [Post Code] and enter the number.
You can select one of the 5 most recently selected cities by
pressing [Last 5] on the "City" line.
Entering an address and activating guidance (1/2)

Page:   < prev 1-10 11-20 21-30 next >