Citroen C5 2009.5 (RD/TD) / 2.G Owner's Guide

Page 31 of 314

I
33
M O N I T O R I N G


Dynamic
stability control
(ESP/ASR) fl ashing. The ESP/ASR regulation is active.
The system optimises traction and
improves the directional stability of
the vehicle. fi xed, accompanied
by an audiblesignal and a
message on the
instrument panel screen.
Unless it has been deactivated with
the indicator lamp on the button on,
the ESP/ASR system is faulty. Have it checked by a CITROËN
dealer.

Engine
autodiagnosis system fi xed.
The emission control system has a
fault. This lamp should switch off when
the engine is started.
If it does not switch off, contact a
CITROËN dealer urgently.
fl ashing. The engine management system
has a fault. Risk of destruction of the catalytic
convertor.
Have it checked by a CITROËN dealer.

Warning lamp is on Cause Action/Observations

Page 32 of 314

I
34M O N I T O R I N G

Warning lamp is on Cause Action/Observations

Low fuel
level fi xed. When it fi rst comes on there
remains
approximately
5 litres of
fuel in the tank. You must refuel as soon as possible to
avoid running out of fuel.
This warning lamp wil come on every time
the ignition is switched on, until a suffi cient
addition of fuel is made.
Fuel tank capacity: 71 litres.
Never continue to drive until you run out
of fuel, this could damage the emission
control and injection systems.

Maximum
coolant
temperature fi xed red.
The temperature of the
cooling system is too high. Stop as soon as it is safe to do so.
Wait until the engine has cooled down
before topping up the level, if necessary.
If the problem persists, contact a
CITROËN dealer.

Battery
charge fi xed. The battery charging circuit
has a fault (dirty or loose
terminals, slack or cut
alternator belt, ...). This lamp should switch off when the
engine is started.
If it does not switch off, contact a
CITROËN dealer.
+
Seat belt not
fastened/
unfastened fi xed.
The driver and/or the front/
rear passenger has not
fastened or has unfastened
their seat belt. Pull the strap then insert the tongue in the
buckle.

Seat belts
not fastened/ unfastened fi xed, associated
with the seat belt not fastened/unfastened
warning lampl. The illuminated dots represent the not
fastened/unfastened passengers.
They come on:
- fi xed for 30 about seconds on starting
the vehicle,
- fi xed from 0 to 12 mph (0 to 20 km/h) when driving,
- fl ashing above 12 mph (20 km/h), accompanied by an audible signal for
about 120 seconds.

Page 33 of 314

I
35
M O N I T O R I N G
Service indicator
System which informs the driver
when the next service is due, in ac-
cordance with the manufacturer's
servicing schedule.
The point at which the service is due
is calculated from the last indicator
zero reset. It is determined by two
parameters:
- the distance travelled,
- the time elapsed since the last service.
More than 620 miles (1 000 km)
remain before the next service is due
For 5 seconds after the ignition is
switched on, the spanner symbol-
ising the service operations comes
on. The distance recorder display
line indicates the distance remaining
before the next service is due.

Example: 1 900 miles/km remain
before the next service is due.
For 5 seconds after the ignition is
switched on, the display indicates: 5 seconds after the ignition is switched
on,
the spanner is switched off ; the
distance recorder resumes its normal
operation. The display then indicates
the total and trip distances.
Less than 620 miles (1 000 km)
remain before the next service is due

Examples: 500 miles (900 km) re-
main before the next service is due.
For 5 seconds after the ignition is
switched on, the display indicates:
5 seconds after the ignition is
switched on, the distance recorder
resumes its normal operation. The
spanner remains on to indicate that
a service must be carried out soon. Service overdue
For 5 seconds after the ignition is
switched on,
the spanner fl ashes
to indicate that the service must be
carried out as soon as possible.

Example: the service is overdue by
300 miles/km.
For 5 seconds after the ignition is
switched on, the display indicates:
5 seconds after the ignition is
switched on, the distance recorder
resumes its normal operation. The
spanner remains lit .
The distance remaining may be
weighted by the time factor, depend-
ing on the driver's driving habits.
Therefore, the spanner may also
come on if you have exceeded the
two year service interval.

Page 34 of 314

I
36M O N I T O R I N G
Service indicator zero reset
After each service, the service indi-
cator must be reset to zero.
The procedure for resetting to zero
is as follows:

 switch off the ignition,

 press and hold the trip distance
recorder zero reset button,

 switch on the ignition; the dis-
tance recorder display begins a
countdown,

 when the display indicates "=0" ,
release the button; the spanner
disappears.
Following this operation, if you wish
to disconnect the battery, lock the
vehicle and wait at least fi ve minutes
for the zero reset to be taken into ac-
count. Engine oil level indicator
System which informs the driver
whether the engine oil level is cor-
rect or not.
This information is indicated for a
few seconds when the ignition is
switched on, after the service infor-
mation.
The level read will only be correct if
the vehicle is on level ground and
the engine has been off for more
than 15 minutes.
Oil level correct
Oil level low
This is indicated by displaying of the
message "Oil level incorrect".
If the low oil level is confi rmed by a
check using the dipstick, it is essential
that the level is topped up to prevent
damage to the engine. Oil level gauge fault
This is indicated by displaying of the
message "Oil level measurement in-
valid". Consult a CITROËN dealer.

Page 35 of 314

I
36M O N I T O R I N G
Service indicator zero reset
After each service, the service indi-
cator must be reset to zero.
The procedure for resetting to zero
is as follows:

 switch off the ignition,

 press and hold the trip distance
recorder zero reset button,

 switch on the ignition; the dis-
tance recorder display begins a
countdown,

 when the display indicates "=0" ,
release the button; the spanner
disappears.
Following this operation, if you wish
to disconnect the battery, lock the
vehicle and wait at least fi ve minutes
for the zero reset to be taken into ac-
count. Engine oil level indicator
System which informs the driver
whether the engine oil level is cor-
rect or not.
This information is indicated for a
few seconds when the ignition is
switched on, after the service infor-
mation.
The level read will only be correct if
the vehicle is on level ground and
the engine has been off for more
than 15 minutes.
Oil level correct
Oil level low
This is indicated by displaying of the
message "Oil level incorrect".
If the low oil level is confi rmed by a
check using the dipstick, it is essential
that the level is topped up to prevent
damage to the engine. Oil level gauge fault
This is indicated by displaying of the
message "Oil level measurement in-
valid". Consult a CITROËN dealer.

Page 36 of 314

I
37
M O N I T O R I N G
Engine oil temperature gauge
Under normal operating conditions,
the bars should be within section
1 .
In severe operating conditions, the
bars may extend into section 2 .
In this event, slow down, and if neces-
sary, stop the engine and check the
levels (see corresponding chapter). Coolant temperature
indicator
Under normal operating conditions,
the bars should be within section
1 .
In severe operating conditions, the
bars may extend into section 2 , the
engine coolant temperature warning
lamp A and the STOP warning lamp
will light up, stop immediately .
Switch off the ignition. The cooling
fan may continue to operate for a
certain time .
Consult a CITROËN dealer.
If the SERVICE warning lamp lights
up, check the levels (see correspond-
ing chapter). On horizontal ground, the lighting of
the fuel low warning lamp warns you
that you are at the reserve level.
A message alert is displayed on the
instrument panel.
Fuel gauge indicator

Page 37 of 314

I
38M O N I T O R I N G
Total distance recorder
System which measures the total
distance travelled by the vehicle
during its life.
The total and trip distances are dis-
played for thirty seconds when the
ignition is switched off, when the
driver's door is opened and when
the vehicle is locked or unlocked.
Trip distance recorder
System which measures a distance
travelled during a day or other pe-
riod since it was reset to zero by the
driver.

 With the ignition on, press the
button until zeros appear. Lighting rheostat
System for manual adjustment of
the brightness of the instruments
and controls in relation to the exte-
rior brightness.
Operation

 Press button A to decrease the
brightness of the instruments
and controls.

 Press button B to increase the
brightness of the instruments
and controls. Deactivation
When the lighting is off, or in day
mode on vehicles fi tted with daytime
running lamps, pressing the buttons
does not have any effect.

Page 38 of 314

II
39
M U L T I F U N C T I O N S C R E E N S
MONOCHROME SCREEN C Main Menu
Press on the button A to view the
Main Menu of the multifunction
screen. This menu gives you access
to the following functions:
Presentation
Radio-CD
(see "Audio and Telematics"
chapter)
Bluetooth ®
system
(see "Audio and Telematics"
chapter)
Controls

1. Time

2. Ambient temperature

3. Date and display zone
When the outside temperature is
between +3 °C and -3 °C, the tem-
perature display fl ashes (ice risk).
The ambient temperature displayed
may be greater than the actual tem-
perature, if the vehicle is parked in
bright sunlight.
It is recommended that the driver
should not operate the controls
while the vehicle is in motion. Personalisation -
Configuration
This permits activation/deactivation
of the:
- brightness and contrast of the multifunction screen,
- date and time,
- units of the outside temperature displayed.

A. Access to the "Main Menu"

B. Cancellation of the operation or
return to the previous display

C. Scrolling in the screen menus
Confi rmation at the steering wheel

D. Confi rmation on the audio equip-
ment control panel

Page 39 of 314

II
40
M U L T I F U N C T I O N S C R E E N S
Adjusting the brightness and
contrast

 Press on A .

 Use C to select the "Brightness -
video adjustment" menu. Confi rm
with a press on C on the steering
wheel or D on the audio equip-
ment.

 Select the confi guration of the
screen using C . Confi rm with a
press on C on the steering wheel
or D on the audio equipment.

 Select the brightness setting.
Confi rm with a press on C on the
steering wheel or D on the audio
equipment.

 Select the inverse or normal dis-
play mode using C then validate
with a press on C on the steering
wheel or D on the audio equip-
ment. To adjust the brightness
select "+" or "-" and save your
setting with a press on C .

 Confi rm with "OK" on the screen. Adjusting the date and the
time

 Press on A .

 Use C to select the "Date and
time adjustment" menu, then
confi rm your choice with a press
on C on the steering wheel or D
on the audio equipment.

 Select the screen confi guration
using C . Confi rm with a press on

C on the steering wheel or D on
the audio equipment.

 Select the date and the time set-
tings, using B . Confi rm with a
press on C on the steering wheel
or D on the audio equipment.

 Press C to select the values you
wish to modify. Confi rm your
choice with a press on C on the
steering wheel or D on the audio
equipment.

 Confi rm with "OK" on the screen. Choosing the units

 Press on A .

 Use C to select the "Choice of
units" menu, then confi rm your
choice with a press on C on the
steering wheel or D on the audio
equipment.

 Using C , select the unit then val-
idate with a press on C on the
steering wheel or D on the audio
equipment.

 Confi rm with "OK" on the screen.
Selection of the type of
information displayed (Mode)
Successive presses on the end of
the wiper stalk or on the MODE but-
ton on the audio equipment permit
selection of the type of informa-
tion presented on the multifunction
screen (date or radio, CD, MP3 CD,
CD changer).

Page 40 of 314

II
41
M U L T I F U N C T I O N S C R E E N S
16/9 COLOUR SCREEN (WITH MY WAY)
Displays on the screen
It displays the following information
automatically and directly:
- time,
- date,
- altitude,
- ambient temperature (the value displayed fl ashes if there is a risk
of ice),
- audio functions,
- satellite navigation system infor- mation. Controls
From the MyWay control panel, to
select one of the applications:

 press the dedicated "RADIO" ,

"MUSIC" , "NAV" , "TRAFFIC" ,

"SETUP" or "PHONE" button
for access to the corresponding
menu,

 turn the dial to move the selection,

 press the dial to confi rm the se-
lection,
or

 press the "ESC" button to aban-
don the current operation and re-
turn to the previous display.
* According to country. For more information on these
applications, refer to the "Audio
Equipment" section or to the spe-
cifi c user guide given to you with
the other owner's documents. "SETUP" menu

 Press the "SETUP" button to
gain access to the "SETUP"
menu. This allows you to select
from the following functions:
- "System language",
- "Date & time",
- "Display",
- "Units",
- "System".
System language
This menu allows you to select
the language used by the dis-
play: Deutsch, English, Espanol,
Français, Italiano, Nederlands,
Polski, Portugues, Türkçe * .

Page:   < prev 1-10 11-20 21-30 31-40 41-50 51-60 61-70 71-80 ... 320 next >