Citroen C5 2010.5 (RD/TD) / 2.G Owner's Manual

XI
!
179
P R A C T I C A L I N F O R M A T I O N
CHANGING A BULB Headlamps
Model with Xenon headlamps (D1S)

1. Sidelamps: W5W

2. Dual-function Xenon
headlamps (dipped/main): D1S

3. Cornering
lighting: HP19

4. Daytime running lamps: HP24
For the maintenance of the front
headlamp unit and the changing of
HP19, D1S and HP24 bulbs, contact
a CITROËN dealer.
Risk of electrocution
Xenon bulbs must be replaced by a
CITROËN dealer.
You are advised to change both
D1S bulbs at the same time, if one
of them has failed.
The headlamps are fi tted with
polycarbonate glass with a
protective coating:

 do not clean them using a dry
or abrasive cloth, nor with a
detergent or solvent product,

 use a sponge and soapy water,

 when using a high pressure
washer on persistent marks, do
not direct at the lamps or their
outlines for too long, so as not
to damage their protective coat-
ing and seals.

 Do not touch the bulb directly
with your fi ngers, use lint-free
cloths.
Changing a bulb should only be
done after the headlamp has been
switched off for a few minutes (risk
of serious burns).
It is imperative to use only anti-
ultraviolet (UV) type bulbs in order
not to damage the headlamp.
Always replace a failed bulb with a
new bulb with the same type and
specifi cation.

XI
180
P R A C T I C A L I N F O R M A T I O N
Main beams

 Remove the protective cap A .

 Disengage the retaining spring.

 Remove the bulb and replace it,
paying attention to the direction
of fi tting.

 Refi t the retaining spring.

 Refi t the protective cap A .
Model with halogen headlamps

1. Main beams: H1

2. Sidelamps: W5W

3. Dipped beams: H7

4. Directional lighting: H7

5. Daytime running lamps: HP24
For the maintenance of the front
headlamp unit and changing HP24
bulbs, contact a CITROËN dealer.
Sidelamps

 Remove the protective cap A .

 Pull the bulb holder to remove it.

 Replace the bulb and refi t the
bulb holder.

 Refi t the protective cap A .

XI
181
P R A C T I C A L I N F O R M A T I O N
Sidelamps

 Remove the protective cap A .

 Pull the bulb holder to remove it.

 Replace the bulb and refi t the
bulb holder.

 Refi t the protective cap A . Dipped beam

 Remove the protective cap B .

 Disconnect the connector by
pressing it between the thumb
and index fi nger.

 Free the bulb from its two metal
clamps.

 Take out the bulb.

 Replace the bulb, exerting a
slight axial force.

 Refi t the connector, until it is all
the way in.

 Refi t the protective cap B . Directional lamp

 Remove the protective cap C .

 Disconnect the connector by
pressing it between the thumb
and index fi nger.

 Free the bulb from its two metal
clamps.

 Take out the bulb.

 Replace the bulb, exerting a
slight axial force.

 Refi t the connector, until it is all
the way in.

 Refi t the protective cap C .

XI
182
P R A C T I C A L I N F O R M A T I O N
Front foglamp

 Remove the fi xing screw of
cover A using a torx tool, tip the
cover over and remove.

 Remove the fi xing screw of
lamp B using a torx tool and pull
the headlamp unit to remove it
from the bumper.

 Disconnect the connector D .
 Remove the bulb by performing
a quarter of a turn.

 Replace the bulb.

 Refi t the connector D .

 Refi t the headlamp unit in the
bumper.

 Screw the headlamp unit in.

 Position the cover using its guides
and screw in.

Bulbs: H8
Direction indicators

 Remove the fi xing screw of
cover A using a torx tool, tip the
cover over and remove.

 Remove the fi xing screw of
lamp B using a torx tool and pull
the headlamp unit to remove it
from the bumper.

 Detach the bulb C by pressing
on bars 1 and 2 .

 Disconnect the connector (pull
whilst pressing on the grey
tongue using a fl at screwdriver).

 Replace the bulb.

 Refi t the connector (push the
grey tongue in well).

 Refi t the headlamp unit in the
bumper.

 Screw the headlamp unit in.

 Position the cover using its
guides and screw in.

Bulbs: HP24W

XI
183
P R A C T I C A L I N F O R M A T I O N
The side repeater is sealed.
If the bulb is faulty, replace the side
repeater.
Consult a CITROËN dealer.
Side repeaters
Rear lamps (Saloon)
Identify the failed bulb.

1. Brake
lamps and sidelamps:
P21 W/5W

2. Sidelamps: R5W

3. Reversing lamp: H21W

4. Foglamps: H21W

5. Direction indicators: P21W
 Open the boot.

 Using a fl at screwdriver, remove
the 3 clips which fi x the trim in
the lamp area.

 Partially remove the trim F .

 Disconnect the connector G .
Boot-mounted lamps

 Detach the bulb holder H .

 Replace the bulb.

 Refi t the bulb holder H .

 Refi t the connector G .

 Replace and fi x the trim F with its
clips.

When refi tting, take care not to
trap the electrical cables.

XI
183
P R A C T I C A L I N F O R M A T I O N
The side repeater is sealed.
If the bulb is faulty, replace the side
repeater.
Consult a CITROËN dealer.
Side repeaters
Rear lamps (Saloon)
Identify the failed bulb.

1. Brake
lamps and sidelamps:
P21 W/5W

2. Sidelamps: R5W

3. Reversing lamp: H21W

4. Foglamps: H21W

5. Direction indicators: P21W
 Open the boot.

 Using a fl at screwdriver, remove
the 3 clips which fi x the trim in
the lamp area.

 Partially remove the trim F .

 Disconnect the connector G .
Boot-mounted lamps

 Detach the bulb holder H .

 Replace the bulb.

 Refi t the bulb holder H .

 Refi t the connector G .

 Replace and fi x the trim F with its
clips.

When refi tting, take care not to
trap the electrical cables.

XI
184
P R A C T I C A L I N F O R M A T I O N
Wing-mounted lamps

 Remove the lateral boot trim
fl ap A . To do so, pull it towards
the inside of the boot, then pull it
upwards.
 Disconnect connector B .

 Unscrew the 2 fi xings C .

 Remove the lamp from its housing.
 Detach the bulb holder D .

 Replace the bulb.

 Refi t the bulb holder D .

 Place the lamp in its housing.

 Screw in the 2 fi xings C .

 Refi t connector B .

 Refi t the trim A .
You can use the wheelbrace to
screw or unscrew the fi xings C .

XI
185
P R A C T I C A L I N F O R M A T I O N
Boot-mounted lamps

 Open the boot.

 Using a fl at screwdriver, remove
the 3 clips which fi x the trim in
the lamp area.

 Partially remove the trim F .

 Disconnect the connector G .
Rear lamps (Tourer)
Identify the failed bulb.

1. Brake
lamps and sidelamps:
P21 W/5W

2. Sidelamps: R5W

3. Reversing lamp: H21W

4. Foglamps: H21W

5. Direction indicators: P21W
 Detach the bulb holder H .

 Replace the bulb.

 Refi t the bulb holder H .

 Refi t the connector G .

 Replace and fi x the trim F with its
clips.

XI
186
P R A C T I C A L I N F O R M A T I O N
Wing-mounted lamps
Remove the lateral boot trim A .
To do so:

 Pull it towards towards the inside
of the boot.

 Pull it upwards.
 Disconnect the connector B .

 Unscrew the fi xing screw C .

 Remove the lamp from its housing.
 Detach the bulb holder D .

 Replace the faulty bulb.

 Refi t the bulb holder D .

 Place the lamp in its housing.

 Screw in the fi xing screw C .

 Refi t the connector B .

 Refi t the trim A .
You can use the wheelbrace to screw
or unscrew the fi xing screw C .

XI
187
P R A C T I C A L I N F O R M A T I O N

Number plate lamps (W5W)

 Insert a thin screwdriver into one
of the external holes of the lens.

 Push it outwards to unclip it. Third brake lamp (LEDs)
For the replacement of this type
of LED lamp, contact a CITROËN
dealer.

 Remove the lens.

 Change the faulty bulb.