Citroen C5 DAG 2007.5 (DC/DE) / 1.G Owner's Guide
Page 31 of 231
33
II
Front passenger's airbag deactivation warning lamp
See “Airbags”.
I N S T R U M E N T P A N E L
W A R N I N G L A M P S
Front passenger's air-bag activation warn-ing lamp
See “Airbags”.
Seat belt not fastened
This warning lamp is located on the roof console, in front of the front interior lamp. It informs you of the driver and passenger seat belts which are not fastened.
The lit up locations represent the seat positions which are not fas-tened.
Driver's seat belt not fastened:The warning lamp lights up from 0 to 20 km/h (12 mph).Over 20 km/h (12 mph):
t h e w a r n i n g l a m p fl a s h e s ,a beep is repeated for about 2 minutes with 3 progressive loudness levels.
Page 32 of 231
34
II
The simultaneous lighting of the SERVICE warning lamp and the display of the message “ P a r t i c l e fi l t e r ( F A P ) a d d i -tive level too low” on the instrument panel screen indicates that the additive needs to be topped up.
Contact a CITROËN dealer as soon as possible.
I N S T R U M E N T P A N E L
P A R T I C L E F I L T E R
I n a d d i t i o n t o t h e c a t a l y t i c c o n v e r t e r , t h i s fi l t e r c o n t r i b u t e s a c t i v e l y t o t h e p r e s e r v i n g o f a i r q u a l i t y , b y c o l l e c t i n g t h e polluting particles that have not been burnt off. Black exhaust fumes are thus eliminated.
C l o g g i n g o f t h e p a r t i c l e fi l t e r
C l o g g i n g i s c a u s e d b y t h e p a r t i c l e fi l t e r s t a r t i n g t o b e s a t u r a t e d ( o w i n g t o e x c e p t i o n a l l y l o n g p e r i o d s s p e n t d r i v i n g i n u r b a n c o n d i t i o n s : l o w s p e e d s , t r a f fi c j a m s , e t c . ) .
I n o r d e r t o r e g e n e r a t e t h e fi l t e r y o u a r e a d v i s e d t o d r i v e a s s o o n a s p o s s i b l e , w h e n t r a f fi c c o n d i t i o n s a l l o w , a t a s p e e d of 60 km/h or more for at least 5 minutes. If the problem persists, contact a CITROËN dealer. I n o r d e r t o r e g e n e r a t e t h e fi l t e r y o u a r e a d v i s e d t o d r i v e a s s o o n a s p o s s i b l e , w h e n t r a f fi c c o n d i t i o n s a l l o w , a t a s p e e d I n o r d e r t o r e g e n e r a t e t h e fi l t e r y o u a r e a d v i s e d t o d r i v e a s s o o n a s p o s s i b l e , w h e n t r a f fi c c o n d i t i o n s a l l o w , a t a s p e e d
Note: If the vehicle has been running for long periods at very low speeds or at idle, vapour emissions may be seen coming from the exhaust under acceleration. These have no consequ ences for the running of the vehicle or for the environment.
The simultaneous lighting of the SERVICE warning lamp and the display of the message “Risk of saturation of par- t i c l e fi l t e r ( F A P ) ” on the instrument panel screen indicates an increased risk of saturation.
Contact a CITROËN dealer as soon as possible.
DIESEL additive level
Page 33 of 231
35
II
B
C
A
Range
This is the distance that can still be travelled on the amount of fuel remain-ing in the tank.
When the range is lower than 30 km (19 miles), only four dashes are dis-played.
Instantaneous consumption
This is the result from the consumption recorded within the last 2 seconds. This function is only available when travelling at over 30 km/h.
Instantaneous information
OPERATION
The trip computer is displayed on the instrument panel screen. I t gives you access to:2 types of instantaneous information:
Range.Instantaneous consumption.This information can be displayed in zone B of the instrument panel screen when you switch the ignition on, immediately after the display of oil level and/or maintenance information.The different information to be displayed is selected by rotating the con-trol knob A.
3 types of information for two journeys 1 and 2:
Average speed.Average consumption.The distance travelled.This information is displayed in zone C of the instrument panel by rotat-ing the control knob A.
Page 34 of 231
36
II
I N S T R U M E N T P A N E L
T R I P C O M P U T E R
Distance travelled
This is the distance that has been travelled since the last reset to zero of the Journey selected.
Journeys
Journeys 1 and 2 are independent of each other but identical in use. They allow you, for example, to assign journey 1for daily calculations and journey 2 for monthly calculations.
Reset a journey to zero
When the required journey is displayed, make a long press on th e left-hand control knob A on the steering wheel.
Return to the main instrument panel screen display
Successive rotations of the control knob A on the steering wheel allow you to return you to the main instrument panel screen display (vehicle speed), via the navigation information scree n, then the screen displaying only the total mile-age and the trip mileage (bottom of screen).
A second rotation of control knob A allows you to display the information for journey A2.
Average speed
This is calculated (since the last reset to zero of the trip computer) by dividing the dis-tance travelled by the time taken (with the engine running).
Average consumption
This is the relationship between the fuel consumed and the distance travelled since the last reset to zero of the selected journey.
Information for two journeys 1 and 2
A fi r s t r o t a t i o n o f c o n t r o l k n o b A on the steering wheel allows you to display the information for journey 1.
Page 35 of 231
37
II
A
I N S T R U M E N T P A N E L
T E L E M A T I C S
Display of navigation information on instrument panel screen
You can display navigation information on the instrument panel screen by rotating the left-hand knob A on the steering wheel.
Page 36 of 231
38
II
A
I N S T R U M E N T P A N E L
C H E C K S / O I L L E V E L
Engine oil level indicator
When you switch the ignition on, the engine oil check is displayed for a few seconds on the instrument panel screen.Note: to ensure that this measurement is accurate, check the oil level o n horizontal ground after the engine has been switched off for at least 15 min-utes. An incorrect engine oil level can seriously damage your engi ne.
“Oil level incorrect” indicates that the oil level is too low.
Check using the manual dipstick. See “Lev-els”.
If, after topping up, the message re-appears, contact a CITROËN dealer.If, after topping up, the message topping up, the
“Oil level invalid” indicates a malfunctioning of the indicator.
Contact a CITROËN dealer.
“Oil level correct” indicates normal operat-ing.
Log of alerts
This function allows you to display the log of alerts.
Press on button A. The following messages appear consecutively on the instrument panel screen:Tyre pressure check.
Maintenance indicator reminder.Display of message alerts.
Oil level check.
Page 37 of 231
39
II
Maintenance indicator
It informs you when the next routine service is due in accordance with the vehicle servicing schedule in the Main-tenance Guide. This information is dependent on two parameters: the mileage covered, and the time elapsed since the last visit
Functioning if the distance to the next service is less than 3000 km (approx. 1900 miles)
When switching on the ignition, a message is displayed on the instrument panel screen for a few seconds. It indicates to you the remaining distance before the next service.
Example: there remain up to the next service: 1900 km.
A few seconds after the ignition is switched on, the message disap-pears.
Functioning if the distance to the next service is less than 1000 km (approx. 600 miles)
When switching on the ignition, a message is displayed on the instrument panel screen for a few seconds. It indicates to you the remaining distance before the next service.
Example: there remain up to the next service: 500 km. When switch-ing on the ignition, a message is displayed on the instrument panel screen for a few seconds:
A few seconds after the ignition is switched on, the message disap-pears, then the maintenance sym-bol (spanner) remains lit.
Operation if the service inter-val has been passed
When switching on the ignition, a message is displayed on the instrument panel screen for a few seconds. It indicates to you that the service interval has been exceeded.
The routine service on your vehi-cle needs to be carried as soon as possible.
A few seconds after the ignition is switched on, the message disap-pears, then the maintenance sym-bol (spanner) remains lit.
I N S T R U M E N T P A N E L
M A I N T E N A N C E I N D I C A T O R
Page 38 of 231
40
II
A
Resetting to zero of the maintenance indicator
If you are carrying out the service yourself, the procedure for resetting to zero is as follows:Swicth off the ignition, then move the key to position S, anti-theft.
Press on button A and keep it pressed.Switch on the ignition. The instrument panel screen counts down from 10 to 0 and displays the maintenance symbol.
Hold down button A until the zero appears and the maintenance symbol disappears.Switch off the ignition.
Page 39 of 231
41
IIB
A
I N S T R U M E N T P A N E L
M A I N M E N U
“Vehicle parameters” menu
This allows you to access the parameters relating to:The vehicle lighting.
The comfort levels in the vehicle.
See “Instrument panel - Vehicle parameters”.
Page 40 of 231
42
II
I N S T R U M E N T P A N E L
V E H I C L E P A R A M E T E R S
“Vehicle parameters” menu
This menu can be accessed from the instrument panel “Main menu”. It allows you to set the lighting and comfort set-tings for your vehicle.
“Lighting” menu
Once you have selected this menu, you can:Activate/deactivate the lighting of the day-time-running lamps.
Activate/deactivate the guide-me-home lighting and adjust its duration.Activate/deactivate the dual-function Xenon directional headlamps.