Citroen C8 DAG 2008.5 1.G Workshop Manual

Steering wheel controls
54
Selecting the function
- Place the dial in the LIMIT position.
The limiter is selected but is not yet
active. The display indicates the
last programmed speed.
Programming a speed
A speed can be programmed without
activating the limiter but with the
engine running.
To memorise a speed higher than the
previous one:
- press the Set + button.
A brief press increases the speed by
1 mph (km/h).
A maintained press increases the
speed in steps of 5 mph (km/h). Activation / Deactivation (off)
Pressing this button once activates
the limiter, pressing the button again
deactivates it (OFF).
To memorise a speed lower than the
previous one:
- press the Set - button.
A brief press decreases the speed by
1 mph (km/h).
A maintained press decreases the
speed in steps of 5 mph (km/h).

Steering wheel controls
ERGONOMICS and COMFORT
55
Switching the function off
- Place the dial in position 0 or switch
off the ignition to switch the system
off. The last programmed speed
remains in the memory.
Exceeding the programmed
speed
Pressing the accelerator pedal in order
to exceed the programmed speed
will have no effect unless you press
the pedal
fi rmly beyond the point of
resistance .
The limiter is deactivated temporarily
and the programmed speed fl ashes.
To return to the limiter function, reduce
your speed to below the programmed
speed. Operating fault
The programmed speed is cleared and
the dashes fl ash for a few seconds.

Contact a CITROËN dealer to have the
system checked.
Flashing of the speed
The speed fl ashes:
- following forcing of the accelerator point of resistance,
- when the limiter cannot prevent an increase in the vehicle speed due
to the profi le of the road or on a
steep descent,
- in the event of sharp acceleration. Good practice
In any event, the speed limiter cannot
replace the need to observe speed limits,
nor can it replace the need for vigilance
and responsibility on the part of the driver.

Always pay attention to the profi le of the
road, take care on sharp acceleration and
stay in complete control of your vehicle.

To avoid any jamming under the
pedals:
- ensure that the mat and its fi xings positioned correctly,
- never place one mat on top of another.

56
Ventilation
VENTILATION
CORRECT USE OF THE
VENTILATION AND AIR
CONDITIONING
Vents

"Leave them open"
For optimum distribution and diffusion
of hot or cool air in the passenger
compartment, there are adjustable
central and side vents which can be
directed sideways (right or left) towards
the top of the body. For your comfort
while driving, do not close them, direct
the fl ow of air towards the windows
instead.
The air vents directed towards the fl oor
of the vehicle complete the equipment. Passenger compartment filter,
carbon filter
Ensure that this fi lter is in good
condition and have all of the fi lter
elements replaced regularly.
Refer to the "Checks" section of
chapter 7. Air conditioning
In all seasons, if fi tted on your
vehicle, the air conditioning should
only be used with the windows closed.
However, if the interior temperature
remains high after a prolonged period
parked in the sun, do not hesitate to
ventilate the passenger compartment
for a few minutes.
If your vehicle is fi tted with automatic
air conditioning, use the AUTO mode
as much as possible as it permits
optimised control of all of the functions:
air fl ow, passenger compartment
comfort temperature, air distribution,
air intake mode or air recirculation in
the passenger compartment.
Operate the air conditioning system for
5 to 10 minutes, once or twice a month,
to keep it in perfect working order.
It is normal that the condensation
created by the air conditioning system
results in a fl ow of water which may
form a puddle under the vehicle when
parked.
If the system does not produce cold air,
do not use it and consult a CITROËN
dealer .

ERGONOMICS and COMFORT
3
57
Ventilation
De-icing the rear screen
and mirrors Demisting, visibility
programme
DE-ICING AND DEMISTING
The comfort programme
may not be suffi cient to
quickly demist or de-ice the
windows (humidity, several
passengers, ice).
In this case, select the
visibility programme. The visibility
programme indicator light comes on.
It activates the air conditioning, the air
fl ow, the de-icing of the rear screen
and provides optimum distribution of
the ventilation to the windscreen and
side windows.
It deactivates the air recirculation.
Press this button, with the
engine running, to de-ice the
rear screen and mirrors.
The de-icing indicator light
comes on. The duration
of de-icing depends on the exterior
temperature.
Pressing the button again reactivates
the de-icing.
It is possible to stop the de-
icing before it is switched off
automatically by pressing this
button again. ADDITIONAL HEATER
To improve your comfort, vehicles fi tted
with an HDi engine may be fi tted with
automatic additional heating.
However, with the engine at idle
or when the vehicle is stationary, it
is normal to notice a high-pitched
whistling and a slight emission of
smoke and odour.

58
Ventilation
AUTOMATIC AIR CONDITIONING WITH SEPARATE SETTINGS
Do not cover the sunshine sensor
located in the centre of the fascia.
This is used to regulate the air
conditioning.
Located on the centre console, the
control panel is to the right of the gear
lever.
1 - AUTO mode
This is the normal air
conditioning operating mode.
Refer to the beginning of the
"Ventilation" section of chapter 7.
The driver and front passenger can
each adjust the air temperature to suit
their requirements.
They can also activate or disarm the
rear ventilation adjustment controls. For your comfort, the settings selected
when the ignition is switched off will be
retained when it is switched on again,
if the temperature in the passenger
compartment has not changed
signifi cantly; otherwise, operation will
resume in automatic mode.
- Press the
"AUTO" button.
Depending on the comfort temperature
selected, the system controls the air
distribution, fl ow and intake so that the
passenger compartment is comfortable
and has an adequate circulation of air.
You do not have to make any further
adjustments.
When the engine is cold, in order
to prevent a rush of cold air, the
ventilation will reach its optimum level
progressively.
The "AUTO" symbol is displayed.

ERGONOMICS and COMFORT
3
59
Ventilation

2 - Driver’s temperature
adjustment
4 - Adjustment of the air
distribution
Pressing the corresponding
button(s) 4 allows you to
position the air fl ow towards:
- the windscreen,
- the side vents and the central vents,
- the side vents, the central vents and the footwells,
- the windscreen and the footwells,
- the footwells.
The indicator light corresponding to the
position selected 4 comes on.
5 - Adjustment of the
rear ventilation ("REAR"
version)
To permit adjustment of
the ventilation to the rear
passengers, press the REAR
button.
The rear ventilation symbol is displayed.

3 - Passenger’s
temperature adjustment
The required value is displayed (from
14 to 28: comfort value = 21).
The maximum difference between the
value displayed for the driver and for the
passenger may not be greater than 5.
If you use these manual adjustments,
the AUTO symbol switches off.
Press the corresponding "
+
" and "
-
"
buttons to adjust.
To make the driver and passenger
setting the same:
- air conditioning with "MONO "
version, press the MONO button.
- air conditioning with "REAR" version, press the + button for more
than two seconds.
On entering the vehicle, the
interior temperature may be
considerably lower (or higher)
than is comfortable. It is not necessary
to change the value displayed in order
to quickly obtain the desired level of
comfort. The system will operate at
maximum performance to reach the
comfort value set. MONO Version
Press this button once to
obtain an even temperature
throughout the passenger
compartment. The reference
value is selected by the
driver. Take care not to obstruct
the side vents and the
air outlets on the fl oor.
The row 2 side vents air
fl ow adjustment controls
are operational and can
be adjusted.
To deactivate the rear
ventilation controls,
press the
REAR button
again.
The rear ventilation
symbol switches off.

60
Ventilation

6 - Adjustment of the air fl ow
- Turn control knob 6 to
the right or to the left
respectively to increase or
decrease the air fl ow.
On the display, the blades of the fan
darken when the air fl ow is increased.
8 - Intake of exterior air/
Recirculation of interior
air
- Press this button to recirculate the air inside.
The air recirculation symbol and
indicator light 8 are displayed.
Recirculation insulates the passenger
compartment from outside smells and
smoke.
9 - Air conditioning
On/Off
- Press this button to activate automatic operation of the
air conditioning.
The symbol and the indicator light

9 are displayed.
- Press this button again to switch off the air conditioning.
The symbol and the indicator light

9 switch off.
Avoid prolonged operation of
interior air recirculation (risk
of misting of the windows and
deterioration of air quality).
- Press this button again to return air intake to automatic control.

7 - Switching the system off
- Turn air fl ow control knob 6 to the
left until the display switches off.
The action disarms all the system
functions, with the exception of
demisting of the rear screen. Your
comfort setting is no longer maintained
and switches off.
For your comfort, avoid remaining in
the off position.
- Operating control knob 6 again or
the "Visibility" button or "AUTO"
button reactivates the system with
the values which were present
before it was switched off.
Flashing of the points in the
temperature setting values indicates
that there is a malfunction of the air
conditioning.
Consult a CITROËN dealer.

ERGONOMICS and COMFORT
3
61
Ventilation
the side vents and the central
vents,
MANUAL
Located on the centre console, the
control panel is to the right of the gear
lever. the side vents, the central
vents and the footwells, the footwells,
the windscreen and the
footwells,
1 - Setting the air distribution
Turn control knob 1 to the
corresponding position to direct the
fl ow of air towards: 2 - Temperature
adjustment
Position control knob 2 to suit
your requirements: from blue
(cold when the air conditioning
is on) to red (hot).
To lower the temperature inside the
passenger compartment quickly,
position control knob 2 on "MAX" .
The air conditioning 5 and the air
recirculation 4 come on.
Turn the knob away from the "MAX"
position when the ambient air suits
your requirements.
The air conditioning 5 remains on while
the air recirculation 4 switches off.

62
Ventilation 3 - Setting the air fl ow
Turn control knob 3 to the
right or to the left respectively
to increase or reduce the fl ow
of air.
4 - Intake of exterior air/ Recirculation of
interior air
Press button 4 to recirculate
the air inside.
The air recirculation indicator
light 4 comes on.
Recirculation insulates the passenger
compartment from external odours and
fumes.
Used simultaneously with the air
conditioning 1 , recirculation improves
the performance of the system when
set to hot as well as to cold.
Avoid prolonged operation in
interior air recirculation mode
(risk of misting of the windows and
of deterioration of the air quality). Recommended settings for the air conditioning
For optimum operation of the manual system, it is recommended:
With Automatic Air Conditioning, operation in AUTO mode is recommended,
irrespective of the requirement.
Remember to switch it off when the ambient air suits your
requirements.
If I require...
Air
distribution
Temperature Air fl ow Air
recirculation AC
Heating
–
Cooling
De-icing
Demisting
5 - Air conditioning
ON/OFF
The air conditioning is
intended to operate in all
seasons. In summer it allows
the temperature to be reduced and in
winter, above 0 °C, it increases the
effectiveness of the demisting.
Press switch 5 .
The air conditioning indicator light
5 comes on if the air fl ow is suffi cient.
Pressing this button again switches off
the air conditioning.

ERGONOMICS and COMFORT
3
63
Seats
FRONT SEATS WITH MANUAL
ADJUSTMENT
1 - Forwards/backwards adjustment
Lift the bar and slide the seat forwards
or backwards.
SEATS
2 - Seat back angle adjustment
Pull the lever upwards and set the
required angle.