stop Citroen DS3 2014 1.G Owner's Manual
Page 10 of 376
DS3_en_Chap00b_vue-ensemble_ed01-2014
Exterior
customising kits
These expressive stickers form part of a range of kits, very
d
ifferent one from another, which
a
llow you to create a unique
and
attractive exterior for your
v
ehicle.
Guide-me-home lighting
After switching off the ignition, under low lighting conditions the headlamps remain on for a few seconds to help you leave the vehicle.
Active city Brake
The purpose of this system is to avoid a frontal collision or reduce the speed of impact if the
d
river fails to take action or does not take
s
ufficient action.
2 41
13 5 157
Stop & Start
This system puts the engine t
emporarily on standby during
s
tops in the traffic (red lights, traffic
j
ams, etc...). The engine restarts
a
utomatically as soon as you want
t
o move off. The Stop & Start system
r
educes fuel consumption, exhaust
e
missions and the noise level when
s
tationary. 118
Page 26 of 376
DS3_en_Chap01_controle-de-marche_ed01-2014
Warning lampis oncau seAction / Observations
di
esel engine
pre-heating fixed.
The
key is at position 2 (ignition on) in
t
he ignition switch.Wait
until the warning lamp goes off before starting.
The
period of illumination of the warning lamp is
d
etermined by the climatic conditions (up to about
t
hirty seconds in extreme climatic conditions).
If
the engine does not start, switch the ignition off and
t
hen on, wait until the warning lamp goes off again,
t
hen start the engine.
Parking brake fixed. The
parking brake is applied or not
p
roperly
r
eleased.Release
the parking brake to switch off the warning
l
amp, keeping your foot on the brake pedal.
Observe
the safety recommendations.
For
more information on the parking brake, refer to the
c
orresponding
s
ection.
Stop & Star t fixed. When
the vehicle stops (red lights,
t
raffic jams, ...) the Stop & Start system
h
as put the engine into STOP mode.The
warning lamp goes off and the engine restarts
a
utomatically in START mode, as soon as you want to
m
ove off.
flashes for a few
seconds,
then goes
o
f f.STOP
mode is temporarily
u
navailable.
or
START
mode is invoked
au
tomatically.For
more information on special cases with STOP
m
ode and START mode, refer to the "Stop & Start"
s
ection.
Page 29 of 376
27
DS3_en_Chap01_controle-de-marche_ed01-2014
Warning lamps
When the engine is running or the vehicle is being driven, the illumination of one of the
f
ollowing warning lamps indicates a fault which
r
equires action on the part of the driver.Any
fault resulting in the illumination of a warning lamp must be investigated further by r
eading the associated message in the multifunction screen.
If
you encounter any problems, do not hesitate to contact a CITROËN dealer or a qualified
w
orkshop.
Warning lamp is on
cau
seAction / Observations
STOP fixed,
alone or
a
ssociated with
another
w
arning
lam
p,
a
ccompanied by an
a
udible signal and a
m
essage on the screen.Illumination
of the warning lamp is
a
ssociated with a serious braking
s
ystem or engine coolant temperature
pro
blem.Stop
as soon as it is safe to do so as the engine may
c
ut out when driving.
Park,
switch off the ignition and call a CITROËN dealer
o
r a qualified workshop.
Service temporarily. Minor
problems have occurred for
w
hich there is no specific warning
lam
p.Identify
the problem by reading the message shown in
t
he screen, such as, for example:
-
t
he engine oil level,
-
t
he screenwash level,
-
t
he remote control battery,
-
s
aturation of the particle emission filter on Diesel
v
ehicles (see the "Checks - Particle emissions
f
ilter" section).
For any other faults, contact a CITR
oË
N dealer or a
qualified
w
orkshop.
fixed. Major
problems have occurred for
w
hich there is no specific warning
lam
p.Identify
the problem by reading the message shown
i
n the screen and contact a CITR
oË
N dealer or a
qualified
w
orkshop.
Monitoring
Page 30 of 376
DS3_en_Chap01_controle-de-marche_ed01-2014
Brakingfixed, associated with t
he STOP warning
lam
p.The
braking system fluid level is too l
ow.You
must stop as soon as it is safe to do so.
Top up with brake fluid recommended by CITROËN.
If
the problem persists, have the system checked by a
C
ITROËN dealer or a qualified workshop.
+ fixed,
associated with
t
he ST
oP a
nd ab
S
w
arning
lam
p.The
electronic brake force distribution
(
EBFD) system has a fault.You
must stop as soon as it is safe to do so.
Have
it checked by a CITROËN dealer or a qualified
w
orkshop.
Warning lamp
is on
cau
se
Action / Observations
Anti-lock Braking
System (ABS) fixed.
The
anti-lock braking system has a
f
ault.The
vehicle retains conventional braking.
Drive carefully at reduced speed and contact a
CITROËN
d
ealer
o
r
a q
ualified
w
orkshop
w
ithout
d
elay.
dy
namic stability
control (ESP/
ASR) flashing.
The
ESP/ASR regulation is active. The system optimises traction and improves the
d
irectional stability of the vehicle.
fixed,
associated with
i
llumination of the lamp
i
n the "ESP OFF"
button,
accompanied by
a
n audible signal and a
m
essage in the screen.The
ESP/ASR system has a fault. Have it checked by a CITROËN dealer or a qualified
w
orkshop.
Page 31 of 376
29
DS3_en_Chap01_controle-de-marche_ed01-2014
Warning lampis oncau seAction / Observations
Engine
autodiagnosis
system flashing.
The
engine management system has
a
fault.Risk
of destruction of the catalytic converter.
Have
it checked by a CITROËN dealer or a qualified
w
orkshop.
fixed. The
emission control system has a
f
ault.
The warning lamp should go off when the engine is started.
I f it does not go off, contact a CITROËN dealer or qualified w
orkshop without delay.
Low fuel level fixed. When it first comes on there remains a
pproximately 5 litres of fuel in the
tank. You
must refuel as soon as possible to avoid running o
ut of fuel.
This
warning lamp will come on every time the ignition is
s
witched on, until a sufficient addition of fuel is made.
Fuel
tank capacity: approximately 50 litres (petrol),
4
6 litres (Diesel) or 33 litres (LPG); depending on
v
ersion: approximately 30 litres (petrol or Diesel).
Never continue to drive until you run out of fuel as
this
could damage the emission control and injection
s
ystems.
Maximum coolant
temperature fixed.
The
t
emperature
o
f
t
he
c
ooling
s
ystem
i
s too high.Stop
as soon as it is safe to do so.
Wait
until the engine has cooled down before topping
u
p the level, if necessary.
If
the problem persists, contact a CITROËN dealer or
q
ualified
w
orkshop.
Monitoring
Page 32 of 376
DS3_en_Chap01_controle-de-marche_ed01-2014
Warning lampis oncau seAction / Observations
Engine oil
pressure fixed.
There
is a fault with the engine
l
ubrication system.You
must stop as soon it is safe to do so.
Park,
switch off the ignition and contact a CITROËN
d
ealer or a qualified workshop.
Battery charge fixed. The
battery charging circuit has a fault
(
dirty or loose terminals, slack or cut
a
lternator belt, ...).The
warning lamp should go off when the engine is
s
tarted.
If
it does not go off, contact a CITROËN dealer or a
q
ualified
w
orkshop.
d
oor(s) open fixed
if the speed is
b
elow 6 mph (10 km/h).A
door or the boot is still open. Close the door or boot.
fixed
and accompanied
b
y an audible signal if
t
he speed is above
6
mph (10 km/h).
Page 37 of 376
35
DS3_en_Chap01_controle-de-marche_ed01-2014
With the engine running, when the needle is:
- i n zone A ,
the temperature is correct,
-
i
n zone B, the temperature is too high;
t
he central STOP
warning lamp and the
m
aximum temperature warning lamp 1
come
on in red, accompanied by an
a
udible signal and a message in the
m
ultifunction
s
creen.
You must stop as soon as it is safe to do so.
Wait
a few minutes before switching off the
e
ngine.
Contact a CITR
oË
N dealer or a qualified
workshop.
coolant temperature indicator
After driving for a few minutes, the temperature a nd pressure in the cooling system increase.
To
top up the level:
F
w
ait for the engine to cool down,
F
u
nscrew the cap by two turns to allow the
pressure to drop,
F
w
hen the pressure has dropped, remove
t
he cap,
F
t
op up the level to the "MA X" mark.
Monitoring
Page 45 of 376
43
DS3_en_Chap01_controle-de-marche_ed01-2014
Monochrome screen c
Information displays
F Press the button, located at the end of the wiper stalk , to display the various trip
computer
tabs in succession. -
t
he current information tab
w
ith:
●
t
he range,
●
t
he current fuel
c
onsumption,
●
t
he distance remaining to
b
e travelled or the Stop &
Start time counter,
-
t
he trip "1"
tab with:
●
t
he distance travelled,
●
t
he average fuel
c
onsumption,
●
t
he average speed,
f
or the first trip.
-
t
he trip "2"
tab with:
●
t
he distance travelled,
●
t
he average fuel
c
onsumption,
●
t
he average speed,
f
or the second trip.
F P ressing the button again returns you to t
he normal display.
16/9 colour screen (eMyWay)
Trip zero reset
F When the trip required is displayed, press
the button on the end of the wiper stalk for
m
ore than two seconds.
Tr i p s "1" and "2" are independent but their use
is
identical.
For
example, trip "1" can be used for daily
figures,
and trip "2"
for monthly figures.
Monitoring
Page 46 of 376
DS3_en_Chap01_controle-de-marche_ed01-2014
A few definitions…
Range
(miles or km)
current fuel consumption
(mpg or l/100 km or km/l)
Stop & Start time
counter
(minutes / seconds or hours / minutes)
This
value
may
vary
following
a
change
i
n
the
style
of
driving
or
the
relief,
r
esulting
in
a
significant
change
in
the
c
urrent
fuel
consumption.
If dashes are displayed continuously
while
driving
in
place
of
the
digits,
c
ontact a CITR
oË
N dealer or a
qualified
w
orkshop.
When
the
range
falls
below
20
miles
(30
km),
d
ashes
are
displayed.
After
filling
with
at
least
5
litres
of
fuel,
the
range
is
recalculated
and
is
d
isplayed
when
it
exceeds
60
miles
(100
km).
distance remaining to
destination
(miles or km)
T
his indicates the distance which can still be
travelled
with
the
fuel
remaining
in
the
tank
in
r
elation
to
the
average
fuel
consumption
over
t
he
last
few
miles
(kilometres)
travelled. This
is
the
average
fuel
consumption
during
the
l
ast
few
seconds.
This
is
the distance remaining to be travelled
t
o
the
final destination. It can be entered by
t
he user.
If the distance is not entered, dashes are
displayed
in place of the digits.
If
your
vehicle is fitted with Stop & Start, a time
c
ounter
calculates the time spent in STOP
m
ode
during a journey.
I
t
resets
to zero every time the ignition is
s
witched
on with the key.
distance travelled
(miles or km)
T
his indicates the distance travelled since the
last
trip
computer zero reset.
Average speed
(mph or km/h)
T
his
is
the average speed calculated since the
l
ast
trip
computer zero reset (ignition on).
Average fuel
consumption
(mpg or l/100 km or km/l)
T
his
is
the
average fuel consumption since the
l
ast
trip
computer zero reset.
This
function is only displayed from
20
mph
(30 km/h).
Page 64 of 376
DS3_en_Chap03_ouvertures_ed01-2014
This is indicated by lighting of the courtesy lamps and flashing of the direction indicators
f
or a few seconds.
Locating your vehicle
F Press the closed padlock to l
ocate your locked vehicle in a
c
ar
par
k.
Anti-theft protection
Electronic engine immobiliser
The key contains an electronic chip which has a special code. When the ignition is switched
o
n, this code must be recognised in order for
s
tarting to be possible.
This
electronic engine immobiliser locks the
e
ngine management system a few minutes
a
fter the ignition is switched off and prevents
s
tarting of the engine by anyone who does not
h
ave the key.In the event of a fault, you are
informed
by illumination of this
w
arning lamp, an audible signal and a message
i
n the screen.
In
this case, your vehicle will not start; contact
a
CITROËN dealer as soon as possible.-
P
osition 1: Stop
-
P
osition 2: Ignition
-
P
osition 3: Starting
Ignition switch
keep safely the label attached to
the keys given to you on acquisition of
t
he vehicle.