automatic Citroen DS3 RHD 2016 1.G Service Manual
Page 144 of 380
LED daytime running lampsThis daytime lighting, a signature of the vehicle, comprises two sets of light-emitting diodes
(
LEDs), located in vertical housings below each
h
eadlamp.
On
starting the vehicle, in daylight the daytime
r
unning lamps come on automatically, if the
l
ighting stalk is in position "0" or "AUTO" .
If
the sidelamps and headlamps are switched
o
n manually or automatically, the daytime
r
unning lamps go off.
In
fog
or
snow,
the
sunshine
sensor
m
ay
detect
sufficient
light.
Therefore,
t
he
lighting
will
not
come
on
au
tomatically.
Do
not
cover
the
sunshine
sensor,
c
oupled
with
the
rain
sensor
and
l
ocated
in
the
centre
of
the
windscreen
b
ehind
the
rear
view
mirror;
the
a
ssociated
functions
would
no
longer
be c
ontrolled.
Automatic
guide-me-home
lighting
When the automatic illumination of headlamps f
unctions is activated, if the ambient light level
i
s low the dipped beam headlamps remain on
w
hen switching off the ignition.
Settings
Activation and deactivation, as well as the duration of the guide-me-home lighting can
b
e set in the vehicle configuration or settings
m
enu (except for the monochrome screen A,
f
or which the duration is fixed at 60 seconds).
Page 146 of 380
The vehicle's front and rear wipers are designed to improve the driver's visibility
p
rogressively according to the weather
c
onditions.
Wiper controls
Programming
You can modify the settings for the following functions:
-
a
utomatic
r
ain
sen
sitive
w
indscreen
w
ipers,
-
r
ear wiping on engaging reverse gear.
Model with AUTO wiping
The wiper commands are issued directly by the driver by means of the stalk A and the ring B.
Manual controls
Windscreen wipers
A. Wiping speed selection stalk.
Single wipe (press down and
r
elease).Automatic,
then single wipe.
Fast
(heavy rain).
Normal
(moderate rain).
Intermittent
(proportional to the
s
peed of the vehicle).
Of f.
or
Model without AUTO wiping
Refer to the corresponding section.
Page 148 of 380
Automatic rain sensitive
windscreen wipers
The windscreen wipers operate automatically, without any action on the part of the driver, if
r
ain is detected (sensor behind the rear view
m
irror), adapting their speed to the intensity of
t
he rainfall.
Activation
This is controlled manually by the driver by pushing s talk A to the "AUTO" p osition.
It is accompanied by the illumination of this indicator lamp in the instrument panel and a
message in the multifunction screen.
Switching off
This is controlled manually by the driver by moving stalk A upwards, returning it to
p
osition
"0".
It
is accompanied by the indicator lamp
i
n the instrument panel going off and a
m
essage in the multifunction screen.The
automatic wiping must be r
eactivated if the ignition has been off
f
or more than one minute, by pushing
s
talk A downwards.
Page 149 of 380
147
Operating fault
If an automatic wiping fault occurs, the wipers will operate in intermittent mode.
Have
it checked by a CITROËN dealer or a
q
ualified
w
orkshop.
To retain the effectiveness of the flat
wiper
blades, it is advisable to:
-
h
andle them with care,
-
c
lean them regularly using soapy
w
ater,
-
n
ot use them to hold a sheet of
c
ardboard against the windscreen,
-
r
eplace them at the first signs of
w
e a r.
Do
not cover the rain sensor, linked
w
ith the sunshine sensor and located in
t
he centre of the windscreen behind the
r
ear view mirror.
Switch
off the automatic wiping when
u
sing an automatic car wash.
In
winter, it is advisable to wait until the
w
indscreen is completely clear of ice
b
efore activating the automatic wiping.This
position allows the wiper blades to
b
e lifted for winter parking, cleaning or
r
eplacement without damaging the bonnet.
In
the minute following switching off of the
i
gnition, any action on the wiper stalk positions
t
he wipers vertically.
To
park the wipers after this has been done,
s
witch on the ignition and operate the wiper stalk.
Vertical windscreen wiper
position
Visibility
Page 151 of 380
149
Interior mood lightingThe dimmed passenger compartment lighting improves visibility in the vehicle when the light is p
o o r.
Switching on
At night, the illumination of footwells and the central dashboard storage compartment comes
o
n automatically when the sidelamps are
s
witched on.
Switching off
The interior mood lighting switches off automatically when the sidelamps are
switched
off.
It
can be switched off manually using the
i
nstrument panel lighting rheostat button.
F
W
ith the lighting on, press several times on
t
he left hand button of the instrument panel
t
o progressively reduce the dashboard
l
ighting level.
F
P
ress again to reduce the lighting level
t
o the minimum and switch off the interior
m
ood
l
ighting. This
comes on automatically when the boot is
o
pened and goes off automatically when the
b
oot is closed.
Boot lamp
The lighting time varies according to the c ircumstances:
-
w
hen the ignition is off,
a
pproximately ten minutes,
-
i
n energy economy mode,
a
pproximately thirty seconds,
-
w
hen the engine is running, no limit.Programming
Switching the function on or off is done using the vehicle settings menu.
Visibility
Page 154 of 380
Direction
i ndicators
F Left: lower the lighting stalk beyond the p
oint of resistance.
F
R
ight: raise the lighting stalk beyond the
p
oint of resistance.
Three flashes of the direction
indicators
F Press briefly upwards or downwards, w
ithout going beyond the point of
r
esistance; the direction indicators will
f
lash 3 times.
Hazard warning
lam
ps
Visual warning with of all the direction i
ndicators flashing to alert other road users to a
v
ehicle breakdown, towing or accident.
F
P
ress this button, all of the direction
in
dicators
f
lash.
They
can operate with the ignition off.
Automatic operation of
hazard warning lamps
When braking in an emergency, depending on the deceleration, the hazard warning lamps
c
ome on automatically.
They
switch off automatically the first time you
a
ccelerate.
F
Y
ou can also switch them off by pressing
t
he button.
Page 156 of 380
Under-inflation detection
System which automatically checks the pressures of the tyres while driving.
T he under-inflation detection system
d
oes not replace the need for vigilance
o
n the part of the driver.
This
system does not avoid the need to
c
heck the tyre pressures (including the
s
pare wheel) every month as well as
b
efore a long journey.
Driving
with under-inflated tyres
i
mpairs road holding, extends braking
d
istances and causes premature
t
yre wear, particularly under arduous
c
ondition (high loading, high speed,
lon
g
jo
urney).The
inflation pressures defined for
y
our vehicle can be found on the tyre
p
ressure label.
For
more information on the
i
dentification markings, refer to the
c
orresponding
s
ection.
Tyre
pressures should be checked
w
hen the tyres are "cold" (vehicle
s
topped for 1 hour or after a journey of
l
ess than 6 miles (10 km) at moderate
s
peeds).
Other wise
(when hot), add 0.3 bar to
t
he pressures shown on the label.
Driving
with under-inflated tyres
i
ncreases fuel consumption.
The
system monitors the pressures in the four
t
yres, once the vehicle is moving.
It
compares the information given by the four
w
heel speed sensors with reference values,
which must be reinitialised ever y time the
tyre pressures are adjusted or a wheel
changed .
The
system triggers an alert as soon as it
d
etects a drop in the inflation pressure of one
o
r more tyres.
Page 160 of 380
Braking assistance systems
Group of supplementary systems which help you to obtain optimum braking in complete
s
afety in emergency situations:
-
a
nti-lock braking system (ABS),
-
e
lectronic brake force distribution (EBFD),
-
e
mergency braking assistance (EBA).Anti-lock braking system
and electronic brake force
distribution
Linked systems which improve the stability and manoeuvrability of your vehicle when braking,
i
n particular on poor or slippery sur faces.
Activation
The anti-lock braking system comes into operation automatically when there is a risk of
w
heel lock.
Normal
operation of the ABS may make itself
f
elt by slight vibration of the brake pedal.
When
braking in an emergency, press
v
ery firmly without releasing the
p
ressure.
Operating fault
If this warning lamp comes on, together with the STOP and ABS
warning
lamps, accompanied by an
a
udible
signal and a message in the screen, it
i
ndicates
a malfunction of the electronic brake
f
orce
distribution which could result in loss of
c
ontrol
of
the vehicle when braking.
You must stop as soon as it is safe to do so.
When
replacing wheels (tyres and
r
ims), ensure that they conform to the
ma
nufacturer's
r
ecommendations.
If
this warning lamp comes on,
a
ccompanied by an audible signal
a
nd a message in the screen, it
i
ndicates
a malfunction of the anti-lock braking
s
ystem
which could result in loss of control of
t
he
vehicle when braking.
In
either
case, contact a CITROËN dealer or a
q
ualified
w
orkshop.
Page 161 of 380
159
Emergency braking assistance
System which, in an emergency, enables you to obtain the optimum braking pressure more
q
uickly, thus reducing the stopping distance.
Activation
It is triggered by the speed at which the brake pedal is pressed.
The
effect of this is a reduction in the
r
esistance of the pedal and an increase in
b
raking
e
fficiency.
When
braking in an emergency, press
f
irmly without releasing the pressure.
Trajectory control systems
Anti-slip regulation (ASR)
and dynamic stability
control (
d
SC)
The anti-slip regulation (also known as traction control) optimises traction to prevent skidding
o
f the wheels, by acting on the brakes of the
d
riving wheels and on the engine.
The electronic stability control acts on the
brake
of one or more wheels and on the engine
t
o keep the vehicle on the trajectory required
b
y the driver, within the limits of the laws of
p
hysics.Activation
These systems are activated automatically each time the vehicle is started.
They
come into operation in the event of a grip
o
r
t
rajectory
pro
blem.
This
is indicated by flashing of this
w
arning lamp in the instrument panel.
Safety
Page 162 of 380
deactivation
In extremely severe conditions (deep snow, mud...), when it is not possible to move off, it
m
ay be useful to temporarily deactivate the
s
ystems, so that the wheels can spin freely and
r
egain grip.
F
P
ress this button, located on the left below
t
he steering wheel.
Illumination
of the lamp in the button indicates
t
hat the systems are deactivated.
Reactivation
These systems are reactivated automatically each time the ignition is switched back on
o
r from 30 mph (50 km/h) except 1.6 litre
(
THP 165, THP 155 and THP 150) and
G
T R ACING petrol engines.
F
P
ress this button again to reactivate them
m
anually.
Operating fault
The DSC/ASR systems offer exceptional s afety i n n ormal d riving, b ut
t
his should not encourage the driver to
t
ake extra risks or drive at high speed.
The
correct functioning of these
s
ystems depends on observation of the
ma
nufacturer's
r
ecommendations
o
n:
-
w
heels (tyres and rims),
-
b
raking components,
-
el
ectronic
c
omponents,
-
a
ssembly and repair procedures.
After
an impact, have these systems
c
hecked by a CITROËN dealer or a
q
ualified
w
orkshop.
Illumination
of this warning lamp in the
i
nstrument panel and the lamp in the
b
utton, accompanied by an audible
s
ignal and a message, this indicates a
m
alfunction of these systems.
Have
it checked by a CITROËN dealer or a
q
ualified
w
orkshop.