key FIAT ULYSSE 2008 2.G Connect NavPlus Manual

7
No
Do not use stain removers, antista-
tic sprays or thinners to clean a CD.
No
Do not use very damaged, cracked
or deformed CDs.
No
Use of such CD may damage the
player. Keep CDs away from direct
sunlight and all sources of heat.
Errato
INTRODUCTION
The CONNECT Nav+ system es-
sentially consists of:
– a keypad on the front panel and
two knobs (encoders);
– controls on the central unit and re-
mote controls on the steering wheel;
– electronic control unit inside the
dashboard.
The system interface is the mul-
tifunctional display used by all in-
tegrated components.
Unavailable functions will appear sha-
ded on the display and cannot be ope-
rated. Notes on CDs
Do not stick labels onto the surface
of a CD. Do not write on the surface
of a CD with pencils or pens.
001-025 CONNECT ULISSE GB 20-10-2008 10:08 Pagina 7

9
Some controls have multiple functions which depend on the active system mode. The activated function in some cases
depends on how long the button is pressed as shown in the following table:
Key Short press (less than 1 second) Long press (over 1 second)
1SOS
2˚
3SOURCE
4
5£
6
7•
8
9ESC
10N
11
–
–
–
–
–
–
–
–
–
Show active mode general information.
– Display emergency call menu
(medical emergency, breakdown, etc.).
Eject audio CD audio or navigation CD-ROM.
Select mode: radio, CD, CD changer.
System on/off.
Turn: adjust volume and audio settings
(treble, bass, balance, fader, loudness).
Telephone mode.
Dial set number.
Answer incoming call.
CONNECT Nav+ comprised system
multifunctional display
bCONNECT mode.
CD compartment/housing.
Quit selection menu or go from a submenu to a
higher level menu.
Radio mode: tune radio in 50 kHz (in FM) or 1 kHz (in
AM) steps to the next radio station from the
currently tuned station.
CD changer mode: select next CD.
Sound settings.
001-025 CONNECT ULISSE GB 20-10-2008 10:08 Pagina 9

10
Key Short press (less than 1 second) Long press (over 1 second)
12
13
14
˜
15LIST
16
17O
18MENU
19
÷
20
21Ô
–
–
CD mode: fast forward by one track.
–
–
–
Show help menu.
CD mode: fast backward by one track.
Store current station (1 – 6).
– IR port.
SIM card housing adapter.
Radio mode: tune radio to the next station;
press twice: switch from LO mode to DX mode.
CD mode: go to next track.
CD changer mode: go to next track.
Radio mode: show receivable radio stations in
alphabetical order.
CD mode: show track list contained on CD.
MP3 mode: show folder list contained on CD.
Turn: select function.
Press: confirm selected functions.
Radio mode: tune radio in 50 kHz (in FM) or 1 kHz (in
AM) steps to the previous radio station from the current-
ly tuned station.
CD changer mode: select previous CD.
Access to function menus.
Radio mode: tune radio to the previous station;
press twice: switch from LO mode to DX mode.
CD mode: go to previous track.
CD changer mode: go to previous track.
Radio mode: recall preset station (1 – 6)
Telephone mode: dial telephone number (1 – 12).
CD changer mode: select CD (1 – 6).
Reject incoming call.
Hang up current call.
001-025 CONNECT ULISSE GB 20-10-2008 10:08 Pagina 10

11
Key Short press (less than 1 second)Long press (over 1 second)
22BND AST
23TA/PTY
24DARK
25MODE
26
27MEMO
28˜
29
30SRC
31
32÷
33 MEMO
Automatic station store (in FMAST band).
PTY (Type Program): activate search filter
according to broadcasting station category.
–
–
Navigation mode: repeat last voice message
(supplied by system).
–
–
–
–
–
–
– Select frequency band FM1 – FM2 – FMAST
(autostore) – AM.
TA (Traffic Announcements): automatic
reception of traffic announcements.
Press once: partial dimming of display.
Press twice: dimming of display.
Press three times: normal display brightness.
Change current display.
Voice controls
Anticlockwise:
Radio mode: previous preset station.
CD changer mode: select previous CD.
Radio mode: manual tuning next station.
CD mode: select next track
Audio section: volume up.
Pressed with button 31: mute function
Select mode: radio, CD, CD changer.
Audio section: volume down.
Pressed with button 29: mute function
Radio mode: manual tuning previous station.
CD mode: select previous track
Clockwise.
Radio mode: next preset station.
CD changer mode: select next CD
001-025 CONNECT ULISSE GB 20-10-2008 10:08 Pagina 11

12
Key Short press (less than 1 second)Long press (over 1 second)
34MUSIC
35MODE
36ESC
37TEL
38NAV
39MAIN
40
41MENUAudio settings: treble, bass, balance, fader, loudness auto-
matic volume adjustment
according to speed.
Change current display.
Quit selection menu or go from a submenu to a higher
level menu.
Telephone mode.
Navigation mode.
Go to main menu.
Turn: select function.
Press: confirm selected function.
Access function menus.–
–
–
–
–
–
–
Show help menu.
001-025 CONNECT ULISSE GB 20-10-2008 10:08 Pagina 12

14
fig. 2
F0B1005g
SWITCHING THE SYSTEM
ON/OFF
The system will be switched on when
the key is switched to the Mposition.
The system will be switched off when
the key is turned to the Sposition.
With the key at S, press knob (4) to
operate the system for 20 minutes only
to protect the battery charge.
ANTITHEFT PROTECTION
The CONNECT Nav+ system is
provided with an automatic antitheft
system which does not need to be
operated by the user. CONFIGURATION
Press MENU(18); turn and press
the knob (16 – 40) to select the
CONFIGURATION function - fig. 2.
The following settings may be acces-
sed:
– “Display configuration”: turn and
press the knob (16 – 40) to select and
confirm. This function is used to chan-
ge the display colour, adjust brightness,
set the date and time and set the unit
of measure.
– “Sound”: turn and press the knob
(16 – 40) to select and confirm. This
function is used to adjust the voice
control volume, set the voice synthe-
sis parameters and switch the auxiliary
input (RCA socket) located in the
oddment compartment on and off.– “Select language”: turn and press
the knob (16 – 40) to select and con-
firm. This function is used to select the
required language.
– “Define vehicle parameters”: turn
and press the knob (16 – 40) to select
and confirm. This function may be
used switch some vehicle parameters
on and off. The parameters change ac-
cording to the version (e.g. parking
sensors, etc.).
001-025 CONNECT ULISSE GB 20-10-2008 10:08 Pagina 14

15
With the key at M, the audio section
may be switched on and off by pres-
sing the knob (4).
VOLUME ADJUSTMENT
Turn the knob (4) clockwise to turn
the radio volume up and anticlockwi-
se to turn it down.
AUDIO SETTINGS
Sound settings (BASS/ TREBLE), ba-
lance (BAL), fader (FAD), loudness
(LOUD), automatic volume and type
of sound (musical ambiance) may be
adjusted. The balance and fader func-
tions emphasise the sound from the
left/right and the front/rear speakers.
The loudness function is used to
emphasise the bass and treble tone
when the volume is low. To access the
audio settings function, repeatedly
press
(11) to adjust bass (BASS),
treble (TREB), loudness (LOUD), fa-
der (FAD), balance (BAL), automatic
volume and sound type (musical am-
bience).The system will deactivate the audio
adjustment system after a few seconds
if no action is performed or if the ESC
(9 - 36) is pressed after making the
setting.
IMPORTANTThe bass and treble
settings are source specific. They may
be adjusted separately in RADIO, CD
or CD changer mode.
Bass settings (BASS)
When the message “BASS” appears
on the display, turn the knob (4) to
adjust the setting as follows:
– “BASS -9” for setting bass to mi-
nimum level;
– “BASS 0” for setting bass to me-
dium level;
– “BASS +9” for setting bass to maxi-
mum level.Treble setting (TREB)
When the message “TREB” appears
on the display, turn the knob (4) to
adjust the setting as follows:
– “TREB -9” for setting treble to mi-
nimum level;
– “TREB 0” for setting treble to me-
dium level;
– “TREB +9” for setting treble to
maximum level.
Loudness function (LOUD)
This function allows to automatical-
ly emphasise bass and treble settings
when the volume is low. Simply turn
the knob (4) to switch the function on
and off.
AUDIO
001-025 CONNECT ULISSE GB 20-10-2008 10:08 Pagina 15

17
Automatic station search
Briefly press ÷(19) or ˜(14)
to select either the previous or the
next station.
Hold the button corresponding the
chosen direction pressed to change
frequency continuously.
Tuning will stop at the first recei-
veable station when the button is re-
leased.
Only the stations transmitting traf-
fic information will be selected if the
TA function is on.
Station search is firstly run with “LO”
sensitivity (most powerful stations)
and then with “DX” sensitivity
(weaker stations).
To perform a search with “DX” sen-
sitivity directly, press ÷(19) or
˜(14) twice.Manual station search
Briefly press
▲ (10) or ▼(17). Hold
the button corresponding the chosen
direction pressed to change frequency
continuously. Tuning will end as soon
as the button is released.
Manual stations store
Proceed as follows to manually sto-
re stations:
– tune to the required station;
– press one of the buttons from 1to
6(20) and hold the button pressed
until you hear the acoustic tone.
Automatic FM station store
(Autostore)
Hold BAND/AST(22) pressed to
activate the “Autostore” function.
When this function is on, the radio will
automatically store the six FM band
stations with the strongest signal.The message “FMAST” will appear
on the display during automatic tuning.
The stations will be automatically sa-
ved under buttons from 1 to 6 of key-
pad (20). After saving, the radio will
be automatically tuned to the first sta-
tion in the FMAST band, correspon-
ding to the frequency stored under se-
lection button 1 of keypad (20).
Each station is stored only one. Re-
gional programmes may be stored twi-
ce.
The system will work as follows
when the Autostore function is on:
– all other functions are off when Au-
tostore starts;
– Autostore is stopped when the
source is changed (radio, CD, CD
changer) during the function;
– volume adjustments will not ap-
pear on the display.
001-025 CONNECT ULISSE GB 20-10-2008 10:08 Pagina 17

21
– “Program tracks”: this function is
used to play the tracks on the CD. Se-
lect and confirm the function. A keypad
will appear on the display for entering
the number of tracks to be program-
med: “reset” cancels all selected tracks,
“delete” cancels the last selected track,
“OK” confirms the selection.
LIST function
This function is used to display the li-
st of tracks on the CD. Press LIST
(15) while playing a CD to activate the
function. Turn and press the knob (16
- 40) to select and start playback.CD CHANGER MODE
(where provided)
(not compatible with MP3 CDs)
To guarantee best sound playback,
we recommend using original CDs. If
CD-R/RW are used, we recommend
using good quality media that are bur-
ned at the slowest speed possible.
IMPORTANT Do not use 8-cm
audio CDs even with a specific adap-
ter. This type of disk may damage the
system.
Select radio mode and repeatedly
press SOURCE(3) o SRC(30) to
select CD changer mode.
How to select a CD
Press buttons from 1 to 6 on the
keypad (20) to select the required
CD.How to select a track
Proceed as follows to select a track
on a CD in the CD changer:
– briefly press ˜(14) to select
the next track;
– briefly press ÷(19) to play the
current track from the beginning and
press it again to go to the previous
track.
Fast track search
(forward/backward)
Hold ˜(14) or ÷(19) press
to play the CD tracks at fast speed
either forwards or backwards. Relea-
se the button to return to normal
playback speed.
CD changer mode menu
Repeatedly press MODE(25- 35)
to display audio mode.
Press (16 - 40) until the following
menu appears on the display:
001-025 CONNECT ULISSE GB 20-10-2008 10:08 Pagina 21

25
During the album copying step, the
albums already copied to the hard di-
sk and the CD cannot be played.
The system will automatically com-
pact the CD in MP3 format if the
tracks are not already in MP3 format.
Hold SOURCE(3) pressed to start
copying the CD.
Turn and press the knob (16 – 40)
select “Stop the copy” to stop.How to rename an album
Press MENU(18 – 41) and select
“Audio functions” by turning and pres-
sing the knob (16 – 40).
Select the “Jukebox” function and
then “Jukebox management” by turn-
ing and pressing the knob (16 – 40).
Select the album to be renamed by
turning the pressing the knob (16 –
40).
Select “Rename” and use the al-
phanumeric keypad to assign a new
name to the selected album.
Select “OK” by turning the knob (16
– 40) and press to confirm. Playing the jukebox
Repeatedly press SOURCE(3) to
select the “Jukebox” function.
Press LIST(15), turn and press the
knob (16 – 40) to select the tracks.
001-025 CONNECT ULISSE GB 20-10-2008 10:08 Pagina 25