FORD AEROSTAR 1996 1.G Workshop Manual

Page 51 of 353

49
*
[SR30080(ALL)05/95]
RWARNING
Never leave a child unattended in your
vehicle.
*
[SR30090(ALL)05/95]
RWARNING
Safety belts and seats can become hot in a
vehicle that has been closed up in sunny
weather; they could burn a small child.
Check seat covers and buckles before you
place a child anywhere near them.
*
[SR30100(ALL)06/95]
RWARNING
Failure to follow all of the instructions on
the use of this child restraint system can
result in your child striking the vehicle's
interior during a sudden stop or crash.
*
[SR30110(ALL)05/95]
How to use the Built-In Child Seat
*
[SR30120(ALL)05/95]
Read the following procedures and all of the
labels on the Built-In Child Seat before using the
seat.
*
[SR30130(ALL)07/95]
RWARNING
Never use the Built-In Child Seat as a
booster cushion with the adult safety
belts. A child using the adult belts could
slide forward and out from under the
safety belts.
[SR30140(ALL)06/95]
1. Pull the headrest release strap and grasp the
headrest as shown in Figure 1. Then release
the strap and rotate the headrest fully until
the latch ªclicksº in the full up position.
File:03cpsra.ex
Update:Tue Aug 29 17:35:04 1995

Page 52 of 353

50 [SR30155(ALL)08/95]
one third page art:0095048-AFigure 1
*
[SR30160(ALL)05/95]
2. Continue to unfold the child seat until it
rests on the seat as shown in Figure 2.
[SR30170(ALL)06/95]
half page art:0095049-A
Figure 2
File:03cpsra.ex
Update:Tue Aug 29 17:35:04 1995

Page 53 of 353

51 [SR30190(ALL)05/95]
3. Read the information and warnings on the
child seat. Check the child's size, weight and
age to be sure the child is not too small or
too large for the child seat. Refer to Figure 3.
[SR30195(ALL)06/95]
two third page art:0095050-A
Figure 3
[SR30200(ALL)06/95]
4. Pull up on the two black looped straps at
the upper corners of the child seat to unsnap
the cushion protector flap.
[SR30210(ALL)05/95]
5. Lower the seat cushion.
[SR30230(ALL)05/95]
6. Pull the lap and shoulder belts cinch release
strap while pulling the shoulder belts fully
out. Refer to Figures 4 and 5.
File:03cpsra.ex
Update:Tue Aug 29 17:35:04 1995

Page 54 of 353

52 [SR30240(ALL)05/95]
half page art:0095051-AFigure 4
[SR30250(ALL)05/95]
one third page art:0095052-A
Figure 5
*
[SR30260(ALL)05/95]
6. If connected, squeeze the top and the bottom
of the right half of the chest clip and pull to
separate both halves.
File:03cpsra.ex
Update:Tue Aug 29 17:35:04 1995

Page 55 of 353

53 [SR30270(ALL)06/95]
7. Place the child on the child seat and position
the shoulder belts over each shoulder. Refer
to Figure 6.
[SR30280(ALL)06/95]
one third page art:0095053-A
Figure 6: Shoulder safety belt placement on the child
[SR30300(ALL)08/95]
8. Insert either the left or right safety belt
tongue into the single opening of the crotch
belt buckle as shown in Figure 7. (It does
not matter which tongue is inserted first.)
Then insert the other tongue.
*
[SR30310(ALL)06/95]
RWARNING
If both tongues do not latch in the buckle,
do not use the child seat. See your dealer
for repairs.
[SR30320(ALL)06/95]
one third page art:0095054-A
Figure 7: Fastening the crotch safety belt buckle
File:03cpsra.ex
Update:Tue Aug 29 17:35:04 1995

Page 56 of 353

54 [SR30330(ALL)08/95]9. Fasten both halves of the chest clip below
the child's shoulders and adjust it to
comfortably hold the shoulder belts in place
on the child's chest. The purpose of this clip
is to position the shoulder belts correctly on
the child's shoulders. The clip can be easily
pulled apart, and is designed to pull apart
during a collision. The clip helps keep the
shoulder belts on the shoulders of a sleeping
or squirming child. Refer to Figure 8.
[SR30340(ALL)05/95]
one third page art:0095055-A
Figure 8: Securing the chest clip
File:03cpsra.ex
Update:Tue Aug 29 17:35:04 1995

Page 57 of 353

55 [SR30350(ALL)08/95]
10. Pull the shoulder belts out to ensure that the
crotch safety belt buckle is securely fastened.
Adjust the lap and shoulder belts by pulling
firmly on the adjustment belt. Refer to
Figure 9.
[SR30360(ALL)05/95]
half page art:0095056-A
Figure 9: Checking for securely latched buckle and locked
retractor
[SR30370(ALL)08/95]
11. If the shoulder belts are pulled too tight,
pull on the lap and shoulder belts cinch
release strap to loosen the shoulder belts on
the child's shoulders. Refer to Figure 4. Then
retighten the lap and shoulder adjustment
belt per Step 10 above.
File:03cpsra.ex
Update:Tue Aug 29 17:35:04 1995

Page 58 of 353

56
*
[SR30380(ALL)05/95]
To remove the child from the built-in child
seat:
[SR30390(ALL)06/95]
1. Squeeze the tabs on the top and bottom of
the chest clip and pull the halves apart to
open the chest clip. Refer to Figure 8.
*
[SR30400(ALL)06/95]
2. Press the release button on the crotch safety
belt buckle.
[SR30410(ALL)05/95]
3. Slide the shoulder belts off the child's
shoulders and remove the child. Refer to
Figure 6.
*
[SR30420(ALL)06/95]
To stow the built-in child seat:
[SR30430(ALL)05/95]
1. Return the child seat cushion to the upright
position and lift the protector flap toward
the headrest.
[SR30440(ALL)05/95]
2. Fasten the snaps securely.
[SR30450(ALL)05/95]
3. Pull on the headrest release strap and rotate
the headrest downward until it latches
against the child seat cushion.
[SR30460(ALL)05/95]
RWARNING
Always fasten the protector flap snaps
when stowing your child seats to prevent
the child seat cushion from rotating
forward in a collision.
[SR30470(ALL)05/95]
The seat can now be used by an adult.
File:03cpsra.ex
Update:Tue Aug 29 17:35:04 1995

Page 59 of 353

57
*
[SR30480(ALL)05/95]
Inspection after a collision
*
[SR30490(ALL)06/95]
RWARNING
All built-in child restraints, including
seats, buckles, retractors, seat latches,
interlocks, and attaching hardware should
be inspected by a qualified dealer
technician after any collision.
*
[SR30495(ALL)08/95]
If the child seat was in use during a collision,
Ford recommends replacing it. However, if the
collision was minor and a qualified technician
finds that the child restraints do not show
damage and continue to operate properly, they
do not need to be replaced. If there is any
bending of the vehicle seatback or seat structure,
it should also be replaced. Built-in child seats
not in use during a collision should also be
inspected and replaced if either damage or
improper operation is noted.
*
[SR30500(ALL)05/95]
Built-in child seat maintenance
*
[SR30510(ALL)05/95]
Regularly inspect the lap and shoulder belts
system of your child seat. See your Ford dealer
if the shoulder belt webbing is frayed, or if the
buckle and tongue are damaged and/or do not
function properly.
%*
[SR30520(ALL)05/95]
Cleaning
*
[SR30530(ALL)08/95]
Your Built-In Child Seat may be cleaned with
mild soap and water. Do not use household
cleaners as they may weaken the webbing or
damage the plastic parts. For your convenience,
the liner can be removed, machine-washed, and
air-dried.
File:03cpsra.ex
Update:Tue Aug 29 17:35:04 1995

Page 60 of 353

58 %
*
[SR30540(ALL)07/95]
Safety Belts for Children
*
[SR30550(ALL)07/95]
Children who are too large for child safety seats
should always wear safety belts. (See instructions
with your child seat, or contact its manufacturer,
to determine maximum size of child that will
safely fit in the seat.)
*
[SR30560(ALL)07/95]
RWARNING
If safety belts are not properly worn and
adjusted as described, the risk of serious
injury to the child in a collision will be
much greater.
*
[SR30570(ALL)07/95]
If the shoulder belt portion of one of the lap and
shoulder belts can be positioned so that it does
not cross or rest in front of the child's face or
neck, the child should wear the lap and shoulder
belt. Moving the child closer to the center of the
vehicle may help provide a good shoulder belt
fit.
*
[SR30580(ALL)07/95]
To improve the fit of lap and shoulder belts on
children who have outgrown child safety seats,
Ford recommends use of a belt-positioning
booster seat that is labelled as conforming to all
Federal motor vehicle safety standards.
Belt-positioning booster seats raise the child and
provide a shorter, firmer seating cushion that
encourages safer seating posture and better fit of
lap and shoulder belts on the child. A
belt-positioning booster should be used if the
shoulder belt rests in front of the child's face or
neck, or if the lap belt does not fit snugly on
both thighs, or if the thighs are too short to let
the child sit all the way back on the seat cushion
when the lower legs hang over the edge of the
seat cushion. You may wish to discuss the
specific needs of your child with your
pediatrician.
File:03cpsra.ex
Update:Tue Aug 29 17:35:04 1995

Page:   < prev 1-10 ... 11-20 21-30 31-40 41-50 51-60 61-70 71-80 81-90 91-100 ... 360 next >