FORD C MAX 2008 1.G Owners Manual

Downloaded from www.Manualslib.com manuals search engine BATTERY CARE
The battery requires very littlemaintenance. The fluid level ischecked regularly during the routineservice inspections.
USING BOOSTER
CABLES
CAUTIONS
Connect batteries with only thesame nominal voltage.
Always use booster cables withinsulated clamps and adequatesize cable.
Do not disconnect the batteryfrom the vehicle’s electricalsystem.
To connect the boostercables
Flat battery vehicleA
Booster battery vehicleB
209
Vehicle batteryABCDE75183

Downloaded from www.Manualslib.com manuals search engine Positive connection cableC
Negative connection cableD
1.Position the vehicles so that theydo not touch one another.
2.Switch off the engine and anyelectrical equipment.
3.Connect the positive (+) terminalof vehicle B with the positive (+)terminal of vehicle A (cable C).
4.Connect the negative (-) terminalof vehicle B to the groundconnection on the left-hand sidesuspension turret of vehicle A(cable D).
CAUTIONS
Do not connect to thenegative (–) terminal of theflat battery.
Make sure that the jump leadsare clear of any moving parts.
To start the engine
1.Run the engine of vehicle B atmoderately high speed.
2.Start the engine of vehicle A.
3.Run both vehicles for a minimumof three minutes beforedisconnecting the cables.
CAUTION
Do not switch on the headlampswhen disconnecting the cables.The peak voltage could blow thebulbs.
Disconnect the cables in the reverseorder.
CHANGING THE VEHICLE
BATTERY
Vehicles with a petrolengine
If the battery has been disconnectedthe vehicle may exhibit some unusualdriving characteristics forapproximately 8 km (5 miles) afterbattery reconnection while theengine management system realignsitself with the engine.
210
Vehicle battery

Downloaded from www.Manualslib.com manuals search engine GENERAL INFORMATION
CAUTIONS
Use only approved wheel andtyre sizes. Using other sizescould damage the vehicle and willmake the National Type Approvalinvalid.
If you change the diameter of thetyres from that fitted at thefactory, the speedometer may notdisplay the correct speed. Take thevehicle to your dealer to have theengine management systemreprogrammed.
A decal with tyre pressure data islocated in the driver’s door openingat the B-pillar.
Check and set the tyre pressure atthe ambient temperature in whichyou are intending to drive the vehicleand when the tyres are cold.
CHANGING A ROAD
WHEEL
Spare wheel
Your vehicle is equipped with eithera spare wheel or a tyre repair kit(ContiMobilityKit). See Tyre repairkit (page 217).
All vehicles
WARNINGS
Use only approved wheel andtyre sizes. Using other sizescould damage the vehicle and willmake the National Type Approvalinvalid.
If you change the diameter ofthe tyres from that fitted at thefactory, the speedometer may notdisplay the correct speed. Take thevehicle to your dealer to have theengine management systemreprogrammed.
Vehicles with a temporaryspare wheel
WARNINGS
If the spare wheel differs fromthe other fitted wheels, theserules must be followed:
Do not exceed 80 km/h (50mph).
Drive the shortest possibledistances.
Do not fit more than one sparewheel on your vehicle at anyone time.
Do not use snow chains on thistype of wheel.
Do not drive through anautomatic car wash.
211
Wheels and tyres

Downloaded from www.Manualslib.com manuals search engine Vehicles with stability control
Vehicles with ESP may exhibit someunusual driving characteristics. Switchthe ESP off. See Using stabilitycontrol (page 161).
All vehicles
Note:The spare wheel is locatedunder the floor cover in the luggagecompartment.
•Raise the rear of the floor cover inthe luggage compartment.
1.Completely unscrew the boltanticlockwise.
2.Lift out the spare wheel.
3.Remove the jack which is locatedbeneath the spare wheel.
4.Install the defective wheel in thereverse order.
Vehicle jack
WARNINGS
The vehicle jack supplied withyour vehicle should only be usedwhen changing a wheel inemergency situations.
Before using the vehicle jack,check that it is not damaged ordeformed and that the thread islubricated and free from foreignmatter.
Never place anything betweenthe jack and the ground, or thejack and the vehicle.
Note:The vehicle jack is located inthe underfloor storage compartmentunder the spare wheel.
Note:Vehicles with a tyre repair kitor run flat tyres are not equipped witha vehicle jack or a wheel brace.
It is recommended to use aworkshop type hydraulic jack forchanging between summer andwinter tyres.
Note:Use a jack with a minimumlifting capacity of 1.5 tonnes and alifting plate with a minimum diameterof 80 millimetres (3.1 inches).
212
Wheels and tyresE72563 E72564

Downloaded from www.Manualslib.com manuals search engine 1.Remove the spare wheel.
2.Unscrew the retaining bolt byturning anti-clockwise andremove the jack with the wheelbrace.
1.After using the jack, turn thehandle until the arrow on the armpoints directly towards the dot inorder to attach the wheel braceto the jack.
2.Clip the wheel brace onto the jackhandle and fold the handle backagainst the jack as shown in thegraphic.
Jacking and lifting points
CAUTION
Use only the specified jackingpoints. If you use other positions,you may damage the body, steering,suspension, engine, braking systemor the fuel lines.
213
Wheels and tyresE78134 E78135

Downloaded from www.Manualslib.com manuals search engine Emergency use onlyA
MaintenanceB
Indentations in the sills A show thelocation of the jacking points.
214
Wheels and tyresE92658AB E93184A

Downloaded from www.Manualslib.com manuals search engine Removing a wheel
All vehicles
WARNINGS
Park your vehicle in such aposition that neither the trafficnor you are hindered or endangered.
Set up a warning triangle.
Make sure that the vehicle is onfirm, level ground with thewheels pointing straight ahead.
WARNINGS
Switch off the ignition and applythe parking brake.
If your vehicle has a manualtransmission, select first orreverse gear. If it has an automatictransmission, select park.
Have the passengers leave thevehicle.
Secure the diagonally oppositewheel with an appropriate blockor wheel chock.
Make sure that the arrows ondirectional tyres point in thedirection of rotation when the vehicleis moving forwards. If you have to fita spare wheel with the arrowspointing in the opposite direction,have the tyre refitted in the correctdirection by a properly trainedtechnician.
Do not work underneath thevehicle when it is supported onlyby a jack.
Make sure that the jack isvertical to the jacking point andthe base is flat on the ground.
CAUTION
Do not lay alloy wheels facedown on the ground, this willdamage the paint.
215
Wheels and tyresE92932 E93020

Downloaded from www.Manualslib.com manuals search engine •Insert the flat end of the wheelbrace between the rim and thehub cover and twist carefully toremove the cover.
Vehicles with locking wheelnuts
Note:Replacement locks and wheelnuts can be obtained using the wheelnut reference number certificate.
•Insert the nut key onto the lockingnut.
All vehicles
1.Slacken the wheel nuts.
2.Place the jack with the whole footarea on firm ground.
3.Jack up the vehicle until the wheelis clear of the ground.
4.Unscrew and remove the wheelnuts and take off the wheel.
Fitting a wheel
All vehicles
Note:Make sure that you use thecorrect wheel nut for the type ofwheel, if in doubt check with yourdealer.
1.Push the wheel onto the wheelstuds.
2.Screw on the wheel nuts andsecure in a clockwise directionensuring that the tapered end ofthe wheel nuts is facing the wheel.
3.Lower the vehicle and remove thejack.
Vehicles with locking wheelnuts
•Insert the nut key onto the lockingnut.
216
Wheels and tyresE78139 E72572

Downloaded from www.Manualslib.com manuals search engine All vehicles
1.Fully tighten the wheel nuts in thepattern shown.
2.Press the hub cap firmly with theball of the hand.
3.Stow the locking nut and thewheel brace safely.
4.Stow the jack and defective wheelin reverse order and secure them.
Note:Have the tightening torque ofthe wheel nuts and the tyre pressurechecked as soon as possible.
TYRE REPAIR KIT
Your vehicle may not have a sparetyre. In this case it will have anemergency tyre repair kit that can beused to repair one flat tyre.
The tyre repair kit is located in thespare wheel well.
General information
WARNINGS
Depending on the type andextent of tyre damage, sometyres can only be partially sealed ornot sealed at all. Loss of tyrepressure can affect vehicle handling,leading to loss of vehicle control.
Do not use the tyre repair kit ifthe tyre has already beendamaged as a result of being drivenunder inflated.
Do not try to seal damage otherthan that located within thevisible tread of the tyre.
Do not try to seal damage to thetyre’s sidewall.
The tyre repair kit seals most tyrepunctures [with a diameter of up tosix millimetres (1/4 inch)] totemporarily restore mobility.
Observe the following rules whenusing the kit:
•Drive with caution and avoidmaking sudden steering ordriving manoeuvres,especially if the vehicle is heavilyloaded or you are towing a trailer.
•The kit will provide you with anemergency temporary repair,enabling you to continue yourjourney to the next vehicle or tyredealer, or to drive a maximumdistance of 200 kilometres(125 miles).
•Do not exceed a maximumspeed of 80 km/h (50 mph).
217
Wheels and tyresE72573

Downloaded from www.Manualslib.com manuals search engine •Keep the kit out of the reach ofchildren.
•Only use the kit when the ambienttemperature is between –30°C(-22°F) and +70°C (+158°F).
Using the tyre repair kit
WARNINGS
Compressed air can act as anexplosive or propellant.
Never leave the tyre repair kitunattended while in use.
CAUTION
Do not keep the compressoroperating for more than 10minutes.
Note:Use the tyre repair kit only forthe vehicle with which it was supplied.
•Park your vehicle at the roadsideso that you do not obstruct theflow of traffic and so that you areable to use the kit without beingin danger.
•Apply the parking brake, even ifyou have parked on a level road,to make sure that the vehicle willnot move.
•Do not attempt to remove foreignobjects like nails or screwspenetrating the tyre.
•Leave the engine running whilethe kit is in use, but not if thevehicle is in an enclosed or poorlyventilated area (for example,inside a building). In thesecircumstances, switch thecompressor on with the engineturned off.
•Replace the sealant bottle with anew one before the expiry date(see top of bottle) is reached.
•Inform all other users of thevehicle that the tyre has beentemporarily sealed with the tyrerepair kit and make them awareof the special driving conditions tobe observed.
Inflating the tyre
WARNINGS
Check the sidewall of the tyreprior to inflation. If there are anycracks, bumps or similar damage, donot attempt to inflate the tyre.
Do not stand directly beside thetyre while the compressor ispumping.
Watch the sidewall of the tyre.If any cracks, bumps or similardamage appear, turn off thecompressor and let the air out bymeans of the pressure relief valve B.Do not continue driving with this tyre.
The sealant contains naturalrubber latex. Avoid contact withskin and clothing. If this happens,rinse the affected areas immediatelywith plenty of water and contact yourdoctor.
218
Wheels and tyres