trailer FORD MUSTANG 2003 Workshop Manual

DESCRIPTION AND OPERATION
Maintenance Schedule —
Vehicles with Gasoline Engines
The maintenance schedule is designed to protect against major repairs resulting from neglect or
inadequate maintenance and to prolong the life of the vehicle.
General Maintenance Information
NOTE: This is a generic maintenance schedule for all Ford, Lincoln and Mercury vehicles. There may
be items listed that do not apply to all vehicles.
The Normal Schedule applies to operation of the vehicle under typical, everyday driving conditions.
The maintenance frequency in this schedule typifies what the vast majority of vehicles will require. The
listed services should be carried out at specified mileage intervals. There are, however, additional
services required that only the noted vehicles require.
If the vehicle is operated in one or more of the following special operating conditions, those additional
services will be required. The special operating conditions are:
ztowing or carrying heavy loads.
z extensive idling and/or driving at low speeds for long distances.
z driving in dusty conditions.
z off- road operation.
There are also exceptions to the Normal Operating Schedule which will require more frequent
maintenance for some components. Those exceptions are:
znatural gas and propane vehicles — fuel tank intervals.
z normal vehicle axle — maintenance and lubrication.
z police and taxi vehicles — maintenance and lubrication.
z engine oil and yellow coolant — time and mileage-based interval.
Special Operating Condition Requirements
When towing a trailer or using a camper or car- top carrier:
z Change engine oil and install a new oil filter every 4,800 km (3,000 miles) or 3 months.
z Change transfer case fluid every 96,000 km (60,000 miles).
z Change manual transmission fluid as required.
z Inspect and lubricate U- joints as required.
During extensive idling and/or low speed driving for long distances, as in heavy commercial use such
as delivery, taxi, patrol car or livery: SECTION 100-
03: Maintenance Schedule 2003 Mustang Workshop Manual Klj . 1 ba
112003 Mustang Workshop Manual
17. 11. 2011file:///C:/Ford/2000 - 2004/tsocache/SHEF_4464/S3B~us~en~ ...

Exceptions To Normal Schedule
Yellow Coolant
zChange coolant at 5 years or 160,000 km (100,000 miles) of the vehicle's life, whichever comes
first.
z After the initial change, change coolant every 3 years or 80,000 km (50,000 miles) thereafter.
Natural Gas and Propane Vehicles
zInspect NGV fuel tanks from the date of tank manufacture every 3 years.
z Inspect propane fuel tanks from vehicle build date every 5 years.
z Install new NGV fuel tanks from the date of tank manufacture every 15 years.
Normal Vehicle Axle Maintenance
Rear axles and power take off (PTO) units containing synthetic lubricant and light duty trucks equipped
with Ford- design axles are lubricated for life. These lubricants are not to be checked or changed
unless service is required, or if a leak is suspected, or the axle assembly has been submerged in
water.
The axle and PTO should be changed anytime they have been submerged in water. Non- synthetic
rear axle lubricants should be replaced every 4,800 km (3,000 miles) or three months, whichever
occurs first, during extended trailer tow operation above 21°C (70°F) ambient and wide open throttle
for extended periods above 45 mph.
The 3,000 mile lube change interval may be waived if the axle was filled with 75W140 synthetic gear
lubricant meeting Ford specification WSL- M2C192-A, part number F1TZ-19B546- B or equivalent. Add
four ounces of additive friction modifier C8AZ-19B546- A (EST-M2C118- A) or equivalent for complete
refill of Traction- Lok rear axles.
The axle lubricant should be changed anytime an axle has been submerged in water.
Police and Taxi Vehicle Axle Maintenance
Replace rear axle lubricant every 160,000 km (100,000 miles). Rear axle lubricant change may be
waived if the axle was filled with 75W140 synthetic gear lubricant meeting Ford specification WSL-
M2C192- A, part number FITZ-19580-B or equivalent. Add four ounces of additive friction modifier
C8AZ- 19B546- A (EST-M2C118- A) or equivalent for complete refill of Traction- Lok rear axles.
The axle lubricant should be changed anytime an axle has been submerged in water. Klj . 10 ba
112003 Mustang Workshop Manual
17. 11. 2011file:///C:/Ford/2000 - 2004/tsocache/SHEF_4464/S3B~us~en~ ...

4. WORN RINGS OR DILUTED OIL: When the engine is accelerated (dotted needle), the needle
drops to 0 kPa (0 in- Hg). Upon deceleration, the needle runs slightly above 74 kPa (22 in- Hg).
5. STICKING VALVES: When the needle (dotted) remains steady at a normal vacuum but occasionally flicks (sharp, fast movement) down and back about 13 kPa (4 in- Hg), one or more
valves may be sticking.
6. BURNED OR WARPED VALVES: A regular, evenly- spaced, downscale flicking of the needle
indicates one or more burned or warped valves. Insufficient hydraulic lash adjuster or hydraulic
lash adjuster (HLA) clearance will also cause this reaction.
7. POOR VALVE SEATING: A small but regular downscale flicking can mean one or more valves are not seating.
8. WORN VALVE GUIDES: When the needle oscillates over about a 13 kPa (4 in- Hg) range at idle
speed, the valve guides could be worn. As engine speed increases, the needle will become
steady if guides are responsible.
9. WEAK VALVE SPRINGS: When the needle oscillation becomes more violent as engine rpm is increased, weak valve springs are indicated. The reading at idle could be relatively steady.
10. LATE VALVE TIMING: A steady but low reading could be caused by late valve timing.
11. IGNITION TIMING RETARDING: Retarded ignition timing will produce a steady but somewhat low reading.
12. INSUFFICIENT SPARK PLUG GAP: When spark plugs are gapped too close, a regular, small pulsation of the needle can occur.
13. INTAKE LEAK: A low, steady reading can be caused by an intake manifold or throttle body gasket leak.
14. BLOWN HEAD GASKET: A regular drop of fair magnitude can be caused by a blown head gasket or warped cylinder head- to-cylinder block surface.
15. RESTRICTED EXHAUST SYSTEM: When the engine is first started and is idled, the reading may be normal, but as the engine rpm is increased, the back pressure caused by a clogged
muffler (5230), kinked tail pipe or other concerns will cause the needle to slowly drop to 0 kPa
(0 in-Hg). The needle then may slowly rise. Excessive exhaust clogging will cause the needle to
drop to a low point even if the engine is only idling.
16. When vacuum leaks are indicated, search out and correct the cause. Excess air leaking into the system will upset the fuel mixture and cause concerns such as rough idle, missing on
acceleration or burned valves. If the leak exists in an accessory unit such as the power brake
booster (2005), the unit will not function correctly. Always fix vacuum leaks.
Excessive Engine Oil Consumption
The amount of oil an engine uses will vary with the way the vehicle is driven in addition to normal
engine- to-engine variation. This is especially true during the first 16,100 km (10,000 miles) when a new
engine is being broken in or until certain internal engine components become conditioned. Vehicles
used in heavy- duty operation may use more oil. The following are examples of heavy- duty operation:
z trailer towing applications
z severe loading applications
z sustained high speed operation Klj . 12 ba
172003 Mustang Workshop Manual
17. 11. 2011file:///C:/Ford/2000 - 2004/tsocache/SHEF_4464/S3B~us~en~ ...

CAUTION: The vehicle should not be driven if the fluid level indicator shows the fluid
below the DO NOT DRIVE mark or internal failure could result.
NOTE: If the vehicle has been operated for an extended period, at high highway speeds, in city traffic,
during hot weather, or while pulling a trailer, the fluid needs to cool down to obtain an accurate
reading.
NOTE: The fluid level reading on the indicator will differ from operating and ambient temperatures. The
correct reading should be within the normal operating temperature range.
Under normal circumstances the fluid level should be checked during normal maintenance. If the
transmission starts to slip, shifts slowly, or shows signs of fluid leaking, the fluid level should be
checked.
1. With the transmission in P (PARK), the engine at idle, foot pressed on the brake, move the range selector lever through each gear and allow engagement of each gear. Place the
transmission range selector lever in the P position.
2. Wipe the fluid level indicator cap and remove the indicator.
3. Wipe the indicator with a clean cloth.
4. Install the indicator back in the filler tube until it is fully seated, then remove the indicator. The fluid level should be within the normal operating temperature range.
High Fluid Level
A fluid level that is too high may cause the fluid to become aerated due to the churning action of the
rotating internal parts. This will cause erratic control pressure, foaming, loss of fluid from the vent tube,
and possible transmission failure. If an overfill reading is indicated, drain and refill the transmission.
Low Fluid Level
A low fluid level could result in poor transmission engagement, slipping, or failure. This could also
indicate a leak in one of the transmission seals or gaskets. Adding Fluid Item Description
1 Fluid level at room temperature 10°-
35°C (50°-95°F) 2 Fluid level at operating temperature 66°-
77°C (150°-170°F) 3 Do not drive mark Klj . 2 ba
32003 Mustang Workshop Manual
18. 11. 2011file:///C:/Ford/2000 - 2004/tsocache/SHEF_2748/S3B~us~en~ ...

SIR Coil Assembly (Clockspring)Air Bag Restraint System
Slip Ring (Clockspring)Air Bag Restraint System; Steering Column Switches
SRS Control ModuleAir Bag Restraint System
Starter MotorStarters
Starter Interrupt RelayStarters
Starter SolenoidStarters
Starter RelayStarters
Steering Wheel Position SensorAnti-Lock Brakes
StoplightsExterior Lights
Stoplight SwitchEngine Performance; Cruise Control Systems;
Anti-Lock Brakes
Sun Roof ECUPower Sun Roof
Sun Roof MotorPower Sun Roof
Sun Roof Position SensorPower Sun Roof
TaillightsExterior Lights
Throttle Position (TP) SensorEngine Performance
Torque Converter Clutch Solenoid/SwitchEngine Performance
Traction Control SwitchAnti-Lock Brakes
Trailer Tow ConnectorExterior Lights
Trailer Tow RelayExterior Lights
Transmission/TransaxleEngine Performance
Transmission Control Module (TCM)Engine Performance; Starters
Transmission Range SensorStarters; Back-Up Lights; Engine Performance
Transmission Range SwitchBack-Up Lights; Engine Performance; Anti-Theft
System
Turn Signal FlasherExterior Lights
Turn Signal LightsExterior Lights
Twilight Sentinel SwitchHeadlight Systems; Daytime Running Lights
Vapor Canister Le ak Detection PumpEngine Performance
Vehicle Control Module (VCM)Engine Performance
Vehicle Dynamic ModuleElectronic Suspension
Vehicle Speed Control ServoCruise Control Systems
Vehicle Speed SensorData Link Connectors; Analog Instrument Panels;
Cruise Control Systems; Electronic Suspension
Voltage RegulatorGenerators & Regulators
Water-In-Fuel SensorEngine Performance; Analog Instrument Panels
Wheel Speed SensorsAnti-Lock Brakes
Window Timer ModulePower Convertible Top
Windshield Intermittent Wiper RelayWiper/Washer Systems
Windshield Washer MotorWiper/Washer Systems
Wiper MotorWiper/Washer Systems

111
15 ноября 2011 г. 20:18:43Page 9 © 2006 Mitchell Repair Information Company, LLC.