reset FORD MUSTANG 2013 5.G User Guide

RESET FOR SYSTEM CHECK
When this message appears, press
the RESET button and the
information display will begin to
cycle through the following systems
and provide a status of the item if
needed.
1. XXX% OIL LIFE
2. CHARGING SYSTEM
3. DOORS STATUS
4. TRUNK STATUS
5. BRAKE SYSTEM
6. FUEL LEVEL
7. MYKEY DISTANCE (if MyKeyis programmed)
8. MYKEY(S) PROGRAMMED
9. ADMIN KEYS PROGRAMMED
Note:Some systems show a message only if a condition is present.
OIL LIFE
This displays the remaining oil life.
An oil change is required whenever indicated by the information center
and according to the recommended maintenance schedule. USE ONLY
RECOMMENDED ENGINE OILS.
To reset the oil monitoring system to 100% after each oil change perform
the following:
1. Press and release SETUP to display “OIL LIFE XXX% HOLD RESET =
NEW”.
2. Press and hold RESET for two seconds and release to reset the oil life
to 100%.
STEERING FEEL
This feature allows three modes of steering feel.
Press RESET to cycle through the settings of:
•STANDARD–Provides a balance between a comfort and sport feel.
•SPORT–Slightly higher effort required for steering with more road
force felt through the steering wheel. See note below.
98Information Displays
2013 05+ Mustang(197)
Owners Guide gf, 1st Printing
USA(fus)

•COMFORT–Slightly less effort required for steering with less road
force felt through the steering wheel.
Note:When AdvanceTracsport mode is on or when AdvanceTracand
traction control are off, the steering feel will be locked in sport mode.
The display will show STEERING FEEL <SPORT> LOCKED and the
steering feel will not be selectable.
HALO LIGHT
Turns the halo lighting around the gauges on or off.
Press and hold RESET to turn the feature on or off.
AMBIENT LIGHT
Turns the ambient lighting on or off. Ambient lighting provides accent
lighting in various locations such as footwell areas, cup holders and the
center console bin. The parking lamps/headlamps must be on to use
ambient lighting.
Press and hold RESET to turn the feature on or off.
AMBIENT DIM
Use this to adjust the brightness of the ambient lighting.
Press RESET to choose the various settings.
GAUGE COLOR, AMBIENT COLOR, HALO COLOR
GAUGE COLOR:The instrument cluster gauges are backlit with white
backlighting when the headlamps are off. When the headlamps are on,
you can select one of the preset colors for the nighttime gauge
backlighting or create up to three custom colors using the MyColor
feature.
Note:A gauge in a warning condition will be lit red when the headlamps
are on.
AMBIENT COLOR:You can select one of the preset colors for ambient
lighting or create up to three custom colors using the MyColorfeature.
Information Displays99
2013 05+ Mustang(197)
Owners Guide gf, 1st Printing
USA(fus)

HALO COLOR:You can select one of the preset colors for halo lighting
or create up to three custom colors using the MyColorfeature.
Note:Headlamps or parking lamps must be on to set up colors.
To choose colors for the gauges, halo color or ambient lighting do the
following:
1. Press SETUP to reach the GAUGE COLOR, AMBIENT COLOR, or
HALO COLOR menu.
2. Press RESET to scroll through the following color options:
•ICE BLUE•BLUE
•WHITE•ORANGE
•GREEN•RED
•PURPLE•MYCOLOR 1, 2, 3 (SeeHOLD
RESET TO SET MY COLOR 1, 2,
3following, to save personalized
color combinations)
HOLD RESET TO SET MYCOLOR 1, 2, 3 (Saving your own colors)
Apart from the preset colors, you can create your own color by adjusting
the levels of the three primary colors (red, green, and blue) through the
MyColorfeature to achieve any of 125 different combinations. You can
save up to three custom colors in MyColor.
To enter the MyColoradjust mode, do the following (vehicle must be
stationary):
1. Press and hold RESET for three seconds at the MyColor 1, 2 or 3
menu option to reach the MyColoradjust mode.
2. Press SETUP to scroll through the R (red), G (green), B (blue) and
Exit options.
3. Press RESET to blend in more of the color being adjusted.
4. To save and exit, hold RESET for three seconds when prompted.
Pressing RESET for less than three seconds will cycle back through the
colors.
UNITS
Displays the current units English or Metric.
Press RESET to change from English to Metric.
100Information Displays
2013 05+ Mustang(197)
Owners Guide gf, 1st Printing
USA(fus)

AUTOLAMP (SEC)
This feature keeps your headlights on for up to three minutes after the
ignition is switched off.
Press RESET to select the new Autolamp delay values of 0, 10, 20, 30,
60, 90, 120 or 180 seconds.
AUTOLOCK
This feature automatically locks all vehicle doors when the vehicle is
shifted into any gear and driven.
Press RESET to turn autolock on or off.
AUTOUNLOCK
This feature automatically unlocks all vehicle doors when the driver’s
door is opened within 10 minutes of the ignition being turned off.
Press RESET to turn autounlock on or off.
REAR PARK AID
This feature sounds a warning tone to warn the driver of obstacles near
the rear bumper, and functions only when R (Reverse) gear is selected.
Press RESET to turn it off or on.
CREATE MYKEY / MYKEY SETUP/ CLEAR MYKEY
For more information refer to theMyKeychapter.
LANGUAGE = ENGLISH / SPANISH / FRENCH
Allows you to choose which language for the information display.
Selectable languages are English, Spanish, or French.
Waiting four seconds or pressing the RESET button cycles through each
of the language choices.
Press and hold RESET for two seconds to set the language choice.
Information messages
SeeInformation messageslater in this chapter for more information.
Information Displays101
2013 05+ Mustang(197)
Owners Guide gf, 1st Printing
USA(fus)

†Gauge Mode
Gauges Detail Air/Fuel Ratio Virtual gauge shown
Vacuum inHG /
Boost psi
(Shelby
GT500)Virtual gauge shown
Cyl Head Virtual gauge shown
Inlet Air Virtual gauge shown
Oil Press. No virtual gauge available
Oil Temp. Virtual gauge shown
Trans temp
(auto
transmission
only)Virtual gauge shown
Voltage Virtual gauge shown
†SeeVirtual gaugeslater in this section for more information.
†Trip A/ B
Trip time
Trip distance
Fuel used
Avg mpg(L/100km)
Odometer (displays in lower line and may display in other menus)
†SeeTrip computerlater in this section for more information.
Fuel Economy
Fuel Econ. Instant MPG (L/100km)
mi (km) to E
AVG MPG (L/100km)
Fuel Hist.: shows
fuel usage as a
bar graph based
on time. The
duration time can
be changed.Duration: 5 Minutes, 10 Minutes, 30 Minutes, Last 5
Resets. The graph is updated each minute with the
fuel economy that was achieved during the prior 5,
10, 30 minutes of driving.
Information Displays103
2013 05+ Mustang(197)
Owners Guide gf, 1st Printing
USA(fus)

†Track Apps
Accelerometer
Acceleration timer
Brake Performance
Dashboard
Screen (Shelby
GT500)Launch Control
(Shelby
GT500)Off/On / RPM Setting
View/Clear Results
†SeeTrack appslater in this section for more information.
Settings
Driver Assist Rear Park Aid On/Off
Vehicle Autolamp Delay Off or XXX seconds
Locks Autolock On/Off
Autounlock On/Off
Menu Control Standard: with standard set,
pressing the up/down arrows from
a lower level menu will escape to
the main menu.
Memory On: with memory on set,
pressing the up/down arrows will
navigate to the previous lower
level menu.
Oil Life Reset Set to XXX% (Hold OK to Reset).
Shiftpoint
(Shelby
GT500)Shiftlamp On/Off
Shiftpoint 1500–7000 RPM
Shifttone On/Off
104Information Displays
2013 05+ Mustang(197)
Owners Guide gf, 1st Printing
USA(fus)

Settings
Units English or Metric
System Reset Hold OK to Reset System to Factory Default
†The instrument cluster gauges are backlit white when the headlamps
are off. When the headlamps are on, you can select one of the preset
colors or MyColor 1, 2, 3 for the nighttime gauge backlighting. A gauge
in a warning condition will be backlit red when the headlamps are on.
*Track Application features and messages in the information display are
only available in English.
Information
MyKey Admin Keys (Number of admin keys)
MyKeys (Number of MyKeys programmed)
MyKey Miles (km) (Distance traveled using a
programmed MyKey)
System Check Some items will only display during a system check
if a problem has been detected. If an issue exists on
one of the monitored systems, the number of
warnings that need immediate attention will display
in red and the number of informational warnings will
display in amber. Use the up/down arrow buttons to
scroll through the list; press the right arrow button
to display specific information on the highlighted
warning
TRIP COMPUTER (Trip A and B)
Resetting or pausing the trip computer
•Press OK to pause the Trip A or B screen/press again to un-pause.
•Press and hold OK to reset the currently displayed trip information.
Trip time
Registers the time of individual journeys.
Trip distance
Registers the mileage of individual journeys.
Fuel used
Shows the amount of fuel used for a given trip.
Information Displays107
2013 05+ Mustang(197)
Owners Guide gf, 1st Printing
USA(fus)

Brake Performance
Displays the vehicle’s rate of deceleration.
1. Choose desired speed to start recording data.
2. Follow the on-screen prompts.
Dashboard Screen (ShelbyGT500)
For dashboard screen information, see theShelby GT500 Supplement.
Launch Control (ShelbyGT500)
For launch control information, see theShelby GT500 Supplement.
INFORMATION MESSAGES
Note:Depending on the vehicle options equipped with your vehicle, not
all of the messages will display or be available. Certain messages may be
abbreviated or shortened depending upon which cluster type you have.
Press the RESET button for Type 1 displays or the OK button for Type 2
displays to acknowledge and remove some messages from the
information display. Other messages will be removed automatically after a
short time. Certain messages need to be confirmed before you can access
the menus.
AdvanceTrac/
Traction Control
MessagesAction / Description
SERVICE
ADVANCETRACDisplayed when the AdvanceTracsystem has
detected a condition that requires service.
Contact your authorized dealer as soon as
possible.
ADVANCETRAC
OFFDisplayed when the AdvanceTracsystem has
been disabled by the driver.
ADVANCETRAC ONDisplayed when the AdvanceTracsystem has
been enabled by the driver.
TRACTION
CONTROL OFFDisplayed when the traction control system
has been turned off.
Information Displays111
2013 05+ Mustang(197)
Owners Guide gf, 1st Printing
USA(fus)

Compass Zone Adjustment
When something affects the compass readings, typically the compass
corrects itself after a few days of operating your vehicle in normal
conditions. If the compass still appears to be inaccurate, a manual
calibration may be necessary.
1. Determine which magnetic zone
you are in for your geographic
location by referring to the zone
map.
2. Turn ignition to the on position.
3. Press and hold the 7 and 9 radio
preset buttons together for
approximately five seconds until
ZONE XX appears in the CID.
4. Press and release the 7 and 9
radio preset buttons together,
repeatedly until ZONE XX
changes to the correct zone
(1–15) in the CID.
5. The direction displays after the buttons are released. The zone is now
updated.
Compass Calibration Adjustment
Most geographic areas (zones) have a magnetic north compass point that
varies slightly from the northerly direction on maps. This variation is four
degrees between adjacent zones and becomes noticeable as the vehicle
crosses multiple zones. A correct zone setting eliminates this error.
Perform compass calibration in an open area free from steel structures
and high voltage lines. For optimum calibration, turn off all electrical
accessories (heater/air conditioning, wipers, etc.) and make sure all the
vehicle’s doors are shut.
1. Start the vehicle.
2. Press and hold the 7 and 9 radio preset buttons together for
approximately 10 seconds until CAL appears. Release the buttons.
3. Drive the vehicle in a circle slowly (under than 3 mph [5 km/h]); it
may take up to five circles to complete calibration.
4. When the CAL display changes to the direction value (N, S, E, W,
etc.), the compass is calibrated.
1 2 3
4
5
6 7 8 9 101112 13 14 15
11 6Information Displays
2013 05+ Mustang(197)
Owners Guide gf, 1st Printing
USA(fus)

When you select: You can:
A. Memory presets Store your favorite stations for later access.
When tuned to any station, press and hold a
preset button until sound returns and
PRESET # SAVED appears in the display.
Save presets automatically by using the
autoset feature. Press MENU repeatedly until
AUTO PRESET ON/OFF appears in the
display. Use the SEEK buttons to turn AUTO
PRESET to ON, and either wait five seconds
for the search to initiate or press OK to
immediately start the search. If you press
another control within those five seconds, the
search does not start. The 10 strongest
stations will be filled and the station stored in
preset 1 begins playing. If there are fewer
than 10 strong stations, the system stores the
last one in the remaining presets.
Note:Autoset does not delete your original
preset stations.
Note:In order to re-run the autoset features,
you must first turn it off before turning it
back on.
B. MENU Access different audio features:
Compressioncan be turned on or off. When
compression is on, the soft and loud CD
passages are brought together for a more
consistent listening level.
Shufflecan be turned on or off. Turning
shuffle on plays the current CD tracks in
random order.
RDS Radioallows you to search
RDS-equipped stations for a certain category
of music format: CLASSIC, COUNTRY,
JAZZ/RB, ROCK, etc.
In SIRIUS mode,access different satellite
radio options and follow the prompts.
C. CLOCK Set the time. Use the memory presets buttons
to enter the time, then press OK.
120Audio System
2013 05+ Mustang(197)
Owners Guide gf, 1st Printing
USA(fus)