key FORD PROBE 1996 2.G Owner's Manual

Page 149 of 298

149 [DR02550(ALL)03/94]
NOTE: If the shift selector lever will not move
with the key on and the brake pedal
depressed refer toShift lock systemin
the Index.
*
[DR02600(ALL)11/94]
Once the gearshift is secure in the desired
position, release the brake pedal and use the
accelerator as necessary.
%*
[DR02900(ALL)06/92]
Backing Up
*
[DR03000(ALL)02/95]
With the gearshift in the R (Reverse) position,
the vehicle will move backward. You should
always come to a complete stop before shifting
into or out of R (Reverse).
*
[DR03100(ALL)01/95]
Driving
[DR03200(ALL)05/93]
When to use Overdrive (D with Overdrive
activated)
[DR03300(ALL)01/94]
Overdrive is the usual driving position for an
automatic overdrive transaxle. It works the same
way Drive (Overdrive OFF) works, automatically
upshifting or downshifting as the vehicle speeds
or slows.
[DR03400(ALL)01/94]
However, Overdrive also shifts into a fourth
gear Ð an overdrive gear Ð when your vehicle
cruises at a consistent speed for any length of
time. This fourth gear will increase your fuel
economy when you travel at cruising speeds.
[DR03500(ALL)05/95]
Overdrive may not be appropriate for certain
terrain. If the transaxle shifts back and forth
between third and fourth gears while you are
driving on hilly roads, select Drive (Overdrive
OFF) by cancelling Overdrive as outlined below.
File:prdrp.ex
Update:Fri Jun 23 19:35:02 1995

Page 159 of 298

159
*
[DR10530(ALL)05/95]
If the brake pedal is applied while the vehicle is
driven over uneven road surfaces, the ABS may
cycle and the driver may sense a pulsation in
the brake pedal, accompanied by a slight up and
down movement of the pedal height and a
clicking sound. This may also happen when
driving on an inclined surface such as a
driveway while making a sharp turn. This is a
normal condition.
*
[DR10540(ALL)05/95]
Each time you turn the ignition key to the ON
position, the ABS will function through one test
cycle. When this happens, the ABS light will
come on for up to five seconds. If the light stays
on longer than five seconds, shut off the engine
and restart. If it remains on, it means the ABS is
disabled and should be serviced immediately to
restore the benefits of the anti-lock feature.
Normal braking is not affected unless the red
BRAKE system warning light is also lit.
*
[DR10550(ALL)05/95]
ABS has self-check capabilities. As described
above, the system turns on the ABS light each
time you start your engine. After the engine is
started and the ABS light turns off, the system
performs another test the first time the vehicle
reaches 4-9 mph (6-15 km/h). The system turns
on the ABS pump motor for approximately 1/2
second. At this time, a mechanical noise may be
heard. This is a normal part of the self-check
feature. If a malfunction is found during this
check the ABS light will come on.
[DR10560(ALL)05/95]
Ford Motor Company has not found any
detrimental effects of popular mobile road
transmitting equipment installed on vehicles
equipped with the Anti-lock Brake System if
normal radio installation practices are rigidly
followed. However, if after installing mobile
radio transmitting equipment, the Anti-lock
Brake System light comes on at any time other
than immediately after turning the key to the
File:prdrp.ex
Update:Fri Jun 23 19:35:02 1995

Page 167 of 298

167
*
[DR22355(ALL)09/93]
Towing a manual transaxle (MTX) equipped
vehicle behind another vehicle, such as a
Recreational Vehicle (RV), is allowed only if it is
towed forward. The parking brake must be
released, the gearshift must be in Neutral, the
ignition key must be in the ACC position, the
battery must be disconnected to eliminate battery
drain, and the steering wheel unlocked. You
may tow your MTX equipped vehicle only in a
forward direction with the front wheels on the
ground without damage to the transaxle.
*
[DR22358(ALL)02/92]
Do not tow your manual transaxle equipped
vehicle at a speed faster than 55 mph
(88 km/h). The maximum towing distance is
unlimited.
*
[DR22360(ALL)05/95]
RWARNING
Never use a tow bar that attaches to the
bumper when you tow your vehicle. This
could damage the bumper and cause an
accident.
File:prdrp.ex
Update:Fri Jun 23 19:35:02 1995

Page 202 of 298

205
*
[SV01850(ALL)05/95]
RWARNING
The cooling fan is automatic and may
come on at any time. Always disconnect
the negative terminal of the battery before
working near the fan.
*
[SV01900(ALL)03/95]
q
If you must work with the engine running,
avoid wearing loose clothing or jewelry that
could get caught in moving parts. Take
appropriate precautions with long hair.
*
[SV02000(ALL)01/95]
q
Do not work on a vehicle in an enclosed
space with the engine running, unless you are
sure you have enough ventilation.
*
[SV02100(ALL)01/95]
q
Never get under a vehicle while it is
supported by a jack only. If you must work
under a vehicle, use safety stands.
*
[SV02200(ALL)01/95]
q
Keep all lit cigarettes and other smoking
materials away from the battery and all
fuel-related parts.
*
[SV02500(ALL)03/95]
If you disconnect the battery, the engine must
ªrelearnº its idle conditions before your vehicle
will drive properly. To find out how the engine
does this, seeBatteryin this chapter.
*
[SV02700(ALL)03/95]
Working with the engine off:
[SV02750(ALL)02/95]
1. Set the parking brake fully and make sure
the gearshift is securely latched in P (Park)
(automatic transaxle) or Neutral (manual
transaxle).
*
[SV02800(ALL)03/95]
2. Remove the key from the ignition after you
turn the engine off.
*
[SV02850(ALL)03/95]
3. Block the wheels. This will prevent your
vehicle from moving unexpectedly.
File:prsvp.ex
Update:Fri Jun 23 19:33:26 1995

Page 290 of 298

Index 299
I
Identification Number, Vehicle (VIN) . . . 193
Idle
relearning.............. 173
speed................. 45
Ignition
positions of the ignition......... 37
removing the key............ 41
Infant seats (see Safety seats)........ 24
Instrument cluster............. 51
mechanical............... 52
Instrument panel
lighting up panel and interior...... 72
location of components......... 63
J
Jack
operation.............. 177
positioning.............. 177
Jump-starting your vehicle
attaching cables............ 171
disconnecting cables.......... 173
K
Keys
positions of the ignition......... 37
removing from the ignition....... 41
stuck in lock position.......... 37
L
Lamps
checking............... 256
daytime running light system...... 78
flashing the lamps........... 81
fog lamps............... 74
hazard flashers............. 81
high beams.............. 80
instrument panel, dimming....... 72
File:prixp.ex
Update:Fri Jun 23 19:30:26 1995

Page:   < prev 1-10 11-20 21-30