radio GMC ENVOY 2006 Get To Know Guide

Getting to Know YourEnvoy8
Content TheftDeterrent System
Arm the ContentTheft Deterrent
System
• Lock the doors using the power door
lock switch or by pressing the Lock
button on the Remote Keyless Entry
transmitter.
• After closing all doors, the security
lamp on the radio stops flashing and
remains lit. After a delay of about 30
seconds, the lamp darkens and the
system arms itself.
• When arming with the power door
lock switch, at least one door must be
open and the key must be removed
from the ignition. (A door does not
have to be open to arm the system
with the Remote Keyless Entry
transmitter.)
•The system will not arm if the door is
locked with a key or the manual door
lock button is pressed.
• If the alarm is tripped, the horn
sounds and the headlamps/taillamps
flash for about two minutes. The
alarm sounds whenever a locked
door is opened without the key or
Remote Keyless Entry transmitter,or
if someone attempts to turn on the
ignition without the correct key.
Turn off the alarm
• Unlock a door with the key or press
Unlock on the Remote Keyless Entry
transmitter.
• Starting the engine with the correct
key will also turn off the alarm.
See Section 2 of your Owner Manual.
Lockout Protection
Prevent your ignition key from being
locked in your vehicle
• When the key is in the ignition and
a door is open, pressing any power
door lock switch unlocks the driver
door and locks all other doors.
See Section 2 of your Owner Manual.
Headlamp Controls
The exterior lamps knob is located on
the instrument panel, to the left of the
steering wheel.
Turn off the Daytime Running Lamps
(DRL) and automatic headlamp
system
• Move the knob to the OFF ( )
position.
The automatic headlamp system auto
matically reactivates at the next keyon.

9
Activate the Daytime Running Lamps
(DRL) and automatic headlamp system
• Move the knob to the AUTO ( )
position.
• All exterior lamps and the instrument
panel/radio lights will illuminate when
they are needed.
Manually activate the parking lamps,
sidemarker lamps, taillamps, instru
ment panel/radio lights and license
plate lamps
• Move the knob to the parking lamp
()position.
Manually activate the headlamps, all
exterior tail/marker lamps and the
instrument panel/radio lights
• Move the knob to the ON ( )
position.
Activate the fog lamps
• Press the button (see “A” below)
located on the instrument panel to the
right of the exterior lamps switch
once.
• An indicator lamp will illuminate.
• To turn them off, press the button
again.
See Section 3 of your Owner Manual.
Heated, Power Outside Mirrors
(if equipped)
Activate heat feature on the power
outside mirrors
• Press the rear window defogger
button on the climate control panel.
See Section 2 of your Owner Manual.
Outside Mirror with Curb View
Assist (if equipped)
This feature automatically adjusts the
passenger side mirror downward to a
preset tilt position when the vehicle is in
Reverse gear. The mirror returns to its
normal position when the vehicle is
moved out of Reverse. See your Owner
Manual to activate this system for the
first time.
See Sections 2 and 3 of your Owner Manual.
A

Getting to Know YourEnvoy10
Memory Seats (if equipped)
Save driver seat preference memory
setting
• Adjust the driver seat (including seat
back recliner and lumbar) to a com
fortable position.
•Press and hold either the driver 1 or
driver 2 memory button located on
the driver’sdoor. A double chime will
sound to confirm your settings.
To program settings for a second driver,
repeat the same procedure using the
other numbered memory button.
See Section 2 of your Owner Manual.
Electric Adjustable Pedals
Adjust the brake and accelerator
pedals to comfortable positions
• Press the switch located on the steer
ing column toward you to move the
pedals closer to you.
• Press the switch away from you to
move the pedals away from you.
See Section 2 of your Owner Manual.
Entertainment Systems
Set the time on radios without using
the Radio Data System (RDS)
• Press the H or HR button until the
correct hour appears on the display.
• Press and hold the M or MIN button
until the correct minute appears on
the display.
The time may be set with the ignition on
or off.
Note:The pedals cannot be positioned
farther away from the driver than they
are in their standard position. This
feature can be programmed to work
with the memory function (if equipped)
on your vehicle. Adjustment of the
powered pedals requires that the
vehicle be in Park.

11
Set the time to an FM station’s Radio
Data System (RDS) setting
(if equipped)
• Press and hold both HR and MN for
two seconds until UPDATED and the
clock symbol appear on the display.
• If the time is not available from the
station, NO UPDAT appears in the
display.
Program radio station presets
• Turn the radio on.
• Press the BAND button to select the
band (AM/FM1/FM2/XM1/XM2).
• Use the seek or tune knob to tune in
the desired station.
• Press AUTO EQ to select the equal
ization that best suits the type of
station selected.
•Press and hold one of the six num
bered buttons until a beep sounds;
release the button.
•Repeat these steps for each station
preset, using a different numbered
button for each station.
Display a station’s INFO message
when INFO appears on the display
•Press INFO to see the message.
Once the complete message has
been displayed, INFO disappears
from the display.
Tune to an RDS broadcast of a
selected program type
• Press the TYPE button to select the
Program Type you want to listen to.
• Press the or button.
Access one of the two available XM
Satellite Radio bands (if equipped)
• Press the BAND button until XM1 or
XM2 appears on the display.
Load one CD into the SixDisc CD
Player (if equipped)
• With the ignition on, press and
release the LOAD side of the LOAD
CD button.
• Wait for the indicator light at the right
side of the slot to turn green.
•Insert the disc partway into the slot,
label side up; the player will pull the
disc in.
Load multiple CDs
• With the ignition on, press and hold
the LOAD button for two seconds.
The unit beeps and the light to the
right of the slot begins to flash.
• When the light stops flashing and
turns green, insert a disc partway,
label side up.
• The indicator light will begin blinking
and then turn green. Load another
disc at this time.
• When loading more than one but
fewer than six CDs, press the LOAD
button again to signal that loading is
complete.

Getting to Know YourEnvoy12
• When more than one disc is loaded,
anumber for each disc is displayed.
• To play a specific CD, press the CD
AUX button and then the number of
the CD you want to hear.
• A small bar appears under the CD
number that is playing, and the track
number appears.
MP3 Radio (if equipped)
A CDR or CDRW containing MP3
audio tracks will play automatically when
inserted into the CD/MP3 player.
See Section 3 of your Owner Manual.
Rainsense Wipers (if equipped)
Rainsense Wipers automatically control
the frequency of the wipers from Off to
High speed according to the amount of
moisture on the windshield.
Headlamp Washers
(if equipped)
Spray the headlamps with washer
fluid
• Press the headlamp washer button
(see “A” above) located on the
instrument panel to the left of the
steering wheel.
See Section 3 of your Owner Manual.
Activate the Rainsense feature
• Set the wipers to one of five moisture
sensitivity settings on the multifunc
tion lever.
• The closer the setting is to the Off
position, the less sensitive it will be to
moisture.
See Section 3 of your Owner Manual.
Note:Turn this feature off before enter
ing an automatic car wash.
Note:CDs with any affixed labels may
jam in the CD player. Label a CD using
apermanent marker. If more than one
CD is inserted into the slot at one time,
or if scratched or damaged CDs are
played, the CD player could be dam
aged. When using the CD player, use
only CDs in good condition without
labels; load one CD at a time; and keep
the CD player and the loading slot freeof foreign materials, liquids and debris.
A