HONDA ACCORD COUPE 2006 CL7 / 7.G Owners Manual

If you need to close the moonroof
manually, it means the moonroof
opening/closing function is
developing a problem. Have your
vehicle checked by your dealer.
Remove
the wrench. Reinstall the
round plug.
To
remove the round plug in the
center of the headliner, turn the
plug by using a screwd river or
coin, then pry it out. Make sure to
align the tabs on the round plug to
the notches on the ceiling as
shown in the illustration.
If
the electric motor will not close
the moonroof , do the f ollowing:
Check the f use f or the moonroofmotor (see page ). If the fuse
is blown, replace it with one of the
same or lower rating.
Try closing the moonroof . If the
new f use blows immediately or the
moonroof motor still does not
operate, you can close the
moonroof manually.
Get the moonroof wrench out of
the tool kit in the trunk. Insert the moonroof wrench into
the socket behind the plug. Turn
the wrench until the moonroof is
f ully closed.
4.
3. 1.
2.
5.
6.
284
If equipped
Closing t he Moonroof
T aking Care of t he Unexpect ed
279
SOCKET
ROUND PLUG TAB
NOTCH
MOONROOF WRENCH
——y
y
(%yy

The under-hood fuse box is on the
driver’s side. To open it, push the
tabs as shown. If
something electrical in your
vehicle stops working, the first thing
youshouldcheckforisablownfuse.
Determine from the chart on pages
and , or the diagram on the
f use box lid, which f use or f uses
control that device. Check those
f uses f irst, but check all the f uses
bef ore deciding that a blown f use is
the cause. Replace any blown f uses,
and check if the device works.
Turn the ignition switch to the
LOCK (0) position. Make sure the
headlights and all other
accessories are of f .
The interior f use box is on the
driver’s lower lef t side. To remove
the f use box lid, put your f inger in
the notch on the lid, and pull it
upward slightly, then pull it toward
you and take it out of its hinges. The vehicle’s f uses are contained in
two f use boxes.
Remove the cover f rom the f use
box.
1.
2. 283 284
Checking and Replacing Fuses
Fuses
280
INTERIOR
UNDER-HOOD
TAB
NOTCH
——y

y
(%yy

Check the smaller f uses in the
under-hood f use box and all the
fuses in the interior fuse box by
pulling out each one with the f use
puller provided in the under-hood
fuse box.
Check each of the large f uses in
the under-hood f use box by
looking through the side window
at the wire inside. Removing these
f uses requires a Phillips-head
screwdriver.
3.
4.
CONT INUED
Fuses
T aking Care of t he Unexpect ed
281
BLOWNBLOWN
FUSE
FUSE PULLER
——y
y
(%yy

Look for a blown wire inside the
fuse. If it is blown, replace it with
oneofthesparefusesofthesame
rating or lower.If you cannot drive the vehicle
without fixing the problem, and you
do not have a spare fuse, take a fuse
of the same rating or a lower rating
from one of the other circuits. Make
sureyoucandowithoutthatcircuit
temporarily (such as the accessory
power so
cket or radio). If the replacement fuse of the
same rating blows in a short time,
there is probably a serious
electrical problem with your
vehicle. Leave the blown fuse in
that circuit, and have your vehicle
checked by a qualified mechanic.
If the driver’s power window fuse is
removed, the AUTO function of the
driver’s window will be disabled. To
reset the AUTO function, see page
.
If the radio fuse is removed, the
audio system will disable itself.
Thenexttimeyouturnonthe
radio you will see ‘‘CODE/COdE’’
in the frequency display. Use the
preset bars to enter the code (see page ).
If you replace the blown f use with a
spare f use that has a lower rating, it
might blow out again. This does not
indicate anything wrong. Replace the
f use with one of the correct rating as
soon as you can.
5. 6.
92 172
Fuses
282
BLOWN
FUSE
Replacing a f use with one that has a
higher rating greatly increases the
chances of damaging the electrical
system. If you do not have a
replacement f use with the proper rating
f or the circuit, install one with a lower
rating.
——y
y
(%yy

µµ
Î
Î
Î Î
Î Î
Î
Î
´
Î
Î
Î
No. Amps.
CONT INUED
Amps.
Circuits ProtectedAmps.
No. Circuits Protected
No. Circuits Protected
1: All except U.S. 4-cylinder LX model
2: 4-cylinder models
3: 6-cylinder models
6
7
8
9
10 10 A
7.5 A 15 A
20 A
10 A
30 A
10 A
15 A
10 A Right Headlight Low Beam
Back Up
FI ECU (ECM/PCM)
Condenser Fan
Not Used20 A
30 A
7.5 A 20 A
40 A
40 A
15 A
30 A
30 A
20 A
40 A
40 A
40 A
40 A
100 A
50 A
50 A
11
12
13
14
15
16
17
18
19
20
21
22
23
Cooling Fan
Cooling Fan
MG. Clutch
Horn, Stop
Rear Defroster
Back Up, ACC
Hazard
ABS Motor
VSA Motor
ABS Unit
VSA Unit
Option
Option
Heater Motor
Battery
Not Used
BIG1Main
Power Window Main
1
2
3
4
5 Left Headlight Low Beam
Rear Defroster Coil
Left Headlight High Beam
Small Light
Right Headlight High Beam
2
3
2 3
2 3
1
1
Fuse Locations
T aking Care of t he Unexpect ed
283
UNDER-HOOD FUSE/RELAY BOX
——y
y
(%yy

µ
µµ
µ
µ
µ
µ
µ
Î
Î
Î
Î
Î
No. Amps.
No.No.
Amps. Circuits Protected Circuits Protected Amps. Circuits Protected
: All except 4-cylinder LX model
1
2
3
4
5
6
7 20 A
15 A
7.5 A
30 A
8
9
10
11
12
13 14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
15 A
15 A
10 A
15 A
10 A
7.5 A 10 A Door Lock
Front Accessory Sockets
OPDS (Occupant Position
Detection System)
IG Wiper
Not Used
Not Used
DBW
Ignition Coil
Daytime Running Light
Laf Heater
Radio
Interior Light
Back Up 20 A
20 A
20 A
15 A
15 A
7.5 A
7.5 A 10 A
7.5 A
20 A
20 A 20 A
7.5 A
7.5 A Driver’s Power Seat Sliding
Heated Seats
Driver’s Power Seat
Reclining
Not Used
ACG
Fuel Pump
Washer
Meter
SRS
IGP
Not Used
Not Used
Passenger’s Power Window
Driver’s Power Window
Moonroof
Not Used
A/C
Not Used
ACC
Not Used
Fuse Locations
284
INTERIOR FUSE BOX
——y
y
(%yy

µµ
If your vehicle needs to be towed,
call a prof essional towing service or
organization. Never tow your vehicle
with just a rope or chain. It is very
dangerous.
If , due to damage, your vehicle must
be towed with the f ront wheels on
the ground, do this:
Release the parking brake.
Shif t the transmission to neutral.
The operator
loads your vehicle on the back of a
truck. Therearetwowaystotowyour
vehicle:
With the f ront wheels on the ground,
do not tow the vehicle more than 50
miles (80 km), and keep the speed
below35mph(55km/h).
If your vehicle is equipped with a
f ront spoiler, remove it bef ore
towing so it is not damaged.
The tow
truck uses two pivoting arms that go
under the tires (f ront) and lif t them
of f the ground. The other two tires
remain on the ground. Release the parking brake.
Start the engine.
ShifttoD,thentoN.
Turn of f the engine. Leave the ignition switch in the
ACCESSORY (I) position so the
steering wheel does not lock.
Leave the ignition switch in the
ACCESSORY (I) position so the
steering wheel does not lock.
CONT INUED
Manual Transmission:
Automatic Transmission:
Emergency Towing
Flat -bed EquipmentWheel-lif t Equipment
This is the best way to trans-
port your vehicle.
T his is an
acceptable way to tow your
vehicle.
T aking Care of t he Unexpect ed
285
Improper towing preparation will
damage the transmission. Follow the
above procedure exactly. If you cannot
shif t the transmission or start the
engine (automatic transmission), your
vehicle must be transported with the
f ront wheels of f the ground.
——y

y
(%yy

Emergency Towing
286
The steering system can be damaged if
the steering wheel is locked. Leave the
ignition switch in the ACCESSORY (I)
position, and make sure the steering
wheel turns f reely bef ore you begin
towing.
Trying to lif t or tow your vehicle by the
bumpers will cause serious damage.
The bumpers are not designed to
support the vehicle’s weight.
——y
y
(%yy

Thediagramsinthissectiongive
you the dimensions and capacities of
your vehicle, and the locations of the
identif ication numbers. It also
includes inf ormation you should
know about your vehicle’s tires and
emissions control systems.................
Identif ication Numbers .288
Specif ications
..................
(4-cylinder Models) .290
Specif ications ..................
(6-cylinder Models) .292
DOT Tire Quality Grading .....................
(U.S.Vehicles) .294
Unif orm Tire Quality ..................................
Grading .294
.................................
Treadwear .294
......................................
Traction .294
.............................
Temperature .295
.................................
Tire Labeling .296 .......................
Emissions Controls .297
.....................
The Clean Air Act .297
Crankcase Emissions Control
....................................
System .297
Evaporative Emissions Control ....................................
System .297
Onboard Ref ueling Vapor ................................
Recovery .297
...
Exhaust Emissions Controls .298
....................
PGM-FI System .298
Ignition Timing Control
................................
System .298
Exhaust Gas Recirculation ...................
(EGR) System .298
Three Way Catalytic ...........................
Converter .298
....................
Replacement Parts .298
..
Three Way Catalytic Converter .299
..............
State Emissions Testing .300
T echnical Inf ormation
Technical Inf ormation
287
——y
y
(%yy

Your vehicle has several identif ying
numbers in various places.
The vehicle identif ication number
(VIN) is the 17-digit number your
dealer uses to register your vehicle
f or warranty purposes. It is also
necessary f or licensing and insuring
your vehicle. The easiest place to
find the VIN is on a plate fastened to
the top of the dashboard. You can
seeitbylookingthroughthe
windshield on the driver’s side. It is
also on the certification label
attached to the driver’s doorjamb,
and is stamped on the engine
compartment bulkhead. The VIN is
also provided in bar code on the
certif ication label.
Identif ication Numbers
288
VEHICLE IDENTIFICATION NUMBERCERTIFICATION LABEL
——y

y
(%y
y