HONDA ODYSSEY 2011 RB3-RB4 / 4.G Owners Manual
Page 131 of 722
ÛÝÛÝ
µ
µ You can choose this item to
customize f rom ‘‘DOOR SETUP’’ by
pressing the INFO ( / ) button
repeatedly.
There are two settings you can
choose f rom:
Press the SEL/RESET button to see
the selections.
Select the desired setting by
pressing the INFO ( / ) button,
then enter your selection by pressing
the SEL/RESET button.
You can customize the power
tailgate setting not to open without
unlocking the tailgate lock f irst by
remote transmitter from the outside.
ANYTIME The tailgate unlocks
andopenswhenyoupressandhold
the tailgate button on the remote
transmitter for 1 second. The
tailgate will automatically relock
when you close it when the doors are
locked.
WHEN UNLOCKED In this mode,
you must unlock the tailgate bef ore
opening it. In addition, the tailgate
will not automatically relock when
you close it.
See page f or how to customize
the power tailgate keyless open
mode.
165
U.S. models only
On Canadian models
PT G (Power T ailgat e) K eyless Open
ModeMulti-Inf ormation Display128
10/07/17 09:51:04 31TK8600_133
2011 Odyssey
Page 132 of 722
When your selection is successf ully
completed, the display changes as
shown above, and then goes back to
the customize item screen.If the ‘‘SETTING INCOMPLETE’’
message appears, go back to ‘‘PTG
KEYLESS OPEN MODE’’ and
repeat the procedure again. To exit this mode without changing
the settings, select ‘‘EXIT’’ by
pressing the INFO button, then
press the SEL/RESET button. The
display goes back to the customize
item screen.
CONT INUED
Multi-Inf ormation Display
Instruments and Controls
129
10/07/17 09:51:10 31TK8600_134
2011 Odyssey
Page 133 of 722
ÛÝÛÝ
Press the SEL/RESET button. The
display changes as shown above.
You can choose this item to
customize f rom ‘‘DOOR SETUP’’ by
pressing the INFO ( / ) button
repeatedly.
When you push the LOCK button on
the remote transmitter, some
exterior lights f lash, and a beeper
sounds when you push the LOCK
button again within 5 seconds to
verify that the doors and the tailgate
arelockedandthesecuritysystem
has set (see page ). You can
customize the exterior lights not to
f lash and the beeper not to sound.
Select ON or OFF by pressing the
INFO ( / ) button, then enter
your selection by pressing the SEL/
RESET button.
479
Multi-Inf ormation DisplayK eyless L ock A cknowledgment130
10/07/17 09:51:16 31TK8600_135
2011 Odyssey
Page 134 of 722
CONT INUED
If the ‘‘SETTING INCOMPLETE’’
message appears, go back to
‘‘KEYLESS LOCK
ACKNOWLEDGMENT’’ and repeat
the procedure again.To exit this mode without changing
the settings, select ‘‘EXIT’’ by
pressing the INFO button, then
press the SEL/RESET button. The
display goes back to the customize
item screen.
When your selection is successf ully
completed, the display changes as
shown above, and then goes back to
the customize item screen.
Multi-Inf ormation Display
Instruments and Controls
131
10/07/17 09:51:23 31TK8600_136
2011 Odyssey
Page 135 of 722
ÛÝÛÝ
If you unlock the doors and the
tailgate with the remote transmitter,
but do not open any of the doors or
thetailgatewithin30seconds,the
doors and the tailgate automatically
relock and the security system sets.
You can change this relock time
f rom 30 seconds to 60 or 90 seconds.
Press the SEL/RESET button, then
press the INFO button.
You can choose this item to
customize f rom ‘‘DOOR SETUP’’ by
pressing the INFO ( / ) button
repeatedly.
Select the desired setting by
pressing the INFO ( / ) button,
then enter your selection by pressing
the SEL/RESET button.
Securit y Relock T imerMulti-Inf ormation Display132
10/07/17 09:51:29 31TK8600_137
2011 Odyssey
Page 136 of 722
When your selection is successf ully
completed, the display changes as
shown above, and then goes back to
the customize item screen.If the ‘‘SETTING INCOMPLETE’’
message appears, go back to
‘‘SECURITY RELOCK TIMER’’ and
repeat the procedure again. To exit this mode without changing
the settings, select ‘‘EXIT’’ by
pressing the INFO button, then
press the SEL/RESET button. The
display goes back to the customize
item screen.
Multi-Inf ormation Display
Instruments and Controls
133
10/07/17 09:51:35 31TK8600_138
2011 Odyssey
Page 137 of 722
Î
Î
Î
Î
Î
Î Î ÎÎ
Î
Î
Î
Î
Î
Î To use the horn, press the center pad of the steering wheel.
If equipped
1:
2:Controls Near the Steering Wheel134
HAZARD WARNING
BUTTON
AUXILIARY INPUT JACK
HORN WINDSHIELD
WIPERS/WASHERS
CRUISE CONTROL
BUTTONS
PASSENGER AIRBAG
OFF INDICATOR
Vehicle with navigation system is shown. (P.136)
(P.169)
(P.163)
(P.486)
STEERING WHEEL
ADJUSTMENTS
(P.143)(P.83) (P.209)(P.412) (P.414,
442)
(P.189)
AUDIO SYSTEM
(P.234)
(P.33)
(P.142)
(P.135)
(P.480)
(P.411)
(P.571)
(P.585)
(P.496, 517)
(P.496,517)
HEADLIGHT/TURN SIGNAL/
FOG LIGHTS
BLIND SPOT
INFORMATION SYSTEM
(BSI) OFF SWITCH
POWER SLIDING
DOOR SWITCHES
PARKING SENSOR
SYSTEM SWITCH
VOICE CONTROL
BUTTONS
BLUETOOTH
HANDSFREELINK
BUTTONS MULTI-INFORMATION
BUTTONS
COOL BOX SWITCHREAR ENTERTAINMENT
SYSTEM
SEAT HEATER
SWITCHES
REMOTE AUDIO
CONTROLS
POWER TAILGATE
SWITCH VEHICLE STABILITY ASSIST
(VSA) OFF SWITCH
1
2
2
2
2
2 2 22
2
2
2
2
10/07/19 15:50:55 31TK8600_139
2011 Odyssey
Page 138 of 722
µ
µ
µ
µ µ
µ
µ
µ
µ The wipers run at high
speed until you release the lever.
The wipers are not activated.
The wipers run at low speed.
The wipers run at high speed. Pull the
wiper control lever toward you, and
hold it. The washers spray until you
release the lever. The wipers run at
low speed, then complete one more
sweep after you release the lever.
The length of the wipe
interval is varied automatically
according to vehicle’s speed.
Vary the delay by turning the
adjustment ring. If you turn it to the
shortest delay ( position), the
wipers change to low speed
operation when the vehicle speed
exceeds 12 mph (20 km/h).
MIST
OFF
INT Intermittent
LO Low speed
HI High speed
Windshield washers
Push the right lever up or down to
select a position. 1.
2.
3.
4.
5.
6. MIST
OFF
LO
HI
Windshield Washer
INT
Windshield Wipers
Windshield Wipers and Washers
Instruments and Controls
135
ADJUSTMENT RING
10/07/17 09:51:52 31TK8600_140
2011 Odyssey
Page 139 of 722
ÎÎ
Î
µ
µ
ÎTurn signal
Of f
Parking and indicator lights
AUTO
Headlights on
High beams
Flashhighbeams
Fog lights of f
Fog lights on
If equipped
Rotate the switch clockwise to
turn the rear window wiper ON. When you turn the wiper switch to
the ‘‘OFF’’ position, the wiper will
return to its parked position. OFF
The wiper operates every 7
seconds af ter completing two
sweeps.
Hold past ON to activate the rear
window wiper a f ew times and to
spray the rear window washer. Rotate the switch
counterclockwise also to spray the
window washer and turn the wiper
on.
When you shif t the transmission to
the reverse position with the f ront
windshield wiper activated, the rear
wiper operates automatically even if
therearwiperswitchisoff.
When the wiper control lever is
positioned as f ollows: The rear window wiper
operates intermittently.
The rear window wiper
operates continuously.
Therearwindowwasherusesthe
same f luid reservoir as the wind-
shield washer. 1.
2.
3.
4.
5.
6.
7.
8.
9.
:
1.
2.
3. 4
Turn Signal and Headlights
Rear Window Wiper and Washer
INT
LO or HI
Windshield Wipers and Washers, Turn Signal and Headlights136
10/07/17 09:52:04 31TK8600_141
2011 Odyssey
Page 140 of 722
µµ
µ
Push down on the
lever to signal a lef t turn and up to
signal a right turn. To signal a lane
change, push lightly on the lever,
and hold it. The lever will return to
center when you release it or
complete a turn. If you leave the lights on with the
key removed f rom the ignition
switch, you will hear a reminder
chime when you open the driver’s
door.
To switch f rom low
beams to high beams, push the lef t
lever f orward until you hear a click.
The high beam indicator will come
on (see page ). Pull it back to
return to low beams. To flash the
high beams, pull the lever back
lightly, then release it. The high
beams will stay on as long as you
hold the lever back.
Turning the
switch to the ‘‘ ’’ position turns
on the parking lights, taillights,
instrument panel lights, side-marker
lights, and rear license plate lights.
Turning the switch to the ‘‘ ’’
position turns on the headlights.
When the light switch is in the
‘‘ ’’ or ‘‘ ’’ position, the
lights on indicator comes on as a
reminder. This indicator stays on if
you leave the light switch on and
turn the ignition switch to the
ACCESSORY (I) or the LOCK (0)
position. 73
CONT INUED
Turn Signal
High Beams
Headlights On
Turn Signal and Headlights
Instruments and Controls
137
10/07/17 09:52:10 31TK8600_142
2011 Odyssey