Hyundai Getz 2004 Owner's Manual

8. CONSUMER INFORMATIONVehicle Identification Number (VIN) .............................................. . 8-2
Engine num ber ................................................ ................................. 8-2
Tyre pressures ................................................... .............................. 8-3
Snow tyres ................................................... .................................... 8-4
Tyre chains ................................................... ................................... 8-4
Tyre rotation ................................................... .................................. 8-4
Tyre balancing ..................................... ............................................. 8-5
Tyre Replacem ent ................................................ ............................ 8-5
Wheel Replacement ................................................... ...................... 8-5
Spare tyre and t ools ............................................... .......................... 8-6
8
tbuk-8.p65 3/23/04, 4:27 PM
1

8- 2 CONSUMER INFORMATION
I030A01TB EADA010C
I010A01TB-DAT
VEHICLE IDENTIFICATION
NUMBER (VIN)
The vehicle identification number (VIN)
is the number used in registering your
car and in all legal matters pertaining to
its ownership, etc.
It can be found on the centre piller of the
driver side and the lower side of the
front passenger seat.
I010B01A-GAT
ENGINE NUMBER
F040A01TB-1 F040A02TB
1.1L 1.3L
1.6L
I030B01TB
tbuk-8.p65 3/23/04, 4:27 PM
2

CONSUMER INFORMATION 8- 3
4.5Jx13
5.0Jx13
5.0Jx14
5.5Jx14
5.5Jx15
4.0Tx14 TYRE
SIZE
RIM
SIZE PRESSURE, kPa (PSI)
15/80R13
165/65R14
175/65R14
185/55R15
T105/70D14 REAR
210(30)
420(60) FRONT
230(33)
420(60)
UP TO 2
PERSONS UP TO
MAX. LOAD
REAR
230(33)
420(60)
FRONT
210(30)
420(60)
The engine number is stamped on the
engine block as shown in the drawing. I030A02TB-EAT
TYRE PRESSURES
In modern high-speed motoring, correct
tyre pressures are vitally important.
I010B01B
HTB263
Diesel EngineIncorrect tyre pressures can affect ve-
hicle safety by causing reduced adhe-
sion, steering response and tyre failure
through overheating. The tyre pressure
must only be checked when the tyres
are cold. The correct tyre pressures are
indicated on the label affixed in the
glove box and below.
Tyre pressures should be increased by
3 psi when the vehicle is driven fully
laden or under conditions of sustained
high speed motoring.
tbuk-8.p65 3/23/04, 4:27 PM
3

8- 4 CONSUMER INFORMATION
!
I050A01TB-EAT
TYRE CHAINS
Tyre chains, if necessary, should be
installed on the front wheels. Be sure
that the chains are the proper size and
that they are installed in accordance
with the manufacturer's instructions.
To minimize tyre and chain wear, do not
continue to use tyre chains when they
are no longer needed.
SI030A2-E
SNOW TYRES
If it is desired to fit snow tyres to the
vehicle, it must be ascertained that the
original size and load carrying capacity
are met by the replacement tyres. When
using snow tyres, the vehicle should
not be driven at speeds in excess of 60
MPH.
I060A01FC-EAT
TYRE ROTATION
The tyre wear characteristics will vary
between each tyre dependant upon the
conditions of use. It is normal for the
front tyres to wear more rapidly than
those fitted to the rear of the vehicle and
therefore tyre rotation will provide a
means of helping to ensure an even
wear rate across the tyre set. For ve-
hicles fitted with radial ply tyres, rota-
tion should be confined to front to rear
tyre alternation. It is not recommended
that radial ply tyres be rotated from side
to side.
WARNING:
o When driving on roads covered with snow or ice, drive at less
than 30 km/h (20 mph).
o Use the SAE "S" class or wire & plastic chains.
o Don't use the tyre chains in 185/ 55R 15 tyre to prevent body dam-
age.
o If you have noise caused by chaws contacting the body, retighten the
chain to avoid contact with the
vehicle body.
o Retighten the chains to prevent from a body damage after driving
0.5 ~ 1 km with equipping chains.
HA1409Spare tyre
tbuk-8.p65 3/23/04, 4:27 PM
4

CONSUMER INFORMATION 8- 5
!
SI060B1-E
TYRE REPLACEMENT
Tyres must be replaced when the wear
indicators appear as a solid bar across
the tyre tread. At this point, the remain-
ing tread depth will be approximately
0.06 in.(1.6 mm). In addition to this, the
tyre must be replaced if any portion of
the tread has become bald or if there are
any lumps, bulges or deep cuts in the
sidewalls or tread.
Replacement tyres must be of the rec-
ommended size and rating and should
be of the same manufacture and tread
pattern on each axle.
SI060D2-E
WHEEL REPLACEMENT
Wear indicator
1.6 mm (0.06 in.)
HGK248
NOTE:
o Do not use the temporary spare
tyre for tyre rotation.
o Aluminium wheels which are not
supplied as Original Equipment
should not be mixed on the same
vehicle with the original steel
wheels. However, it is acceptable
that the steel spare wheel be used
in conjunction with Original Equip-
ment aluminium wheels since the
offset of both wheels is compat-
ible. Radial and cross ply tyres
should not be mixed on the same
vehicle.
SI060A1-E
TYRE BALANCING
Incorrect tyre balance will cause steer-
ing vibration and uneven tyre wear. The
vehicle tyres are balanced during pro-
duction but may need further balancing
throughout the life of the tyres.
It is recommended that the tyres be
balanced on the car for best results and
that the tyres are balanced whenever
they have been removed from the wheel
for repair. The original wheels may only be re-
placed with Hyundai Approved wheels.
WARNING:
Driving on worn or defective tyres is
dangerous. Worn tyres may cause
loss of steering control and a seri-
ous deterioration of braking effi-
ciency. Defective tyres may cause
vibration and loss of control through
blow outs.
Tyres of different size, construction or
tread pattern should not be intermixed
on the same axle. Radial and cross ply
tyres should not be used on the same
vehicle.
The use of tyres and wheels of non
approved sizes can be dangerous.
tbuk-8.p65 3/23/04, 4:27 PM
5

8- 6 CONSUMER INFORMATION
I100A01TB-EAT
SPARE TIRE AND TOOLS
Your Hyundai is delivered with the fol-
lowing:
Spare tyre and wheel
Wheel nut wrench, Wrench bar,
Spanner, Screw driver
Jack, Towing Hook HTB224
tbuk-8.p65
3/23/04, 4:27 PM
6

9. VEHICLE SPECIFICATIONS
Measurement ................................................................................... 9-2
Engine .............................................................................................. 9-3
Lubrication chart ............................................................................... 9-4
9
tbuk-9.p65 7/3/2008, 4:11 PM
1

9- 2 VEHICLE SPECIFICATIONS
1.3 L
1.6 L
Type Wheel free playRack stroke Oil pump type 150 (3,810) 65.6(1,665) 58.7(1,490) 96.7(2,455)57.1(1,450) 56.7(1,440)
Overall length Overall width Overall height (unladen) Wheel baseWheel tread J030A02TB-EAT TYRE1.1 L
13.5V,70A
Dual hydraulic with brake booster Ventilated disc DrumCable
J010A01TB-EAT MEASUREMENT
J060A01TB-DAT FUEL SYSTEM
Rack and pinion 0 ~ 1.18 in. (0 ~ 30 mm) 5.20 in. (132 mm) 5.5 in. (140 mm) Vane type
165/65R14 175/65R14, 185/55R15
StandardOption
Front Rear
in. (mm)
J020A01TB-EAT POWER STEERING
Fuel tank Capacity Litre
45 Imp.gal
9.9
J040A02TB-EAT ELECTRICAL
Item Battery Alternator
J050A01FC-GAT BRAKE Type Front brake typeRear brake type Parking brake
J035A03TB-EAT SPARE TYRE
Temporary (space-saver) (T 150/70 D14) Full size
1.1L 1.3/1.5/1.6L
DIESEL
1.5 L
60AH
12V, 90APETROL
Manual Power 13.5V, 90A
45AH
tbuk-9.p65
7/3/2008, 4:11 PM
2

VEHICLE SPECIFICATIONS 9- 3
PETROL
1-3-4-2
BKR5ES-11 RC10YC4
0.039 ~ 0.043 in. (1.0 ~ 1.1 mm) 1.3 L
71.5 x 83.5 1,341
- -
700 ± 100
BTDC 5° ± 5°
1.1 L
67 x 77 1,086
0.13 mm0.17 mm
850 ± 100
BTDC 6° ± 5° 1.6 L
76.5 x 87 1,599
- -
Engine TypeBore x Stroke Displacement (cc) Firing order/Injection orderValve clearance (Cold Engine 20 ± 5°C) Spark plugSpark plug gap Idle speed (RPM)Ignition timing (Base)/Injection timing IntakeExhaust NGK CHAMPION
J070A01TB-EAT ENGINEDIESEL
1.5L
3-Cylinder in -line SOHC
83 x 921,493
1-3-2
- -- - --
Auto control
ITEMS
4-Cylinder in -line SOHC 4-Cylinder in -line DOHC
tbuk-9.p65
7/3/2008, 4:11 PM
3

9- 4 VEHICLE SPECIFICATIONS
Oil & Grease Standard
API SG or SAE 20W-40, 20W-50 (ABOVE -10°C) ABOVE SAE 15W-40, 15W-50 (ABOVE -15°C)SAE 10W-30 (-25°C ~ 40°C) SAE 10W-40, 10W-50 (ABOVE -25°C) SAE 5W-20 (BELOW -10°C) *1, *2SAE 5W-30 (BELOW 10°C) *1 SAE 5W-40 (BELOW 20°C) *1
API CF-4 SAE 30 (0°C ~ 40°C)
or ABOVE, SAE 20W-40 (ABOVE -10°C)
ACEA B4 SAE 15W-40 (ABOVE -15°C)
or ABOVE SAE 10W-30 (-20°C ~ 40°C) SAE 5W-30 (-25°C ~ 10°C)SAE 0W-30 (BELOW 10°C) *1, *2
*1. Restricted to driving condition and vehicle destination*2. Not recommended for sustained high speed vehicle operationNormal driving condition Severe driving condition HYUNDAI GENUINE PARTS MTF 75W/90 (API GL-4)DIAMOND ATF SP-III, SK ATF SP-III Dextron 2 DOT 3, DOT 4 or equivalent Ethylene glycol base for aluminium radiator
Item
Engine Oil Petrol Diesel
Engine Oil Consumption
Transaxle Manual Auto
Power Steering
Brake Fluid Coolant
J080A03TB-EAT LUBRICATION CHARTQ'ty (litre)
Drain and refill (with oil filter) : 3.3 (2.9 Imp.qts) Drain and refill (with oil filter) : 4.8 (4.2 Imp.qts) MAX. 1L / 1,500 Km MAX. 1L / 1,000 Km 2.15 (1.86 Imp. qts) 6.1 (5.3 Imp.qts) (Petrol only)As required As required Petrol : 5.5(4.8 Imp.qts)Diesel: 5.7 (5.0 lmp.qts)
tbuk-9.p65 7/3/2008, 4:11 PM
4