light HYUNDAI I10 2019 Owner's Guide

4-17
04
Immobiliser Indicator
Light (without smart
key) (if equipped)
7his indicator light illuminates
‡When the vehicle detects the immo-
biliser in the key with the ignition
switch in the ON position.
- At this time, you can start the
engine.
- The indicator light goes off after
starting the engine.
7his indicator light blinks
‡When there is a malfunction with
the immobiliser system.
In this case, we recommend that
you have the vehicle inspected by a
HYUNDAI authorised repairer.
Immobiliser Indicator
Light (with smart key)
(if equipped)
7his indicator light illuminates for
up to 3 seconds
‡When the vehicle detects the smart
key in the vehicle with the Engine
Start/Stop button in the ACC or ON
position.
- At this time, you can start the
engine.
- The indicator light goes off after
starting the engine.
7his indicator light blinks for a few
seconds
‡When the smart key is not in the
vehicle.
- At this time, you cannot start the
engine.
7his indicator light illuminates for 2
seconds and goes off
‡If the smart key is in the vehicle and
the Engine Start/Stop button is ON,
but the vehicle cannot detect the
smart key.
In this case, we recommend that
you have the vehicle inspected by a
HYUNDAI authorised repairer.
7his indicator light blinks
‡When there is a malfunction with
the immobiliser system.
In this case, we recommend that
you have the vehicle inspected by a
HYUNDAI authorised repairer.

4-18
Instrument cluster
Turn Signal Indicator
Light
7his indicator light blinks
‡When you operate the turn signals.
If any of the following occur, there
may be a malfunction with the turn
signal system.
- The turn signal indicator light illumi-
nates but does not blink
- The turn signal indicator light blinks
rapidly
- The turn signal indicator light does
not illuminate at all
If any of these conditions occur, we
recommend that you have your vehi-
cle inspected by a HYUNDAI autho-
rised repairer.
Low Beam Indicator
Light
7his indicator light illuminates
‡When the headlamps are on.
High Beam Indicator
Light
7his indicator light illuminates
‡When the headlamps are on and in
the high beam position.
‡When the turn signal lever is pulled
into the Flash-to-Pass position.
High Beam Assist
(HBA) indicator light (if
equipped)
7his warning light illuminates
‡When the high-beam is on with the
light switch in the AUTO light posi-
tion.
‡If your vehicle detects oncoming or
preceding vehicles, High Beam
Assist system will switch the high
beam to low beam automatically.
For more details, refer to “High
Beam Assist (HBA)” in chapter 5.
Light ON Indicator
Light
7his indicator light illuminates
‡When the tail lights is on.
Front Fog Indicator
Light (if equipped)
7his indicator light illuminates
When the front fog lights are on.
Rear Fog Indicator
Light (if equipped)
7his indicator light illuminates
‡When the rear fog lights are on.

4-19
04
Press Brake
(for Automated Manual
Transmission)
7his indicator light illuminates 

4-20
Instrument cluster
Forward Collision-
Avoidance Assist sys-
tem warning light (if
equipped)
7his indicator light illuminates
‡When you set the ignition switch or
Engine Start/Stop button to the ON
position.
- It illuminates for approximately 3
seconds and then goes off.
‡When there is a malfunction with
FCA.
In this case, we recommend that you
have the vehicle inspected by a
HYUNDAI authorised repairer.
For more details, refer to “Forward
Collision-Avoidance Assist (FCA)”
in chapter 6.
Lane Keeping Assist
system indicator light
(if equipped)
7his indicator light illuminates
‡[Green] When the system operating
conditions are satisfied.
‡[White] The system operating con-
ditions are not satisfied.
‡[Yellow] When there is a malfunc-
tion with the lane keeping assist
system.
In this case, we recommend that
you have your vehicle inspected by
a HYUNDAI authorised repairer.
For more details, refer to “Lane
Keeping Assist (LKA)” in chapter
6.
LCD display messages
Key not in vehicle
(for smart key system)
This warning message is displayed if
the smart key is not in the vehicle
when you open or close door in the
ACC position or ON position. The
warning sound is heard when you
close door without a smart key in
vehicle.
When attempting to start the vehicle
always have the smart key with you.
Key not detected
(for smart key system)
This warning message is displayed if
the smart key is not detected when
you press the Engine Start/Stop but-
ton.
Press START button with key
(for smart key system)
This warning message is displayed if
you press the Engine Start/Stop but-
ton whilst the warning message “Key
not detected” is displayed.
At this time, the immobiliser indicator
light blinks.
Low Key Battery
(for smart key system)
This warning message is displayed if
the battery of the smart key is dis-
charged whilst changing the Engine
Start/Stop button to the OFF position.

4-22
Instrument cluster
Door, Bonnet, Tailgate open
indicator
OAC3079037R
This warning is displayed indicating
which door, bonnet, or tailgate is
open.
CAUTION
Before driving the vehicle, you
should confirm that the door/ bon-
net/tailgate is fully closed. Also,
check there is no door/bonnet/tail-
gate open warning light or mes-
sage displayed on the instrument
cluster.
Turn on FUSE SWITCH
This warning message is displayed if
the fuse switch located on the fuse
box under the steering wheel is OFF.
You should turn the fuse switch on.
For more details, refer to “Fuses”
in chapter 8.

4-23
04
Low Tyre Pressure (if equipped)
OAC3079037R
This warning message is displayed if
the tyre pressure is low. The corre-
sponding tyre on the vehicle will be
illuminated.
For more details, refer to “Tyre
Pressure Monitoring System
(TPMS)” in chapter 7.
Heated Steering Wheel turned
off (if equipped)
This message illuminates if the heat-
ed steering wheel will turn off auto-
matically approximately 30 minutes
after the heated steering wheel is
turned on.
For more details, refer to “Heated
Steering Wheel” in chapter 5.
Low fuel
This warning message is displayed if
the fuel tank is almost out of fuel.
When this message is displayed, the
low fuel level warning light in the clus-
ter will come on.
It is recommended to look for the
nearest fueling station and refuel as
soon as possible.

4-24
Instrument cluster
Low engine oil (if equipped)
This warning message is displayed
when the engine oil level should be
checked.
If this warning message is displayed,
check the engine oil level as soon as
possible and add engine oil as
required.
Slowly pour the recommended oil lit-
tle by little into a funnel. (Oil refill
capacity : approximately 0.15 ~ 0.26
gal. (0.6 ~ 1.0 l)
Use only the specified engine oil.
(Refer to "Recommended lubricants
and capacities" in chapter 8.)
Do not overfill the engine oil. Make
sure the oil level is not above F (Full)
mark on the dipstick.
NOTICE
If the message is displayed contin-
uously after adding the engine oil
and travelling approximately
50~100 km after the engine warms
up, we recommend that the system
be checked by a HYUNDAI autho-
rised repairer.
Engine has overheated
(if equipped)
This warning message is displayed
when the engine coolant temperature
is above 120°C (248°F). This means
that the engine is overheated and
may be damaged.
If your vehicle is overheated, refer
to “Overheating” in chapter 7.
Check headlight (if equipped)
This warning message is displayed if
the headlamps are not operating
properly.
In addition, if a specific lamp(turn sig-
nal lamp etc.) is not operating proper-
ly, the warning message according to
a specific lamp (turn signal lamp etc.)
is displayed. A corresponding bulb
may need to be replaced.
Make sure to replace the burned out
bulb with a new one of the same watt-
age rating.
Check brake light (if equipped)
This warning message is displayed if
the stop lamps are not operating
properly. A lamp may need to be
replaced.
Make sure to replace the burned out
bulb with a new one of the same watt-
age rating.

4-25
04
Check HBA (High Beam Assist)
system (if equipped)
This warning message is displayed if
there is a problem with the High Beam
Assist system. We recommend that
you have the vehicle inspected by a
HYUNDAI authorised repairer.
For more details, refer to “High
Beam Assist (HBA)” in chapter 5.
Check forward safety systems
(if equipped)
This warning message is displayed if
there is a problem with Forward
Collision-Avoidance Assist system.
We recommend that you have the
vehicle inspected by a HYUNDAI
authorised repairer.
For more details, refer to “Forward
Collision-Avoidance Assist (FCA)”
in chapter 6.
Check DAW (Driver Attention
Warning) system (if equipped)
This warning message is displayed if
there is a problem with Driver
Attention Warning system. We rec-
ommend that you have the vehicle
inspected by a HYUNDAI authorised
repairer.
For more details, refer to “Driver
Attention Warning (DAW)” in chap-
ter 6.
Check LKA (Lane Keeping
Assist) system (if equipped)
This warning message is displayed if
there is a problem with Lane Keeping
Assist system. We recommend that
you have the vehicle inspected by a
HYUNDAI authorised repairer.
For more details, refer to “Lane
Keeping Assist (LKA)” in chapter
6.
Check exhaust system
(if equipped)
This warning message illuminates if
the GPF system has a malfunction.
At this time, GPF warning light also
blinks.
In this case, we recommend that you
have the GPF system checked by a
HYUNDAI authorised repairer.
GPF : Petrol Particulate Filter
For more details, refer to "Warning
lights" in this chapter.

4-27
04
LCD display modes
Menu
Trip Computer
Driving Assist
User Settings
Master warning
Up/DownFuel Economy Lane safetyDriver Assistance
The Master Warning
mode displays warning
messages related to the
vehicle when one or
more systems is not
operating normally. Door
Accumulated InfoDriver Attention
Warning Lights
Convenience
Drive Info
Intelligent Speed Limit
WarningService Interval
Other Features
Digital SpeedometerLanguage
Reset
Transmission
The information provided may differ depending on which functions are applicable to your vehicle.

4-28
Instrument cluster
Trip computer mode
OAC3069039R
The trip computer mode displays
information related to vehicle driving
parameters including fuel economy,
tripmeter information and vehicle
speed.
For more details, refer to "Trip
Computer" in this chapter.
Driving Assist mode
OAC3069013TU
L.A/'AW/ISLW
This mode displays the state of the
Lane Keeping Assist, Driver Attention
Warning and Intelligent Speed Limit
Warning.
For more details, refer to each sys-
tem information in chapter 6.
Master warning mode
OAC3069028TU
This warning light informs the driver
the following situations.
- Forward Collision-Avoidance Assist
system malfunction (if equipped)
- Forward Collision-Avoidance Assist
radar blocked (if equipped)
- Lamp malfunction (if equipped)
- High Beam Assist malfunction (if
equipped)
- Tyre Pressure Monitoring System
(TPMS) malfunction (if equipped)
The Master Warning Light illuminates
if one or more of the above warning
situations occur.
At this time, a Master Warning icon (
)
will appear beside the User Settings
icon (
), on the LCD display.
If the warning situation is solved, the
master warning light will be turned off
and the Master Warning icon will dis-
appear.