speed HYUNDAI I10 2021 Owner's Manual

5-17
05
Auto door lock/unlock features
Impact sensing door unlock sys-
tem (if equipped)
All doors will be automatically
unlocked when an impact causes the
air bags to deploy.
Speed sensing door lock system
(if equipped)
All doors will be automatically locked
ZKHQ YHKLFOH VSHHG H[FHHGV  PSK
NPK
Child-protector rear door locks
(if equipped)
OAC3059060TU
The child safety lock is provided to
help prevent children seated in the
rear from accidentally opening the
rear doors.
The rear door safety locks should be
used whenever children are in the
vehicle.
The child safety lock is located on the
edge of each rear door. When the
child safety lock is in the lock posi-
tion, the rear door will not open if the
inner door handle is pulled. To lock the child safety lock, insert a
key (or screwdriver) (1) into the hole
and turn it to the lock position.
To allow a rear door to be opened
from inside the vehicle, unlock the
child safety lock.
WARNING
If children accidently open the rear
doors whilst the vehicle is in
motion, they could fall out of the
vehicle. The rear door safety locks
should always be used whenever
children are in the vehicle.
How to lock the door in case of
emergency
OAC3059061TU
In case of an emergency (battery dis-
charge, etc.) you can manually lock
the door using the emergency key.
1. Open the door
2. Insert the emergency key into the
emergency lock located at the
back of the door and turn the key in
the horizontal direction.
3. Close the door.

5-24
Convenient features
Outside rearview mirror
OAI3059018
%HVXUHWRDGMXVWPLUURUDQJOHVEHIRUH
driving.
Your vehicle is equipped with both
left-hand and right-hand outside rear-
view mirrors.
The mirror heads can be folded to
prevent damage during an automatic
car wash or when passing through a
narrow street.
When vehicle speed is over 9 mph
NPKWKHRXWVLGHUHDUYLHZPLUURU
will not fold.
WARNING

5-46
Convenient features
OAC3059031TU
„Front
„Rear
OAC3059032TU
A : Wiper speed control
· MIST (
) – Single wipe
· OFF (O) – Off
· INT (---) – Intermittent wipe
(if equipped)
· LO (1) – Low wiper speed
· HI (2) – High wiper speed
B : Intermittent wipe time
adjustment
C : Wash with brief wipes
D : Rear wiper/washer control/
Wash with brief wipes
·
– Wash with brief wipes
· ON (
) – Continuous wipe
· OFF (O) – Off
Windscreen wipers
Operates as follows when the ignition
switch is in the ON position.
MIST (
) : For a single wiping cycle,
push the lever upward
and release. The wipers
will operate continuously
if the lever is held in this
position.
OFF (O) : Wiper is not in operation.
INT (---) : Wiper operates intermit-
tently at the same wiping
intervals. To vary the speed
setting, turn the speed con-
trol knob (B).
LO (1) : The wiper runs at a lower
speed.
HI (2) : The wiper runs at a higher
speed.
i Information
If there is heavy accumulation of snow
or ice on the windscreen, defrost the
windscreen for about 10 minutes, or
until the snow and/or ice is removed
before using the windscreen wipers to
ensure proper operation.
If you do not remove the snow and/or
ice before using the wiper and washer,
it may damage the wiper and washer
system.
WIPERS AND WASHERS

5-53
05
MANUAL CLIMATE CONTROL SYSTEM
ãIF EQUIPPED
ä
OAI3059100
1. Temperature control knob
2. Fan speed control knob
3. Mode selection knob
4. Air intake control button
(recirculated air position or outside
(fresh) air position)$&$LUFRQGLWLRQLQJEXWWRQ
(if equipped)
6. Rear window defroster button
(if equipped)

5-54
Convenient features
Heating and air conditioning
1. Start the engine.
2. Set the mode to the desired posi-
tion.
To improve the effectiveness of
heating and cooling :
- Heating:
- Cooling:
Mode selection
OAC3059100R
3. Set the temperature control to the
desired position.
4. Set the air intake control to Fresh
mode.
5. Set the fan speed control to the
desired speed.
6. If air conditioning is desired, turn
the air conditioning system on.

5-58
Convenient features
System operation
Ventilation
1. Select the Face Level mode.
2. Set the air intake control to fresh
mode.
3. Set the temperature control to the
desired position.
4. Set the fan speed control to the
desired speed.
Heating
1. Select the Floor Level mode.
2. Set the air intake control to fresh
mode.
3. Set the temperature control to the
desired position.
4. Set the fan speed control to the
desired speed.
5. If desired, turn the air conditioning
ON with the temperature control
knob set to heat in order to dehu-
midify the air before it enters into
the cabin.
If the windscreen fogs up, select the
Floor & Defrost
mode or press
the Front Defrost
mode.
2peration 7ips

5-62
Convenient features
AUTOMATIC CLIMATE CONTROL SYSTEM
ãIF EQUIPPED
ä
OAI3059101I
1. Fan speed control knob
$&$LUFRQGLWLRQLQJEXWWRQ
5HFLUFXODWLRQPRGH)UHVKPRGH
4. Mode selection button
5. Rear window defroster button
(if equipped)6. Front windscreen defroster button
7. OFF button
8. Temperature control knob
9. AUTO (automatic control) button
10. Climate control screen

5-63
05
Automatic heating and air con-
ditioning
OAI3059110I
1. Press the AUTO button.
The modes, fan speeds, air intake
and air-conditioning will be controlled
automatically according to the tem-
perature setting you select.
OAI3059111I
2. Turn the temperature control knob
to set the desired temperature. If
the temperature is set to the lowest
setting (Lo), the air conditioning
system will operate continuously.

5-64
Convenient features
Manual heating and air condi-
tioning
The heating and cooling system can
be controlled manually by pushing
buttons other than the AUTO button.
In this case, the system works
sequentially according to the order of
buttons selected. When pressing any
EXWWRQH[FHSWWKH$872EXWWRQZKLOVW
using automatic operation, the func-
tions not selected will be controlled
automatically.
1. Start the engine.
2. Set the mode to the desired posi-
tion.
To improve the effectiveness of
heating and cooling, select the
mode according to the following:
- Heating :
- Cooling :
Mode selection
OAC3059100R
3. Set the temperature control to the
desired position.
4. Set the air intake control to fresh
mode.
5. Set the fan speed control to the
desired speed.
6. If air conditioning is desired, turn
the air conditioning system on.
7. Press the AUTO button in order to
convert to full automatic control of
the system.

5-68
Convenient features
Air conditioning
OAI3059107I
3XVKWKH$&EXWWRQWRPDQXDOO\WXUQ
the air conditioning system on (indi-
cator light will illuminate).
Push the button again to turn the air
conditioning system off.
OFF mode
OAI3059116I
Push the OFF button of the front to
turn off the air climate control system.
However, you can still operate the
mode and air intake buttons as long
as the ignition switch is in the ON
position.
System operation
Ventilation
1. Select the Face Level mode.
2. Set the air intake control to fresh
mode.
3. Set the temperature control to the
desired position.
4. Set the fan speed control to the
desired speed.
Heating
1. Select the Floor Level mode.
2. Set the air intake control to fresh
mode.
3. Set the temperature control to the
desired position.
4. Set the fan speed control to the
desired speed.
5. If desired, turn the air conditioning
ON with the temperature control
knob set to heat in order to dehu-
midify the air before it enters into
the cabin.
If the windscreen fogs up, select the
Floor & Defrost
mode or press
the Front Defrost
mode.